Having problems with your 1995 GMC Sonoma ?

1995 gmc sonoma - how do i replace fan relay switch?

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1995 GMC Sonoma

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1998 GMC Sierra. Blower motor works sometimes. No particular circumstances, just when it wants to. Checked all fuses, relays, even replaced the resistor, nothing. Followed the wire harness and found the two pigtails that others have mentioned. Took the wires off, black and purple, and turned ignition on. Getting around 11 volts on all sittings except for the highest setting, it reads 0 volts. The compressor turns on at the console, all the switches on the console work, just not the fan.


Could it be the blower motor it self? sometimes they have a "bad spot" when it is not working, can you hit it and make it run? pretty common on these trucks. the switch is also common. they often melt at the connector on the back making a bad connect ... 1998 GMC Sierra

1995 gmc sonoma - how do i replace fan relay switch?


... 1995 GMC Sonoma

I have a 1991 GMC K3500 with a 7.4 engine. The truck is equiped with a factory auxiliary cooling fan in front of the condensor coil. It will not come on now and the engine temp wants to creap up over 210 when idling with a/c on. I have replaced the thermal switch in the right head as well as the fan motor,radiator,water pump,clutch fan,and a relay on the left fender. I proved out the ground wire on the thermal switch. The relay has a diagram on it but i'm unsure how it works! I don't know if the


... 1992 GMC Sierra K1500

Have a 1997 gmc sonoma had blower motor bypassed with toggle switch cause regular switch broke. Wanted to correct problem installed new blower control board and now nothing still works. replaced resistor, and relay for unit. relay just makes a continuous clicking noise


... 1997 GMC Sonoma

I appreciate the help regarding the Dodge ?2002? radiator fan relay switch, but I can?t find a replace part anywhere on the web. What I see is a replacement ?relay radiator fan? and nothing about a switch. I?ll definitely check for the relay switch, but I find it odd that I can?t find a separate replacement switch. Should I call NAPA?


The device that turns the radiator fan on is a temperature sensor on the lower radiator hose towards the engine block. That could be the switch that you are referring to. When the coolant reaches a certain temperature it tells the radiator to turn ... 2002 Dodge Caravan

Car came in overheating, fan working then. Replaced water pump, thermostat. Roadtested car and still overheats after about 20 minutes of driving. Elec. cooling fan does not come on unless turn on the a/c. Replaced cooling temp switch, radiator fan switch, fan clutch, and also the resistor pack. Need to know if there are 2 relays for the electric cooling fan and where they are located at. The engine code is Awm, also is there 2 fuses for the relay also appricate any help here. We also hooked up a


Tech Bulletin from Nov 9 2004.....Engine Coolant Temp Sensor issue....\015\012\015\012It is 13 pages.....if you email me at [email protected], I ca ... 2004 Volkswagen Passat

Here what is probably a simple question to you experts.......on my car, my relay switch to my radiator's fan went out...now, here's the deal... Radiator Fan has a positive and negative wire. Car battery has a positive and negative side. Toggle switch has a positive and negative side.. as you may have gotten the picture, how should the wiring go, in order for the toggle switch to control the power to the fan, until i can get the relay switch replace? (of course the desired result is to t


To wire this properly, you want to run a grond to the frame somewhere and simply control the power side with the toggle. You will not hook the negative to any toggle. Make sure the toggle is rated to at least 30amp so you don't burn the switch. If yo ... Mazda 626

My engine coolant temperature switch not turning on fan relay until car runs warm above normall. I replaced temp switch I can make fan relay kick on fan by jumping the two wires together that run to temp switch. I can't get fan to come on until car is running hot


Year make and model ?Did you get all of the air out of the cooling system when you filled it back up ? The fan is supposed to come on at 220 degrees. ... Cars & Trucks

Hi, I have a 1995 Jeep Grand Cherokee 6 cylinder, 2wd. I need to replace the A/C Fan relay switch but I don't know where the relay is. Can anyone help me to locate the relay switch? The issue my Cherokee is having is, when I shut off the engine the fan will not shut off. So the battery will die. Also I can no longer can control the fan-a/c on the console. It just runs loud and blows air out as though the fan is on high.


Under hood in high voltage fuse box ... 1995 Jeep Grand Cherokee

The brakes went out on my 2000 GMC Sonoma SLS. Bulb replaced. Where is the relay switch located under the dash?


... GMC Sonoma

I need to fuse box diagram to locate the relay switch for radiator fan. I replaced the temp sensor and have tried relay switch in all spots and radiator fan still won't come on. I need to know which relay is for turning on radiator fan


... Chevrolet Equinox

I have a 2001 chevy S-10 pickup and recently lost high speed on the heater/ac fan, so I replacecd fan motor basicly because it was making noise on the lower speeds and also replaced the resister module, this did not solve the problem This evening I replace the solid state relay mounted on the fire wall, still no luck, the fan works fine in 1,2,& 3 but no go in #4, any suggestions? I can hear the relay click when I jump the high speed terminals with the fan switch removed


It sounds to me like you have changed everything but the actual switch try that ... 2001 Chevrolet S-10

In our 1995 Cadillac Deville we can't get the fans to come on to cool the radiator. There are four relay switches and we don't know if we have to replace all of them or is there just one and where is the one that cools the radiator. We have already replaced fuses and still radiator overheating. Now need to replace the module pcm or fan relay - but don't know which one or if all four have to be replaced.


The most common overheating problem with the Northstar engine is a blocked purge line. It's job is to purge air out of the cooling system.There is a small diameter hose coming from near the top of the coolant tank,this is the purge line.W ... 1995 Cadillac DeVille

The heater/ac fan will not turn on when I turn the switch. I have already replaced the blower motor, resistor, and relay switch but it still doesn't work. what part of the dash do I need to take apart to replace the fan switch?


... 2002 Chevrolet Malibu

I have a 1991 toyota 4 runner and i am having problems with overheating, i have replaced the water pump,fan clutch, 3 radiators,2 radiator caps,the upper and lower radiatior hoses,2 thermostats and the temp, sending unit, the gauge on the instrument pannel reads it is only half way, but it will never go above that, so i was told it could be a clogged block, or a fan relay switch, my question is where it that fan relay switch located? or do you know of any other reasons why i could still be havin


Most comun problem on those cars is the HEAD GASKET there was a recall for that. but not enymore i think. ok the problem is the head gasket on cylinder #6. it breaks they say couse the head is made out of aluminium and the block is iron. You should h ... 1991 Toyota 4Runner

Driver side cooling fan was working and passenger side was not, switched 4 pin relays around multiple times, now passenger fan works and driver side does not work and I can't get the driver side to work by switching relays. Runs hot, uses coolant and oil, runs about 170-185 as long as the car is moving, runs at 200-230 while idle, checked all fuses and they are fine. Thought maybe it was the relays, thermostat or the water pump if it was replaced with a non-original part.


The coolant sensor controls these fans,one is for moderate cooling,the other kicks in when the temp gets up higher,so change the coolant sensor.Turn the ac on max cool,see if the cooling fans both come on,and let me know. ... 2001 Chevrolet Monte Carlo

2002 Grand Cherokee Larado AC cooling fan (small fan in front of radiator fan) stuck and was running after car was switched off. I had to disconnect the battery to get it to stop running. When I tried to replace the battery cable the fan started to run again. I touched the cable to the battery again and herd a click from the engine and the fan would not come on. I replaced the battery and cranked the car and turned the AC on but can't get the AC fan to come on. My machanic replaced the relay mod


... 2002 Jeep Grand Cherokee

Over heating I need to replace my clutch fan relay switch & I cannot locate it in my car. My fan works fine if I bypass it and every thing else is good, its just the relay, the car over heated 2 times only nothing bad came of it. I refuse to have a dealer fix it,bad enough the relay is $35.00 & no dealer is going to charge me hundreds of dollars to fix what I can do my self. Can eny one help me? Wheres the electric clutch fan relay located for my 86 chrysler lebaron?


Looking for the electric fan thermostat/switch on a 93 lebaron myself.. ... 1986 Chrysler LeBaron

94 Plymouth sundance coolant fan relay which terminals are supposed to have what power values I know the grey wire is Hot 12v constant and light green is to the fan and one to the AC relay are the other two wires supposed to be powered or negative and when and why? the fan only runs when the AC is turned on I have replaced both the coolant temp switch and the relay neither fixed the fact that the fan wont turn on when the engine gets hot i dont know what to check next.


Cooling fan does not come on at all ... 1994 Plymouth Sundance

I hooked my battery up backwards. It took out the headlights and the heater fan. Replaced the light switch and still nothing but after much test lighting I found out the fan switch is still good. All fuses and relay are good under the hood. What could this be? Are there more relays for these two things I don't know about? Also all ground wires are still in tact.


... 2001 Hyundai Accent

Cooling fan wont turn on when my 1996 b20b honda orthia starts over heating, have replaced fan switch on thermo housing, replaced thermo(stat), switched the relay, and changed and bled the coolant, please help


First we must be sure that the power is reaching the fan ,disconnect the wires from the switch .run a wire from the positivefanwire direct to positive terminal on battery ,do the same onthe negativeside,and the fan should run if there is nothing wron ... 1996 Honda Accord

1999 S-10 Blazer. Blower fan quit working, replaced with new one, only works on high. Also replaced the fan switch relay, still only works on high. Now what? The switch?


Yep the switch ... 1999 Chevrolet Blazer

Overheating when idleing I have replaced fan switch relay,temperature sensor. I ran a hot wire from the battery and the fan will come on that way but it will not come on manually.Are there any other relays or problems I could replace?


Are u sure u put a fan relay module in it. the relay is under the passenger side headlamp. take out the headlamp cut a 2x2 hole in the plastic jump the circuit from there if the fan turns on there is your problem. Very common problem in those cars ... 2000 Jeep Grand Cherokee

Radiator resivoir is cracked and fans not running and i need to replace the radiator and or run a toggle switch for the fan relay switch if the wiring is bad


It may already have a blown head gasket. The max pressure on the cooling system in normal conditions is 18psi. How do you know the fan or fans are ok ? The computer signals the relay to turn the fans on if the engine temp reaches 220 degrees o ... 1995 Dodge Neon

1990 silouette 3.1 v-6 looking for the temp switch, replaced temp sensor, fan relay and fan ( fan tests good and runs independently) still won't come on. Temp gauge is jumpy and showing 240-260. replaced thermostat and water pump. Radiator holding pressure but does not seem like its at 260 I'd estimate 190. Gauge is wrong but I can't find it to replace it.


Hey if it was constantly running at these temps you would dhave definately damaged the engine by now. the temp guage is integrated with the instrument cluster and not replaaceable unless the whole guage cluster is replaced. you could go to a professi ... 1999 Oldsmobile Alero
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.2927 seconds