Having problems with your 1994 Toyota MR2 ?

ALTERNATOR HOW EASY IS IT TO FIT AN ALTERNATOR IN AN MR2 1994 MODEL

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

You will have to raise the car and support it pon Jack stands and install it from underneath. MAKE SURE THAT you are turning the bolts in the correct direction to loosen the belt. My brother broke mine and I had to have AutoZone order one for me...(the long thin bolt attached to the alternator) After that you should be able to reach it by removing the underbonnet plastic and you may have to remove parts of your wheel well plastic to get a better view. Good Luck!
Repair Help & Product Troubleshooting for 1994 Toyota MR2

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

ALTERNATOR HOW EASY IS IT TO FIT AN ALTERNATOR IN AN MR2 1994 MODEL


You will have to raise the car and support it pon Jack stands and install it from underneath. MAKE SURE THAT you are turning the bolts in the correct direction to loosen the belt. My brother broke mine and I had to have AutoZone order one for me...(t ... 1994 Toyota MR2

FITTING AN ALTERNATOR IN AN MR2 1994 MODEL - 1994 Toyota MR2


Can you be more specific please ... 1994 Toyota MR2

Where can I buy a water pump of Hyundai Galloper 1999-2000 model Engine - D4BXN or its alternative products that fit the car or model. Please help?


The only information I could find on that engine is that it is apparently a Mitsubishi product, you might try locating a part number on the water pump, that would be very beneficial, then you could google the part number or even take it to your local ... Hyundai Motor 2000 Tiburon

My alternator keeps blowing i have went threw 3 of them, i also would like to know which other toyota model alternators fit my 1992 celica


Replace the battery,and make sure the connections to the battery are clean,and shiny when the new battery is installed,any kind of amp that maybe in the car for a radio after market,will do this also.Anything to make the alternator work to hard to lo ... 1992 Toyota Celica

Mitsubishi 4M51 The alternator pulley bearing of my 24V Mitsubishi Rosa 4M51 1999 model is worn out. Which other vehicle's alternator bearing can fit? If not available here in Kenya, what other modification can I carry out?


... Cars & Trucks

I purchased an alternator from e bay advertised as late model gm. it looks like gm but has no screw on the back to attach ahe battery wire. it has a connector with three large pins in it. the other connector has three smaller pins in it. what could it fit? it appears to be a 75 amp alternator


From what you are describing, it sounds very similar to a late model ford alternator that were made through the 90's, and it sounds like the type that ford used in the F-350's and larger trucks. ... 1986 Chevrolet Chevy

I have a 1991 mr2 with no power steering is it possible to get power steering fitted and is it easy enough to do it myself?


Yes you can convert it to power steering with factory parts or after market parts. You should do research in your area for what is available. There are electric and hydraulic systems out there. Depending on the amount you are willing to spend and how ... Toyota MR2

I washed the engine, then cruise control stopped functioning, before that rpm needle went mad and fluctuated from 0 to max on and off. I think there is a short circuit , but don't know where to find or start from. Fuses are OK. CAR: HYUNDAI grandeur 2000 (3 Ltr not xg) (cannot select this model for "What product is it about?")but cruise control is not company fitted , i been told.


If you have an after-market cruise control system, you'll need the specs from the company that manufactured it. Otherwise, it's guess work. Does the Check Engine light come ON when this happens? Whenever the "Check Engine" light comes on, there is ... 2001 Hyundai XG300

Ford focus 2lt d overcharging new alternator fitted x2 + new battery x2 where is the carging regulator sittuated on the vehicle 2005 model


... 2005 Ford Focus

The Villages , Fl Fire Dept. is restoring a 1960 model fire truck to be used in our school fire prevention programs, It has a Motrorola alternator model 81HA5023A serial 6939 130 amp alternator and we need a wiring diagram to install it on the apparatus The truck had been previously involved in a fire, The alternator has only 2 terminals on the rear, One to ground (which is positive) and the other to the amp gauge on the dash The Fire Apparatus is a Americal LaFrance Metro series 1966 model ye


... Chevrolet C3500

I have bouht a new alternator for my 1999 3.0l Izuzu trooper and the two pin plug does not fit the back of the alternator. it is the right alternator but my car is imported. is this the reason the plug is different and can I just remove the plug and fit using spade connectors


No reason why not as long as you get it right ... Isuzu Trooper

What model years bucket seats will fit a 1990 F-150? What model years tailgates will fit a 1990 F-150


... 1990 Ford F150

2 months ago I had my car serviced, a new timer and tensioner belt were fitted. 10 days later the turbo packed in. 14 days after this was fixed the alternator belt jumped its housing and a new alternator was fitted. 30 days later and I am now not getting any acceleration when I try to overtake. The error code indicates that the boost pressure maximum limit is not being reached. What might be causing it, and could any of teh previous repairs have caused this to happen. The same garage has done al


How did u know that your turbo died? did you get a check engine light or the mechanic just told you that was the problem? boost pressure max limit not reached can mean a few things but the first thing to check is whether the turbo is spinning up and ... 2003 Volkswagen Passat

My model wasnt in the available list; I have a 1967 VC Valiant, which broke down about 6 months ago and hasn't been run since. I have replaced the alternator, as I was told (by an auto electrician)that that was the reason it stopped working originally. I have found the same model alternator and wired it up the same as the old one was wired when it was working. The car wouldnt start, but was making a kind of dry choking noise. I thought maybe it had run dry of fuel, so I put some in it. Still ma


Love your choice of car!As far as the flooding goes take your air filter assembly off and while some one is cranking the car and you do the throttle you can see how much fuel is going into the engine.If too much you will smell and see a lot of fuel,i ... Chrysler Voyager

Fitting of Beam benders to my Renault Scenic 2005 model scenic II model new shape. The Eurolights shows that I should fit the round disc to the left of the Dipped beam bulb/shroud. this does not seem correct , as my beams shine to the the right of the Headlamp as you look at it which shines up the Kirb to our left when driving. , so surely the deflectors should be put to the right of the dipped beam to push the beam to the left as looking at the Headlamp ( or Right if sitting in the driving sea


... Renault 181

Alternator overcharging Hi, i have mazda 6 2006 model, i'm having problem with charging of the car, i had the alternator change about a week ago and within 2 days the alternator went dead not charging at all, i took it back to my electrician and was told the alternator was bad, i bought another one and now its also overcharging up to 17, pls help. [email protected]


If there are rebuilding it have them check the rotor may be flying open ... 1991 Peugeot 405

1987 chevy c10 5.7 350 v8 tbi engine swapped with 1995 Chevy 1500 tbi all the same but alternator and a/c on opposed side and alternator that fit the 1995 motor don't have same electronic connectors 1987 wiring harness alternator connector only has two wires the new 1995 alternator with new connector has three wires coming from it how do I get that connector wired in the old ones place


... Cars & Trucks

Recently, I changed the altenator of Toyota camry 2007 because the alternator is bad and the alternator harness connector was taped because it was broken already. The mechanics was trying to open the tape because it was not properly fitted into tne socket of the new alternator . During the process the harness got messed up. How will I get the alternator harness because when I went to dealer they said I have to buy the whole Engine harness wire assembly which is very costly?ok


You have not given us your location but in my area if you go to the carbreakers/strippers you will find that they have already cut the harness because they can't be bothered to disconnect properly. Try those in your area then use block connectors to ... 2007 Toyota Camry

Power failure MR2 Mrk 2. Battery and alternator tested to be working. Sparks from positive alternator connection if touched with spanner when battery connected - shows a connection is present I presume. However, the battery will not charge and the alternator will not power the car when running. All just dies. Is there maybe a relay that has gone or something between the battery and alternator? Many thanks


If the alternator isnt charging the battery then the alternator is faulty. have the diodes in the alternator checked. \015\012\015\012hope this helps ... 2003 Cadillac CTS

I'm trying to switch the belt that is on the alternator. The previous belt was loose enough to pull right off. Now i'm stuck because I haven't the slightest idea of how to slide the alternator to get the new belt on and fitting properly. There is one side bolt and one top bolt attached to the alternator and when taken off the alternator remains solid and will not slide down. I believe i'm missing something in the process.


HI, this video will show you how to remove the alternator in your Camry.\012 ... 1993 Toyota Camry V6

Galaxy alternator got a galaxy 2004 1.9 tdi and the wheel come of the end of the alternator , i have had a new alternator fitted over two weeks ago and the car drives fine but when i go to the car for the school run and start it the battery light comes onand the computer bleeps and say alternator workshop i get a couple of yards up the road and the message goes and battery light goes out and never comes bk on ,unless i turn the car of and restart it again....the battery has been tested and is ch


The first thing to do is to reset the codes and if it returns then i would say theres a problem with the alternator, or the wiring, if it returns it sounds like the alternator is taking a while before it starts charging and the computer sees this, i ... 2003 Ford Escort

I am replacing an old GM alternator, on a boat, with a Valeo 12v 60A (A13N110) It has a B+ and a B- terminal, the B- is common with the body of the alternator. In addition there is are spade terminals. Marked L and +. The old alternator only had one wire from the ignition warning light. Can this go to the spade + to exite the windings? How is it normaly connected? The new Valeo alternator was orriginaly (I believe) fitted to a Renault 5


Hi\015\012\015\012The following is how this type of alternator should be connectrd.\015\0121. B+ to the main battery supply\015\0122. B- to the earth of the motor.\015\0123. L to the light terminal wire which was the exs ... Renault R5

Everytime the car is started hot or cold the alternator belt screems momentary and goes away. the car has a new battery fitted and the alternator has had new bearings,regulator,diode module (four pin reg) Voltage across positive at alternator pos terminal to earth chassis is 14.2V as it should even though when the belt is screeming so appears that current load across alternator is overloading the mechanical output of the microbelt can cope with.The belt is tight on pulleys. I believe the the fo


I would first try replacing the belt. These normally last about 5 to 7 years. It may be somewhat glazed, allowing it to slip under load. If that does not work, you might need to replace the tensioner pulley. ... 2005 Suzuki Swift

What other model willme 2.5 pajero 1993 model fit


Here in the states the Montero was primarily supplied with the 3.0 V6. Either 5-speed manual or 4 speed (with OD) automatic.\015\012\015\012Thanks,\015\012Tom ... 1993 Mitsubishi Montero

Does the moulinex strainer filter for model A753 fit on model 864


... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.9735 seconds