Having problems with your 1995 GMC Sierra ?

How do you replace the license plate light on a k1500 1995 gmc truck

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

All you have to do is reach up underneath the rear bumper, grab the light socket and turn a quarter turn counter-clock wise and pull the socket out of the housing. Then firmly grab the light bulb and pull straight out. Just reverse these directions for replacement.
Repair Help & Product Troubleshooting for 1995 GMC Sierra

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 2001 GMC Jimmy 4d 4x4. Recently while I was hooking up my trailer to a 4pin connection on the truck it caused a short or something to cause the trucks license plate lights to go out and the trailer 4pin coming from the truck not to work. I pulled the lights out and replaced the bulbs and still no results to the license plate lights. Is there a fuse somewhere that may have gone out or did it short something out? I looked for a fuse in the normal place on the driver side dash and could


... 2001 GMC Jimmy

How do you replace the license plate light on a k1500 1995 gmc truck


All you have to do is reach up underneath the rear bumper, grab the light socket and turn a quarter turn counter-clock wise and pull the socket out of the housing. Then firmly grab the light bulb and pull straight out. Just reverse these directions f ... 1995 GMC Sierra

Replace 2004 yukon license plate lights - Yukon GMC Cars & Trucks


... GMC Yukon

Have a 1998 Dodge Ram1500 and my boyfriend tried to wire a license place light into the current wiring for the stock license plate light and blew the fuse for my running lights. I replaced the fuse and he gave up trying to wire the light but now I have no stereo and no interior lights in my truck. I have checked all the fuses in the cab and under the hood and they are all good.........help please.


Trade him off on a new model that has a (Clue) what he is doing, ... Dodge Cars & Trucks

2002 GMC SONOMA 4X4- 4.3 Front marker/parking lights dont light up, bulbs are fine. tail lights- when turn signal is on the tail light blinks with tail light and backup light and license plate light all at the same time on left side. brake light on left goes out when brakes are applied?? Extended cab door rattles as if not closed, yet it is and latch mechanism has been replaced repeatedly in attempt to fix prob...Please Advise...THANK YOU ! Tina


... 2002 GMC Sonoma Extended Cab

1994 GMC Suburban K2500 HVAC problem Removed HVAC face plate to replace three lights on the circuit board so that function switches would be illuminated (previous bulbs not functioning Reinstalled unit, turned the truck on, everything works as it should (heat, ac, defrost, floor, etc.) the problem is all display lights are on while the truck is running and also remain on approx 30 sec after ignition is turned off, key removed, door closed. Thinking that this could be a cpu issue, I dis


Check the control head terminals.Make sure they are clean.These terminals are very touchy.The ecm has no output for the hvac unit.The control head itself is the module.All the info is in the control head assembly.If the terminals are all good then wh ... GMC Suburban

I had to change a flat tire. When I was replacing my spare tire to the storage location somehow it cause my truck to shut off. I found it blew out my license plate light bulb and tripped my fuel cut off switch. Once I corrected both of those this used it started right up and ran fine for a short time and then it died while driving. I didn't replace my fuel pump. Now I'm having to start the vehicle in neutral otherwise it will not go into gear, the interior lights do not work, nor does the speedo


I may only not knowing model and year be able to guess---have you tried after reset of the fuel safety switch to disconnect the negative battery connection to let the vehicle computer try to reset when it is connected again? ... Cars & Trucks

Light replacement Replacing the license plate light on the rear bumper of a 2001 gmc yukon xl.


Just reach behind the bumper and grab the light/electrical harness and twist is either way and then it should pull out put in a new 194 bulb and you are set. ... 2001 GMC Yukon XL

Replace license plate light 1998 gmc jimmy


... 1998 GMC Jimmy

1997 gmc k1500 license plate light problems


... GMC Sierra

License plate light out on my '04 gmc envoy,how do i replace it?


Has 2 screws for the cover, take them out and replace the bulb/s. Might check the seal that seals the entire license plate panel, it's black. Common problem is that this seal comes folded under from the factory and allows water into the bulb area. ... 2004 GMC Envoy

Replace grand vitara license plate light - Cars & Trucks


... Cars & Trucks

How do i replace the license plate light - Cars & Trucks


... Cars & Trucks

Can someone explain how to replace the license plate lights on the rear bumper of a 2001 gmc yukon xl? Sorry for the novice question.


Under the bumper turn the light socket 1/4 turn and pull out.bulb should a 194 I think? ... 2001 GMC Yukon XL

Hello, I have a 2002 GMC Envoy and my check engine light is on. The code populated is P0014, I've read different solutions to this code, however I am still unsure as to which route to go. Would the replacing the Camshaft sensor resolve my issue? Also, when my AC is on the timing appears to go up and down (from 0-2), as if my truck wants to shut off, and then Pressure Oil Low // Stop engine displays. Thank you for any assistance you can provide.


DTC P0014 - "B" Camshaft Position - Timing Over-Advanced or System \015\012Performance \015\012 (Bank 1) = to see Trouble Code P0011DTC P0011 - "A" Camshaft Position - Timing Over-Advanced or System Performance (Bank 1)What ... 2002 GMC Envoy

E350 license plate light replace - Ford Cars & Trucks


... Ford Cars & Trucks

Replace license plates lights 2000 avalon - Toyota Cars & Trucks


... Toyota Cars & Trucks

License plate light bulbs need replacing - Xterra Nissan Cars & Trucks


... Nissan Xterra

1992 GMC truck K1500 (5.7L) series noticed the voltage this morning (~34 deg F) while driving (~ 60mph) was about about 11V with only the head lights on. Over the last year or so it seems that the voltage gauge has indicated lower voltage especially in the summer time (~12.5V). The battery and alternator have been replaced within the last year. When I turned the left turn signal on this morning the speedometer oscillated quite a bit with the rhythm of the turn signal and then when I turned the


Replace the alternator, it has bad diodes. Rebuilt alternators never seam to last very long ! ... 1992 GMC Sierra K1500

Replace 2008 subaru license plate light bulb - Outback Subaru Cars & Trucks


... Subaru Outback

Audi a4 2004 license plate light replacement - A4 Audi Cars & Trucks


... Audi A4

I have a 1991 chevrolet k1500 truck i have no reverse lights and now no tail lights, i have checked fuses all good, i replaced all the bulbs both sides of truck and replaced bulb holder tray on each tail light ... still have no tail lights or reverse lights just signals and brake light:( any help would be appreciated also theres a 3 pronged fuse under the dash that clicks when i step on brake pedal i tested it for power and only got power out of 1 of the prongs could that have something to do wi


Sounds like you may have a wiring problem at the back of the truck right side underneath behind the bumper were the wires travel from the front to the rear of the truck, if you check the wires for damage, broken,green corrosion or rubbed through this ... Chevrolet C1500

I have a license plate holder with light that I bought from a third party. I do not have a back bumper so I am using the existing lights wire to hook to the new license plate light. here is the problem: the truck has two wires going to the bulb, I only have one wire coming from this new light. I am assuming that the two wires are a positive from the battery and wire to the switch, can I tie these two together on the one line? or do I only require the positive wire? need assistance.


I would get a voltmeter, hold the black ground wire to the chassis, turn on the lights and touch the red hot wire from the voltmeter briefly to each one of your wires. which ever one of them gives you 12 volts is the one to attach to your new light u ... 1995 Nissan Pickup

License plate lights stopped working, tried license plate lights stopped working, tried replacing bulb, still doesnt work. is there a fuse to check? where is the fuse?


There is a fuse panel inside the car usually near the driver area, check the knee bolster (below steering wheel) close to the driver door, also check the side of the dash where the driver door closes. ... 2002 Ford SVT Focus

2001 LeSabre - replace rear license light. The rear license plate lights do not light up the license at night. How do you get to them? What size bulb do you need?


Kind of tricky, took me an hour to get it figured out, but you got to open the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can ... 2001 Buick LeSabre
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.3162 seconds