Having problems with your 1994 Lexus Es 300 ?

Why does it continue to over heat even after changingth cylinder head gaskets?

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Overheating can be caused by a few different things such as the fans not going on, the thermostat being stuck closed, or blockages in the engine due to deposits (which can be resolved by flushing the cooling system).
\015\012
\015\012If the head gasket was changed this could indicate that the engine overheated due to another problem that caused this.
Repair Help & Product Troubleshooting for 1994 Lexus Es 300

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Why does it continue to over heat even after changingth cylinder head gaskets?


Overheating can be caused by a few different things such as the fans not going on, the thermostat being stuck closed, or blockages in the engine due to deposits (which can be resolved by flushing the cooling system).\015\012\015\012If th ... 1994 Lexus Es 300

After replacing the head gasket in a 1978 2 1/4 litre 4 cylinder landrover the engine wont start the battery has plenty of power to crank the motor I even blew hot air into the air intake to try to assist ignition but this still did not work when I removed the glow plugs they were wet with fuel but due the ignition swith being worn out I cant seem to get the glow plugs to heat up, I also had to remove the injectors to remove the head can you give me any tips on what I can do to start the motor


... 1993 Land Rover Defender

I have a 2000 Daewoo Leganza. When I first bought it, there was no heat in car, temperature guage was blowing sky high and shutting down engine. It was discovered that there was engine problems, so that was sorted along with new cylinder head gasket, everything worked fine until now. I again am getting no heat in car, finding it considerably harder to demist car (blower still working). Temperature gauge is rising to 3/4 level, but never goes above and does drop while driving, but continually goe


The temp gauge and no heat are two seperate issues, unrelated. The temp gauge fluctuations are a result of the sending unit, mine does the same thing, shows going to 3/4 mark then descending and up and down in synch with the radiator fan activation. ... 2000 Daewoo Leganza

My car continues to overheat even after taking it to engineereing services for repaires on the cylinde head. the heating problem starts when i travel long distances yet my cooling fan is in working order and water will boil in the radiator and does not circulate from the auxilliary radiator water bottel. I only get the temperature gauge down ones i switch the heater and fan to full capacity, winter and summer.


Hello, cfish630 and thank you for asking your question on Fixya!\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012\012 Here is a simple process that will ... 1998 Toyota Corolla

Engine misfire I have a 2000 Pontiac Montana that started to miss, my code reader said misfire #1 cylinder. I had it looked at and was told that the head gaskets needed to be replaced. After replacing the head gaskets along with new plugs & wires it now has a misfire on #5 cylinder. I swaped coils, injectors, plugs and wires and the problem remains. Could it be the ignition box or even the computer, or what? This vehicle also has another problem with the lights strobeing, I thought this was the


We have the same problem down to the lights and everything\015\012Did you ever figure out what it was? ... 2000 Pontiac Montana

I have 1996 mitsubishi pajero 2.8TD, it over heated blew head gasket & blew hole in radiator,had it fixed put new cylinder head & radiator on it, its only bin done for couple of weeks,not sure if head gasket has gone again but as i parked up at my house was getting steam out of bonnet temp gauge was at half way had a look & had boiling sound & steam coming out of expantion tank (bottle)a bit baffled on what problem is any ideas, thanks.


Are you sure you had installed the correct gasket? did you compare it with the old gasket that you took off? I suspect that you got the wrong gasket and blocked up the holes between cylinder head and engine block thats why the coolant are not circula ... Mitsubishi Outlander

My 1994 toyota corolla is still over heating after i replace the thermostat head gasket and even got the head milled already but it only over heats after about 5 miles of driving and i already flushed the radiator and the water in the resevoir is bubbling


... 1990 Toyota Corolla

I have a 2001 Nissan Sentra and my heat is not working I have taken it to my mechanics and he can not figure out why it is not working he checked my head gasket and all heating coils, and even replaced the thermostat but it does not work. The only time my heat works is if I am on the highway and going at least 60mph for longer than 10mins. I don;t know what to do. Also my car has a real hard time starting, I live in upstate NY so it's really cold here but it seems as though my engine is freezing


I would check the water pump for proper operation. The pump can fail where the shaft is disconnected from the impeller. The engine will spin the shaft but very little water pumping is done. This would explain why the engine coolant is not circulat ... 2001 Nissan Sentra

I am trying to remove the cylinder heads to replace the head gasket and don't want to twist off the head bolts. I have tried some heat and penetrating oil and tapping on the top but they still are


What kind of vehicle are you working on? Usually head bolts are torqued betweent 50 to 70 ft/lbs. so yeah, you'll need to put a long breaker bar on it, make sure it's at least 1/2 " drive so you don't break your tool ... Cars & Trucks

I have a 98 honda civic dx(D16Y7) I having problems with my heating. The car gets up to normal operation temp and the upper hose is hot and the lower hose is ice cold and the heats not so great. I have replaced the radatior, all hoses, and thermostat, and still the same problem. I even check the heater core and all hoses on that as well. Nothing is cloged. It just seems not to be circulating right. All plugs check out find so i know its not a head gasket. I have let the car run with the heat


Trace the hose that goes into the heater core from the engine and the other hose from the core back to the engine. I believe there is a valve that opens and close to let hot water circulate into the heater core. When you more the dial of the t ... Honda Civic

My Grand Prix stared running hot. We replaced head gaskets and intake gaskets, replaced water pump, thermostat, and flushed radiator. My car is still running hot. The heat not blowing hot even after new thermostat. it will idle cool. But if you press gas or drive it instantly stars running hot


Are you sure that the radiator is not clog ,also check the cap for broken gasket also check the hoses for stiffness i would also wanna run it without thermostat to see what happens ,some times they come defected from manufacturer good luck ... Pontiac Grand Prix

My van continues to over heat even after adding coolant/water. Doesn't seem to be radiator. I was told possibly exhaust manifold gasket. What does that part have to do with my van over heating?


That is a good question, your car most likely does not have exhaust manifold gasket, and this, while not a good thing, would not cause overheating.\012Pressure test the cooling system, repair any leaks. Have you replaced the thermostat? Do not ... 2003 Chevrolet Venture Passanger

I have a KIA Carnival mod 1999 2.5 V6 24 val. gasoline I have continuous bubbling in the water container, replace cylinder head gasket in 2 opportunities and the problem continues, What is the distribution point for this model and how many kilograms and degrees should take cover cilindors


... Kia Sedona

Volvo s40 1600 petrol reg 2001 - new head gasket and timing belt fitted (vvt model)didn't realise you should go past timing marks and come back 1/4 turn ! engine runs but very hard to start and somtimes cuts out when returning to idle..... low compression on all cylinders - tea spoon of oil down spark plug hole raises cylinder 1 and 2 to correct compresion but does not help 3 and 4. started first time before over heating, not sure were to go with it. could this be a fault because oil pump not in


... Volvo S40

99 venture ran excellent had head gasket problem replaced all gaskets and put on a timing gear and chain will not fire up right it sounds like only one or two cylinders are firing like the timing is off. checked the gear and chain its right on checked firing order checked spark i even used starter fluid all sounds like timing is off all new spark plugs & wires it ran almost perfect before i tore it down dont know what to try, Dave


If anything moved prior to your replacing these items you could be on the exhaust side of the stroke vs the compression side,, (180 degrees out of time) remove the number one plug,, and this sounds dumb , but it works,, put your finger ... 1999 Chevrolet Venture

01 sts head and gasket good replaced water pump thermo rad cap works good for 2hrs then over heats and no heat im stumpted cooling fans maybe i cant figure it out a bad thermostat even though it was just replaced no loss of power no milky substance or grey or smoke in oil or exhaust please help seems like once i put the new thermo in al this started happening temp gage is eratic these cars are great but when something goes or goes wrong what a nightmare please help


The temp gauge being erratic should have been your sign. Are you sure its overheating or are you going by what you see being registered on the temp guage.Also after doing work such as water pump sometimes you will get air lock in the system you need ... 2001 Cadillac Sts

I have hiace 3L with new head water pump,radiator,clutch fan,thermostat,radiator cap,fuel filter,new timing belt and it over heats after 100 km and has blown the cylinder head gasket twice since . any ideas


Probably a dumb question but was the engine block skimmed and on certain cars you get different thickness gaskets for different performance heads, and is the timing correct? ... 1994 Toyota Corolla

I have a 2001 VW Passat 1.6S. I have just had the cylinder head gasket, timing belt, water pump and thermostat replaced. When the thermostat is removed the engine runs perfectly. However when it is reinserted the engine runs ok until it heats up and then the car doesnt seem to be running on all cylinders and loses a lot of power intermittently. My mechanic is talking about the temperature sensor because he has basically replaced everything else. I would really appreciate any ideas that you might


It could be the temmperature sensor, however its sound like the thermostat is still bad, this happens on occasion where you get a brand new part that has a factory defect ... 2001 Volkswagen Passat

Overheating 2000 chevy venture overheating, have replaced the Thermostat, waterpump and even went as far as checking the heads and reaplacing the head gaskets. Seem to still be over heating when Vech. is just idoling. I have yet to have the cooling fan checked. However when the Van does get hot i'll turn on the AC and that seems to bring the temp down.


Hello, have you ran a scan tool on it yet to see if its not your coolant temp sensor or other temp sensor if you don't own one you can have any place like auto zone run one for you for free you'll have more of a idea of what ... 2000 Chevrolet Venture

Not starting I have a 96 rodeo, 3.2 motor, no codes actiave or inactiave, no blown fuses, ones that i can see, or find. i have spark, i have fuel and pressure, the motor cranks over, but will not run. battery plenty of juice & amps,took the alarm out of the pic, even though you cant even crank it if the alarm is engaged. I am running out of solutions for this, i have no idea what is stopping it from fireing up. it might of had a head gasket going when i got it, but no over heating, no misfires,


Maybe the ecm? ... 1996 Isuzu Rodeo

TOYOTA 16V 1ZZ oil and coolant mixing ,even after resurfacing cylinder head and fitting new gasket


... Toyota Cars & Trucks

Hi I need help with my 2004 Freelander TD4: suddenly blue/white smoke coming out the back of the car ( the car did not over heated the heat gauge was at normal position) notes that there was oil leaking everywhere and that there was oil in the coolant water tank as well, suspect head gasket blown Removed the head, no indication of a blown head gasket, send the head in for testing. Pressure test 100%, so put new head gasket and head bolts, replace oil filter and oil. Start the car and after a


Cracked block. once it heats up the crack gets bigger and the oil gets thinner which makes more oil burn. run car without the oil cap on and see if lots of air/ oil comes out if so thats blow by and you need a new engine. ... Cars & Trucks

90 lincoln was running hot 3 yrs ago,and no heat just replaced head gasket,heads pass pressure test,no cracks in heads, head gasket was bad,still no heat,heater hoses hot, pressure test cooling system holds pressure,top hose collaspes sometime when rev up,did have heat on idle yesterday no heat today on idle or rev up, any tips?


Have you even considered the heater core? Have the heater core checked/replaced. As for the top hose collapsing...that is not good. Have the entire system checked out by a qualified mechanic. ... 1997 Lincoln Continental

Is there ant other way water can get into the cylinders other then blown head gasket? Ive replaced the head gasket twice now and water is still getting in causing miss firing, white smoke and milky oil. Can water get into the inlet manifold some other way? Every cylinder had signs of water when i took the head off yet the gasket looked fine.I have had the head preasure tested and it is o.k.


It is possible the block isn't level. I'm guessing you have the shop manual for this and it will have the specs in it for block tolerance. You'll need a straight edge and feeler gauge to check it. My first guess was that your head is warped but yo ... 1996 Jeep Cherokee Sport

Harmonic balance I am trying to replace head gasket, cannot get harmonic balance off the motor. Tried two different pullers, the thing will not budge. We even tried heating it with a torch for over 20 minutes, it still would not come off. Any suggestions.


You'll have to get the Chrysler balancer puller. Yes, they have a special one for that brand of car. This will make life easier for you. ... 1996 Dodge Avenger
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.8571 seconds