Having problems with your 1994 Chevrolet Cavalier ?

No fire on 2000 chevy cavalier - 1994 Chevrolet Cavalier

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

To check timing position I suggest doing a compression check to see if there is compression 100 psi or better evenly across all cyl. if you do not then I suggest replacing timing chain and valves. if the timing did jump then it did bend valves. sometimes it will even crack the head. so I suggest a complete head check if that is the case. also do not reuse old head bolts. not a cheap issue to fix but if the car is in decent condition, its worth it.
Repair Help & Product Troubleshooting for 1994 Chevrolet Cavalier

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Firing order for 1988 chevy cavalier z24 2.8 - 1988 Chevrolet Cavalier Z24


Here you go.http://autorepair.about.com/library/firing_orders/bl-fo-10962.htm ... 1988 Chevrolet Cavalier Z24

No fire on 2000 chevy cavalier - 1994 Chevrolet Cavalier


To check timing position I suggest doing a compression check to see if there is compression 100 psi or better evenly across all cyl. if you do not then I suggest replacing timing chain and valves. if the timing did jump then it did bend valves. somet ... 1994 Chevrolet Cavalier

My 1998 chevy cavalier will not fire - Cavalier Chevrolet Cars & Trucks


Battery good? will it turn over?if good and turns over, check fuses on ignition; might be under hood near battery and also check the ones under dash. get a diagnostic tool and plug in and get codes will be the fastest way of finding out ... Chevrolet Cavalier

My 2000 Chevrolet S10 ZR2, 147,000mile is miss firing and hesitating. Comes up with codes P0301, #1 cyclinder misfire and p0453. I took my truck to Chevy garage and they did a compression test, came back ok(120psi)in all cylinders. Had cyclinder leak down test proformed, 100% leak. I took the heads off when i did #1 push rod had some carbon build up. Had them sent to a machine shop, they were pressure tested and decked. They said heads were fine. I have replaced, Distributer and module,Distrib


I have done a full engine replacement on these, a zr2 to be exact. I have found that a p0300 (multiple misfire) usually points the the Piece of **** injection spider, then I had a p0301 as well after replacing that with the multiport unit upgrade an ... 2004 Chevrolet S-10

2000 chevy cavalier will not fire - Cavalier Chevrolet Cars & Trucks


... Chevrolet Cavalier

Firing order for 93 chevy cavalier - 1993 Chevrolet Cavalier


... 1993 Chevrolet Cavalier

Im not sure of the correct firing order for a 93 chevy cavalier 2.2 litre and how are the spark plugs numbered from left to right 1-2-3-4 and how are the distributor posts numbered from top to bottom 1-2-3-4?


For the 1993 Chevy Cavalier 2.2L:\015\012\015\012Firing Order:\015\0121-3-4-2\015\012\015\012Cylinders:\015\012........(back)\015\0121......2 ... 1996 Chevrolet Cavalier

Firing order for 1991 chevy cavalier - 1991 Chevrolet Cavalier


4 or 6 cyl...? [email protected] ... 1991 Chevrolet Cavalier

1996 Chevy Cavalier not firing on 1 & 4


The engine computer can tell the ignition module to change the timing but it doesn't control the spark , the module does. So if you are loosing spark on 1 and 4 it is not the engine computer or the wiring going to it. The problem has to be a plug, pl ... 1996 Chevrolet Cavalier

Firing order for 1998 chevy metro 1,0 liter three cyl.


... Chevrolet Cars & Trucks

1988 chevy nova number 1 cylinder not firing - 1988 Chevrolet Nova


... 1988 Chevrolet Nova

What is batt 1 fuse on a 2000 chevy cavalier - Chevrolet Cars & Trucks


... Chevrolet Cars & Trucks

1 & 4 on the coil pack is firing 2 & 3 is not. I would like to know if the module is bad? Have a 1991 chevrolet cavalier rs.


... 1991 Chevrolet Cavalier

94 chevy caliver 2.2 litre firing order - Cavalier Chevrolet Cars & Trucks


... Chevrolet Cavalier

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil


Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

1993 Chevy Cavalier 2.2 not firing on 2 cylinders


The reason I'm asking this is because a dual coil fires BOTH plugs at the same time. If one plug doesn't fire right, the other won't either, even to a point that neither does. Kepp the coils where they are and swap the plugs and wires and see if you ... 1999 Chevrolet K1500

1993 Chevy Cavalier 2.2 not firing on 2 cylinders


You can test it but removing wires on the coil. they should have same strength as 1 and 4. if they are weaker then you have a bad coil. if nothing happens your have a bad module.\015\012if you want put the 1,4 coil on the suspected bad tabs on ... 1993 Chevrolet Cavalier

1999 chevy s10 blazer had to the shop twice first time running rough eng. lite on smelt like salfer shop hooked up to comp. said cyl. 6 miss fire ran a eng. vac on it or others words injuction cleaner. ran ok for a while last week started running bad again took in said cyl. 1 miss fire so thay ran an other eng. vac. on it check light went off and with in 2hrs ran rough again and eng. lite back on and died got it going took to shop said cyl. 1 miss fire what should i do know tried of spending all


Can't say for sure that its a definite fix, but sulfur smell generally indicates a catalytic converter failure. Running injection cleaner through the system will sometimes also partially clear the problem in the cat but it quickly returns. If the sho ... Chevrolet Blazer

Fireing order for a 2003 chevy cavalier


... 2003 Chevrolet Cavalier

1998 chevrolet cavalier cylinder 1 misfire - 1998 Chevrolet Cavalier


... 1998 Chevrolet Cavalier

MY son thinks he got the firing order on my Cavalier wrong. Can you give us the firing order on this vehicle please-1989 Chevrolet Cavalier Z24-2.8


Hi! Please check out the link I provided to guide you on 1989 chevrolet cavalier z24 firing order. HOpe this helps and thank you for using FixYa. Please click here ... Chevrolet Cavalier

2003 chevy cavalier 2.2 auto. 2003 chevy cavalier 2.2 auto. Without a/c, everything is normal. If the a/c is turned on, the engine rpms will go to between 2,000 and 3,000 rpms. If you shut the a/c off, the rpms will return to 1,500, but won't return to normal until the engine is shut off.


... Chevrolet Cavalier

I KNOW THE FIRING ORDER OF A CHEVY 350 IS 1-8-4-3-6-5-7-2. i NEED TO KNOW WHERE #1 Is. I have put #1 wire at the 6:30 position facing from the front bumper, and all I am getting is backfire!


This help? ... 1994 Chevrolet Silverado 2500

I have a 1999 Chevy Cavalier Z242.4L and it is miss firing i replaced the coil cover and the car stoped miss firing and ran good for a month then it started to do it again so i checked my oil and i was low and dirty so i gave it an oil change and started it up and now it miss fires more got alot harder knock now. what will make it do this and how can i fix it please help?


The misfires and the knock are likely two different problems.\012Find the darkest place you can and with the engine at idle, open the hood and look along the ignition wiring for and arcing from the cables.\012GM uses miserable ignition cables a ... 1999 Chevrolet Cavalier

Cherolet celebrity i have a 1989 chevrolet celebrity that is only firing on two cylinders and i have changed the spark plugs, the coil packs, my firing order is 1,3,4,2, my car is starting but its not firing on cylinder two and three what could be the problem


Your problem is the ignition module that is mounted under the ignition coils. This would have to be a 2.5. Good luck ... 1989 Chevrolet Celebrity
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.0264 seconds