Having problems with your 1993 Isuzu Trooper ?

Hello..my brake lite came on i chance de brakes all but the lite stil on please tell my wat to do

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

When you do the brakes on those, and your light stays on, try bleeding the brake (start with the right rear, left rear, right front, then left front) Be sure to pump the brakes before you bleed them. If that doesn't work, you may have an issue with your ABS unit, and it might need to be replaced.
Repair Help & Product Troubleshooting for 1993 Isuzu Trooper

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hello..my brake lite came on i chance de brakes all but the lite stil on please tell my wat to do


When you do the brakes on those, and your light stays on, try bleeding the brake (start with the right rear, left rear, right front, then left front) Be sure to pump the brakes before you bleed them. If that doesn't work, you may have an issue with ... 1993 Isuzu Trooper

We were driving down the road and the speedometer did a little dance and then went down. All the lights in the instrument panel came on and then went back to normal except the ABS and the brake light. These 2 stayed on. We put it on a OBDII scanner and it came back with a P0500 code. Please tell us this is easy to fix and then tell us how to fix. Thank you so much. Trudy Smith


Please check out this link. http://www.obd-codes.com/p0500 The code meens that the computer is not getting a good signal from the VSS, Vehicle speed sensor. Your VSS shoul ... 1998 Dodge Ram

Smoke rolled out from under hood, popped hood, brake fluid all over engine, cannot tell where it came from resevoir empty.. i am a poor female and hope i can fix this my self please help tell me where its coming from the only thining i see that looks wet is the line going to the bottom of resevoir


Sounds like you found the leak already, add a little more fluid & have someone hit the brakes while sitting to confirm. That line will need to be replaced, and system will need to be bled. ... 1991 Lincoln Mark VII

Warning lights could you please tell me what the warning lights (RED ONE WITH BATTERY SIGN AND ORANGE/YELLOW ONE WITH A CURLED WIRE SIGN AND THE HANDBREAK LIGHT) mean on a nissan pulsar diesel 1995. several of the lights came on together when i was driving from the airport and the brakes were not working properly i do not have a manual to identify the fault.


Hi\015\012\015\012the handbrake light means your handbreaks on you switch might need to be replaced\015\012the battery light means the battery is low on charge either a new battery or alternotor need to know more to answer that one ... 1984 Nissan Pulsar

I have a audi a6 2.8 quattro 1998 model,and a warning light came on,looks like a circle with open and closed brackets around the circle with a hour glass in the middle of the circle,please can you tell me wat that means,i dont have any manual...thx


Not sure by the discription , but may be brake ware warning light. ... 1998 Audi A6

My power seat stopped working. But the passenger seat works fine... Also it keeps telling me key not accepted but it turns on fine. Some warning light came saying brake light failure .. Please help.


At the rear electrical center, check 30A fuse 25. Replacement should get your seat moving again. The brake light warning indicator may simply mean that a brake light is burned out. I have no thoughts regarding the key problem ... Cars & Trucks

There is a warning lite came on my car. its colour is oringe and in looks like a little engien. can u tell me what it is please


This is your check engine light. What this mean is your computer detected something wrong in your car usually electrical. It will have to be taken to a shop or auto parts store to further diagnose the reason its coming on. ... Mazda 323

2006 chev uplander the trac control lite is on code 0131 systym pressure circiut ,but both the trac control and abs systym works ?? do i need too buy that two thousand dollar module too put the lite out i erased codes and the minute i press the brake the lite comes back on the first time i erased the code it didnt come on tell the abs brakes pulsated but now soon as i apply brake too shift into reverse the trac lite comes on. but the systym definetly works not sure about the stability part .


... 2008 Chevrolet Uplander

ABS 2009 avenger, ABS and brake lights stay on, cleard codes still came back, had dealer clear codes, still came back. dealer says its a speed sensor,i replace all 4, then he tells me its the brakes i have new breaks put on, now he is telling me its a fuse, i checked all fues's, nope not it AGAIN, now he says its the ABS sending unit or the ABS modutaltor and he said if you replace one better replace both, now they want A NOTHER 1300.00. can ANYONE HELP ME


... 2009 Dodge Avenger

Stock 1986 Suzuki Samurai. On the way to town today My Sensor lite, Battery & brake lite came on on the dash panel. I stopped and found that the bolt that attaches the altenator adjustement bracket to the water pump had fallen out. I replaced the bolt & checked belt tension (OK). Started it back up, and warning lites stayed ON. So Far I've: checked all fuses, cycled the sensor switch, disconnected the battery for a hour/ reconnected it, checked brake fluid level & emergency brake switch (OK), ch


... 1987 Suzuki Samurai

Brakes Good Morning! I was headed down my driveway this morn and realized I had no brakes. My neighbor came and poured brake fluid into the res and I watched under neath when he pumped the brakes the fluid came swooshing out with each pump, This is happening in the rear of the car. Can you tell me what this is and about how much it should cost me to get this fixed? Many thanks your kind assistance. Regards, Nancy


You have a leaking brake line or a bleeder valve is open. if it is the bleeder valve than all you have to do is close it. if it is a broken line then you will have to buy new line. if you do it your self it will only cost around twenty with about fou ... 2000 Buick LeSabre

I have a 2000,740i. the brake lights stays on constanly even when the car is turn off. after aweeks the brake lights are not working now.i change all the bulbs yet still not works.can someone tell what seems to be the problem with my electric.or were the brake relay,brake fuse and the light module please help have tired with people telling changees


Try to replace stop light switch at the brake pedal. ... 2006 BMW L7

I have just fitted new pads to the front of my 1998 bmw 523i almost immediatly after the warning lite came on.just before i changed,the last 15mph or so there was a shuddering till it came to stop.thought it may have been pads on metal,but once removed,there was still some wear left on them.new ones in,and when braking at low speed it persists,but when braking from higher speeds,brakes feel and operate fine,until lower speed,then shudders until i stop.it almost feels like the abs is coming on to


When you replaced your brake pads did you also replace your rotors??? If you haven't replaced them, I can almost guarantee your rotors are warped and need replacing. Anytime you replace brake pads, replace the rotors as well. That's what i reccome ... BMW 525

Similar problem, 07 KIA Sedona, ECS OFF lite and check engine lite on at all time but with no acceleration or Deccerleration issues. Took if for Diag scan at local Auto parts store. Scan came up with "Brake Switch A/B correlation problem". Solution 1. Open or short 2. Poor connection 3. Faulty Brake switch. I assumed it would be ok to drive since ECS OFF lite is on and I have a switch that allows me to turn the ECS off. Not sure how true that is but have been driving it since this mo


... 2007 Kia Sedona 3.8

1999 f450 abs brakes lite comes on all the time. When lite goes off at intermitant times, usually when brakeing you hit the other car. which fuse is the fuse for the abs brake///??? Please help


Seem to me that a wheel bearing may be wearing out\015\012scan to find code of trouble wheel sensor ... 1999 Ford Super Duty F 450

I have no brakes on my 51 kaiser. i have new pads but absolutely no brakes! can u tell me how the brake sustem works? is it hydrolic? if so or not how do i put fluid into the system? its the only thing keeping the car off the road, please let me know anything u can tell me?


A 51 Kaiser had brake shoes on all 4's. You must have a fatman suspension with Mustang brakes on it ... Dodge 4

95 olds cutlass supreme sl with 3.1 6 cyl. ABS and Brake light stays on. Brake pedal is hard to push but front brakes work. Back brakes don't work at all. Took the brake lines off at the rear caliper and hit the brakes and no fluid came out. Master cyl. is full. Please advise. Thanks.


You may have a ABS problem. I would drive it and attemp to skid the tires an dsee if the pump activates. sometimes this will unstick any valves inside the ABS unit. you may need to have a qualified repair shop check deeper. the ABS will have a code, ... 1995 Oldsmobile Cutlass Supreme

DROVE CAR TO SHOP. THEY CHANGED FRONT BRAKES. THEY THEN DECIDED TO CHANGE ONE BACK CALIBER AND REAR SHOES. TRIED FOR i DON'T KNOW HOW LONG TO BLEED AND COULD NOT. THEY ARE TELLING ME THAT SOMEONE HAS PUT THE WRONG BRAKE FLUED AND SCREWED UP THE SYSTEM, AND i AT LEAST NEED A MASTER CYLINDER. THEY ARE SAYING MY PEDDLE IS TO THE FLOOR. I DROVE THERE WITH BRAKES, NO BRAKE LIGHT WAS ON, i FEEL WHAT EVER HAPPENED, HAPPENED THERE, OR THEY JUST DON'T KNOW HOW TO BLEED THE CAR. PLEASE HELP ME. I LEFT THE


Hi! They sure know how to bleed a car but just a thought on this, since the pedal is on the floor right after the bleeding the prolem will be on the hydrovac. Its not the brake master cylinder either but the HYDROVAC. If the hydrovac has a vaccum lea ... 2004 Nissan Altima

I have a 2004 chevy venture, 3.4 l v6 engine. the red brake light stays on on the dash and on the convenience center it tells me i have low brake fluid. the brake fluid is not low and if you disconnect the wire harness from the switch in the master cyl, the light and warning sign goes out. i replace that switch and it did not cure the problem .help please.


This can also be caused by the park brake switch, go under the dash and locate the park brake switch, it is a simple ground switch (it is located on the actual park brake mechanism), remove the wire connector to the park brake switch and ground it to ... Chevrolet Venture

Check engine lite came on i hooked up to the computer on the car and the code P1138 came up came up can you tell me what this means.


On the Nissan it indicates that the 'swirl control valve' is malfunctioning. The valve is located in the lower part of the intake manifold. Removing and cleaning the valve sometimes provides a solution to the problem. ... 2004 Nissan Sentra

When i first start the truck it misses and if not completely warmed up it will make a popping sound like a small backfire. The engine check lite came on as well as the brake lite and the ABS lite is also on. This is a 1998 Mazda B2500. I have replaces the 2 coils, the throtle sensor and the air bypass valve, and it is still running rough. When it warms up it runs good. HELP I have been told it may be the catalytic convertor.


I think that when you change the coils you crossed the ignition wires make sure the firing order is right ... 1998 Mazda Pickup

Hi every one, I have Mitsbishi Pajero 93, when I came to start it in the morning the A/T lite and batery lite as well as the fuel filter lite stays on and I am loosing battery plus the electric windows do not work, I visited my local mechanic they could not solve it, would you please help me with it. Regards. Aif


Check if the battery is being charged..sounds like an alternater problem. ... 1994 Mitsubishi Montero

I have a 2005 titan and i changed my front brake pads and bleed to 2 front calipers and the brake pedal is still soft . i took the calipers off and push the pistons back in fluid came out of the top of the master ? i put the pads in in on both sides and bleed the brakes with the top off? am i doing this wrong ? please help.


There is no need to bleed the system unless you opened the lines or the reservoir ran dry. The pedal should stiffen up once the pads have reseated. If you do have to bleed, leave the top on or you will spill fluid. To bleed, have one person pump u ... 2005 Nissan Titan

Batery lite and brake lite comes on. Had it serviced reman alternator, all new belts,and new power steering tensner. drove home same lites came on, could the aaaalternator be bad? Jay


Yes, check voltage output with tester, with engine running, lights and a/c on should be more than 12v about 13.5-14volts if not alternator is not charging system ... 1997 Mitsubishi Montero Sport

Battery lite Good Morning.. I have a problem I hope you can help me with...My battery lite is flickering...causing my lites to do the same..could you please tell me what you think it might be?? Thank you!!


... 2002 Mazda 626
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.6642 seconds