Having problems with your 1994 Hyundai Excel ?

Removing a headlight assembly on a hyundai excel 2 door

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1994 Hyundai Excel

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Removing a headlight assembly on a hyundai excel 2 door


... 1994 Hyundai Excel

About a year and a half ago my 93 buick century died and i got a bunch of work done: parts added included: alternator assembly, interstate battery, starter assembly, ball joint, door window motor, primewell ps 850, under labor it does say that they checked charging system, removed and replaced alternator assembly, battery, starter assembly, ball joint, gave an oil change etc, door window motor. not too long after, i went to drive to the store and when i depressed the gas pedal the headlights


Thanks for choosing FixYa and welcome. ... 1993 Buick Century

1999 honda passport (isuzu rodeo), problem: All lights (dash,dome,headlights,....) pulsate dim bright, dim bright. Had altanator checked was ok. removed battery terminals while running and didnot die. Battery good terminals very clean and tight. rev engine above 1kRPM remains bright. Has been doing this for months, now lately the power door locks quit working, when button is pressed for door locks can hear relay in the door lock button assembly click but the cylinoids in the doors dont engage, a


I have the same car and the same problems. I think it may be a ground issue. Once the weather is a bit warmer, I will be checking the different connections. Does anyone else have any ideas. ... 1999 Isuzu Rodeo

HELLO how do u remove an IGNITION CYLINDER LOCk from a 1992 HYUNDAI EXCEl..I see a roll pin in it underside> I know how to remove whole assembly from steering colum, but how do u remove cylinder (round) part that key goes in?? thanks


U have to turn the key in the bsrell to accesory position and then the pin will push in so u can remove the barell ... 1992 Hyundai Excel

Hyundai door handle removal - 1994 Hyundai Excel


... 1994 Hyundai Excel

1991 Dodge Spirit 4 door gaskets have dried out on headlight reflector/lens assembly. Cant figure out how to remove the assembly to regasket. two screws are visible on one side, but can't see where the screw is that holds in the other side.


Should be the same as my 95 Acclaim. There should be an adjusting slot on the top and the side closest to the grill. There is one underneath as well, but you can't see it. Use a small screwdriver to pry the adjusters out of their slots, then pull ... 1991 Dodge Spirit

Cannot remove headlight assembly on 2007 Hyundai Sonata removed all bolts/screws, but will not come out.


How many bolts did you remove?... three (3)? If so, good. Now you have to drop the front bumper next to the headlamp assy so it will be clear of it.. then it will come out. ... 2007 Hyundai Sonata Limited Sedan

I am an engineer able to deduce and correct problem on inability to operate power lock of passenger door on '95 Monte Carlo. However, after removing interior door panel and removing 3 latch-mounting screws, I am unable to access and disconnect latch assembly from exterior door "handle" and exterior key lock, necessary to enable removal of latch assembly from door cavity for examination and repair. In answering, please indicate whether or not the window race must be removed for adequate access in


Well with your engineering experience you should have been able to figure out the latch assembly is not the problem!Did you even check the rocker lock switch with a test light to see if it is ok,If you had power rocking the the switch to lock,then wi ... Chevrolet Monte Carlo

2010 hyundai veracruz removing left headlight assembly


... 2010 Hyundai Veracruz

How to remove headlight assembly on 2001 Hyundai elantra


... 2000 Hyundai Elantra

How do you replace the headlight on a1984 Oldsmobile 2-door Cutlass Supreme? I can't see what retains the head lamp assembly but it appears that the external plastic frame must be removed first and it's held in by what appears to be 4 small Torx fasteners, one at each corner. One problem is that the lower two fasteners are so far recessed that I can not get my Torx driver onto them. Any suggestions will be greatly apprecicated. Thanks. Tom D.


That is exactly what holds your light in, when you say torx driver I am assuming that you are using a multi-driver, you might need a nice slim torx screw driver to get into the recession to get the screws out, a magnetic one will be the best to reins ... 1984 Oldsmobile Cutlass Calais

Need to remove headlight assembly on a 1999 ford escort 4 door sedan.


... 1998 Ford Escort

Removal of headlight assembly to change headlight bulb on 2007 gmc yukon xl. I see the two screws above but can't tell if there is more to removing assembly. seemed easy initialy, but can't figure it out. It looks impossible to change bulb without removing the headlight housing. Thanks


... 2007 GMC Yukon

This is on a 1997 Geo Tracker 4-door. The inside door latch cover is broken and causing major problems. My problem is: after removing the philips screw holding the cover on and loosening the assembly, I can not remove the bar that attaches to the latch. I have tried prying off the white clip on the bar and squeezing the clips on the door latch - no go. I need to replace the whole door latch assembly, and am stuck on getting the stupid thing OFF. Thanks for any help you can offer!


Most of the white clips on the bars twist upward and the bar pulls out of it. ... 1997 Geo Tracker 2 Door

2001 Buick LeSabre. How to remove headlight assembly... Just need to remove and replace the headlight assembly on my 2001 LeSabre Custom. I think it's just a matter of removing a couple of bolts, but would like to make sure before I start.. Thanks


The bolts you are looking to remove are located on the top of the light housing. It only takes 2 of them to remove the housing. One is about 6 to 8 inches long, and the other one is much shorter than that. Just unscrew and remove them, and pull the h ... 2001 Buick LeSabre

2003 Ford Explorer, closed back hatch door on jacket and the zipper part of the jacket is jammed in the door jamb making the assembly inoperable. Any advice how to remove this? When trying to open from the outside the hadle will press but does not engage the door assembly. Have tried to remove jacket but cannot get out.


Unfortunately your probrably going to have to take off the interior panel on the door so the latch can be manuelly released from inside the door itself ... 2003 Ford Explorer Sport

Headlights blinking 95 concorde - recently replaced powertrain control module. Now when any door is opened, the headlights start flashing. Initial trace found that the headlamp delay relay was clicking. Remove relay and lights stop flashing. However, removing relay also kills instrument panel lamps. Currently have entire dash broken down and open. Have checked the body control module, headlight switch and connectors, headlamp dimmer switch, all door switches. No problems or defects (i.e. shorts


... 1995 Chrysler Concorde

Every time I open my door my panic alarm goes off and I can't get it to stop until I pull my horn fuse and my headlight fuse I hav ethe identical problem I have a 2000 sebring two door and if I open either door the alarm system goes off. I key fob is ok, I have tried unlocking the car with the key and it still goes off. Until I find a solution I have removed the alarm fuse ( under the dash driver side) and removed the horn fuse ( under the hood) so now only my headlights flash, now at least my


Hi..the reason for the problem is the security\015\012system.If ther is any short of wire or any damage\015\012in the wiring system it could lead to this problem.\015\012so this problem o ... 2000 Chrysler Sebring

Difficulty removing Low Beam Headlight Bulb -2005 Hyundai Elantra


... 2005 Hyundai Elantra

How do you remove the round plastic ring that covers the fuel filter assembly on a 2003 Hyundai Elantra GL? It looks like it screws off but it's stiff and doesn't want to move. Help?


... Hyundai Motor 2003 Elantra

How do you remove the round plastic ring that covers the fuel filter assembly on a 2003 Hyundai Elantra GL? It looks like it screws off but it's stiff and doesn't want to move. Help?


... Hyundai Motor 2003 Elantra

How do I safe remove the headlight assembly on a BMW 325i premium package?


There are 2 8mm screws on the top of the headlight and 2 identical looking screws on the backside of the headlight assembly (you will need about a 6 in extension for those 2). Directly under the headlight assembly you might have a painted trim piece. ... 2001 BMW 325

How to remove the fog light assembly on a 2006 Monte Carlo. After the headlight removal and the bulb removal from the fog light assemby... How does the assembly come off of the body, properly? When taking a closer look, there are 2, possibly 3 clips that the assembly is attached to. I am not sure how to get the assembly apart from those properly. Any help would be greatly appreciated. Thanks.


You must access the fog light from under the car. ... 2006 Chevrolet Monte Carlo

Removal and replacement for a 1997 ford F350 headlight assembly I need to remove and replace the headlight assembly in a 1997 Ford F350


... 1997 Ford F350 Crew Cab

Can the factory headlight lens covers on a 2001 Mercury Cougar be removed and cleaned ? I can remove the entire healight assembly and change the bulbs, but the inside of the healight cover is dirty and needs to be cleaned, I can't figure out how to take the clear plastic cover off the headlight assembly. Thanks for an input.


The lincoln LS had the same problems, and the lens was held to the headlight assembly with a sticky glue.\012To remove them, some guys were successful by warming the headlight assembly in the oven untill the glue softened up enough to be pulled ... 2002 Mercury Cougar
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.1671 seconds