Having problems with your 1993 Jeep Cherokee Country ?

Need to wire up anew ignition switch in 1993 jeep cherokee

\015 Oem key and column not an option\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1993 Jeep Cherokee Country

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need to wire up anew ignition switch in 1993 jeep cherokee


... 1993 Jeep Cherokee Country

I need to run the fan wire to the ignition switch where is the ignition switch located on a 2003 jeep grand cherokee laredo


Sounds like you need tests run at the fanswitch which is screwed into the head. sounds like you need the updates for your vehicles wiring and the tsb's that pertain to the correct identification of parts, wires and switches. you may need a thermosta ... 2003 Jeep Grand Cherokee

I need wire diagram for 1996 jeep cherokee blower motor switch , the wire harness melted and wires were loose when i went to change it. I need to know what coloer wire goes where?


... 1996 Jeep Cherokee Country

I need a wiring diagram for the rear window wiper on a 97 Jeep Grand Cherokee. I have power to it when the switch is on but it will not work. The only power to the wiring plug is when the switch is on and only in the one wire. Can you help?


Review this documents:- ZJ-Secc-8K-Windshield-Wiper-and-Washer-Systems (Page 7)- ... 1997 Jeep Grand Cherokee

I need to know order of 6 wires to brake light switch for 95 Jeep Grand cherokee


... Cars & Trucks

I have a 1992 jeep Cherokee that has a ground issue on the starter relay. i get power from the ignition switch and can start it with a paper clip. i am looking for a diagram to trace the brown with yellow striped ground wire on the starting circuit. this wire has wires, and one i think goes to the computer. thank you, nathan


... 1992 Jeep Cherokee Sport

MY 2001 JEEP GRAND CHEROKEE BLOWER WILL NOT WORK. CHECKED THE FUSE AND THAT IS NOT THE PROBLEM. PULLED THE WIRES AND WIRED DIRECT AND THE BLOWER WORKED. I SUSPECT IT IS THE RESISTOR OR THE SWITCH. WHERE IS THE RESISTOR LOCATED AND WOULD I NEED TO GO THRU A DEALER FOR REPLACEMENT PARTS?


The resistor is screwed into the heater housing under the dash on the pass. side. If you have auto temp then the part is expensive. You should be able to see red and black wires going to the resistor. If the resistor is bad it usually has high speed ... 2001 Jeep Grand Cherokee

On my 1996 Jeep Cherokee Country the fuel pump wont engage and there is no spark coming from the coil to the distributer I changed the ignition switch looked over the fuses and battery wires checked other wires only engine only rolls over


IF IT HAS THE 4.0L ENGINE IS HAS A CRANKSHAFT SENSOR ON TOP WHERE THE TRANSMISSION MEETS THE ENGINE.NO SIGNAL FROM IT WILL CAUSE NO SPARK OR FUEL BECAUSE THE COMUTER DOES NOT KNOW WHERE #1 CYLINDER IS.SOMETIMES U CAN TAP ON THE SENSOR AND IT WILL WOR ... 1996 Jeep Cherokee Country

I have a 1995 jeep cherokee sport 4wd 4.0L with air ps/pb/cc/abs. I recently (2 weeks ago) lost all ac/heater blower speeds except high and now 2 of the wires to the ignition switch get so hot with the air/heater running on high they will start smoking. Ac still functions just cant run it with above symptom. Have tried disconnecting the aux cooling fan and unpluging the ac compressor separately and same time with no help. Additionally with the fan switch in a position that the blower motor does


Never just replace any item because someone suggested it may have failed. Before replacing anything, you need to check each item for any signs it's bad. In addition to what I mentioned, the blower motor itself can also cause a problem if it is worn o ... 1995 Jeep Cherokee

I have a 1998 Jeep Grand Cherokee Laredo. It will not start. After checking fuses then changing the ignition switch on console I still can not get anything to light up on the dash when I turn the key, Someone told me that it is probably the on board computer. Is there anyway to check that system or do I need to buy one to find out. Thank you for your help. 160.000 mile Cherokee owner


Hello jam... you need to have your jeep's computer scanned for error codes. many auto parts stores, even AAMCO shops now scan for free. Start there. Joe ... 1998 Jeep Grand Cherokee

I have a 1998 Jeep Grand Cherokee. Brakes work fine but no abs. This I can live without but as the abs light does not come on dash board, testing station failed it. Tried obvious like bulb and wiring but nothing. Has anyone had similar problem? All I need is abs light to work, on with ignition, off when engine fully started. HELP!!!! PLEASE


It is problem with abs control unit, replace it for testing purpose and try it. ... Jeep Grand Cherokee

1996 jeep cherokee sport. I am trying to install a fog light kit. one switch, 2 fog lights. Need color wiring diagram or how to instructions. kit directions are terrible


If it's a lighted switch, you should have 3 terminal connections on it. One for the "ignition on" wire (from your fuse box). One going to the fog lights to turn them on when you flip the switch and one ground for the switch light to work. If your swi ... 1993 Jeep Cherokee Country

How do you disable an alarm system for a 1991 Jeep Cherokee Laredo. We lost the keys, and took advice from an auto mechanic. He suggested that we drill the ignition but when we did, we drilled too far into and damaged the switch. We tried hot wiring but everytime we get a jump, the security disables the starter. We'll hear it try to start but no luck. Is there anyway we can either A)bypass the alarm system or B)disable the alarm system so we can get it up and running?


... Jeep Cherokee

Need help on re wiring the right turn signal in the rear of my 1993 jeep grand Cherokee. Brought the Jeep Grand Cherokee and found that the right turn signal in the rear of the car doesn't work. Took it apart and found that it was wired to the front turn signal. Need to know how to fix this.


Review the Repair Manual for Jeep ZJ-Secc-8W-Wiring-DiagramsWith this guide the work is so easy to solve (remember rated this hel ... 1997 Jeep Grand Cherokee

I need a wiring diagram for a 1997 BRITISH Jeep Grand Cherokee Laredo (I think ZJ) Diesel 2.5 TD (all dash ignition lights gone & no start)


... 1997 Jeep Grand Cherokee

Need wiring diagram for 91 jeep cherokee ignition


... Cars & Trucks

Need the wiring diagram for the ignition - 1997 Jeep Grand Cherokee


... 1997 Jeep Grand Cherokee

My 1996 grang cherokee jeep 4.0L keeps skipping after changed plugs, wires, and distributor cap. Will i need a new ignition coil?


A bad Throttle position sensor will cause "skipping" like its not running right also. ... 1995 Jeep Grand Cherokee

I have a 97 jeep grand Cherokee it turns of i reach a stop sign and the rps start go go down until it finally shuts off. I have a new battery, wires plugs, new spark plugs, new ignition coil and asked mechanic to check fuel pump and he said its good i don't know what else it could be need help badly.


YOU NEED TO CHECK FUEL PRESSURE ... 1997 Jeep Grand Cherokee

All windows not working. not getting power to switches. checked for broken wires between door and body. checked all fuses on right hand side and under hood, fuses not labled inside jeep, no blown fuses. is there another control that needs to be reset or another fuse panel? is there another way to trouble shoot this problem? Help..98 grand cherokee laredo.


There is a relay that controls the power to the window lift motors that is most likely the problem I dont think the wire has broke to all of the doors ... 1998 Jeep Grand Cherokee

Need a wiring diaghram for blower motor switch on a 1994 jeep cherokee


... 1994 Jeep Grand Cherokee

Need to replace ignition switch in a 1994 jeep cherokee


... Jeep Cherokee

1999 jeep cherokee no spark. need ignition wiring schematic to pinpoint. thanks for your help


... 1999 Jeep Grand Cherokee

01 Jeep cherokee. good battery. new starter. new ignition switch. new transmission range sensor. checked ALL fuses and grounds. starter relay has power. relay has no output signal. has a known good starter relay. NEED HELP!?


Ground a test light to negative ( ground ) then remove relay and check for power, then have some one turn key forward as to start vehicle and check again there should be another hot when key is turned to start let me know if it helps thanks ... 2001 Jeep Cherokee

124 88 200 model ignition switch wire colours and pin locations ignition switch wires cut of replaced switch need to know where wires must be put into which pins


... 1990 Mercedes-Benz E-Class
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4624 seconds