Having problems with your 1994 Mercury Tracer ?

Door Panels How do you take the window crank off? I need to take off the door panel and I have no idea how. The only spot holding it on is the window crank now

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

There's a small wire clip right behind where the door panel meets with the crank. Its really hard to see. I had to pry the crank a bit with a screw driver to see it. Anyway, when you do see it there's a part that protrudes more than the rest, and you can slide a screw driver back there and pry it out.
Repair Help & Product Troubleshooting for 1994 Mercury Tracer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Door Panels How do you take the window crank off? I need to take off the door panel and I have no idea how. The only spot holding it on is the window crank now


There's a small wire clip right behind where the door panel meets with the crank. Its really hard to see. I had to pry the crank a bit with a screw driver to see it. Anyway, when you do see it there's a part that protrudes more than the rest, and you ... 1994 Mercury Tracer

Hello, I have a 2003 Ford focus . The left rear window regulator cable is broken. I need to replace the whole regulator. I have taken the door cover off and I can see the problem but I do not know how to get the old regular out. How do you take the window from the plastic assembly holding the window. I got everything loose, I just can't seem to get it out. Duct tape is holding the window in place. Any suggestions?


... 2003 Ford Focus

My rear window on the drivers side wont go up or down by either window control. My guess is that the window motor is bad or needs grease. How is the best way to take the door off without ruining the part that holds it to the door? would it be out or an upward motion?


Http://wiki.answers.com/Q/How_do_you_remove_interior_door_panel_on_2000_stratus\015\012\015\012try that link sor ... 2005 Dodge Stratus

The rear passenger window fell (slipped down) when we closed the door. There is no tension to hold the window up and the power control doesn't effect it. You can push the window up and down by hand but the slightest vibration will make it fall. Can I fix this or is it time to take it to a mechanic? 2003 Grand Cherokee Laredo. If it is an adjustment I can try but motor replacement then I will take it in.


... 2003 Jeep Grand Cherokee

92 toyota camry...power window jamming - driver's side...ideas for repair, plus how to take door panel off nicely...i did drop a small bolt (from changing driver's mirror) down inside door panel....am wondering if it has worked its way into a bad place...window has been working fine even since bolt dropped...but now won't go all way up or down and sounds unhappy


The power window jamming simply signifies that its motor is bed and needs to be replaced.I will recommend you visit a site that has all needed information and illustration/ diagrams for this required procedure.http://www.2carp ... Toyota Camry

Window Crank How do you take the Window crank off of the interiror door panel?


Theres a special tool you need for removing the c-clip from behind the handle ... 1998 Chevrolet S-10 Pickup

The drivers side window catches when I open the door. It does drop down as it's supposed to, but doesn't come down far enough. I can hold the window and push it down a further 1/4 inch. Any ideas how to disassemble the door to adjust it? It's a 2001 Carrera Coupe.


... 2001 Porsche 911 Carrera

Trying to take apart the door panel for a 1989 Pontiac Grand Am. I can NOT find a diagram anywhere to show me where the hidden screws and clips are, does such a thing exist anywhere on the net or could someone describe how to disassemble the panel and get to things like the window roller (manual crank window)? I also tried looking around in a Heynes book but did not find anything useful, those mostly stay to electrical/mechanical aspects. I'm asking how the molding for the door panel comes ap


Ok hidden screws, in the door handle and latch. see in the middleof the latch is a cip, raise it up to expose a screw. In the arm rest, see the plug type fittings remove them.to show u the screws. Under the electronic window switch, Pry up the switch ... 1989 Pontiac Grand Am

In taking off the inner door panel on the passenger side of a 2001 GMC Sierra, I found the bracket that holds the door panel to the door was broken, it appears to be replaceable, any ideas where I can find one online or a schematic of the door?


Salvage yard or dealer is the best bet for finding one ... 2001 GMC Sierra Crew Cab

My 1998 Explorer (4 door XLT) has the driver side window stuck in the down position. All other power windows work and I am getting power at the switch to take window down but no power to roll up. Any ideas on this?


Yes, we had both motors fail on the drivers side front and rear windows.\015\012If you disconnect the motor from the switch you can test the terminals on the switch. If both sets of terminals are hot the motor should go both directions. If onl ... 1998 Ford Explorer

I need to take the window crank handle off of my door


Auto parts store h as special tool to remove clips but u can use a flathead scerw driver gently pull handle from door panel and sneak screw driver behind handle pushing c clip out but becarefull they sometimes shoot out ... 1995 Dodge Neon

How to replace the window power motor?i removed all the covering of the door. I see the window motor but have no idea how to take it out.


It's possible you need a regulator along with the motor; if you hear a "crunchy" sound and the window moves up and down when you push the switch the regulator has failed. To remove the motor, you'll need to remove the regulator assembly, which the mo ... 2001 Chevrolet Malibu

Window crank broke on 97 Wrangler. (Full door) I would like to replace it. It looks like the post to hold on the crank is what broke.


... 1997 Jeep Wrangler

Rear window will not roll up. i removed the door panel and there was a cable that had been disconnected from the motor, my problem is that i cannot get the rear window to disconnect from the plastic lever that holds it, so that i could take the track arm out and find out what the cable is suppose to connect to. the motor fine its winds and unwinds but the cable is loose... any solutions?


There is a nylon peg that holds the window to the regulator.You need to use a 1/8 in.pin punch to remove the peg.But you have to get the window up far enough where the peg lines up with the hole in the regulator.You will have to replace the regulator ... 2005 Chevrolet Malibu

'04 Honda Pilot L/F Power Window Inop. Motor will run with power applied directly to the motor. Tried "new" reman, same result-will not move from door switch. Power control unit 'clicks' when window switch pushed and pulled but motor does not respond. New power control unit over 200 miles away (not a popular part?). I don't have a wiring diagram so who knows what route the power had to take. Any ideas? Geoff Overley Mason, Ohio 45040


Yes correct, the power control module seems the issue.Its not functioning as it should.-------\015\012Thanks for the update.Thanks.Helpmech. ... 2006 Honda Pilot

Crank window I recently replaced the Passenger side vent window assembly and now I have difficulty cranking the door window up and down. Although it cranks hard the problem is at about 2 inches from fully closed. Very hard to crank. Once it's up the edge farthest from hinges is not completely in the weather strip channel. (Door panel off) I reach inside the door and push it fully closed. When I crank it down so much resistance I feel as though the window mechanism will break, The first inch or s


When you replaced the vent window assy. did you seat the assy. into the door channel? Something is out of alignment. ... 1993 Jeep Cherokee Country

I can't take off my door panel off because the window crank will not come off.


What kind of vehicle? If it is a GM product it will have a keeper on back side of window crank. It fits into a slot and can be removed by simply pulling on it with a crooked pick. ... 1998 Pontiac Sunfire

I can't get the window crank off the door so i can take the panel off so i can get to the speaker


There is a special tool designed to remove the clip that holds the handle on it isint exspencive ... 1995 Buick LeSabre

I have a 2000 Jeep Grand Cherokee Laredo. The front passenger window made a loud noise and then went down on it's own. I was unable to get it back up without taking the door panel apart and then pushing it up manually. Now it won't stay up on it's own, I had to tape it. Took it to the dealer and they said it needed a new motor/regulator and clips, they wanted $500 and I said forget it. Any ideas what happened and what I could do to fix it myself?


Unfortunately the dealership is right in this case,the regulator has plastic components in it to guide the window and to hold pressure against it while its up if those parts happen to strip or break you will have the problem you faced with now,but $5 ... 2000 Jeep Grand Cherokee

The windows on my Aston Martin DB9 have stopped adjusting the last 5mm on closing or opening the door (battery ran flat..!) I have had the problem before but can't remember the simple fix to re program. (I think it involves holding two buttons down somewhere..?) Any ideas?


Press the 2 windows down tell the endand hold it for 4 sec then rise it up tell the end and hold it tell u here a sound. ... 2005 Aston Martin DB9

84 S10 how to remove door panel do I take the window crank off and if so how


... 1984 Chevrolet S-10

I need to take off my door panel to change the speakers in my truck how can i get it over the window crank?


There is a tool made just for this purpose. Go to any auto parts store\015\012autozone/advance or napa etc. and ask for a window crank removal tool.\015\012They cost about $10.00. There is a spring clip between the crank and the door pane ... 2001 Chevrolet Tracker

Door Handle I got the panel detached but it is still connected by the window crank. Anyone know how to take that off a Hyundai accent?


Put thin piece of cloth between window crank, twist it around, turn window crank up and down, then pull thin piece of cloth away from the round spinable crank ball (piece you hold) this shud remove interior hidden C clip. try again if you dont suc ... 2002 Hyundai Accent

My remote immobiliser will open & shut the doors windows etc but will not take the immobiliers off there for i'm un able to start my car I have replaced the batteries in the reomte but this makes no diffrence. its a C200 manaul est 1996 petrol any ideas!


Pull the system out. there are so many problems with those programs. its in your best interest to get rid of the entire system ... Mercedes-Benz C230

I need to take off the door panel and cant get it over the window crank


\015\012\015\012Remove the manual door crank handle, if equipped with manual windows. Pry the handle slightly forward to reveal the retaining ring holding it to the door crank arbor. Use the retaining ring pliers to spread and th ... 2001 Chevrolet Tracker
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.4975 seconds