Having problems with your 1992 Toyota Camry V6 ?

How to replace a knock sensor of toyota camry v6

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1992 Toyota Camry V6

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Just got a 1992 Toyota Camry LE 4 cylinder and the check engine light came on. The code displayed 52, knock engine signal. Does this code indicate I need to replace a sensor? Is there a larger issue with the engine? Or could it just be a loose wire? Is this something I could easily replace myself? Thanks for reading and feedback.


... Cars & Trucks

My mechanic stated that I need to replace the two knock sensors for the Toyota Camry 1993 6cyl. Well I have a check engine light and the diagnostic calls for that Please let me know if I really needed and what willl be the impcat If I do not replace. The car is consuming a lot of fuel it is the reason


Http://www.ehow.com/about_5704398_knock-sensor-do_.html ... 1993 Toyota Camry V6

How to replace a knock sensor 1992 toyota camry le v6


... 1992 Toyota Camry V6

How to replace knock sensor on a 1996 toyota camry 2.2 engine


... 1996 Toyota Camry

How do I replace a knock sensor for a 1992 toyota camry v6 le


First, I would like to mention that most knock sensor codes are not caused by the knock sensors, but a mechanical problem with the engine. The knock sensors cannot differentiate between noises caused by mechanical problems like a bad pulley bearing, ... 1992 Toyota Camry V6

How to replace a knock sensor of toyota camry v6


... 1992 Toyota Camry V6

Where is the knock sensor on a 2003 Toyota Camry?


Code p0325 = ecm engine control moduel ... 2003 Toyota Camry

I have a 91 toyota pick up with a 3.0 im getting dtc 52 after driving short distances. I have replaced the engine (short block and reman heads) for an unrelated problem and along with that i replaced the knock sensor and pigtail harness. After I had replaced the sensor there was a fault set every time the the vehicle was revved up past idle, I found that the new sensor was bad and replaced it again and now I have my current problem. I have overlaid the harness with a shielded wire and i still ge


... 1991 Toyota 4Runner

Where is the anit-knock sensor on a 1996 4 cyl toyota camry


Should be on the side of the block facing the firewall. It may or may not be contacting coolant so you may have to drain the radiator.Keep in mind knock sensors almost never fail. You may have an engine component making a noise or vibration the ... 1996 Toyota Camry

Toyota Camry Knock Sensor Problem The top of the radiator on my 1993 3.0 lt Toyota Camry V6, 3VZ FE engine split some months back and it overheated. I have since sorted out the head gaskets and it seems to be running okay. However the check engine light comes on once the engine warms up. Previously this light was coming on soon after the engine overheated, but I thought that it would go away once the repairs had been done. When checking the fault code it comes up that there is a fault with the ?


Hello. You have posted an excellent question.\015\012\015\012The code 55 you are getting, in Toyota terms, as as follows: \015\012\015\012"No number one knock sensor signal to the ECU fo four crank re ... 1993 Toyota Camry V6

My Toyota camry 2004 had it's abs light on. The front brake pads have been replaced but the light is still on. An auto electrician after diagnosis suspected that the abs sensors arevall bad. How do I get to replace the sensors? at what cost both front and rear?


... 1990 Toyota Camry

Knock sensor location in 92 toyota camry - 1992 Toyota Camry V6


... 1992 Toyota Camry V6

Toyota Camry Knock Sensor Problem The top of the radiator on my 1993 3.0 lt Toyota Camry V6, 3VZ FE engine split some months back and it overheated. I have since sorted out the head gaskets and it seems to be running okay. However the check engine light comes on once the engine warms up. Previously this light was coming on soon after the engine overheated, but I thought that it would go away once the repairs had been done. When checking the fault code it comes up that there is a fault with the ?


Replace knock sensors ... 1993 Toyota Camry V6

Problem with toyota camry knock sensor switch


Ther are two, they are located below the intake manifold. not for the weekend guy.cost very from dealership to aftermarket. ... 2000 Toyota Camry

2005 Toyota Camry - knock sensor


Your sensor went off because it overknocked.\015\012Try using a different type of fuel with a higher octane.\015\012Erase the code and use the better gas. if it comes back then we will worry about replacing it. ... 2005 Toyota Camry Solara

Voltage to knock sensor on 1993 Toyota Camry 2.2L


... Magellan RoadMate

1998 toyota camry 4 cyl. replaced o2 sensor,


... 1998 Toyota Camry

How to replace the front oxygen sensor on a 2003 toyota camry


... 2003 Toyota Camry

Location of throttle position sensor and how to replace it 1997 toyota camry 2.2 4cylinder


HelloAt the point where the air intake hose is connected to the engine is a part called the "throttle body". the TPS is attached to the outside of the throttle body. See picture below. ... 1997 Toyota Camry

1994 toyota camry, has ruff idle, wont accerlerate. have replaced spark plug and wirers, rotor and cap, air filter, fuel filter, oxy sensor, injectors, fuel regulater,throttle postion sensor,idle control sensor


Chang the timeing belt if you have high miles ... 1995 Toyota Camry

My 96 Camry check engine light is on and it has been twice diagnosed as a bad knock sensor. The engine runs fine (29/30 miles on hwy), I do not hear any knocks. I've reset the code (by removing battery cable), but it reappears after 4-6 miles. Do these go bad? The Toyota service dept didn't think so. Is changing a knock senor difficult on this (or any) car?


1998 Camry LE 2.2, is the knock sensor in front of engine at the manifold?If it is will I have to drain the coolant as well ? ... 1996 Toyota Camry

How difficult is it to find and replace the transmission revolution sensor (speed sensor NC) on a 2004 Toyota Camry LE. I found the part on line for around $40.00 to $50.00. I am wondering if this sensor is located on the outside of the transmission and if this something I can do myself. If it would be best to let a professional do this, how much labor do think is involved? Knowing this will protect me from getting ripped off. Thanks, John


... 2004 Toyota Camry

My toyota camry is 2005 LE. It is failing smog test because the sensor showing engine failure. We use a sensor tester and my son it says PO500. What should be done and how much is the replacement part?


Hi,\012to test the sensor correctly, you will need the electric value parameters within which the sensor operates. However, for expediency, it would be to your advantage to have someone plug in a handheld readout device to the car, and it will ... 2006 Toyota Camry

I HAVE A P0016 PROBLEM ON MY TOYOTA CAMRY 2007 I ALLREADY REPLACE THE CAMSHAFT SENSOR AND THE CRAMSHAFT POCITION SENSOR AND I HAVE THE SAME ERROR CODE CAN SOME ONE HELP ME WITH THAT THANX.


This code is not specific to a Cam position sensor failure, sensor failure may set this code. Below is a TSB (technical service bulletin) regarding this code. Keep in mind when replacing cam or crank sensors, they may need recalibration which is done ... Toyota Camry

Where is the knock sensor on 1995 camry 3.0l - 1995 Toyota Camry


... 1995 Toyota Camry
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.7038 seconds