Having problems with your 1994 Nissan Altima ?

Known engine issues with 94 Nissan Altima - 1994 Nissan Altima

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1994 Nissan Altima

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Known engine issues with 94 Nissan Altima - 1994 Nissan Altima


... 1994 Nissan Altima

2003 nissan altima 2.5- I just completed my engine swap DIY and now im having a tapping sound in the engine. Ive changed out the thurmostats- No temprature issue, not the exaust, Idle is even, Sound i


... 2003 Nissan Altima

Hi..Im driving a Nissan Presea r-11 (1997). the issue im having is sometimes the engine turns off when im in low rpm and turning the steering. Also sometimes it stop accelerating even though im pushing the accelerator to the bottom and drops the RPM to 0 and cat stop moving but engine doesn't switch off. What caan be my problem? (I've been told that it might be air-flow sensor.)


I too be live first thing to check oxygen sensor, possibly fuel filter . Hope this helps some. ... 1996 Nissan 240SX

My Nissan Altima 2003, 2.5 is running hot occasionally. I have replaced the (2) thermostats. I did received a Temperature Engine Condition OBD code before I installed the thermostates. The car seems to ride in normal temperature unitl I'm on side streets. The guage will go up to 2nd line before the "H". Then go back to normal tempertature. As of now I haven't received and OBD codes and Service Engine Soon light is not on. Can you assist me to fix this issue. I'm afraid to get it too hot it woul


... 2003 Nissan Altima

Have a 1993 nissan altima. Was driving and transmission just quit like it was put into neutral. It wont go into any gear or park if engine is running. When engine is running and you try to put it in park it grinds. Replaced the transmission with a known good transmission and the replacement is doing the exact same thing. I checked all the signal wires at the tcm and the voltages are all correct. The proper signals are present at the inputs when the gear selector is changed thru the gears. Does


Transmission module and relays hav an issue--computer may also--scan car with a tech ll that runs a data stream to get solution--may need to replace these parts or hav computer reprogramed ... 1993 Nissan Altima

I have a nissan altima gle 2001 and it was working normally. Sudenly service engine soon check turned on and everytime I full stop in a red light, it doesnt matter if it is in Drive gear or if it is neutral, motor start shaking as crazy and RPMs goes down until 500rpm. Anytime, when green light comes, if I press accelerator car performs normally. I checked with a scanner and it is showing P0304 code error cylinder 4 misfire How I can solve this issue?


These are notorious for this problem-a leaking intake gasket at #4-it can be verified by using a can of carb cleaner. Spray around #4 intake port, if the idle changes you have the same issue. Do NOT clean the throttle body on these cars, it is so s ... 2001 Nissan Altima

I have a 2003 Nissan, Altima 2.5 check engine light comes on than car stars jerking, after a while it stops. could this be an electrical or a fuel pump issue?


You need to take it to Autozone so they can scan the computer for you. They will let you know what is wrong and what to get to fix it. It doesn't cost anything for the test. Other part stores offer the same service. If you have a question, let me kno ... 2003 Nissan Altima

93 Nissan altima, high pitched whirring noise upon starting the vehicle. Continues when clutch engaged and driving. Just replaced a part which when you press the clutch down it connects to a cylinder (forget the name of part). Now check engine light on and whirring noise. Started today. Should I stop driving it? I also have an oil leak in my distributor cap which I will be fixing but is this a separate issue?


... Cars & Trucks

I need to replace my engine in my 95 nissan altima and I want to know what's the latest model engine I can replace it with . Maybe a 2000 nissan altima engine


93-2001 are the same if your talking about the 2.4 liter dual cam motor. Some of the sensers are different as you might need to use the old ones but they'll fit right in. 02 changes to 2.5 and nothing works and the 6 won't fit either. If your manu ... 1995 Nissan Altima

Nissan Altima Check Engine Light - P0420 Code


You have a fail exhaust converter on bank # 1Google the PO420 code & read up ... Nissan Altima

2003 Nissan Altima. A/C quit & engine overheated.


Verify the radiator fans, fuses, relays of fans. when you turn on the a/c all the radiator fan turn on too, if not you have a problem with it. ... 2005 Nissan Altima

Nissan altima check engine light on


Not sure with a nissan, but with GM, the ECM's were different with Calif. emmisions ... 2002 Nissan Altima

I have a 2005 Nissan Frontier runs fine on most of the time. Other times after the engine warms up or even when cold the engine will dye, stall out, pops out through the throttle body. Check engine light has been on since this issue began. When I fill the truck up with gas the gas gauge returns to empty with the empty light on. Once I drive a little over 25 miles the gauge moves to barely below the full line and works okay until I refuel. This issue with the dying, stalling out, and pops do not


... 2005 Nissan Frontier

I have this problem for quite a bit. The idling speed when engine started cold is between 700-800 rpm. As the engine gets hotted idling rpm increase to almost 1000rpm. If idling is adjusted back, the rpm is starts low (engine vibration felt) at cold start and most of the times engine can not start. When gas pedal is pressed the engine stalls and sounds the engine is choking. My vehicle is a 1994 Nissan van with 2L engine. Am not sure if it similar to Sentra or Altima but it is carbureted.


There appears to be a thermal movement of choke mechanism that comes about once vehicle is warmed up. Check the chock connections, hot water pipe and linkages tight or clear.\015\012gazakat ... Nissan Sentra

2002 nissan altima 2.5 engine diagram - Altima Nissan Cars & Trucks


... Nissan Altima

Engine diagram 2003 Nissan altima 3.5 - 2003 Nissan Altima


... 2003 Nissan Altima

Engine Mount replacement 2005 nissan Altima - 2005 Nissan Altima


... 2005 Nissan Altima

Engine replacement Will a 1997 Nissan Altima 2.5L engine fit into a 2002 Altima?


No, it is completely different. ... 1997 Nissan.5 Altima

Timing diagram 2003 Nissan Altima 2.5 engine - 2002 Nissan Altima


... 2002 Nissan Altima

Nissan altima 2003 how to change engine belt - 1995 Nissan Altima


TO REPLACE DRIVE BELT YOU LOOSEN DRIVE BELT ADJUSTMENT BOLT SLIP THE BELT OFF THE CRANKSHAFT PULLEY AND REMOVE IT. IF YOU GOT A 2.5L ENGINE YOU HAVE TO ROTATE THE BELT TENSIONER TO RELEASE TENSION ON THE SERPENTINE DRIVEBELT.YOU NEED A HAYNES MANUAL. ... 1995 Nissan Altima

P0731 nissan altima 2006 2.5 engine - 2006 Nissan Altima


... 2006 Nissan Altima

Hello, I bought my Maxima SE 2 weeks ago, the light of "service engine soon" turns on and some times the TCS and SLIP lights are turning on and off and whenever these lights come and go, the motor is vibrating very bad; I was wondering what may make this problem; it has 170,000 Km on it. Thank you, Jullie I have a Nissan Maxima 2002 SE. I have the same issue as most Nissans it seems. My TCS, SLIP, and Servive Engine light are on and solid. Recently, my A/T check light flashes when I star


As for trouble codes, and the dealers recommendation. They are true and accurate, although I would get a second opinion from another auto shop other than the dealer. Do not disclose what you already know other than the problems you are expriencing. ... 2002 Nissan Maxima

Check engine on 2005 nissan altima - 2005 Nissan Altima


... 2005 Nissan Altima

Engine codes Does anyone know the what the codes u1000 and u1001 for a 2002 nissan altima are? I've been everywhere can't find anyone that knows. Where can I get a manual for a 2002 nissan altima?


Sometimes coming data,but the every error comunication,for the scannner rpm up and down same the lightgauge,low high,codes u 1001 1000 ... 2002 Nissan Altima

I have a 1994 nissan Altima GXE 5spd. Car is idling rough when I come to a stop light or stop sign sometimes it stalls. also while driveing threw 1st, 2nd, and 3rd car has a ticking noise coming from engine. The 150HP twincam engine is alot of fun to drive body is is good shape I'd like to find out how to fix these problems without going to Nissan.


Given the ticking sound, you probably need to replace the timing chain assembly. ... 1998 Nissan Altima
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.1803 seconds