Having problems with your 1995 Chevrolet K1500 ?

How do you change a actuator on a 1995 chevy truck 4x4 front differential. Front hubs won't engage.

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1995 Chevrolet K1500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you change a actuator on a 1995 chevy truck 4x4 front differential. Front hubs won't engage.


... 1995 Chevrolet K1500

I have a 1990 K1500 4X4 Chevy pickup that wont engage into four wheel drive. I bought the truck from a friend who had just replaced the actuator on the front end but that did not cure the problem. The shifter in the truck will put the truck into 4 low and 4 high but the front end does not engage, seems to be an elecrical issue as the console doesn't light up when shifting the transfer case. Is there another solenoid or relay on the transfer case that engages the actuator on the front end?


I had the same problem on my 90 K1500, it was the 4 wheel drive actuator unit itself. Bout it at the local parts store for 30 bucks and installed it in 10 minutes or less - and vavoom! 4 X 4 back in business. ... 1990 Chevrolet K1500

I have a 97 chevy with push buttom 4x4.. it wont engage into 4 wheel.. but the buttons say it in 4lo but is in 2 and it wont go in 4wheel. and the switch wont change to 2 wheel... theres power to the actuators... but tey wont engage. and when u turn off the truck the actuaor starts moving by its self but wont engage.. whats the problem?


... Chevrolet Silverado 1500

I need to change the front cover on my front differential for a chevy 2500 4x4 8 bolt hub, have a another front differential from similar truck, but cannot figure out how to get the gears out of it, how does one do that?


You have to pull out the front axles to get the gears out of the differential ... 1990 Chevrolet K2500

4X4 WONT ENGAGE FRONT DIFFERENTIAL BUT FRONT ACTUATOR MOTOR DOES WORK IF JUMPED WITH POS &-


... 2001 Toyota Sequoia

I have a 1991 s10 blazer 4x4.. i have the truck on jack stands and i put the truck into 4wd and the front tires do not move, is their a fuse that helps ingage the 4x4 or is it just the cable that comes from the 4x4 actuator to the front differential


Also verify front axles are fully engaged into differential its common for them to pop out esspecially if the vehicle was driven on a hard dry surface ... 1991 Chevrolet S-10 Blazer

I have a 99 F250 superduty 4x4. The front lockout hubs wont engage, only click when moving. I dont have the pushbutton 4x4, I have to manually lift the lever, and the lights on the dash work. Why wont it engage?


... Cars & Trucks

Have a 2007 F150 stx 4X4 w 5.4 l V8. The 4 wheel drive lever is on the floor. I shift it into 4high, the light on the dash says it is in 4X4 but the passenger side hub whines like it is not engaged. We checked all the vacuum lines, good. We put the truck on jack stands, started it, put it in drive, pulled into 4high, and let my foot off the brake. The passenger side front axel spins but not the wheel. the hub sounds like it does not engage. The drivers side axel is not spining but the wheel can


... Ford F-150

2001 Chevy SLIVERADO 4X4 Light blinks does not engage already changed actuator on front differental


... 2001 Chevrolet Silverado 2500HD

2000 Toyota tacoma will not engage 4x4. Replaced bad vacuum line on 4x4 shift lever housing, have good vacuum at firewall switch and actuator on differential the 4x4 fuse in the cab is also good. It is equipped with automatic hubs and a manual transmission. We have also lifted one side of the vehicle engaged lever for 4x4 and spun tires thinking dash light may not be functioning. Any ideas?


... Cars & Trucks

Front wheels will not engage on my 350 Automatic 1988 chevy 4X4 CK2500 silverado. I have had an intermittent problem in the past but it eventually would work. Now there are no indicator lights on the transfer case shifter and it will not lock in the front wheels. I changed out the thermal actuator on front Axle and cleaned all connections at the front axle plugs but the 4X4 still will not lock in. What else could be causing the problem? I heard maybe a faulty T-switch? where is this t- switch


On that truck your fuse for the instrument panel is the same for that actuator. ... 1988 Chevrolet K2500

I have a 2001 GMC Sierra Pickup that has electronic 4WD that will not engage. If you press the buttons to enter from 2HI to 4HI, 4LO, Etc. the choice of the button changes (lights up) but the truck does not have 4WD engaging or working? I have checked fuses, and they are fine. Could it most likely be the actuator? I am not a mechanic, would it be the transfer case actuator or the front axle actuator? Thanks!


Fullyjr.\015\012\015\012Engaging from 2WD - 4HI/Lo requires movement of the vehicle. very low speed under 5mph, push button should engage. the vehicle has to be moving. ... 2001 GMC Sierra Crew Cab

Hello, 1986 Toyota 4X4 Truck 22R carb engine manual transmission. My son was driving it and the rear wheels locked up. Driving in 2 High mode. He got the truck pulled over to the side of the road using 4X4 high after locking in the front hubs then called me. I tested clutch, engine etc. Engine runs fine, clutch works. Engage transmission and start to release clutch and tranny binds up, (2 high) rear wheels slightly turn, maybe about 1/8 revolution do not turn fully. the engine bogs down and dies


I've seen a similar issue on other transmissions where the shifter slips out of the slots in the shift forks, either due to shifter bushing wear or just general wear on tte trans. It can usually be remedied at least temporarily by popping the shifte ... 1986 Toyota Pickup 4WD

1989 s10 blazer wont go into 4wd. I know i have some vacuum issues so i attempted to manually lock in the hubs by pulling the wire going into the actuator and placing vice grips on it. Even with the wire in the "engaged" position, the front wheels dont move. Also, it shifts into 4wd when i pull the shifter, its just that the front wheels dont engage. Any suggestions??


... Cars & Trucks

2000 chevrolet k2500 push button 4x4 the 4wd doesnt engage i pulled out the front actuator seems to be working pressed the 4hi switch the spring poped pressed 2hi spring decompressed transfer case sounds like its working at least its telling the front actuator to work truck has 167000 miles but runs good please any input would be helpful


... Chevrolet K2500

I have a 96 gmc jimmy i have changed the actuator,actuator cable,all the vac lines,vac switch and switch on differential and still the front tires dont engage,the transfer case is locking in and so is the front drive shaft,any idea what else it could be our problem?


On your Jimmy you need to put it in 4 hi and up under the battery tray is the actuator for the front dif. make sure the vac hose going up to it has vacuum. if it doesn't then start tracking the hoses going down to the transfer case. one goes to th ... 1996 GMC Jimmy

I have a 1990 k1500 chevy pickup i just replaced the front actuator and the cvc joint on the driver side when i engage the truck it pulls to the right when i give gas and when trying to disengage into 2 wheel drive it shutter and shakes at 55 and the light doesnt turn on but when i take out the fuse everything is back to normal but it wont engage what is wrong with my truck?


... 1990 Chevrolet K1500

2002 Superduty Ford F-250 4x4. Had auto locking hubs, changed to manual Warn Hubs, but only lasted for 4 lock-in/lockouts and the the right hub will no longer engage. The mecnhcanic could not fix the problem, so he put on my second new set of Warn hubs, worked for 3 lockin/lockouts and the right front hub will not lock back in. this last time it made a grinding noise until I turned the hub to Lock and then back the "Free" where the noise went away. This condition only happens on the passange


... 2008 Ford F 250 Super Duty 4WD

My left front locking hub on 4x4 ford truck wont lock in


Check the cv joint ... 2005 Ford Ranger

97 Ford Ranger 4X4 manual hubs does not appear to lock with differential. Recently changed pax hub with new Warns, and worked briefly. Seems like the axel gear isn't engaging into the hub.


... 1997 Ford Ranger SuperCab

Auto locking front hubs don't engage when 4wd is selected, transfer case and front tailshaft are spinning but front wheels don't turn. My truck is an Australian released f250 crew cab 7.3litre powerstroke 4x4 released in 2002


... 2003 Ford F250 Super Duty Crew Cab

I think the front axle seals on my 1999 dodge 3500 4x4 need to be replaced. I am replacing the sealed bearing hubs and I wonder how big of a job it would be to switch out the axle seals inside the differential housing. I already drained the oil and removed the cover, but I am reluctant to unbolt the ring gear assembly. Would it be safe to leave the seals and hope that they don't leak? The truck has 200,000 miles on it and up to now has been a great truck. Thank you in advance for any help t


If you have the hubs of than you dont have much futher to go to replace the axl seals. just slide out the axls the passenger side is two pice then take out the four bolts that hold in the carrier gear then pull out the hole gear asemblie the driver s ... 1999 Dodge Ram 2500 4WD

I have an intermittent grinding/metal spining sound that goes away the moment the 4 wheel drive is engaged. Sounds like a free spinning hub partially engaged??? Have had the wheels pulled, front drive shaft pulled, differential fluid changed, still have problem. any ideas?


WELL WHAT YERA IS THIS TRUCK AND IS THE SOUND COMING FROM FRONT OR IS COMING DOWN DRIVE LINE IT COULD BE AT TRANSFER CASE THAT WHY IT GOSE AWAY WHEN IN FOUR WHEEL YOU COULD PULL THE DRIVE LINE IN FRONT AND SEE IF NOIS GOSE AWAY THEN ITS IN FRONT IF ... Ford F-150

My s-10 cant go into 4 wheel drive someone says its the computer in the truck that wont engage the 4x4 if so do i keep looking for a used or new one which i have been looking hi and wide for or can i buy a part that will engage it someone told me buy a locking hub made by warner is this true or is there a product out there just for the s-10? Ben


Usually they came with automatic shift by pushing a button on the dash.I always knew that after 1988 all Chevys came with an electric front differential.So i would check there first its an electric motor,not sure the cost. ... 1997 Chevrolet S-10 Pickup

My f150 4x4 wont engage and i have already change the actuator at both wheels and the thing on the fire wall the vac lines go to and still no 4x4


You may need to work upwards from the wheels past the thing on the firewall. If the part on the firewall has vacuum lines coming out of it, then it must have a vacuum line going into it to provide the vacuum.\015\012\015\012You need to t ... 2005 Ford F-150
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.7562 seconds