Having problems with your 1994 Volvo 960 ?

Where is an airbag sensor located for 1994 volvo 960?

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1994 Volvo 960

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where is the bank 1 sensor 1 located on a volvo v70


Sensor 1 will be located at the front of the catalytic converter. (there is no bank 2 on the V70) ... 1998 Volvo V70

Location of airbag sensor on volvo s40 - S40 Volvo Cars & Trucks


... Volvo S40

Where is Bank 1 sensor 1 located on a 2001 Yukon Denali. I can only find one located on drivers side after cat.( I had the code read it was a po 138 hearter sensor malfun. bank 1 sensor 1) I have been told the sensor is located by the # 1 spark plug. The only thing I see by the plug looks like a water temp. plug going it to the head with some # on the block over it.


Start at the exhaust manifold flange on the drivers side. The first sensor you come to before the cat. converter is the sensor you are looking for. ... 2001 GMC Yukon Denali

I HAVE A P0300 OBD CODE I DID A COMPRESSION TEST TO ENGINE AND IT PASS THE TEST,I DID CHECK EGR VALVE,CHANGE SPARK PLUGS,IGNITION WIRES, CAP AND ROTOR, I DID CHECK TPS SENSOR MAF SENSOR,FUEL PRESSURE,AND OXIGEN SENSORSI I FOUND THAT ON BANK 1 BOTH SENSORS (UP STREAM & DOWN STREAM )WORKS NORMALY BUT ON BANK 2 THE SENSOR 1 CHANGE FROM 0 TO 600 MILIVOLTS BUT NO CHANGES FROM RICH TO LEAN &SENSOR 2 HAS 0 MILIVOLTS & NO CHANGES FROM RICH TO LEAN SO I SWICHT SENSOR TO TEST THEM FROM BANK 2 TO BANK 1 AN


... 1997 Nissan Pathfinder

Where is an airbag sensor located for 1994 volvo 960?


... 1994 Volvo 960

I am installing a performance chip on my 2008 vw beetle. I need help figring out which leads are the IAT leads on the MAF/IAT sensor. It has five leads. Turn engine off, remove key from ignition and remove the negative (black) battery terminal. » Locate the vehicle?s Intake Temperature Sensor (IAT) located on or near the intake tube, in the air box or near the throttle body. Figure 1 shows the typical location for the 2 wire IAT sensor. FIGURE 1. FIGURE 2. FIGURE 3. Visit performance


I have Mitchell and I can't find the wire colors anywhere, My wiring diagrams show the MAF and the IAT but the wires do not indicate who's who. I looked everywhere. We get this alot on the newer models because Mitchell and Alldata update the info ... 2008 Volkswagen Beetle

I have an error code of P0131 which I believe means I have a bad O2 sensor. Bank 1, sensor 1. I think I can probably replace this sensor myself but I am not sure where it is located on my car. I have a Pontiac Grand AM GT with the 3.4L 6 cylinder. Where can I go to see where this sensor is located. I believe it can be either on the manifold or on the exhaust.


... 2000 Pontiac Grand Am GT

On a 2001 chrysler sebring coupe lxi 3.0 where is the O2 "oxygen sensor" physically located, computer says bank1 sensor2. I know Bank 1 is the side where the #1 cylinder is which I "think" is on the firewall side? Someone on this site previously said in another answer it's located on the exhaust manifold at the firewall, sensor 2 is the O2 sensor after the catalytic converter but that is under the car and not at the firewall. There is a sensor on the exhaust manifold at the firewall but it's no


My 2001 chysler sebring lxi 3.0 liter will not start and the starter is brand new ... 2001 Chrysler Sebring

2000 toyota 4 runner the code p1135 bank 1 sensor 1 (bad sensor). where is this sensor located and how many 02 sensor a 4 runner have. can i swap the bank 2 sensor 2 with bank 1 sensor 1 to see if the code will change. like the codes on p0302 and p0301.


P1135 Air/Fuel Sensor Heater Circuit Response (Bank 1 Sensor 1)\015\012almost certainly the heater inside the sensor has failed, the heater speeds up the time it take for the system to go into closed loop fuel control.\015\012The b ... Toyota 4Runner

How many oxgen sensors does a 2004 Hyundai Santa Fe 2.7 2wheel drive vehicle have and where are they located? What idoes Bank 2 Sensor 1, Bank 1 Sensor 2, Bank 1 Sensor 1, and Bank 2 Sensor 2 mean?


You have 4 O2 sensors, bank one is the front cylinders ( close to the readiator ) there is 2 bank 1 O2 sensors one infront of the catalitic convertor ( bank 1 sensor 1 ) and one after the convertor ( bank 1 sensor 2 ) the same on the back cylinders t ... 2004 Hyundai Santa Fe

I have replaced all 4 02 sensors in the 1999 volvo s80. i still get a code of p0154 which states bank 2 sensor 1 no activity. bank 1 sensor 1 shorted out against the exhaust pipes. we replaced all 4 02 sensors. the code is still coming up. what else could it be in the 02 sensors to bring up that code, and what do you suggest?


You have most likely a sensor harness wiring problem, no signal return, at this point your system needs to be hooked up to what is called a "break out box" to see what lead is dead, most likely a broken burnt or damaged wire, there is no easy w ... 1999 Volvo S80

I am getting a engine code that says p0130 o2 sensor bank 1 sensor 1,my question is,where is the bank 1 sensor 1 location?


If your vehicle has a V-6 then it would be the first o2 sensor on the exhaust coming of the front of the engine.If it is a 4-cylinder. then it will be the first o2 sensor coming of of the engine. ... 2004 Hyundai Santa Fe

I need to replace the bank 1 sensor 1 on a 97 ford explorer. I have found the bank 2 sensor 2, but I can't find the bank 1, sensor 1. Is there anywhere to find a diagram or can it's location be described easily.


Thanks for trying fixya,\015\012\015\012There are 4 sensors, though not all of them are technically called "oxygen sensors. There are two that are upstream of the catalytic converters, one on each bank. Then, there are two more, one after ... 1997 Ford Explorer AWD

Can you show me on screen exactly the location of the knock sensor part #22060-30P00 8D SENSOR A and Oxygen sensor part # 22690-40U06 8D, HEATED O,(FR,RH), sensor assy-02, #1 bank, located before the catalytic converter for the '97 Maxima 6 Cyl 3.0L,distributor less ignition. I need to replace these parts, would like to do it myself if possible but can't locate them on my engine or pipe. Do I need special tools to do this?


Gpk722000: the knock sensor is located under the intake manifold.\015\012If you are standing in front of the car, look to the right of the oil filler cap and go more to the center of the valve cover. Now, if you look carefully belo ... 1997 Nissan Maxima

Location of 02 sensor bank 1 sensor 1 on 3 ltr engine


It's right adjacent to the cataytic converter ... 2001 Mitsubishi Eclipse Spyder

Confusion over 2002 Lexus RX300 Bank 1 and 2, Sensor 1 and 2 location?


... 2002 Lexus RX 300

What does the oxygen sensors look like in a 2003 Chevy Venture (warner Brothers Edition) ? How many are there? Where are they located? Can you show a picture of them in place? How do i replace them? Chevy dealer scanned it for codes: "VEHICLE HAS A CODE #PO141 - OXYGEN SENSOR BANK #1 SENSOR #2 WORKING SLOW.. VEHICLE NEEDS OXYGEN SENSOR BANK #1 SENSOR #2 REPLACEMENT.. (A SES LIGHT IS ON - NO RUNNING PROBLEMS)


There should be an O2 sensor before and after the catalytic converter on your vehicle, so it will have 2 sensors. You'll need a 7/8" open end wrench or an O2 sensor socket to replace them.It'll look something like this: http://www.carstee ... 2003 Chevrolet Venture Passanger

I have a O2 sensor out. It is bank 2 , sensor 1. Where is this sensor located? I have the exact sensor thru Car MD but it doesn't tell me where bank 2 sensor 1 is. Can anyone help? Thanks!!!!


Sensor one , bank 2 ( bank 2 is where cylinder number 2 located, in this case it's in the front ) is in the front of the vehicle and mount before the catalytic converter, most likely on the exhaust manifold. the one after the cat ( or down stream is ... 2002 Kia Sedona

I have trouble codes PO141 02 sensor heater circuit malfunction ( bank 1 sensor 2 ) As well as po140 02 sensor circuit No Activity ( Bank 1 sensor 2 ) Where are each of these sensors located on a 1998 sebring 6 cylinder ?


Hi.\015\012\015\012\015\012It is the same sensor.\015\012\015\012\015\012You have to check wiring, connector, then eventually replace the sensor.\015\012\015\012\015\012Bank 1 is always the right side of the ... 1998 Chrysler Sebring

Hi, i have a 2002 jaguar x-type 2.1v6. the engine management light has been for for a few weeks now, i have taken it to a local garage where they told me the fault code was 0037 heater control circuit sensor 2 bank 1. im unsure which this sensor is? i have located the black & grey connectors and i can see the two sensors of which 1 goes through a heat shield can anybody tell me which sensor i have to change and the best angle of approach?? cheers!


Sensor 2 bank 1 is near the bulkhead prior to the cat. (the black connector) you will need a special tool to remove it (22mm,50mm deep socket with a slot cut down it) and its a bit tight but you can just get your arm in there from the offside (UK). D ... 2002 Jaguar X-Type

Need to locate the front o2 sensor on a 97 Olds Achieva 4 cylinder 2.4 Liter engine , check engine light on and it indicates that sensor. I already have replacement part and only located 1 sensor at the end of the catalytic converter and cant find the front sensor. thanks Geno


Facing the engine, look at the back of engine and down. It will be mounted on the manifold. ... 1997 Oldsmobile Achieva

I have a 07 f150 4.6L V8 and I need to replace the Bank 1 sensor 1 oxygen sensor but cant figure out which sensor it is since there are 4 sensors. Where can I find a picture of the location?


Heated Oxygen Sensor (HO2S)- The Bank 1 Sensor 1 tells me that it's an upstream O2 sensor. The larger the number the further down the line of the exhaust it is.\015\012Removal & Installation\015\0124.2L Engine\015\012\015\012\015 ... Ford F-150

Need location of #1 cylinder on 2006 dodge 4.7. I am getting a P0038 code indicating theres a problem w/ the o2 sensor. Says bank 1 sensor 2 heater ctrl circ high. There is a very small nick in the wire running to the sensor. Can it be cut out and spliced back in or does the sensor need to be repalced? Thanks


#1 is the drivers front. The O2 your looking for is on the drivers side after the catalytic converter. You can certainly try to repair the wire. If you use a **** style connector make sure it is one with a heat shrink wrap to protect the wiring from ... 1998 Dodge Ram 1500 4WD

Bank 1 sensor 1 o2 sensor location for 98 Isuzu rodeo


... Cars & Trucks

Location of bank 1 sensor 1 o2 sensor


Should be in the manifold on the back side closest to the firewall. ... Pontiac Grand Am
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.9689 seconds