Having problems with your 1993 Nissan Pathfinder ?

Have 93 pathfinder came out from work and found brake lights on and wont go off can manually push switches at pedal and they go out - low on funds - can you recommend what i need to replace

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

You are going to have to buy a new brake light switch. cheaper at a parts store than a dealer.
Repair Help & Product Troubleshooting for 1993 Nissan Pathfinder

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Have 93 pathfinder came out from work and found brake lights on and wont go off can manually push switches at pedal and they go out - low on funds - can you recommend what i need to replace


You are going to have to buy a new brake light switch. cheaper at a parts store than a dealer. ... 1993 Nissan Pathfinder

I need to know where my egr valve is and upper penium so that I can remove the egr valve the easiest way. I am a woman but I have to do it myself and I could use a diagram or good instructions and the typpe of sockets I need besides 1/4" socket. I want to clean egr and put it back. I am on low funds and this is the second time I have problems with this. I replaced once years ago and it is just about dying again at stoplights just like before. I NEED' HELP ASAP PLEASE?I have a 93 GMC Safari van 6


Nikki, sorry I don't have any pictures of your EGR valve but a lot of parts stores have on line catalog so you can see what it looks like. The EGR valve is there a two bolts that hold it to the intake manifold s ... 1993 GMC Safari

07 mitsubishi endevor, will not start when cold, can crank engine till battery gets low, although it will eventualy start if the gas pedal is held to the floor. a mitsu dealer had my vehicle for roughly 5 days and gave me a "throtle body cleaning" and a "decarb", whatever that means, and told me the sparkplugs needed replaced, in an effort to sort out the issue. they told me the feul system is fine but i found no evedence that it had been checked. i personaly replaced the spark plugs only to fi


... 2007 Mitsubishi Endeavor

I have a 2002 FWD 4 cyl. Santa fe. It has 193000km on it. The clutch is engaging at the very beginning of compression of the pedal. I was wondering if this is an indication that the clutch needs replacing or not. Is there a recommended KM to have it replaced?


You are correct. If the clutch comes in at the very top it will start slipping soon ... 2002 Hyundai Santa Fe

My Toyota corolla Gli auto tranny suddenly low idles and shaking during stop as while stepping on brake pedal, could it be my fuel pump need to be replace anew?


... 1993 Toyota Corolla

2002 Chevy camero - code p1221 - replaced throttle body & accelerator pedal module. Low engine light came back on?? Does computer pick up new part or do I need to have it programmed for new part?


If u did changed the part then that means u got to re-program the computer ... Chevrolet Camaro

I hav 2001 ford taurus 3.0 single head cam engine makes noise , mechanic said that oil pressure is low n need change oil pump. but oil light not comes on always, it becames on only driving, when I release the accelator pedal I want to know where the pump is , how hard it is to replace pls let me know asap.


That sounds like a pump... the oil pump is inside of the engine. You need to drop the oil pan to gain access - however, you will need to pull the motor to do that. ... 2001 Ford Taurus

My 2007 Cadillac SRX feels like it needs a tune up. It runs so rough and misses & sputters. Driving at low speeds it barely moves. Yet the check engine light isn't on. The car only has 67000 miles and has had two timing chains replace in the past two years. What can you recommend?


First when was last tune up? that's a place to start. But for the sputter/miss sounds like a case of moisture/condensation in your fuel. Not necessarily bad gas but with big temp swings moisture and condensation build up. Try running a bottle of STP ... 2007 Cadillac SRX

PO406 Code I have a 2005 Dodge Caravan SE. The engine light came on and I took it to get checked...the computer found it had a PO406 Code. Which means that the ECM has detected the EGR position senosr voltage was too high. I am low in funds due to lossing my job...my question is, How much would it cost me to have it fixed? Does the valve need to be replaced and how much would it cost? Can I keep driving it for short trips to the store? Thank You, ALicia of Houston, TX


I have 2005 Dodge Caravan SE 2.4cc and the code is P0420 I need now what is the exactly problem. all ways when I try to stop the engine turn off or almost turn off. ... 2005 Dodge Caravan

I have a 1999 4.0 Jeep Wrangler with manual transmission. It has been making noise for some time when the clutch is depressed. Today while driving, the clutch seemed to go out. The pedal went all the way to the floor and won't depress the clutch. Does the clutch need to be replaced or could it just be low on fluid?


... 1999 Jeep Wrangler

92 960 2 questions Q1 : transmission (when warmed up ) will sporadically engage into overdrive , in low speeds , then frequently engage and stay engaged into overdrive when stopping (like a manual transmission without disengaging clutch pedal ) have replaced all switches :transmission neutral safety , and 3-way power ,economy and ice mode switch , with no effect on condition . Does need transmission fluid changed ,but was told that would affect overdrive condition Q2 : noticed that hydraulic li


1st thing to do is run a self test of the trans for trouble codes, sounds like a problem with the electronics, may be a poor trans connector connection or a solenoid issue in the trans.\015\0122nd if the oil pressure is low and by your descript ... 1996 Volvo 960

Brake pads need to replace brake pads on 03 envoy xl 6 cyl. from low to high is a difference of 80.00 what is recommended for the car


How to replace lock on glovebox latch 2003 Envoy? ... 2003 GMC Envoy Xl

Manual says Shift Lock Release issue may be due to low voltage battery, less than 9V. The Shift Lock Release problem started shortly before the Malfunction Indicator Lamp problem began. Could low voltage battery be related to the Malfunction Indicator Lamp lighting up steady? If the voltage being low is the cause of the Shift Lock Release problem, how can you tell which, the alternator, belt, or the battery, needs to be replaced or serviced? If the Emissions Controls needs to be replaced, how mu


Go have battery and alternator tested at an auto store such as auto zone/advanced auto or such most auto stores offer this service for free and as to the code the store usually this service for free also ... 2004 Saturn ION

Need to replace the Air Compressor on my 2002 Sant FE. Hyundai Dealer recommended "only" the compressor needed to be replace. Although I am not an expert on air conditioning, this made me skeptical having them do the repair. I always understood that when you replace the compressor that you usually replace the receiver/dryier.or the system will fail again. The Hyundai Dealer said that only "the compressor " needs replacing" Should I be looking for another repair shop?  Looking under the ho


The dryer element is separate from the compressor and can be replaced separately. It may be that the dryer element is fine. I would trust the dealer to know. ... 2002 Hyundai Santa Fe

I have a 2008 acura tl-s with 7600 miles on it. I just brought my car in this past Saturday for it's B1 service. I was told that the brakes are very low and need to be replaced. The service request writer showed me the car, with the wheel on and pointed t o a metal tab near the brake caliper and brake pads stating that tab shows the brake pads are low and need to be replaced. I just checked my car now and I still see the same tab. I want to know if that sounds right, what that tab is for, s


The tab is to let you know when you need brake's, it will make an ugly squeeky sound when it rubs on the brake rotor, that you will want to have it check out, I think there trying to get over you, but that's only my guess, with out me looking at it. ... 2008 Acura Tl

Brake pedal needs to be depressed very hard to stop,pedal is mushy,pads and shoes have been replaced, rear wheel cylinders have been replaced.calipers have been replaced, front brake lines have been replaced,master cylinder has been replaced,brakes have been bled till they run totally clear. seems like front brakes will lock up on snow and ice and skid this is a 1996 suburban k1500 with 112,000 miles,I'm completely stumped what am i missing?


The pedal goes down a long way(Rear brake shoes out of adjustment) or the pedal is hard to push and you have to about use two feet to stop the truck? (booster problem) ... 1996 Chevrolet Suburban

Well I replaced the slave only,and still I have no pedal at all . the master is not leaking ,and i bled the line.when I atempt the pedal,i check the fluid res,to see if the level changes ,it stays the same.Help please I need a pedal,I need my car back.


I dont know much about honda's, but try looking to see if the release bearing is working. could be leaking there or just not working. ... 1992 Honda Accord

Replaced everything but the power booster. brake light comes on. pedal low. have bleed the brakes. no leaks. pedal still low. but have some brakes just not up to normal position on the break pedal


Brake pedal height is determined almost exclusively by the rear brakes adjustment. turn the starwheel adjuster and spin the tire by hand until the tire begins to drag. more for firmer higer brake pedal. it is only too much if you smell the breaks whi ... Ford Econoline Cargo

Hello, While driving on the interstate my 2000 Dodge Neon just went dead (like running out of gas) just bought it couple days ago. Car was parked in a yard for over six months. Trying to get engine running started few times but pressing gas pedal just killed engine. What I think is that fuel filter needs to be replaced but can't figure how to replace it. I'm hoping that's the problem. My question is if do I need to remove fuel pump assembly or can I get filter replaced without doing this.


"within an aluminum like cylinder were plugs are located deposits of engine oil covering almost entirely the spark plug."\015\012\015\012Those are the Spark Plug Wells you are referring to. I just had the same issue. It sounds like you ne ... 2000 Dodge Neon

2001 I30, gas pedal must be held down to set idle from cold start. My mechanic says the ECM and IAC must be replaced. I found a place that will reprogram my ECM and they say that will work but I also will need to replace the Throttle position sensor and Air intake temperature sensor. My mechanic said the sensors are fine and don't need to be replaced. What do I do?


Hi! Used to work on one too and I agree to your second mechanic. ECM may need to be reprogrammed, throttle position sensor, air intake temperature and the MAF (mass air flow) sensor may need to be replaced. The MAF has big contribution on engine perf ... Infiniti I35

Ac question i was told that i need to replace the accumulator which is easy enough but i was also told i need to replace the ac hose line do i need the assembly or just a hose? and will this come with new high and low and will it be fitted for 134 or r12


The accumulator it's self will have the low side fitting on it, on this year truck the accumulator does not come with the hose assembly, just the accumulator, which hose do you need?The discharge hose will have the high side fitting on it, the liquid ... 1990 Ford Bronco

My cluch pedal on my 2004 saturn ion rides up high sometimes, and i replaced the clip that holds the rod to the pedal. however it has happened again. supposedly its not dangerous but very agravating because the clutch is up so high it makes shifting difficult. Do i need to replace the whole pedal?


No there is an adjustment on the rod you should be able to back the nut off and screw it in farther and that should lower the pedal ... 2004 Saturn ION

Need to replace low beam 2005 sts need to know how


... 2001 Cadillac Sts

My car keeps cutting off. It is a 99 oldsmobile intrugue. I had the fuel filter replaced, but it still cuts off when I drive slow or get cought in traffic. The check engine tester gave the code; P0102 maf vaf a ckt low input, which means that the mass air flow circuit has a low input. I would like to know what needs to be replaced, or what the specific name of the part that I am looking for is.


The code you have P0102 is an indication that the mass air flow sensor is not operating properly. Two choices: 1 Disconnect maf. and run car to see if it runs better,not perfect just better. If o/k replace maf. 2 Check to see if the voltages are corr ... 1999 Oldsmobile Intrigue

I need to replace the high beam low beam turn signal switch on a 96 sephia do i need to replace the column or can i just change the switch


You can just change the switch. It takes about 30 min.The part from the dealer is approx. $300. ... Kia Sephia
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.1592 seconds