Having problems with your 1993 Pontiac Sunbird ?

Trans moter mount replacment

\015 Were is transmission engin mountso i can chang it?i found the left and right mounte,so i know its got to be trans\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1993 Pontiac Sunbird

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Trans moter mount replacment


... 1993 Pontiac Sunbird

1994 gmc sierra 1500 pickup 4.3 L. v6...I am dropping trans pan to replace filter and gasket and add fresh trans fluid....the rear pan bolts are obstructed by a cross member and trans mount....I can see bolts on each rear corner of the pan and also one bolt in and I can get on the ones that are in from the corner from above the cross member, but is there one in the center above the trans mount ? does the cross member have to be removed to do this job or not?


What you do is loosen or remove the cross member first\015\012\015\012Then you decide,if using a small air driven cut off wheel to\015\012remove some metal from cross member,will help remove \015\012the trans pan in the future ... GMC Sierra 1500

Trans/clutch I have a 98 S10 4cyl, 5 speed, 165,000 miles, it pops out of 5th gear when im driving and i left off the gas pedal (rear trans mount replaced 1yr ago) same type of deal when in reverse, while backing up let off gas trans pops out of gear. the shiter its self is loose in all gears, as far as i know the clutch has never been replaced, but clutch is still decent. i have been told to adjust the clutch cable, but i dont know where to look, CAN YOU HELP PLEASE?!!


Im sorry the clutch cable wont help you here. you have a bent shifting fork that will not allow the trans to completely engage into the gear. put power to it and it pushes it out of gear.sorry it need to come apart. ... 1998 Chevrolet S-10 Pickup

I have a 99 chevy silverado reagular cab 4.8 manual trans . the engine has a vibration around 1500 to 2000 range . i thought it was my u joints until i stting in my drive way one day reving it and the vibration was there will in neutral . make the whole truck shake . while under it i had a friend rev it to see if motor mount or trans mount was bad nope . couldnt even here it done there just seen exhaust rattling no misses no codes . just replaced both knock sensors so no problem there changes sp


Ck balancer on front of crankshaft ... 1999 Chevrolet Silverado 1500

2005 ford five hundred limited 2wd 6spd trans 139k miles. Recently replaced mounts thinking that would stop the trans from downshifting hard at stopping. But since the replacement the rpm will not go over 3k and shifts hard then instantly drops down to 2k


What you might try is changing the Trans fluid and putting in a new Trans filter or cleaning the filter if it is not disposable. If this does not help before replacing parts on the Trans ask if your Model has a Software fix.\015\012\015\ ... 2005 Ford Five Hundred

Motor and trans mount replacements


The part number for the trans mount is the same for the 2, 2.3 and 2.5 liter engines. It is 4356184. It is $51.00 for the aftermarket Febi/Bilstein and $125.52 for the OEM Saab part. The 2.3 liter mount you want to use will work, but only if it came ... 1998 Saab 900

Need to replace the superchager belt, i know that it isn't easy, remove the lower moter mount spacer of the idler pully mounted inside the mount? '96 riviera


If memory is correct it should be driven by the serpentine belt, which runs through one of the engine mounts. \015\012\015\012To change the belt you'll need to support the engine (by something other than the ... Buick Riviera

Motor Vibrates At around 220 thousand miles my van motor began to vibrate, I took it to the transmission place that rebuilt in at 188.000 miles. They said it was the motor & trans mounts needed to be replaced. It got worse after they replaced them at a cost of 450.00. I had acomplete tune-up from the GMC dealership, still vibrated. The Transmission place said it was the harmonic balancer, I replaced that and the lower pully, still vibrates. It vibrates more when in gear, when stopped I ca r


IF your ****** was removed and re-installed there is a good possibility that there is a problem withe torque convertor. either it is not installed or seated properly or the weight block welded to it may have come off. Also your flex plate ( the part ... 2004 GMC Safari

Engin trans mission moter mount


... 1993 Pontiac Sunbird

Vibration coming from the floor area at stopped position. it goes away somewhat if i shift inot nuetral but is still noticable. I have had all 2 motor mounts and the trans mount replaced to try to fix this. they were originals anyway. thanks for any suggestions


Vibration ...have a 2nd person start the vehicle and visually look under the vehicle while the car is in drive and brake applied ...unless its Manuel shift then i would suggest something of a different procedure to testing ...are all the exhaust moun ... 1993 Chevrolet Cavalier

For some reason my 98 honda accord 2.3 engine. Its starting to jerk slightly when I drive over 45 miles an hour nd I break to a complete stop thats when I feel the jerk. Sometimes the jerk can be harder than others but not real hard. mechanic got belts replaced, put on 4 engine mounts on, replaced trans fluid,sealed valve cover gasket and added a lil bit of oil. Car drives smooth now. I put it on drive,reverse and park. The only problem I have is the jerking when I brake. What could this be??? P


... Cars & Trucks

Same problem My mounts was just replaced,i have a 2000 nissan maxima. two days ago! I wonder what it is?What to do from this point-I WAS WONDERING IF IT WAS THE TRANS. MOUNT???I only changed 3 of them.


... 1997 Chevrolet Malibu

The nissan 3000 is front wheeldrive the 1997 nissan is not can i seperate the motor n trans turn the moter n mount it to the 1997 pathfinder trans


I would venture to say no. The engine might bolt up to the transmission, but I do not think it will have the holes needed for the motor mounts. ... Cars & Trucks

I replaced the transmission in my 2002 f 150 and the shift linkage doesnt hook up proper. The mounting bracket on new trans is too close to trans itself and has to bend to hook up.


There is a cheap kit which is available (and often used on everything from motorcycles to lawnmowers) which will let you shorten the shift linkage cable. Basically the cable is cut to the appropriate length and then a new tip is added to the now bar ... 1998 Ford F150 Regular Cab

I have a 94 mazda b2300 4cyl 5 speed. It runs fine at an idle. but when you reach 4th and 5th gear the truck starts to **** the motor and transmission,like a surge.and continues until you press clutch in. I replaced the m mounts and trans mounts. checked the coil packs and DIS module. all good. what else could it be?? note: checked carrier baring and u joints and universals too


Replace the fuel pump and fuel filter. ... Mazda B2300

Any other way to to replace the serpentine belt from a 1997 park avenue without having to raise the moter mount...there is a mount that blocks the belt from sliding off


Yes at the bottom by the air conditioning compressor is a spacer/bushing that runs through the mount and into the block.I think the nut is an 18mm it is on a stud that is an inverted torx towards the bottom.Many times removing the nut will also unt ... Cars & Trucks

Ex-wife had used this 99 626 Mazda 4 cyl for 4 yrs and said it vibrated so bad at idle she had to put it in neutral[automatic trans] at stop lights with the a/c on. When I used it she was right. I found low compression on 2 adjacent cylinders, 30-60 psi. Pulled head,had valve job done,honed cylinders, installed new set of std rings[piston ring grooves still tight],new timing belt,all engine & trans mounts changed,idle air control valve replaced,new platinum tipped spark plugs, water pump, idler


Check to see if the big hose going from the air filter to the throttle body has a split in the hose convolutes. Thus air is bypassing the MAF sensor. IS CEL light on? Clean MAF sensor wires with carb cleaner too. rpeort results. ... 1999 Mazda 626

How do you replace a trans. mount on my 97 oldsmobile 88


... 1997 Oldsmobile 88

Need to replace a front trans mount.


... 2001 Oldsmobile Aurora

My 1994 caravan shakes severly while driving.I lifted the front end and started the engine,i noticed the engine swings side to side.I have already replaced the motor and trans mounts,both axels,wheels,tires,bearings,rotors,and brakes.I havent had any luck with the problem what do you recomend.


Have the tie rod ends been replaced? is the rack ok, no excess movement? the engine movement is normal, the mounts are very soft to isolate engine vibration, also check the free play in the ball joint, remember a little play ... 1994 Dodge Caravan

In 5th gear of an automatic transmission at 65-70 km per hour and between 1500 and 1750 rpm the car starts to resonate or shake.But once I slow down or speed up it goes away. I have checked the transmission fluid level and quality and engine mounts they are ok. The trans. fluid was replaced about 18000 kms ago and the car has about 90000kms total. When I try to recreate the problem in neutral it doesn't shake.


Bad tire or sterring wore ... 2006 Mazda 3

I am in arizona trying to fix Moms 1990 accord LX The engine shudders at idle, I replaced the front motor mount, clearly bad, however it still has the steering wheel viberating while at a stop in or out of geat /automatic trans. Also the chech engine light is on, the (S) sport setting light on the dash starts to flash after just a few moments of running and the button on the shifter has no reaction to being depressed or relaesed. Also the speedomiter will work just at random so I went on line


The trans also has a mount that may be bad.Jack the car up and look to see if the cv axle is almost sitting on the frame. This could also be your problem Usually when one mount goes bad there is bound to be others..The trans has solenoids that are co ... 1990 Honda Accord

1995 3 door auto has a grinding/cluking sound when turning hard left at slow speed that comes & go's,on the front left or rear left &some times on front right,replaced front&rear dif mounts told it may be trans,cv,axals,wheel bearings,etc ?????? help pls


Clicking is usually due to a bad axle shaft. ... 1996 Toyota RAV4

I have a coolant leak after removing a stud from moter mount when replaceing serpentine belt how do i fix


More than likely this stud you removed was one of the front cover blots, that actually works to seal the front cover up also.Remove that same stud again, and install some thread lock onto the bolt, then re=install it.This should correct your problem, ... 1996 Buick LeSabre

1999 Chrysler 300 M. intermittent thumping noise from front seems rotational in timming but not consistant or continious, most often on smooth pavement and right hand curves but inconsistant. Both CV axles have been reciently replaced with new units. Motor and Trans mounts seem to be OK


... 1999 Chrysler 300M
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.8657 seconds