Having problems with your 1995 Chevrolet G20 ?

Oil leak on bottom of engine block where oil cooler adapter screws in

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1995 Chevrolet G20

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Oil leak on bottom of engine block where oil cooler adapter screws in


... 1995 Chevrolet G20

Oil and Coolant leak of about 11/2 quarts coolant - 1/2 quart oil per night Leak 1 (Coolant) Appears to be coming from the radiator bottom right corner. Leak 2 (oil) Appears to be coming from the engine block or rubber blown gasket from under the block. I have checked the hoses and they are intact, as well as drainage plugs Any advice would be great!


The passenger right side of the car doesn't have any flanges for cooling system, if that's correct then your radiator has a leak or puncture.The driver side of vehicle has both the in and out flanges for the radiator. Very common to see l ... 2000 Volkswagen Beetle

My OIL light stop engine light keeps coming on 2001 Volvo S60 2.4T, only at idle, 750-850 rpm, otherwise runs great! so far have replaced oil pan o rings, then found out about air being in oil. Checked, it has air in oil when hot. Am now replacing two strange looking gaskets on Oil Cooler attached to oil pan. It was leaking a little bit of oil at bottom of oil cooler after the pan gaskets changed. Should I change it out as well? So tightened it real tight and it takes it much longer for the ligh


Oil pump ... Volvo S60

How do you remove 350 engine oil cooler? There is a leak where the oil cooler connects to the engine block. I can see that I can get a gasket set but what all needs to be done to take it off and put it back together.


... 1993 Chevrolet Suburban

2001 Mustang SVT Cobra. Just did oil change , hand tightened new filter then w filter wrench tightened 3/4 turn. Leaking coolant , not oil from seam on engine oil cooler where it is screwed on. Is this a common problem? I have been changing oil for 9 yr on it and do not feel I was overtightening it , assuming that is the problem. Assume I have to replace the oil cooler unless you can suggest an easy quick fix while still in place. What is the proper part number if replacement needed? Ken


The oil filter adapter gasket has probabally failed ...maybe the oil filter adapter is bad also. I would remove the adapter clean it well and inspect. Repair or replace as needed. ... Ford SVT

On my 98 Jetta GL there is a block that comes off the engine that the oil filter screws into. When i start the car oil starts leaking around that block really Bad!


Mine does the same thing im in the prosess of fixing it the part that comes off the engine is called a oil filter adapter and the square deal the is on there is the oil cooler and the oil filter screws onto that i thing it is the gasket to the oil fi ... 1998 Volkswagen Jetta

1999 Ford Taurus GL Wagon 3.0 V6 178K - Two issues. 1 - oil pan - slight leak due to worn oil pan gasket, probably cork. Worn rusted spot on the bottom of the pan. I have a replacement pan from a salvage yard but I'm having a problem getting the oil pan off the car. It seems to be blocked by the exhaust system - how do I remove the old oil pan? Did Ford really do this? Is it really this difficult to remove the oil pan? 2 - The service engine soon light came on. My mechanic checked codes and it c


Drop the exhaust header pipes to remove pan.the bands are starting to slip in the trany :(ford #&^*(*&^$%$^!!!! ... 1999 Ford Taurus

Oil is gushing out of the oil filter housing adapter -- the housing that attaches to the engine block, and onto which the oil filter screws to. Is this an easy item to replace?


You may need a new gasket to the block, or it may be the cooler oring. ... Volkswagen Passat

Bum engine? My daughter has 1995 Chevy Lumina with a 425 engine (?) that leaks oil. The intake valve has been replaced and it still leaks oil. The mechanic says he can't place the origin of the leak because the engine is shaped like a V and the oil pools at the bottom then leaks out all over. How can the oil leak be diagnosed properly on this engine?


... Chevrolet Lumina

I have a 98 beetle that appears to be leaking oil from the cooler. Is there a gasket that can be replace where the cooler mounts to the engine block?


O-ring ... 2000 Volkswagen Beetle

1995 chevy tahoe oil cooler adapter leaking oil from block, want to replace o ring, what do i disconnect?


... Chevrolet Tahoe

My daughter has 1995 Chevy Lumina with a 425 engine (?) that leaks oil. The intake valve has been replaced and it still leaks oil. The mechanic says he can't place the origin of the leak because the engine is shaped like a V and the oil pools at the bottom then leaks out all over. How can the oil leak be diagnosed properly on this engine?


I had a '93 Chevy Lumina (sedan) with the 3.1L V6, and it was also leaking oil badly enough to coat the underside of the car with an oily sheen. A mechanic pointed me in the right direction. There is no distributor on this car, but there is a blank-o ... 1994 Chevrolet Lumina

I have an oil leak in my 1987 Nissan D12 pickup Z24 engine. The oil leak is coming out from around the base of the PCV tube, where it is inserted into the engine block. The oil only leaks out after the engine has ran and then cut off. I have tried placing an o-ring on the tube and sealant but this has yet to stop the leak.


... 1987 Nissan Pickup

HAVE SMALL OIL LEAK FROM TOP OF ENGINE BLOCK DRIPPING DOWN BY SIDE BLACK VERTICAL COVER TO CAM BELT/ALTERNATOR DRIVE BELT. SOMETIMES DROPS ON EXHAUST AND SMELLS. HAD ROCKER COVER GASKET REPLACED 15 MONTHS AGO BY GARAGE WITH WATER PUMP COST ABT £300!! ENGINE STILL VERY LIVELY AT 106,000 MILES BUT I NEVER EXCEED 4000 RPM HAVE A SLIGHT GRATING SOUND ON IDLE FROM AREA OF BELT TO ALTERNATOR VERY SMALL OIL LEAK NEEDING HARDLY ANY TOP UP BUT OIL KEEPS GETTING ON TO FRONT CYLINDER BLOCK [TOP - DOWN] LIK


... 2006 Fiat 124

My 1994 camaro w/ 3.4L engine has an oil leak in rear of engine. It is running down both sides of the block in rear. Oil filter is wet, but not leaking, the starter and bell housing drip oil and its getting on the exhaust. It doesn't look to be coming from valve covers, but it's hard to see. Oil sensor leaked, but has already been replaced. Could it be a gasket in the rear of intake? Is this common problem? 194,000 miles Semms to drip 1 drop every 5 seconds when running, and leaves 5 spots the s


This is most likely a leak from your rear main seal. It happens and can be a pain to replace if you're a DYI kinda person without the nec. equipment.\015\012\015\012\015\012Raise and safely support the vehicle with jackstan ... 1995 Chevrolet Camaro

How do you repair a oil leak where the filter adapter connects to the engine block on a 1995 jimmy 4x4


... 1997 GMC Jimmy

I have a 2001 Chevrolet Suburban 2500 4x4 6.0 liter engine. This vehicle has engine oil cooler located the radiator tank drivers side. I have developed a coolant leak located where the upper threaded inlet of the cooler exits the radiator tank. The cooler inlet threads protrude out of the tank about 1/2". A large nut tightens down onto the radiator tank. This coolant leak is around the upper inlet and the tank. I have previously tightened this large 1.70" O.D. nut to stop the leak with suc


The procedure you are thinking about doing is the correct procedure but you need to know that there is a rubber seal behind the large nut. Best to remove the line, remove the large nut and replace the rubber seal. Overtorquing the nut will crack the ... 2001 Chevrolet Suburban

Oil leak at oil filter to block adapter


... 2001 Ford Expedition

Daelim S3 brand New, with oil leak. After a little more than 500 kms I’ve noticed a oil leak on the bottom of the engine, these small drops of oil were expelled from a small hole on the bottom of the water pump, The repair was made (substitution of a small rubber ring/retainer/seal that prevents the oil from coming outside) , but after three days and a few kms the problem remains. What should be the solution ?


... Cars & Trucks

My BMW a 330Ci 2004, 155000 miles is getting the oil light on for last 5/6 months. My mechanic changed the oil level sensor and it still leaked. He changed the oring in the bottom of the oil pan. the leak stopped but just last week after a few weeks the engin oil light came back on. I do not know if the mechanic added more oil when he changed the oring because it was leaking still. So today I added oil because it was very low. I just hope that my car is not burning the oil there is no smoke an


... BMW 330

There's oil leak on engine block where the oil filter is attached. It's the part between the oil filter and engine block


Ok you can disassemble the oil filter and loosen the bolts that \012connect the basis of the filter to block and this is a board of rubber or ring \012that is the one that sealed with the time, this is crystallizing that is why you \012leakage of oil ... 1995 Jeep Grand Cherokee

Can oil leak come from motor mount bolts that screw in block on a 2.4 l


... 1999 Chevrolet Malibu

How do i fix the oil leak at the round block on the side of the engine where a normal oil filter would attach. seems to be where the remote filter lines run down and attach. leaking from where it meets the block.


It seems that you have a bad oil filter adapter seal. You can usually pick one up at your local parts store, if not, they may have to order it. To change the seal you must first remove the lines close to block and the you shoul be able to unscrew the ... 1994 Chevrolet S-10 Blazer

There's an oil leak at engine oil cooler unit, got it fixed by using sealant but after 2 weeks it began to leak again. do i need to buy a new cooler unit or just simply change the o-rings (if available). please advise.....


... 2002 Nissan Pathfinder

Leaking oil from bottom of engine. Looks like it is coming from a rectangular aluminum plate. Perhaps this is the bottom of the engine or oil pan.


There are several places it could be coming from.The primary one is the oil pan. This would be the pan directly under the engine. It has the oil pan drain plug in it. If you are unfamiliar with the underside of automobiles you need to be sure y ... 2002 Ford Escape
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4827 seconds