Having problems with your 1993 Isuzu Trooper ?

Idles to high all the time at 2100 - 1993 Isuzu Trooper

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

If its a diesel check the throttle cable is not bent.
Repair Help & Product Troubleshooting for 1993 Isuzu Trooper

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

99 mercury sable automatic trans vehicle idles very low randomly even stalls out sometimes high idle occurs as well reaches about 4000 rpm at times. engine light threw 4 codes, all to do with o2 sensors both bank 1 sensor 1 and bank 2 sensor two. now i cant seem to find any vacuum leaks and i highly doubt that more than 1 o2 sensor failed at the same time. any ideas in which direction i should go in?


Sounds like a broken or torn vacum hose, pcv valve clogged, or bad Idle air control motor. Did you spray carb cleaner on vacum hoses or near the plastic intake., and did the motor rev up or down? Those codes represent a lean condition which means mos ... Mercury Sable

Idles to high all the time at 2100 - 1993 Isuzu Trooper


If its a diesel check the throttle cable is not bent. ... 1993 Isuzu Trooper

Idle time Hi, I have toyota tercel 92 , which ran only 67000 miles here's the problems I get 1. its not resting in proper idle time 2. when its in parking gear or Neutal it gets accelerated. 3. its just surge up , I tried adjusting it but it won't happen, even it stays good for some time .. but when I switch it off and the engine cools down , again the idle time is high ..


Look at at your idle control valve. Also could be the idle up vsv. If your not sure where these are let me know and I can help you with that. ... 1992 Toyota Tercel

Firstly, i am experiencing a lot of top ups on oil (1 pint/week). My car smokes a lot and the smoke is white and blueish like. My exhaust is so black and oil greasy residue and some oil is leaking through the head gasket since from the time it was engine over hauled.A friend advised me to buy caburator cleaner which i did and cleaned the cab.There after i am still experiencing the same plus now the high idle when the engine has warmed up but if i press gas pedal for a higher idle the high idling


Your idle problem is because your carb is missing somelines such as vacuum etc.the reason your top up is increasing is because your car is burning oil hence the white/blue smoke.you need your head gaskets changed and also get your mechani ... 1997 Hyundai Elantra

I have a 1989 Oldsmobile Cutlass Ciera that ran excelent and now won't idle but will run at a high idle and seems to run smooth at the high idle. I ran a diagnostic check from OBC and 4 codes came up: 1) C-15 Coolant Temp. Sensor (Low Temp. Idicated), 2) C-22 Trottle Pos.Sensor(Sig.Low Volage), 3) C-42 Electronic Spark Timing(EST)Circit, 4) C-48 Misfire Diagnosis. Could someone please tell me what part needs to fixed or replaced?


First replace the temp sensor it is important for proper fueling dispersment the engine has differnet demands on cold and hot engines.Second at high idle it runs fine only when it kicks down to low idle it messes up which is an indication of a th ... 1989 Oldsmobile Cutlass Ciera

Idle issues my 1991 isuzu trooper idles high than low high than low everytime i stop but i cannot seem to find what is causing it, other than that it runs great, i have changed the accelerator spring and hoses, cleaned the motor but nothing has changed the problem, if i step on the gas pedal hard it will idle normal but that gets annoying after awhile


I had the same problem and when I change the catalytic converter the problem was solve ! ... 1991 Isuzu Trooper

I have a 1999 isuzu rodeo...it idle up real high ..but when i disconnect my battery cable for 1 or 2 min is ldle down for 3 or 4 days then it go back to idling high again.....is my computer goin bad or need reprogramming?


... Cars & Trucks

I have a mazda astina ba 95 just had a clutch change after this has been done it has gotten 2 problems which were working fine before the change, problem 1 is when put into gear doesn't matter what gear it will idle high then I put the air con on at the same time the idle will go a lot higher and stay at a high rpm until I turn the air con off or take it out of gear, 2nd problem is the speedo is now not working, any help would be great as I don't have a lot of knowledge of mazdas


... Cars & Trucks

I have a 1991 isuzu trooper 6 cyl. It won't idle down.I changed tps and another idle control sensor. Someone told me the timing may be off. Could you give me the timing setting. Thanks


... 1991 Isuzu Trooper

Man, I've got issues. I thank you guys for taking the time. Just got my car back from the mechanic, and my car idles crazy to 4 1/2 rpm in park every time I start the car and drops to 1 when in park or reverse. He says he already adjusted the idle control. So why is it revving so dang high?


Sounds like you may need to replace the idle speed control motor(actual sensor)its not reading the signal from the ecu properly hope this helps you by the way this sensor is self adjusting if that doesent solve your problem then have your timing c ... 2002 Toyota Camry

Truck burns alot of fuel, hesitates all the time and high idle, just replaced timing gear and chain. dealer says maybe 1 tooth off on cam, replaced distributor w/cam sensor, crank position sensor, (no change), still has code of cmps and ckps are not corilating


If you have that code the distributor isn't set right. I don't suppose you have access to a scanner? That is the only way to get it set right. ... 1997 GMC Sierra

My 1999 Chevy silverado 1500 started having weird issues first; brakes got soft and went to floor with no loss of fluid, second; it started idling high at around 1,100 rpm's (35mph.) third; if you gave it gas and then abruptly let off it would stall then the only way to start it was to mash the gas to the floor while turning over getting harder to start every time. Fourth; the last time it started it took a half hour to start then battery light came on, volt gage showed maybe 10v drove home ( a


The battery pole was hot ??..ok there is one thing that will explain all of your problems ,, Its a simple problem but extremely hard to pin point.. Its an eletrical short thats messing everything up..do you have experience in auto ele ... Cars & Trucks

I have what appears to be a miss in my 1994 Isuzu trooper. When it sits running at idle, it doesnt seem as bad. When driving and put any torque on it, it gets worse. While sitting at an idle, I pull each wire off the coils one at a time to see if that changes the engine speed. It appears that when I pull the 4th wire (Right wire on the second coil) that it doesnt make a difference. I replaced that spark plug but didnt make a difference. It looks like that middle coil was replaced as it looks new


It may be the wire.Swap the wire with another one to see if the problem stays where it is or moves with the wire. ... 1992 Isuzu Amigo

Had High pitched whine at idle and no accelleration. replaced intake manifold gaskets, plugs, wires, vacumn lines, verified fuel pressure 56psi , TPS voltage is present and smooth from .5-4.5V. whine is gone but still have sluggish to nonexistent acceleration. after approx 1/4 throttle it begins to bog down, cannot exceed 40mph. No water visible in oil. pulled plugwires 1 at a time. while the effect was more pronounced on other cylinders all effected the idle of the car. Any suggestions before i


... 2001 Pontiac Grand Am SE

Isuzu Trooper, 1990, 2.8L - 6V, Manual Transmisson. Milage 140.000 miles.  Problem: Engine starts when cold and climb to high rpm and gradually goes down to 800 rpm as it should. When it?s hot stalls on idle and than it?s hard to start. Can?t hold idle. Immediately stops.. Will not start when is hot. I have replaced head gaskets, inlet manifold gaskets and all exhaust gaskets. Also new thermostat. New spark plugs. New parts in ignition distributor. (3000 miles ago). Fuel pump gives right pres


About the only items I see you haven't checked which could cause this condition according to my books is the O2 sensor, Map sensor and Throttle position sensor. Occasionally the Crank position sensor will throw a bad code at you but not often. I wo ... 1990 Isuzu Trooper

Isuzu Trooper, 1990, 2.8L - 6V, Manual Transmisson. Milage 140.000 miles.  Problem: Engine starts when cold and climb to high rpm and gradually goes down to 800 rpm. When it’s hot stalls on idle and than it’s hard to start. Can‘t hold idle. Immediately stops.. Will not start when is hot. I have replaced head gaskets, inlet manifold gaskets and all exhaust gaskets. Also new thermostat. New spark plugs. New parts in ignition distributor. (3000 miles ago). Fuel pump gives right pressure 11 PSI (


... 1990 Isuzu Trooper

I have a 1991 Isuzu Trooper with the 4 cylinder. It runs good but has a rough idle. At speeds of 55 or greater, the "Check engine light will flash periodically. There are no codes to pull. I have changed the timing belt and re timed the distributor. This caused the vehicle to run better but still has the above problems. What do I check next? I have also checked and repaired all vacuum Leaks


Check the EGR valve. it could have carbon buildup, preventing it to complete close. similar to a vacuum leak. you can removing it and try cleaning the pintal and seat. also check the vacuum hose at the EGR valve. there should be no vacuum at idle and ... 1991 Isuzu Trooper

High idle For years I've experienced a sporatic and widely variable (i.e. 750-1700RPM) idle when the engine is warm. Many mechanics have tried to ID the source of the problem. Usually they say that the throttle body is dirty and needs cleanings (which I've done probably 3-4 times in the past 6 years, with no improvement. About 1 year ago, a mechanic (not the dealer-they could never fix the problem) discovered that the setting on the ICM / senor was WAY off. He adjusted it and the car ran great u


Your car may not have recieved a recall on 02/201998 on the vehicle speed control recall id from NHTSA98v035000. the throttle shaft ball bearings on the sensor side of the throttle body assembly was not insalled in certain throttle bodies. Operation ... 1997 Subaru Legacy

I was running it for the 1st time after this winter it was idling fine at high idle 1,200 rpm and i bumped the throttle and it ran really rough and will barely run at all, I just don't know what went wrong,I replaced the plugs and it still won't run. What happened?


Sounds like it might have varnished gas in the system. I would change the fuel filter, clean out the lines with a good carb/fuel injector cleaner and fill the tank with fresh gas. I will run a little rough until the bad gas is run out. If this dont ... Chevrolet Corvette

High idle For years I've experienced a sporatic and widely variable (i.e. 750-1700RPM) idle when the engine is warm. Many mechanics have tried to ID the source of the problem. Usually they say that the throttle body is dirty and needs cleanings (which I've done probably 3-4 times in the past 6 years, with no improvement. About 1 year ago, a mechanic (not the dealer-they could never fix the problem) discovered that the setting on the ICM / senor was WAY off. He adjusted it and the car ran great u


\015\012I have the same exact problem, but with idling roughly between 700 and sometimes upwards of 2000+ RPM.  I don't have the problem you do as far as the engine heat goes, but I definitely feel the tug, hear the engine sounding bogged ... 2000 Subaru Legacy

I use a 2000 model Isuzu Trooper Limited Edition. MILs indicate 'check trans' and 'check engine' on my dashboard. Scanning reported Code P1870. My experience is sluggish up-shift from 1-2 and refusal to engage gear 4 on long distance drives or sustained high speed driving. Can you please tell me what could be possibly wrong and how to fix it; the Isuzu is recommended to use Dexron III but I am using Dexron II, could this be responsible for the problem? Please help me, somebody. Humphrey.


... Isuzu Trooper

99 isuzu amigo 2.2l changed water pump and put old timing belt back on. the cam pulleys had white marks and so did the crank that all lined up before I took off the belt. Put it back on without moving anything and now engine loafs and shakes slightly when idling. How can I insure I have the timing correct without relying on marks. I know how to find TDC on number 1 then what??


... 1999 Isuzu Amigo

1986 isuzu trooper high idle


... Cars & Trucks

2002 Isuzu Trooper, rough idle issues


... 2002 Isuzu Trooper

1994 isuzu trooper high hc failed emmisions at idle


... 1994 Isuzu Trooper
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.8805 seconds