Having problems with your 1993 Nissan NX ?

Need to know if you have to left the motor to put a water pump on a 1993 nissan nx 2000 with the 2.0 motor

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1993 Nissan NX

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need to know if you have to left the motor to put a water pump on a 1993 nissan nx 2000 with the 2.0 motor


... 1993 Nissan NX

When the car is in park my car idels at about 1500rpm. When the car is in drive it feels like I am driving in 3rd gear. I have a motor with about 60,000 the mechanic who put the motor in said it needed a idel relearn. I brought it to a nissan dealer and they said it either needs a new Throttle body and if that doesn't work a new computer. I have a new water pump, a new alternator. My car is a 2002 Nissan Altima 2.5L automatic and this is going to cost about 2100 dollars


Try a tbs sensor first(throttlebody posistion sensor)its a whole lot cheaper and esaier to replace ... 2002 Nissan Altima

I have toyota camry that has an idle problem...i changed the tps,I cleaned the iac motor and took the throttle body apart and cleaned it.I changed the spark plug wires and changed the spark plugs,and put a new rotor in the distributer cap,and cleaned the fuel injectors,and put in a new radiator and new water pump,and still my car has no power and idles very high between 1 an 2 on the rpm gage..it goes up and down...i need it to stay idle level 1,but no luck..i did just about everything i could t


Did you check the vacumm hoses ? the one on the EGR, high idle means you have a vacumm leak ... 1995 Toyota Camry

I own a 1990 Chevy Lumina car. I had a new radiator put in it. Then I replaced the jhoses, water pump and thermastat. After refilling the system, I ran the motor for 7-8 minutes idling, then I ran it at 2-3000 rpm for a couple more minutes. 1. The fans never came on. 2. The water in the radiator overflow resevoir was boiling (I could hear it and feel it). Is this normal?


The water in the overflow reservoir never boils. For water to boil, it \015\012requires a constant heat source, since boiling uses up heat energy so \015\012rapidly.\015\012\015\012That appearance of boiling is from steam (or some other v ... 1990 Chevrolet Lumina

On my 1992 4.6 crown vic i am changing the motor and putting in a 1993. cv motor the pullies are rusty on the new motor but the ones on the 92 are nice and in good condition. do i need a special tool to remove the pullies and i want to switch over the water pump also do i need special tools for that also? and do i have to put in a new gasket at the same time on the water pump or is it reusable?


The only pulley that u need a special tool for is the Power steering pulley, the ware pump pulley just unbolts and the pump itself is held into the water jacket by 4 bolts, see photo below, I would not reuse the water pump get a new one.. You shou ... Ford Crown Victoria

What could possibly be wrong when my 2003 chevy trailblazer vibrates sitting still in drive with my foot on the brake? . Have already replaced the left motor mount, the fan clutch and the water pump. smoothes out a little when you put transmission in neutral while sitting with foot on brake. mechanic says there is no problem with tuning of engine.


Check the harmonic balancer ... 2003 Chevrolet TrailBlazer

I have replaced a water pump in a 98 dodge dakota sport after i put the motor back together and put water in it it still had water pouring out of the bottom of the motor. is there a freeze plug or a bypass line it could be leaking from


Yes there are freeze plugs are you sure your hose clamps are tight,is this leak the reason you changed water pump, you need to have this truck on a hoist so you can find the origin of the leak ... 1998 Dodge Dakota

I have a 95 Honda accord I recently put in a timing belt a water pump got a new battery but now the car won't start at all. Here is the story the car was sitting for almost a year before I got it I had the oil changed put motor oil bought new fuses and replace the old ones then I got the timing belt replace with a new water pump. My belt broke and I had to put in another one and I had to buy a head gasket cap I really don't know what it was. So now my car kept dying on me and wouldn't start so I


Fisrt of all your alternator is not charging well n there is something draining your battery but can u explain 2 me more am willing to help you ... Cars & Trucks

Water pump I am going to replace the water pump and the manual calls for top dead center cyl 1. Why? I know I am going to be removing the timing belt but as long as it is marked - why does it matter where the pistons are. Also I #1 plug seems to be behind the gen. mount. Spark plug hard to get any trick? Also how in the world am I going to tell TDC with this set up. I am assuming that piston 1 is top left - how I'm going to determine TDC I don't know at least the way the book explains it - look


Once you remove the timing belt covers,rotate engine,by hand via cranckshaft bolt (only in direction of normal engine rotation,i believe clockwise on that) and aligne all timing marks. At this time your engine is at #1 tdc..Follow manual and change b ... 1993 Dodge Spirit

I pulled the #1 spark plug and put my finger over it and had someone turn the motor over until the pressure moved my finger. I then used a socket and moved it the rest of the way by hand until the mark on the pulley was lined up with tho 0. I put a straw inside the #1 cylinder to make sure the piston was at TDC and the piston was not near the top. I had someone hold the straw and turned the motor by hand and got the piston to the top and was pushing the straw out but now the mark on the pulley i


Yes it can be wrong is the crank in right it could be 180 degrees backwards i have seen it happen. but i dont know how much work was done before this problem email me some more info and i can help you further ... 1985 Chevrolet Chevy

460 ford motor. losing water. no holes I can find. But I put antfreeze in and it pumps it back out the over flow. this is around a 1977 or 1978 year motor. other wise run great. I just put 400 miles on it this week. it never missed a beat. But have to keep good eye on water.


If there seems to be a lot of pressure in the cooling system and the coolant blows out the recovery jug,then you may have a head gasket cracked,otherwise run it with the radiator cap on 1/2 way so as not to lose the cap,but to relieve any pressure,bu ... Ford E-350 Super Duty

I have an 89 22re truck put a rebuilt motor in it and replaced everything else when i did it timing cover, oil pump, water pump, radiator etc and its a standerd shift truck no oil cooler..for some reason slowly my coolent is filling up with oil.This has been doing this since i put the motor in no one can tell me what in the world would cause this can you.


Hi!!\015\012\015\012Your problem is a leaking head gasket, a cracked head, mis-installed oil pump or water pump. I would recheck all the installation procedure and you'll find out the problem.\015\012\015\012If you need installation and ... 1994 Toyota Pickup

I am loosing about 1 gal of water per 200 miles without stop leak. With stop leak it goes to about 1 qt. I have had the head gaskets changed. the water pump changed. Somebody told me is was the heater core so I disconnected it for a week with no change. I appears I am getting back pressure through the radiator overflow tank which may pushing the water out when I am driving. There is never any water (except for the A/C drain. All hoses have been changed. Note I also put a new radiator reservoir


Have you replaced the radiator cap? If so, you have a bad gasket, either an intake or head gasket that under HOT pressure, is causing coolant to leak in to the combustion chamber while driving. ... 2005 Chevrolet Avalanche

I have a nissan largo that cuts out when i put it in gear done a fault code reading comes up with code 1-5 =lean mixture 1 8= ant got a clue code 2 1= IAC valve or its cicuit fault no ignition signal from ECM does it want a ECU or may be a fuel injector pump. thanks marg12 forgot to add it a 96 nissan largo 2lt diesel.


... 1986 Nissan 200SX

Looks like the water pump has gone out in my wifes 1998 honda civic. I want to replace it myself with the help of a retired mechanic but need to know the following questions? 1- Do I have to lift up the engine to get the old pump out and new one in? 2- If the radiator is fine and there is a significant leak in the bottom left of the car underneath the timing belts, is that the correct location of the water pump on the civic? Thanks for your help!


Honda have their water pumpin the timing belt case, it also run with the water pump. so taking out the water pump you have to know what you are doing. you need a person with some experience . or buy the book for your vehicle and do it . ... 1998 Honda Civic

GOT O2 XTEERA 2 WHEEL DRIVE HAVE CODES C1106 REAR LEFT SENSOR 2, C1102 REAR LEFT SENSOR 1, @C1111 PUMP MOTOR. THERE'S NO WIRE'S GOING 2 LEFT OR RIGHT REAR WHEELS 4 SENSORS 1 GOING INTO REAR HOUSING I C.ANY HELP OUT THERE ON HOW 2 FIX? THANKS.


Welcome to FIxYa.com\015\012\015\012Before i go on i need a few things to gather the correct info: I need engine size and how many miles on vehicle \015\012\015\012 \015\012\015\012Regards, Lee Davidian\01 ... 2002 Nissan Xterra

2001 nissan xterra is overheating in idle. Water is leaking behind the fan motor. could it be the water pump. How can you check if it is the water pump.


... Cars & Trucks

I have a 1994 chevy caprice classic. Put brand new radiator, water pump and thermostat even put new fan motors but it keeps running hot and water in the collant jug keeps bubbling after ive been driving for about 10-12 mins anyone know what it could be?? Thanks in advance


CHECK WHETHER THE COOLANT IS PROPERLY CIRCULATING.ALSO CHECK WHETHER THE RADIATER PIPES ARE NOT CLOGGED.ITS ALWAYS BETTER TO USE DISTILLED WATER RATHER THAN NORMAL WATER WHILE MIXING IT WITH COOLANT. ALSO CHECK THE TEMPERATURE SWITCH ATTACHED TO THE ... Cars & Trucks

I have a 1983 ford econoline motor home 351 engine. i live in edmonton alberta (very cold winter) i just purchased it and would like some advise or "how to" winterize it.do i need to tarp it? do i disconect the water hose from the pump and put it in the antifreeze and pump direct from the container? do i drain the hot water tank? i never did get any manual with the unit. your suggestions would help. i need before the weekend. thanks.


... 1983 Ford Econoline

Please help. water got into the fuel tank of my 1995 xjr. i pumped all the fuel and water out put some fresh fuel in the tank and eventually got the engine running perfectly. left it a couple of days put some more fuel in tried to start it and the engine wouldnt turn over. all the lights come on on the dash, the P or N light is lit on gear selector but engine wont turn over. any ideas please


... Cars & Trucks

Hi i have a 1983 dodge ram pickup one day it just died so ive been on a long journey of changing parts ive replaced the fuel pump fuel filter pcv and egr valve all the relays took out the fusable links new carb and even went as far as putting in a new motor and with that motor i put in all the parts from the other truck YET the same exact problem persist and what the problem is ill start it it drives for anywhere from 1 min to 10 min and then just cuts out and i have a hell of a time restarting


Check the firewall for a ballast resister. It's a little porcelain thing with either one blade connected wire or two on each side. Held to the firewall with one bolt in the center. Change that, and keep a spare on hand. ... 1983 Dodge Pickup

I have a 1994 Toyota 4-runner. I am having problems with power and smooth running. This 4-runner sit for a few months while I was putting a new water pump, fuel pump, fuel filter and timing belt on it. Once I put everything back together, it fired up like new! Then after a few weeks of running, during the hot summer months, it started losing power when climbing hills. It would miss, and sputter. If you let it sit and cool down, it would start back-up like everything was ok. Once the motor


When you put the timinig belt on;did you get the correct timing? ... 1994 Toyota 4Runner

1996 mercades c220. Been setting for 1 year. I put in new battery in auto 2 new batteries in key remote. Motor will run with a shot of starting fluid. No fuel to motor. Fuel in tank. Is this a security problem? where is fuel pump? Auto does not have Mersades Radio ,it is a after market radio. Where are fuse and relay for fuel pump?


There is a fuel pump relay under the hood on the drivers side. I don't think it is a security problem. Security shuts down the ignition. So it is probably the fuel pump. And the fuel pump is inside the fuel tank. ... Mercedes-Benz C-Class

Windscreen washers HI I have a 2004 Ford Focus C-Max turbo diesel Ghia. I thought assumed the washer bottle was empty as no water was coming out of the front or the back. Put water in but they still do not work. I can hear that the motor is working when trying to get water to come through the jets, but still no water My 2oo4 c-max has the same problem. The reservoir is full and I can hear he pump running but I just have an impotent dribble at the jets. It looks like a major job just to access th


Fords have a common problem with their washer pumps. for the last 12 years ford have fitted a plastic mesh over the inlet to the washer pump, this blocks up with the build up of crystalized washer fluid. fords official protocol says to use a small sh ... 2004 Ford Focus

How to replace water pump on a Nissan Pulsar Hatch 1992 N14 motor


... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.3321 seconds