Having problems with your 1994 Jeep Cherokee ?

Ok, had a trailer wire box attached to rear drivers side-wife left it hanging out and ran over it. Now I have no rear driver tail light or front amber running light. All turn signals and running lights work correctly except for these 2. I have removed damaged box and replaces all light bulbs. Get no reading from wire labeled major at the pig tails. Is there a quick find fusible link or do I get to trace wires?

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Check all your fuses. something may have shorted out and blew out a fuse.if you don`t have blown fuse there is a short somewere.you will have to locate it.
Repair Help & Product Troubleshooting for 1994 Jeep Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Ok, had a trailer wire box attached to rear drivers side-wife left it hanging out and ran over it. Now I have no rear driver tail light or front amber running light. All turn signals and running lights work correctly except for these 2. I have removed damaged box and replaces all light bulbs. Get no reading from wire labeled major at the pig tails. Is there a quick find fusible link or do I get to trace wires?


Check all your fuses. something may have shorted out and blew out a fuse.if you don`t have blown fuse there is a short somewere.you will have to locate it. ... 1994 Jeep Cherokee

Having a problem with my 1990 Jeep Wranglers rear lights. The fuses and bulbs are all fine and my console lights up to show that the turn signal should be working but I am getting absolutely no lights for braking, turning or running lights. Must be the wiring? where do I look. Thanks for taking the time to help me. I am looking forward to getting up to my elbows in grease to fix up this tonka toy of mine.


... 1990 Jeep Wrangler

I recently changed the headunit in my 83 camry and now the cluster lights or the parkers wont come on at all, no front or rear even the selector light is out, i checked the fuses and they are good all bulbs are good, i used a test light at the fuse box inside the car and there is no power getting there. when i flick the switch i hear the relay tick, and now im stumpt any ideas on what it could be? even a wiring diagram, any help would be appreciated thanks :)


... 1983 Toyota Camry

I need a FREE 1992 Toyota Camry taillight wiring diagram. My side rear park lights come on but my park lights that work with the brake lights don't. I changed the bulbs and tested everything. I narrowed it down to a break in the wire between the fuse box and the trunk connector. I need the diagram to tell me what the color code of the wire is that handles the park lights in the rear and not the side / rear park lights that do come on. Any suggestions?


Brown wire is your park LT yellow Left-turn green right-turn. Now the break light my be on it own wire it is red black is ground. but if you have a test light see if the brown wire turns on the test LT when you turn on the park LT or what wire light ... 1992 Toyota Camry V6

2003 jeep liberty left rear running light out. all other lights working. replaced bulb then plug in socket, then entire lens and no change. could it be the wiring for this light only ? how do i tell whch wire is for running light? there are 5 wires in harness.


... 2003 Jeep Liberty

Tailight problems i have replaced headlight switch , brakelight switch,put new socket on right side front , pulled fuse box to fint running light wire burned off, jumped this wire too the headliht switch and got the running lights to work but when brakes are on right side goes dime and hase feed back into the backup bulbs, have cleaned all grounds,and light sockets etc... when i have the running lights working this way the headlight switch starts overheating at the reostat dimmer where it turnes


... 1983 Dodge Cargo

I have no brake lights or blinkers on the rear of my 1989 Jeep Wrangler. I had one left blinker in the rear but not now. Both blinkers work fine on the front. I tried grounding the rear lights straignt to the battery with a long wire and nothing happens. I replaced the turn signal switch and nothing happened. I got a test light and get no power at light. I followed it to the connector near the fuse box and still cant get power. All my fuses are good. What can I try next????


Did you you check all your power ground sources from the switch to the light seem like you power source is not properly ground ... 1989 Jeep Wrangler

2003 Ford Ranger, XLT 6Cyl. Flashers, Running Lights, Reverse Light, Right and Middle Brake Light and Headlights are working. Front running/parking lights are not working. Signal Lights, Front and Rear are not working (replaced Bulbs already). Rear Left Brake Light not working (replaced bulb already). Fuses checked an all appear to be good. What do I do? State Inspection was due yesterday, getting all kinds of hand gestures and horn honking for slowing down to turn without signal lights.


Found very detailed assistance and instructions, FREE on the Ranger Station Forum. It is nice being able to go on-line and find lots of free information from fellow American Ford Ranger owners and not be asked for $$$.\015\012\015\012If ... 2003 Ford Ranger Regular Cab

I have a 98 s10 and the rear brake lights will not come on but my third light above the cab will come on. i have checked grounds on the back of the frame and all seem good. no fuses bad and bulbs are good. when i have the park lights on and the brake pedal is pushed i get a little feed back through the brake wire at the rear when my test light is in the wire. please help Thanks Robert [email protected]


... 1998 Chevrolet S-10 Pickup

94 nissan truck doesn't have running lights, or dash lights. I hard wired the lights with a lead that ran directly from the positive terminal on the battery to the positive lead in to the bulb so I could at least be legal, and as soon as it got positive juice, on came my running lights and so did my dash lights! What would cause this. I have break lights and head lights, but without the direct current no dash or rear running lights.


If by running current as you said fixes the problem. Then you have to check the head light swich and see if it is sending current out on all the needed wires. If it is you have a break in the wires some where. But for it to act the way you say the h ... Nissan Hardbody

All of my lights work on my 2004 gmc envoy except my driver's side rear park lights. I have checked all of my fuses. I have identified (1) fuse box. i did not see a (2nd) fuse box. i have tested all of my bulbs to ensure that they are good. i cannot drive at night because I could receive a citation for faulty equipment. i have opened the rear panel to view the wires and even checked to see if I had some current. i do not appear to recieve any current on the rear driver's side for the park


Hello and welcome to FixYa!\015\012It can be just a bad ground on the rear harness of the tail light. Try to remove the positive battery connector and scratch the contacts for it can be corroded. A contact cleaner spray in can can help to ... GMC Envoy XL

Electrical problem 1998 Lincoln Continental 98,000 miles ---------------------------------------------------------------- What is the control box under the rear window deck? Do you have a diagram of it? I can not get the Brake lights to work. Put new bulbs in, checked fuses, etc. The center rear light in the back window works but the brake lights don't. I am not getting any message indicating that they don't work. Same with the cruise control. Says it works fine. Help,can't drive without brake l


... 1998 Lincoln Continental

Electrical problem 1998 Lincoln Continental 98,000 miles ---------------------------------------------------------------- What is the control box under the rear window deck? Do you have a diagram of it? I can not get the Brake lights to work. Put new bulbs in, checked fuses, etc. The center rear light in the back window works but the brake lights don't. I am not getting any message indicating that they don't work. Same with the cruise control. Says it works fine. Help, can't drive without brake


Check your hazard switch if its activated your brake or turn lights won't work.\015\012try depressing it while checking your lights, turning it on then back off. this could be the problem ... Lincoln Continental

1989 e350 van,duel fuel tanks,tank selector switch on dash. key on, front tank, gauge moves from bottom to empty mark, tank is full. key on, rear tank, gauge dos not move. There is continuity from gauge to orange wire at rear tank. Ran hot wire to gauge, turned on key, selector switch on front tank, gauge read 3/4 tank. Selector switch on rear tank, guage read 1/2 tank. Van will run on either tank. Looks like I'm not getting power to gauge but other gauges work. Is there a seperate


All the items you mention can be the problem and you can add a bad sensor in the tank to the list. The fact that you ran a power wire back and the gauges gave you movement that tells me you most certainly have a short on the power side of the circui ... 1986 Ford Econoline

I need to replace wiring harness from right rear combination light (includes brake light, and running lights). How do you get to the plug to replace the harness. It goes through the metal of the vehicle and I can not find a way to get through the rear interior side to the plug?


The back panels come out if u pry them alit and move the back seats forward.if u need more help let me know an i can send u more details [email protected] ... 2004 Hyundai Santa Fe

I had the same problem, all u do is take apart the box behind the steering wheel, unplug the cluster of wires look to see if the plastic has melted, find out which wire runs the tails and dash, take that wire and hard wire it into the ignition. now the lights come on as soon as u start the car. this is a comun neon problem i now leave the box appart becase if u drive around with it off and feel the wires they get REALLY hot, so imagine how hot they become inclosed in the box, anyways hope this h


... Chrysler Neon

During the day my brake lights work, but not my rear signal lights. when i turn on my head lights, the brake and signal lights will not work. my signal lights in front work all the time, but they blink real fast. i checked my fuses on the dash panel box, all are ok. i checked under the hood and those fuses were ok also, but i do not know about the square big multi pronge fuses. i replaced my rear tail light bulbs also even though my old ones were ok. could there be a loose ground wire or a bad b


U have a short loose ground or power wire check all bulb sockets ur head light switch can be bad also ... Ford Ranger

I have a 1990 toyota camry, the fuse for the dashboard lights, glove box light & rear running lights(they are all the same fuse). blew, I replaced it and all was fine. A week later again the fuse blew, I replaced it and the dash lights & glovebox lights work but NOT the rear lihts!! The brake lights work fine. Can anyone help?? We checked all the bulbs, the connections are all fine. HELP!!!


Depending on the year. I.e. 89-91 camry, all have a yellow god fuse in the driver side of the trunk space behind liner.it is about 2''*3" cant miss it, being only yellow part. It is usual cause of certain outside lights completly out, have had to cha ... 1990 Toyota Camry

Radio, Interior and reading lights, power doorlocks, voltage (battery charge level) meter,running lights all stopped working on one turn of the ignition. No smoke, no unusaul weather or circumstances. Running lights came back after fuse change but quit after one test run. Looking 4 fuse box diagram and wiring info for 94 plymouth voyager. Cruise control and AC have been down from day 1 of used purchase & I don't know if this might short out other circuts in the system. Also power mirrors are sho


... Plymouth Voyager

I need a wiring schematic for a 1990 Chev pick-up HELP ! Trying to hook up tail-lights, got signals, and brake lights, but can't get rear running lights. I have 2 black wires ? I know they are ground, but 2 loose coming from left side, and 2 brown coming from right side, which goes where? I tried directly hooking them all to a grond on frame but that didn't work, burnt a few fuses trying different ways now I'm stumped. Oh ya, this truck has been a farm truck, there is no trailer lights plug and


Also try http://www.etrailer.com/faq-wiring.aspx. They have easy to follow directions and color codes. Plus you can order anything you might need. Hope this helps. ... 1990 Chevrolet K1500

1995 town car, brake lights stopped working, rear window brake light works fine but reg. ones dont work. ive checked bulbs, fuses and wires in trunk. not getting any hot wires in trunk area. could it be the brake switch or some sort of relay under dash area? Its my moms car and shes been driving it for awhile with no brk lights, need help soon. Please help me!! Thanks!!!


... 1995 Lincoln Town Car

2006 Chevy Express. No rear park/running lights or lic. plate light. Everything else works fine. Wires appear OK as well as ground is grounded. Bulbs are good as well as fuses. Any ideas? Front lights work fine. Feel like running a wire from the front ones?


Check rear light fuse and wiring. ... 2006 Chevrolet Express

I am having a brake light problem--all are out. I think the switch is working. With the brake fuse out, I get a 12 volt read across the fuse terminals when the brake pedal is depressed. I think if the brake light switch was bad that I would not have a reading when the pedal is depressed. Is there a relay or something that could be interfering with the circuit. I have tested the wiring at the rear of the car and the lights all come on with a jumper. Thanks


Using a test light, depress brake and see if have 12+ on both wires, when release brake pedal should only have 12+ on one wire, if only have 12+ on one wire then switch is bad.\015\012If you are using a multi-meter, put your negitive on a known ... 1987 Toyota MR2

My right rear running lights arent working i replaced the double bulbs and they still wont work. wondering if its in the switch. the running light fuse ? relay fuse or a burnt up wire?


... 1997 Acura Integra Type R

I had an EGR valve sticking and replaced it after it read up on a computer reading! the truck runs fine but it had sat for 2 1/2 years before i bought it. has dual tanks and the front tank has gas in it from sitting the whole time. rear tank is the one i use. But.... when i drive it shakes real bad, like its missing with overdrive off, and also when i take off from a light. it also makes the sound from the motor that it's not getting gas and wants to die when i take off. check engine light


The tank you are using, is the gas new or old? I didn't know if the one your using is that old too. If it is, that gas is bad. I would say your injectors and fuel filter is clogged. ... Ford F-150
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.2342 seconds