Having problems with your 1994 Honda Passport ?

I have a coolant leak on the line that comes off the bottom of the radiator and goes into a metal line that heads under the motor behind tha altanator

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

If the coolant is leaking then there is nothing one can do except replace the hose that is leaking. Please do that.
Repair Help & Product Troubleshooting for 1994 Honda Passport

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a coolant leak on the line that comes off the bottom of the radiator and goes into a metal line that heads under the motor behind tha altanator


If the coolant is leaking then there is nothing one can do except replace the hose that is leaking. Please do that. ... 1994 Honda Passport

How to replace metal coolant line behind engine heading to rear heater. It is spraying coolant when engine is turned on. The line starts under the passenger side floorboard and goes up behind the engine. THANKS


If you can see a small hole , and you can get to it, you may want to try to repair this there are products out there that dry in seconds, and are strong as hell.\015\012\015\012 I used duramix to seal a rear main seal , 2,000 miles later ... 1999 Plymouth Grand Voyager

Coolent leaking (dripping out pretty good ) behind the motor on the ground after filling up to the jug and motor off. Looking under the motor from the front end I see a rubber hose connected to what looks like a flat metal line running to the same area of the leak. Antbody have any ideas??


I don't know the exact "official " name for it, but the flat metal pipe is used to transfer coolant from one location under the engine to another destination. Being metal, they do rust and leak. You need to get the car on ramps or a lift and get an e ... 1998 Pontiac Sunfire

I took off the old brake line except there is a bolt that connects it in the very rear of the truck above the axel and that bolt is rounded off with about an eigth of an inch old brake line in it, and that nut is totally rounded off thanks to the previous owner, if you follow the rest of the piece it goes to a thick black house but there is some sort of metal piece that is squezed tightly than that goes to the axle, all I want to know is does that metal piece on top of the rubber house come off


Try grindin off the head of the bolt remove the flexline then remove the bolt with vice grips ... 1992 Ford F150 SuperCab

Nissan 300zx twin turbo, VG30DETT motor. coolant in oil. just finished rebuilding the motor and block and heads have been decked and squared to meet up perfectly. head bolts have been torqued down properly. the head gasket is not in question as i have perfect compression. when taking the motor apart the first time i noticed that there seem to be coolant lines running in the lower intake plenum right next to the air passages and i was wondering if it were possible for it to leak out of that area


If car has a oil cooler that uses coolant to lower oil temp. check that, if not you might want to get a coolant psi tester and try locating leak that way. but my expierence is that a head gasket problems cause this also if block was bored and machine ... 1991 Nissan 300ZX

Coolant is leaking out of the metal line that the heater line goes into


... 1996 Dodge Caravan

Brake pedal only goes to the floor with motor running, with motor off the brake pedal is firm...Here's what's been done to this point, I replaced the Master Cylinder & Brake Booster and yes I've checked what vacuum lines for pressure loss someplace but nothing seems wrong ( I replaced the parts due to brake pedal going to the floor with motor off before after attempting to bleed) I then flushed the lines and bleed the front brake calipers old school with someone pumping by foot and


... 1987 Honda Accord

How do i replace blower motor in 1992 ford tempo. the blower motor is behind the glove box but can't get it out because of metal bar. How do I remove the metal bar to get the blower motor out


... 1993 Ford Tempo

I found a cracked vacuum hose under the battery box that I think goes to the cruse actorator but when iwent to repair it there is another hose that heads out towards the head lights that came off too . I don't know and cannot find where it goes it is about 6 inches long and Icannot find a vacuum diagram on line to help me . It is a V 8 can you help me ?


I'm betting your lines are 1 small 1/8 hard plastic line and 1 is like 5/16 rubber. after a tear down I found a 6 inck vacuum ball in the bumper ... 2001 Jeep Grand Cherokee

2005 town and country rear ac line removal behind rear wheel . I have a leak at the fittings under the van behind the right rear wheel. I suspect a seal but cannot remove the lines. there is 1 nut which holds a plastic retainer on a center bolt that has a torx head. Is there a special tool or technique involved in removing the retainer?


... 2005 Chrysler Town & Country

I have an 87 Fiero with a v-6. There is an electric valve just above the accessory drive belts on the right end of the motor with a small vacuum line connecting to the intake manifold, and small lines that go to the cruise control. On the front of the valve is a 1/4" diameter hose that goes forward to the firewall and apparently goes to the bottom of the fuel vapor canister. When I connect that hose, the cruise still doesn't work, and I get a check engine light telling me that the EGR val


Have a wander down the scrapyard and have a look at another vehicle the same for the vac pipe layout ,but although iam not familar with this vehicle i would hazard a guess and say that the vacumn comes from the manifold into the valve then when engin ... 1987 Pontiac Fiero

Metal coolant line underneath motor


If you have prestone leaking there our intake gasket broken ive done a lot of it pierre ... 1999 Chevrolet Malibu

I am having trouble getting to rear brake lines to remove and replace. The issue I am having is that the lines go into the frame in front of rear dif. which is behind the body's back seat. there is very little room to get a line wrench to turn. On the otherside of the same location the line is rubber down to the rear dif. then metal line splits to each break. what is the best way to remove one line from the frame without breaking the other? does the junktion box come out?


... 1993 Cadillac Fleetwood

Hi, I have a 1994 Ford Aspire (manf. by Kia Motors) that was running great until I shut it off for the night.. This morning, engine turns over but doesn't start.. Tried sucking on the gas line that goes into the carburator.. Sucked gas thru the line (yes, spit it out) and reattached gas line to carb.. She almost start but---didn't.. Pulled the gas line back off the carb and cranked her over.. No gas coming thru the line.. Where is the fuel re-set button located, also where is the fuel pump f


Check fuel pump relay under left side instrument panel also remove back seat pull back carpet remove access panel n ck for power at pump ... 1994 Ford Aspire

The blower on my 2003 Ford Expedition won't run, not on low, med, or high; not with A/C or heat. I've looked on line and found the likely cause(s) are bad blower motor resistor, blower motor relay, or the blower motor itself. I'm fairly handy (though an amatuer with cars). I'm planning on replacing all three, but I'm having trouble locating them. I've looked under the dash on the passenger side (and also behind the glovebox. Everything I've seen online shows the blower motor as a round (lar


Hi, the problem is either with the blower resistor or blower motor relay.\015\012\015\012\015\012The blower resistor is located behind the glove compartment inside the cabin. Simply release the glove compartment and this opens the area ri ... 2003 Ford Expedition

I have a 2004 Verona. It has a slight oil leak coming from the back of motor but it is high up on the motor. There is a line that is broken that goes to a vacuum motor at the top backside of motor. Could this be the problem?


... 2004 Suzuki Verona

A person replaced the motor in a 1995 s-10 pickup 4x drive. And not all the vaccum lines are hooked up. Do you have a diagram of the vaccum lines so we can get the 4 wheel drive to work. All other parts were checked and are working, there is just one line we don't know were it goes? Thank you!!!!!!


You can give these websites a try www.autozone.com and www.alldatadiy.com if all fails stop by your local GM ... 1995 Chevrolet S-10 CA Edition

Transmission line The line in front is leaking transmission fluid. It's the line that is in front goes to the radiator. It's metal and part rubber.


... 1999 Ford Contour

Where can I find the heater hose diagram for a 2002 mercury sable gs?I have been having so many problems with my water leaking everything keeps messing up. In the last 1 1/2 years my cooling system has falling apart. First the water tank exploded all over my motor (I have rusty looking stuff all over under my hood), then the metal heater hoses behind the motor broke. I had it rerouted with rubber hose (when the guy rerouted the hose he didn't go all the way to the other side of the motor he ju


AB HAYNES MANUAL MAY HELP YOU, YOU CAN GET THEM ,AT AUTOZONE,ADVANCE AUTO PARTS,NAPA they show a complete tare down and re build ... 2002 Mercury Sable

1984 2.2L horizon vapor locks metal lines from fuel pump there are two they go from pump behind the radiator which sucks hot air right on them then up engine to carburator and tank i guess if i insulate them will it fix it or do i need rubber lines or change direction of line will that cause a problem


Shield them with alium. foil for best resualts ... 1984 Plymouth Horizon

Hay ive put a new motor in my Isuzu mu and runs heaps more power but when i take my foot off the gas and *** to stop and it just rips out with blue white smoke lots off it and when i put motor in the vacuum hoses were disconnected so didn't hook them up on new motor as i don't now were they go only the diesel pump has a vacuum line hooked up and the rev counter isn't going also. could that be causing it to smoke when coming to a stop and would you have a diagram for what vacuum hose goes were an


The vacuum lines attach right before the compressor if the turbo - there are special nozzels for that in the intake piping. And no, they have nothing to do with the smoke. The blue-white smoke is coming from burned-vaporized oil. There's a majo ... 1993 Isuzu Trooper

The hydrolic clutch line has a leak just inside the fire wall where the line goes from metal to plastic. Can barely see it much less fix it. Is there a way besides removing major parts? 1995 3500 Dump body with 45,000 miles.


No there aint a easy way to do it...yu will need a new slave cyl ... 1995 Chevrolet C/K 3500

How do you change the rear brake line that goes between each wheel, the brake line that is metal..


You are going to want to soak the connections several times over a couple days with something like WD-40. Brake lines are tough to remove due to rust, and this will help. Pick up a set of good quality brake line wrenches also. They are designed sp ... 1999 Chevrolet Blazer

Open end vacuum line . it connects somewhere but where? on a 3.3Ldodge motor from the throttle body goes to the back of the motor,but seems like nowhere to hook it up


Visit honestautoestimates.com for solutions to this issue and a free estimate of repair cost. ... 1992 Dodge Caravan

What is the part called that is attached to the side of the trans and faces toward the radiator? It has a metal vacuum line feeding it and a rubber hose connecting them both. It looks alot like an EGR valve and it is located a little lower and to the side of the exhaust near the EGR, it has one nut holding it and goes to the tranny. The rubber hose connecting it to the vac line is cracked and dry rotted and this part looks original. It is moving around while I am trying to find a vac leak. I kn


THAT A TRANSMISSION MODULATOR VALVE.CHECK IT WITH A HAND HELD VACUUM PUMP.PUMP IT UP TO 10HGS TO 18 HGS.IF MODULATOR HOLDS VACUUM ITS GOOD.IF IT DONT HOLD VACUUM.AND IT LOOKS LIKE TRANSMISSION FLUID COMING OUT OF IT.REPLACE IT.MAKE SURE ITS GETTING ... 1994 Pontiac Bonneville
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.2938 seconds