Having problems with your 1994 Hyundai Excel ?

No spark in one cylinder

\015 Hyundi lantra sports wagon 1997 has no spark in one cylinder.i have changed spark plug and checked lead is ok\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :


Pls try to check/replace your distributor cap and/or the rotor. A friendly reminder, pls check that the spark plug gaps are within specifications, the wider the gap the the more arcing from the rotor to the bottom terminals of the distributor cap, the faster the burning/deterioration. If at all possible, try to replace with Bosch or Beck Arnley brands.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Repair Help & Product Troubleshooting for 1994 Hyundai Excel

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :


Probably you have a cracked or otherwise bad Distributor Cap. I would have changed the dist. cap and rotor first, and probably the wires too. You said you changed the boots, did that include the wires? \012\012Pay attention to the order ... Isuzu Axiom

Gx610 honda motor sparks& runs on one cylinder.swap cdi units over ,still runs on the same cylinder swap plugs ,new plugs still runs on the same cylinder cdi units test ok compression same on both cylinders.stop wire connected or disconnected still only sparks on one cylinder fuel to both cylinders

... Cars & Trucks

2002 escape miss fire on cylinder one. took coil from cylinder 5 and put on cyliner one coil did not fire on cylinder one. took coil from cylinder one put on cylinder 5 and it did fire. 160 lbs of compression plug is wet with fuel. replaced spark plugs

Power not reaching cylinder 1 ignition coil. check electrical connections and wiring for any damage. test for power and ground at cylinder 1.\015\012hope this helps. ... 2003 Ford Escape

Honda GX610 - Spark On One Cylinder Only. Coils Replaced (New), Swapped Coils From One To Other - Still Only Spark On One Cylinder ???

... Cars & Trucks

Mazda Eunos 500 - Engine lacks power - investigation reveals strong sparks on all cyls fuel at all cyls compression to specification on all cyls timing ok. Removing spark plug lead on cylinder one makes no difference. Removal of lead on all other cylinders one at a time makes a noticable difference. ? have fitted new leads new spark plugs checked distributor cap for tracking ? 2L V6 1998 160k

When you change the wires did it bring back the dead cylinder? If not check the resistance on that injector it should read 11 to 15 ohms, check another injector to see specific ohms they should be close if not exact. ... Cars & Trucks

My 98 Mitsubishi eclipse 2.0 I recently purchased had oil in the spark plug wells I noticed the valve cover bolts were loose (2) u tightened then down changed plugs and wires when I removed cylinder four plug oil build up went into hole spark plug sits in flash engine light came on and flashes when in park took it to auto zone they removed light but it still flashes in park but never stays on codes they pulled before clearing it were cylinder one and four mis fire but I removed wires one by one

... 1998 Mitsubishi Eclipse

There is no spark for one of the coils, for #s 3 and 6. I replaced the coil with a new one but there is still no spark. When the car malfunctioned, we were driving slowly in a housing development, and all of a sudden, it started to miss apparently on two cylinders. I took it home and checked it out and found it had no spark coming from one of the three coils, for #'s 3 & 6. so, today I got a replacement coil and installed it but with no improvement. What can/do I need to check and how do I do it

The coils set on the ignition module which controls the coils to workReplace that module too as well ... 2000 Buick LeSabre

My 2000 jeep had a blown engine, I rebuilt it completely and it wont start. I have good compression and fuel, however; no spark from the plug wires.It has a new coil pack. It was running before the new engine was put in (5 cylinders). We did the TDC on number one cylinder. I cannot find any loose wires anywhere. This one is electronic with no distributor. I pulled the camshaft position sensor back out, put an alignment pin thru the pulse ring/into hole on the CPS body, put the no.1 cylinder and

Check the body of old engine (core) for a Bosch type relay. or female Bosch connector for the ignition cut-off. (different from starter kill) === On above average alarm system,they has starter kill as well as ignition kill. Check the CPS wiring betw ... 2000 Jeep Wrangler

Misfire code on cylinder 7, 5 liter engine 99 Explorer Limited. I will first replace the spark plug and check. If still a problem then will replace spark plug wire. My question is this, is there anything else I should be looking at? And since I replaced the spark plug wires recently is it possible to buy just the lead for cylinder seven? This is one with the heat shield on it.

Hi yes you should be able to buy them individually if you got to the ford retailer they should be able to supply you with one, as for the misfire, there are a couple of things that could cause this, firstly you can check the ... 1999 Ford Explorer

My 2003 Kia optima 2.4L DOHC engine broke the timing belt & balance shaft belt. It broke one valve cylinder 4, bent two intake valves cylinder two. I had just replaced both coil packs and wires and plugs.I pulled the head and had it reconditioned. My compression is about 165 to 170 psi per cylinder. I fire tested both plugs with clip on spark tester. On one and three getting white fire, logic probed injectors getting firing pulse on all four injectors. With plugs out I smell fuel. Logic probed

Yea run a power balance test. \015\012Basially what you do is pressurize the fuel system and note the pressure. you can use a momentary pulse switch and aligator leads, and get it connected to power and ground. fire the injector and note how mu ... Kia Optima

Engine problem I have a 1995 grand am with a quad four. It started running very hard one day so we put a new fuel filter and spark plugs in it but that didn't seem to help. We then took it to a friend?s garage and found out that the two right cylinders aren?t firing. We put in a new coil on that side and that didn't help. We know that there are sparks when the plugs are outside of the cylinder and that the cylinder is good because we did a compression check. If you have any idea of what the prob

I would look at the injectors being dirty or not coming on when theyre supposed to also older injectors cause alot of rough running probs ... 1995 Pontiac Grand Am

Briggs and stratton intek v-twin 21 hp, running on one cylinder, replaced both spark plugs, replaced one coil on the side thats not firing. what is it??

... Briggs & Stratton Cars & Trucks

I have a 1990 ford 460 EFI cylinders 1,2,6 has no change or little in RPM when spark plug wires removed.The three spark plugs has black carbon on them. I replaced them with new ones with new wires.Co

Check that the egr valve is not stuck open remove it and cover the hole on the intake side and see if it goes away or with engine running remove the vac line from the valve and install a short length of hose and suck on the hose to draw a vac on the ... Ford F 450 Super Duty

I have mazda 323f 1.3 petrol engine 2001 model(UK). It seems to be misfiring and is very sluggish uphill. I have replaced the spark plug leads but this has not cured the problem. You can feel the car is juddering at low revs and the rev counter keeps moving up and down on idle. Somebody suggested replacing the air flow sensor. The problem seems to be confined to one particular cylinder. If the airflow sensor was faulty, would the problem be isolated to one particular cylinder? The air flow senso

I cant solve this problem but i also could use the solution. As i was driving this morning the same thing happened to me. I would put myfoot down an nothing was happening it would only get up to 40 an then the check engine light came on flashing so i ... Mazda 323

Misfire on Cylinder 3 of a 2002 Chrysler Sebring LX (2.7L 6-cylinder engine). I would like to change the spark plugs, but can't reach the 1,3, and 5 plugs even after removing the intake manifold and the ignition coil -- there appears to be not enough space etween the hood (or better lower window part) and the motor to insert the spark plug removal took -- unless there are bendable ones? Are there? Any other way (without lowering the whole motor? I would like to do this in my driveway! Thanks in

You don't have to lower the motor .Ive been in the same situation with the same carI used a swivel adapter . first insert the socket with the swivel on the spark plugthen get an extension and add it to the swivel e ... 2002 Chrysler Sebring

Dead cylinder spark plug has a good spark and distributer has new cap and rotor. Ive checked for vacuum leaks and found none. I had the timing checked and run a diagnostic, everything came back good. Why am I not getting power to this one cylinder?

... 1989 Ford F 150

3.8 L engine missing spark on cylinders one and four. Changed ignition coil pack, but still missing spark on one and four. The ignition module is directly below coils - could that be he problem? The car started missing suddenly.

Most likely it is the ignition module ... 1988 Oldsmobile Delta 88

Vehicle cranks but does not start have replaced crank sensors have replaced cam sensor and PCM only two of my coils fire u can use one of the working coils to check for spark at other coils plugs and there is none...wen starting the vehicle it sounds like its out of time sometimes and others it spens over fine....i am getting fuel to cylinder jus not spark to all cylinders.....at times vehicle will start and run fine for about 1 minute then die after that it wont restart.....can u please help me

Sounds like u need two coils ... 1995 Nissan Maxima

One of the spark plug hole threads in the head of my 2004 Mini Cooper stripped. We have the tools to **** out the hole, and the insert to repair this spark plug hole. What we need is information on the position or location of the intake and exhaust ports on the cylinder, so we know where to position the cylinder properly. Please refer me to information (book, person, online source, whatever) that will describe or show me what it looks like. FYI, my husband is a gifted mechanic, he jus

These forums below can help you obtain information on the position of intake and exhaust ports of the cylinder\015\012\015\012 ... 2004 Mini Cooper

Random misfire cylinder 1 code check. one spark plug wire #1 differant wire than rest hard one to get to. can't get #1 plug wire tight enough around think it is the wire, have new gas cap reset code stayed off for a while wire loosend up and check engine light came back on, thought i would replace all wires (Spark) code check it see if it runs better and reset code, you think?

Yes if it is loose can cause a misfire replace the wires as a set ... 1998 Chevrolet Cavalier

I have a 1987 mercruiser alpha one out drive the boat sat for 5or 6 years engine turns over but no spark also had water in the cylinders drained the oil filled the cylinders with mystery oil let it sit for a few days cranked the engine a few times drained the oil again new oil new fuel new oil filter but cant get a spark from the coil

Alpha One is the out drive, what engine do you have? Remove the distributor cap and verify if your ignition is electronic or contact points. Either way, I recommend going with a Pertronix electronic ignition. This module is a simple drop in installat ... 1986 Chevrolet K1500

There's no spark on cylinder #2; a specialist swapped the leads and the coil pack with a good one with same result. Is this going to be the ECM? or is there something else that determines whether spark gets sent to the cylinder? Diagnostics were not helpful; Tells us what we know; Please help Leon

Quite simply, the power(or "driver") wire needs to be traced back to the ECM and ohm'd out to see if there is a break. If there is no break found, it is going to be the driver inside the ECM itself and the ECM needs to be replaced. Let me know what y ... 1998 Audi A4

I have a 96 camry with a 3.0 v-6 1mz-fe engine. it has three coils which are attach to the left head 2-4-6-cylinder and has three spark plug wires, one from each coil. which spark plug wire goes to which cylinder 1-3-5

Back: 456\015\012Front: 123\015\012\015\0121 links with 6\015\0122 links with 5\015\0123 links with 4 ... 1996 Toyota Camry

I screwed up my 1999 Saturn SL 1.9 SOHC spark plug wiring while trying to put in new one. I tried to do each one separately but the saturn's have a wiring holder i just couldn't get apart to do this. what I need is from left to right looking at the engine spark plugs which cylinder goes to which coil terminal from left to right. There are four coil terminals Please help I am desperate. I can get the car to start and run but it runs really really rough now and I dare not drive it. Stalke

... 1999 Saturn SL

I changed all 4 spark plugs and the ignition coils, but the one spark plug i didn't change personally popped out and now there is no threading on the cylinder head to tighten it back up. is there a way to rethread the cylinder head and if not how do i change it out?

A repair shop can install an insert to repair the threads. ... 2002 Kia Spectra
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.3391 seconds