Having problems with your 1993 GMC Sierra K1500 ?

Install gmc 1500 rear brake shoes - 1993 GMC Sierra K1500

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1993 GMC Sierra K1500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Install gmc 1500 rear brake shoes - 1993 GMC Sierra K1500


... 1993 GMC Sierra K1500

I have replaced 5 brake lines on my 2002 GMC 1500 Sierra, but believe I may have lost track of the correct locations to install the lines at the proportioning block under the lt side of the vehicle. There are 3 possible locations across the top row and 2 along the bottom row. 1 rear line, frt lt line, frt rt line, frt masterline, and rr masterline.Which goes where? Thanks Jim


... 2002 GMC Sierra 1500

My 1997 gmc 1500 has developed a "soft" pedal and the I P lights have come on. If I clamp a pair of vise grips on the rear brake hose before the "T:|"the pedal becomes firm. I have bled the brakes many times, replaced the rear wheel cylinders and lines back to the "T" replaced the drums and shoes, but the pedal is still soft and the lights stay on. I just changed the master cylinder, and still no difference. The master was bench bled before instalation. I did replace the main line going to the


Hi, you are experiencing the GM brake pedal, this is a common problem, most of the time the abs module is to blame. if air gets trapped in the module it will always be spongy. you need to crack the bleeders just after the abs unit and have an assista ... GMC Sierra 1500

Need rear brakes picture 1994 GMC - 1992 GMC Sierra K1500


... 1992 GMC Sierra K1500

92 GMC Sierra 1500,5.7 v-8, Service engine soon light comes on consistantly.brake light sarted blinking 10 times and cycling through over and over again.Obviously an OBD 1 system with an early low tech abs solenoid brake set-up for the rear brakes only.Most likley 2 different problems but I haven't been able to find code info online as of yet.Where can I get code desciptions?


... 1992 GMC Sierra

How to remove emergency brake cable from rear brake shoe on a 2005 gmc sierra 1500


... 2000 GMC New Sierra 1500

Diagram of a 2007 gmc rear brake shoes - Sierra 1500 GMC Cars & Trucks


... GMC Sierra 1500

I change te rear right hub to my subaru outback H6 2005. I have problems to install the rear brake shoes. I need some guide with diagrams or pictures to install the rear brake shoes.


Subaru Car 1998-05 - Reair Guide 1998-05Brake Shoes\015\012\015\012\015\012\015\012Raise and safely support the vehicle.\015\012\015\012\015\012 ... Subaru Outback

2002 GMC Sierra 1500 rear brakes


Hi joelalthomas, if they replaced your brakes and you never even made it home they had better warranty the work and as for the "it was a common problem on 2002-2004 trucks" well check for Chevy recalls as this is a safety issue that would have been c ... 2000 GMC New Sierra 1500

Left rear brakes locked up. Can't get the drum off. Like to back off the shoes to get the drum off. 1989 GMC Sierra


Hi:\015\012There is an rubbber access plug on the back side of the brake mounting plate. You can access the adjustment star wheel , and crank it in to get your brake drum off! ... GMC Sierra 1500

Where to find diagram to install whole rear brake lines on 1992 GMC Sierra 1500 series pickup truck


I don't know about a diagram. Just buy some 1/4 inch brake line and run it as close to the original as you can. ... 1992 GMC Sierra K1500

Install emergency brake shoe on 2008 sierra gmc


... 2008 GMC Sierra 1500

How to assemble 10 inch rear brake shoes on a 1997 GMC Sierra 1500


... 1997 GMC Sierra

Replace rear brake shoes on 1993 gmc sierra 1500


... 1993 GMC Sierra

Need picture diagram of rear brake shoe replacement and directions for a 1996 gmc sierra 2500


I need pictures for 1998 gmc sierra k2500 rear bkake shoes. ... GMC C2500

I Hanve 1996 GMC 1500 brake pedal goes to floor. New brakes & Calipers in front, 1 new wheel cylinder. 3 New master cylinders,1 new brake booster, Brake line in rear rusted out & replaced. Have checked rubber lines for collasping or bubbling, When Bleeding all wheels lock, Have vacum bled and manual bled. Tried different ideas, do not touch brake until bleeder is open and depress and close bleeder. Tried just about everything, Have adjusted rear brakes out. When truck not running you can


Did you try a brake booster ? ... 1996 GMC Sierra

REAR BRAKE LOCK UP AFTER 20 MI DRIVING . TRUCK HAS NEW REAR BRAKES AND DRUMS AND HARWARD WITH AJUST KIT . I AM THINKING FLUSE BRAKE FLUID ( WITCH LOOKS CLEAN ) BRAKE HOSE ? . THIS BRAKE WORK WAS MOST LIKLY DONE AT A MUFFLER SHOP . I SAY THAT BECAUSE OF THE SHOES AND HARDWARE THAT WAS USED . MY COUSTMER PURCHASED THE TRUCK IN THIS CONDITION . THE SHOES AND AJUSTER ARE PROPERLY INSTALED ANY OUTHER IDEAS ON THIS


Does it only do it after the customer applies the brakes or do they just lock up on their own. If it only does it after the customer applies the brakes then it could be a brake hose or is could be a bad master cylinder. If it does it on its own then ... Ford F-150

2002 GMC Sierra 1500 rear brakes


Sounds like a rear end ratio problem ECM malfunction ... 2002 GMC Sierra 1500

Adjust rear brakes 2008 GMC Sierra


... 2008 GMC Sierra 1500

GMC Sierra rear brake pads


Make sure piston is pushed all the way into caliper. if it is install without shims ... 2002 GMC Sierra 1500

Hi,my 1992 dodge dakota 4x4 extended cab with a 318 engine is giving me problems!! The brake light and anti lock lights are both on,brakes were working but I found a leak in the rear brake line. Replaced rear shoes,rear cylinders,rear brake lines,front pads and master cylinder. Bench bled the cylinder and then after installing I bled all the lines till there is no air and only clear brake fluid. Tested the power assist and it holds a vacuum. When the engine is off I can get resistance and the br


... 1992 Dodge Dakota

How to install parking brake lever cable on new brake shoe I've removed the passenger rear brake shoes on my 2003 Kia Sedona. I am not trying to connect the parking cable to the brake shoe. I can't get the outer wire cable to stretch enough to get the cable connected to the shoe


You have to install it into the inverted shoe first,then install the shoe ... 2003 Kia Sedona

New brakes Installed new brakes front and rear including new wheel cylinders, shoes and flexible brake lines in rear at drums, new calipers and pads in front, new master cylinder. Cant get front drivers side caliper to compress and rear passenger side brake pads wont expand. Front caliper is full of fluid, when i crack bleeder open steady stream of fluid pours out, no air. Same with rear passenger side, wheel cylinder full of oil. Filled lines with new fluid using gravity feed method. Any ideas


Still have air inside, because you used gravity feed method. ... 2000 Chrysler Cirrus

1999 Ford E350 van problem: brake pedal is soft; have replaced master cylinder, rear wheel cylinders, rear brake shoes and drums, front calipers, rotors and discs; have bled master cylinder before installation and bled all wheel cylinders as well; have also replaced rear anti-lock system; the rear anti-lock system light on the dash remains on; the pedal gets hard when bleeding the brakes, however, does not stay hard after bleeding. Does the anti-lock system need to be bled as well? If so, how?


Good question, on the antilock system is a bleader too and bleade it the same way you bleade the caliper. After all is done adjust the rear brakes, they should have a drag to them. ... 2007 Ford E-350 Super Duty Length XLT

Replaced rear drum brakes on 98 chevy cheyenne k1500 and brakes worked fine but e brake seemed way too tight, i didnt want to even try but my father in-law said aww its suppose to be that way so he pressed it to the floor with a lot of effort. the brake light is now off but brakes on drivers side rear are stuck and wont free up. did we install something backwards... any suggestions or picture of how its suppose to look? the pass/rear is fine , does one go one way and one another way?


Check the cable, if its corroded, rusted, the spring in the drum isnt strong enough to pull the cable back, to release the brake. You may need a new cable for the drivers side. ... 1998 Chevrolet K1500
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.9654 seconds