Having problems with your 1993 Buick Roadmaster ?

I am changing the front shocks on my 93 Roadmaster Sedan and am having trouble finding a tool to remove the top nut what is recommended?

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1993 Buick Roadmaster

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I am changing the front shocks on my 93 Roadmaster Sedan and am having trouble finding a tool to remove the top nut what is recommended?

... 1993 Buick Roadmaster

I need to remove the front shock absorber on my 2001 Jeep Grand Cherokee Limited, 4.7L engine. When I try to loosen the top shock nut, the entire spindle turns. I cannot find a way to lock the shock spindle in place.

If you have a impact you can try spinning it until it snaps.I'm not sure how much clearance you have .Is there enough above the nut for a vise-grip.More than likely you will have to smack it with a hammer (bend it back and forth),not sure if there ... 2001 Jeep Grand Cherokee

Front Suspension I have a Kia Shuma ll which I think is the same as a Spectra. (somebody correct me if that is wrong) I have had four new shocks fitted and have had a problem with one of the front shocks "crashing down" after a pothole or speed cushion, when I say crashing down I mean that the wheel seem to hit the road quite hard! The garage that fitted them has removed and stripped the unit in front of me and we cannot find a fault. However, there are four bolts at the top of the suspension un

... 2003 Kia Spectra

I am about to install new front struts on my Grand Cherokee. In the engine compartment at top of each wheel well I expected to see the top of the shock absorber bolt with a nut on it, but cannot , it is covered with various items mounted above, winshield washer reservoir, fuse boxes. etc. How is it removed, and do I require a mounting plate with the new strut kit ?

Here is a link to some information that should help you:\012http://www.autozone.com/autozone/repair ... 2007 Jeep Grand Cherokee Overland

I am trying to change the front tire on my 2004 xterra. I used the special tool to remove the lug nuts but can't find an allen's wrench to fit. What size do I need?

... 2000 Nissan Xterra

How do i remove the top half of the back seat in a 1986 caprice. i removed the bottom half with ease but cant seem to find how to remove the top. And im also having trouble removing the door panels

There will be 2 bolts (possibly anchored to the seat belts) on both outer sides ( they may be 18mm nuts or T-50 torx head bolts). Remove them and lift the rear seat straight up, as they lock into hooks in the rear partial shelf. ... 1986 Chevrolet Caprice

Having trouble removing the front wheel. removed lug nuts, but don't know if or how to remove spindle nut

Once the lug nuts are off the wheel should come off, if not bang on the tire with a heavy hammer it is stuck on the hub (RUST). ... 2006 Toyota Corolla

How to remove the top bolts from the rear shocks

Bolts should be easily removed after breaking them loose. If someone replaced them and used nuts on the backside, it may present a problem & require cutting the heads off. Sometimes you can snake a distributor wrench above to grab nut but on most ... 1999 Jeep Wrangler

Trouble finding replacement front shocks for a

Weld a piece in ,or them off the old ones and weld them to the new ones ... 2002 Chevrolet Silverado 1500

I have a Case 830, early Model 310 that has not been started for 8 years, it was running fine when I parked it. I have changed the filters cleaned the fuel tank and lines. I have opened the 5/8 nut on the Front(top), the fuel was gummy at first. The larger nut below has a rubber diaphram. How do I get fuel to come out the top of the pump? It turns over good (replaced starter and batteries). I have removed the line still no fuel.

... Cars & Trucks

HELP cant take off power steering pump, I located two bolts in front of the p/s pump and took them off, I cant find any more in front of the pump from top view, could there be more bolts under or on back of the pump? do I need to get under the van to be able to remove the pump? I really need to remove the p/s pump so I can replace the broken pulley

There is a nut on the back of the pump near the top. It may be accessible from the top if you have long thin arms and a fairly short wrench (15mm, I think) There is a stud on the back of the pump that goes through the bracket and the nut goes on tha ... Plymouth Grand Voyager

I have a 2002 volkswagen jetta. do I need to remove lower ball joint to remove front spring and strut assembly? or can I remove assenbly by removing top and bottom bolt and nut at bottom of strut?

You dont have to.\015\012\015\012but when your in there there is a gap in the back of the spindlewhere it clamps arount the strut stick a prybar in there and pry apart makes it alot easier to get out. unless you have the special tool that ... 2002 Volkswagen Jetta TDI

Your battery do you have any tools? You don't need an 'expert' to do the battery swap. Does your battery have side terminals (+ and -- cables are bolted to the side of the battery) or top terminals (cables attached on the top of the battery)? You also have some type of clamp, or bolt to hold the battery in position so it doesn't roll around under the hood when you go around corners over bumps etc. Top Mount:Loosen the nut on the negative cable 1st. If you have side mount cables, remove the

Sound like you have it covered ... 1989 Yugo Hatchback

2003 Dodge Durgango, trying to remove the drivers side headlamp. Removed three bolts but I have one nut or plug on the top right side if you are looking at the lamp from the front that i do not know how to remove.

It's not a bolt. It's a plastic ball and socket (to keep the headlight in place when you change out the bulbs). Give the headlight a good tug and it will come out. ... 2003 Dodge Durango

Can i readily change a rear shock bushing making a annoying racket going over the smallest of bumps is it a rubber insert i removed pieces of what seems to be rubber from around the top nut of the shock inside the trunk......

The bushing come with new shocks.\015\012you may find good ones at your local junk yard. ... 1999 Buick Century

I'm having trouble finding access to the rear shock absorber on my 86 GLE 740 wagon. I know that bolt access can only be found on the interior of the vehicle, but cannot find it. Recommendations?

Try removing the boot/trunk liner, the access is usually found there ... 1985 Volvo 740

Van shocks Remove top nut on rear shock

... 2004 Ford E-350 Super

How do you brake the top nut on the front top shock


How do you remove the front struts. I cant find the top of them without removing the dash ?

I have not heard back from you; did you find the strut tops? Thanks. ... 1992 Toyota Previa

Need to replace broken front driver side wheel stud on 04 impala - seems like i have to remove hub to make room to push stud through? can someone confirm? if so, how do i get hub off - is it just a matter of removing the axle nut? I don't have a socket big enough to do that, so don't want to buy one unless i have to :). Also, sure would be nice to find an exploded view digram somwhere which names the various parts! thanks!

In the perfect world you are to remove the hub and bearing assembly and yes you would take the axle nut off,but when you are paid flat rate as a mechanic you must beat factory quoted time to make money,so with that said,remove the wheel after c ... 2004 Chevrolet Impala

Audio system im trying to replace the audio system in my car and im having trouble with two things 1 finding out how to remove the front dash to get to the audio deck how do i get to the deck to swap it out 2 getting to the rear speakers to change the blown out ones with new 6x9 speakers how do i remove the rear panel to accsess the speakers

#1. Remove 2 screws above speedometer. and then remove the 2 screws under the AC/heater control\015\012#2. to get to the rear speakers you can either go through the trunk to remove the speakers or take the back seats out.\015\012you dont ... 1998 Pontiac Grand Am

I need to know if I need any special tools to remove and replace the ac pump on a 2000 gmc Z71 sierra with a 5.4 ltr motor. Also it would help to know the best way to get it out. It appears to look like the way to go would be to remove the passenger side front tire and inner fender well and approch it from the lower side rather than comming down from the top. ????????

I dont think so but u have the right idea about removing it from truck go boy go ... 2000 GMC Sierra

Suspension how do i remove the rear srpings so that i can replace them with new ones.there's a weird nut or somethin at the top of the shocks that i cant figure out how to get the shock off.can you help me please?

The shocks are held up with 2 nuts. one on top and on the button.\015\012Do you have a sring compressor???? if you don't I sugguest that you take the pro. and get them do it.\015\012if you are careful on change the spring, it can kill yo ... 1994 Nissan Altima

Rusted up shock nuts

Grip the shaft where it meets the shock with a pair of "vise grips" or a small pipe wrench. use a small wire brush to get the rust off the threads.be carefull not to do this with the new one. the groves on the shaft will ruin the new one. also ive us ... 1989 GMC C1500

2008 Chrysler T&C Front Struts Top Nut Removal

I would not suggest doing this unless you have a wall wounted strut machine...super dangerous.but if you want they have quick struts with new strut, coil ,and top plate. ... 2008 Chrysler Town & Country
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4911 seconds