Having problems with your 1995 Buick Riviera ?

Need piture for 1995 buick rivera supercharger of were the map sensor is at

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

MAP SENSOR ON TOP OF INTAKE BESIDE THE SUPERCHARGER. TAKE THE NEW MAP SENSOR USE IT FOR REFERENCE LOCATING OLD MAP SENSOR. WHEN YOU SEE IT ON INTAKE IF MATCH UP WITH OLD MAP SENSOR THEY MATCH UP YOU LOCATED THAT IT.
Repair Help & Product Troubleshooting for 1995 Buick Riviera

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need piture for 1995 buick rivera supercharger of were the map sensor is at


MAP SENSOR ON TOP OF INTAKE BESIDE THE SUPERCHARGER. TAKE THE NEW MAP SENSOR USE IT FOR REFERENCE LOCATING OLD MAP SENSOR. WHEN YOU SEE IT ON INTAKE IF MATCH UP WITH OLD MAP SENSOR THEY MATCH UP YOU LOCATED THAT IT. ... 1995 Buick Riviera

Need location pitcure to map sensor for 1995 buick rivera supercharger


... 1995 Buick Riviera

I have replaced all fuel injectors, the MAP sensor, the MAF sensor, the fuel pressure regulator, and my Buick wants to putter and stall when it comes to an idle. What could be causing this!? I need answers, $500 later and it's still not running right. The fuel pump is working fine, supposably everything is working fine because the car is not spitting out any codes. But there is something wrong because it keeps acting this way. HELP!!


I would replace the throttle body gasket & clean the throttle position sensor . also check that you have no vaccum leaks or bad hose. check pvc vavle that it not stopped up . ... 1988 Buick Century

Need to know which color wires are what on a 95 buick rivera 3.8l supercharged need color codes for ignition switch


Orange wrap with two small white wires with a connector on the end, at the lower part of steering column where it meets the dash. ... 1995 Buick Riviera

2001 buick regal ls... I have white smoke comming out of the tail pipe of the car, when I first start the car and let it run for a lil bit the hose connected to the thermostat gets tight... I took it to autozone to have it tested and the codes are #p1106 and #p0108. I've changed the map sensor and the mass air flow sensor a little while after I bought the car.... please help I really need to drive my car but don't have the money to pay a mechanic


You're probably going to have to get professional help.White smoke is usually burning coolant. In a previous post you said the intake gaskets were replaced, so if they are installed correctly, it could be a bad head gasket.If it is coolant ... Cars & Trucks

Map sensor 1996 buick riviera supercharged


... Buick Riviera

On 95 buick rivera, modifying supercharger by replacing stock 2.8 inch pulley with a 2.5 pulley, advised to use autolite 104 spark plugs but need to know what to gap


... 1995 Buick Riviera

2001 buick regal ls non supercharged I changed the map and mass flow sensor on 3800 engine. It also has a little knock but it didn't start riding rough ro knocking intil I had the intake manifold gasket changed and they also changed some rings, moter also shakes when shift to drive or reverse, and car shakes when driving


... Cars & Trucks

Her 1995 buick riviera run a little rough at a idle but act like it is turning off and on at highway speed. it has a new set of wires, look like it had a coil pack put on it, no engine light on, you can unplug the map sensor and throttle positioner with no change on how it runs at a idle, what do i need to check and how


Theres 3 seperate dual coils. When its dark outside you might see spark jumping off of it. if not, Buy a coil from junk yard or ebay and swap each one till you find it. if its not this then at least you will have an extra one when it does go out. Ive ... 1995 Buick Riviera

2001 Buick Lesabre Custom map sensor


... Cars & Trucks

I have a 1999 buick regal GS with a 3.8L engine with a supercharger. Today the supercharger belt broke and I am driving this car without the supercharger functioning. Am I doing the engine any harm? Some Buick dealer say "yes" others say "No". One dealer said it was ok, but I would not have the "power" that I once had. I don't need a supercharger on that engine..The car just came that way. I use "regular" gas, and so I am told that in order to receive the "boost" I need "premium"..Am I doing an


In put my car on the diagnostic test machine and it read super charged waste gate silenoid a po243 what does this mean ... 1999 Buick Regal

How to change MAP Sensor on 1997 Buick LeSabre 3.8 Limited? Also advise if I can use a used MAP Sensor from Auto Wreckers or a second quality product from HotSpot....Do I have to disconnect the batter


... Cars & Trucks

Where is the Map sensor located on the 92 Buick


The map senor is located on the passenger side of the upper firewall and will have one electrical connector and one vacuum line running to it. Thank you, Dana ... 1992 Buick Regal

I have a 2003 impala and its reading 5 volt reference voltage circuit condition. what do i need to fix this problem? The problem is causing my car to idle up to high. First the codes read that i needed massive air flow sensor and map sensor now that i have fixed those problems its giving me the new code listed above. 5 volt reference voltage circuit condition ecm has detected a fault in the 5 volt sensor using 5 volt reference line shorted to ground


All your sensors run off the 5 volt ref. so you will have to trace your wiring harness from the pcm\\ecm all the way out under the hood to locate the broken or pinched wire. ... 1998 Chevrolet Malibu

I have a 1990 buick lesarbe limited with the 3800. i just recently did a dinostic test and it said i need to replace my cam sensor, so i did. now the check engine light is still on and it still say i need a new cam sensor. what should i do... it thought i should get new wiring for the sensor but i would like some one else's opinoin before i go spend money.


You will need to replace the interrupter aka. cam magnet. This will require removing the timing cover and cam gear to put it in. Also while you are there replace the cam thrust spring,chain and tensioner. ... 1990 Buick LeSabre

Hesitates after driving for awhile. Acts like it isnt getting enough fuel. I cleaned the 0-2 sensor, replaced thermostate, map sensor and spark plugs. When I am at a stop sign it acts like it is going to die. When put on puter it reads high input 0-2 sensor. 2000 cherokee jeep


You cant clean oxygen sensors, they need to be replaced, Also, remove your IAC and clean it out. ... 2000 Jeep Cherokee

MAP sensor in 1999 buick regal 3800 engine has white, green, and red wires - which is ground, ref voltage and map signal? How do I find the voltage ref source at ECM if no ref voltage at MAP sensor? DTC codes P0107 and P1107 keep turning on service engine light.


P0107 may be a leaking intake or somebody changed the pcv valve and left the o-ring off of it. ... 1999 Buick Regal

I need to find and change map sensor.


This is a rectungaluar black bod with a three wire connector and a vacum hose connector some of them were mounted directly to the intake a few others are mounted on the firewall and a few more have them mounted close to the intk manifold ... 1989 Buick Park Avenue

Where is the map sensor for a trouble code po108 on a 1998 Buick 3.8 engine?


... 1998 Buick Regal

Map sensor we can not find the map sensor on the saturn, need wiring diagram


Hi...\015\012\015\012On a 2.2 L. the map sensor is located Near the throttle body assemble. on intake manifold.\015\012\015\012On a 3.0 L. Is located near the ECM on top of the intake manifold..\015\012\015\012O ... 2003 Saturn Ls 4dr Sedan

I need to replace the map sensor in my 06 jeep liberty diesel...i was wondering if you know the location of the map sensor...i think it is location inside the airbox


The Manifold Absolute Pressure sensor is located on top of the cylinder head, right side, about 2/3 of the way back. there is one screw holding it in. You will need to take off the plastic engine cover off to access it. The sensor in the airbox is th ... 2006 Jeep Liberty

How long does it take check engine light to go off after map sensor is replaced. Car is a 1998 buick leSabre. Code reader pointed to map sensor. I understand it takes several starts for light to reset so how long should I wait.


You can take of the ground of the battery of the car for 30 minutes and the computer will reset. if you drive around without reseting the computer might figure it out after 30 miles. ... 1998 Buick LeSabre

I HAVE A 1999 TOYOTA 4RUNNER. IS HAS VERY LITTLE POWER ON TAKE AND ITS TAKE AWHILE TO GET UP TO SPEED. IF I STEP ON ACCELERATOR IT SOUNDS LKE IT WANTS TO DIE. ALL CODES SAYS BANK 1 O2 SENSOR, CHANGED IT STILL HAVE SAME PROBLEM LIKE ITS SUCKING TO MUCH AIR. UNPLUG MAP SENSOR, VEHICLE DIES. I'M LOST NEED HELP. ON MY WAY TO IRAQ AND WIFE NEEDS A VEHICLE. ANYONE KNOWS THE SOLUTIONS


Replace your fuel filter and, your air filter.and, thank you for your service to our country! ... 1999 Toyota 4Runner

Map Sensor 1994 S10 Map Sensor. It has grey,purple,and green wires. Just need to know which wire goes to what.


One wire gos signal,5 volt, other gos 12 volt. other to ground need a wire diagram to determine which one is ... 1994 Chevrolet S-10

I need a wiring diagram for a 2003 chevy trailblazer for map sensor obd 2 scanner is tellin me low voltage on map sensor code p0105


... 2003 Chevrolet Trailblazer Ext
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 5.1038 seconds