Having problems with your 1992 Honda Accord ?

Can the motor came lose for the transmission and be removed from the top.

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Not Easily that I can think of. Usually the Transmission is dropped down in these vehicles. If you put it up on Jack stands, you'll need to elevate the vehicle from a center point so you can place the stands under the jack points to hold it up. You can usually disconnect the Drivers side Drive shaft and separate the engine and Transmission and lower the transmission done through the opening. It is possible to lift the engine and Transmission together through the top and then Separate them but that is a lot more work then doing it the other way. You can get a loaner Transmission jack from some Auto Zone locations which will make lowering and raising the transmission a lot easier.
Repair Help & Product Troubleshooting for 1992 Honda Accord

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Can the motor came lose for the transmission and be removed from the top.


Not Easily that I can think of. Usually the Transmission is dropped down in these vehicles. If you put it up on Jack stands, you'll need to elevate the vehicle from a center point so you can place the stands under the jack points to hold it up. Yo ... 1992 Honda Accord

I have a 2001 Mitsubishi Spyder with a V6. I am attempting to replace the clucth. I have removed all the transmission mounts, both drive lines, the hydraulic clutch slave cylinder, starter and all the bolt that secure the transmission to the motor. The transmission is approximately 1/4 of an inch from the motor but will not completely separate. It wobbles a feels to be lose. It appears as if the transmission shaft will not completely separate from the clutch assembly. Have i forgotten a step or


Nope, you are on the right course. Look for the bolt that you overlooked. It is failry uncommon for a clutch plate or pilot bearing to cause what you describe, unless the vehicle has had water or corrosion issues, still, the area is essentially prote ... 2001 Mitsubishi Eclipse Spyder

2007 Kia Optima 2.4L After swapping the motor and transmission stopped engaging. Transmission was working perfectly before motor swap. Transmission fluid has been changed and topped off. Decided to push the car down the road and code p0700 (transmission issue) and p0731 (incorrect 1st gear ratio) came up. When on a jack, tires slightly rotate in all gears besides park. Am I looking for a faulty input/output sensor or output shaft speed sensor? I'd hate to start replacing sensors for no good re


... Cars & Trucks

Replaced motor in a 2000 dodge intrepid 2.7 , transmission is losing a quart of transmission fluid a day there was no leak after putting the motor in but has one now didnt remove torque converter when switching out the motor also


If you are losing one quart that often you have a leak, you can buy a special fluorescent dye to put in the fluid, then clean the engine and trans of all fluid and dirt with a pressure washer, drive it about 20 miles and then using a black light leak ... 2000 Dodge Intrepid

I just purchased a 1991 500 sl. I have the following problems: as soon as the car begins to move, a buzzer sound comes on and stays on. I assume it is a safety issue related to the top, i removed the hardtop but that doesnt solve the problem. the motorized convertible soft top doesnt work; about how much would i expect to pay to repair this? there is a noise when the head lights are activated; is this a signal? i charged the a/c but the freon came right back out. check engine came on; car


You have many issues that are all unrelated.\015\012\015\012Buzzer for th lights is supposed to be when the car is off or door is open telling you the lights are on that would lead me to believe your ignition switch or door pin switches a ... 1991 Mercedes-Benz Mercedes Benz Sl Class

2005 Subaru Legacy GT Manual Transmission - while on interstate, heard a noise and then felt like losing acceleration. Pulled off exit and lots of smoke coming out of exhaust. Not a head gasket - no lights came on, nothing rattling in motor, any ideas?


Sounds like something to do with your turbo.. could be loosing boost through an air leak etc... which is where the oil might also be coming from if there has been a blowout pressure goes out oil comes in causeing smoke and loss of acceleration. ... 2005 Subaru Legacy

Shifter 1987 ford ranger 5 speed wont shift came lose on top of transmission need the ball or bushing that fell off but cant find parts store has no info on this


... 1987 Ford Ranger

I have a 96 chevy pick-up with a v-6 auto. The vehical will not start unless you pour fuel into the throttle body then motor will run until the fuel is gone. I changed the Fuel pump in the fuel tank also changed the in line fuel filter. I don't think the injectors in the vortec intake are working. I removed the intake fuel line on top of the intake manifold and turned the key on fuel came out at a high rate. Is there a cur cit controlling the injectors. Any help out there. Best, Don


It sounds like a bad fuel pressure regulator. If you have not replaced it, here is the steps:\015\012\015\012Removal & Installation\015\012\015\012\015\012Disconnect the negative battery cable.\015\012 ... 1996 Chevrolet C1500

Removed the valve body from a chrysler 46re transmission. The rod that attaches to the top of the valve body (park rod?) came out of the transmisson. How do I re install it?


... 2001 Dodge Ram 1500 Truck 2WD

How to remove the convertible top hydraulic electric motor. Car sat unused for 9 months and now the for


... Cars & Trucks

I just purchased a 2000 lincoln continental for my daughter. She said that the service engine light came on and after that the transmission light came on and went off and came on again. I had the mechanic check it and he said I had a code P1744 and that he would need to check for corrosion and that I need a transmission gasket due to leaking. Could the code P1744 also mean the transmission is going? Also I was told that the top side engine mount is cracked (Dog bone). Is that neccessary to repla


Top mount when go's bad eventualy can mess up other thing's, As for the tran's i would change the fluid and the gasket and filter. They are all right there togather, should cost around $75 ... 2000 Lincoln Continental

The convertible top was working fine and i sop to go in a store and let it up ....when i came back out and went to let the top down ---nothing. i can push it back some and press the up button and you can hear the motor working and it will let up. When i push the down part of the button there is no motor noise and it will not let down. I have had no previous problems with the top. what to do? It is a 97 firebird with the v-6 engine.


Hello. Great car. Consider joining the forum called firebird nation at http://www.firebirdnation.com/forums/ .\015\012\015\012This forum will be of inte ... Pontiac Firebird

2005 Mini cooper convertible: cables for sunroof broken and can't get the sunroof part of the convertible top to slide back. Disconnected and Removed the drive motor, but the top seems stuck and won't slide back to access the screws for top removal/ gaining access to replace the cable mecanisms and cables.


... 2007 Mini Cooper S Convertible

My 1993 Dodge Grand Caravan has a problem with the wipers,the wiper motor works but somehow I think the wiper transmission has failed. I removed the three nuts and pulled the wiper motor off,the motor was not connected to the brackets and I think there lies the problem.My problem now is I dont have a clue how any of this goes back together and I have removed trim pieces to make access to repair but I just dont know where to start and I beg for your help in this matter. Randell


... 1993 Dodge Caravan

Windshield wiper linkage came off wiper motor. do I remove whole wiper motor assembly or can I just remove wiper motor


... Ford F-250

I have 1988 1200 C Sportster,, transmission fluid leak,, transmission fluid getting into my motor oil,, all started 1 day,, check both fluids and went riding,, when check my fluids again,, and ever since,, I have to add tranny fluid,, and have too much motor oil,, so came to the conclusion,, that tranny fluid,, is leaking into Motor oil,, how could this be happening,,, the only thing I can think of,, is a crankshaft seal, in primary case behind front gear drive, input would be appreciated,,


... Cars & Trucks

1999 blazer fuel line leaking on top of motor replaced a motor put fuel lines back in. started engine gas came out of the lines on top of the motor.


Inside the fuel line connectors are "o" rings used to seal the connection. The "o" ring has been damaged or has fallen out when the fuel line was disconnected. When reinstalling the fuel line connection you should always use a suitable "o" ring lubri ... 2000 Chevrolet Blazer

During the last snow storm my windshield wiper motor for my 1997 nissan maxima broke and I had a new one ordered. I went through the process, but when it came to reataching the windshied wiper transmission to the motor they became misalinged. The drive gear in the motor was turning so any marks made before the reinstall the final position before to the transmission was useless, so which position do I reattach it to have the wipers in back the normal rest position.


Did you try removeing the wiper arms them selves . Then reinstall them on the splines so they will be in the correct pisition at park and won't travel to far in the opperating mode . You should be able to put them at any pisition you need to as long ... 1997 Nissan Maxima

Transmission removal pictures for a 1996 ford explorer..i need to know how many bolts there are to remove the transmission from the motor


Dimitri; If the Explorer is a 1996, it will have a 4R55E transmission. 1997 and up is 5R55E transmissions, 1995-1996 is the 4R55E, the 4R70W is on the 2002 and up, and the A4LD is on the 1991-1994 Explorers. Just an FIY ... Ford Explorer

How do I remove the cooling fan shroud from the top of the radiator ? I'm trying to change the cooling fan motor, and I've removed the bolt holding the fan shroud to the radiator, but I can't get the fan/shroud off over the top of the radiator.


I would suggest replacing the cooling fan relay in the fuse compartment under the hood first. Cooling fan motors very, very rarely go bad. You will probably end up having to remove the radiator to remove the shroud. You will save yourself a lot of ti ... 1996 Chevrolet Cavalier

2003 dodge neon, manual transmission with a noisy motor mount, (sounds like metal hitting metal) already changed top left motor mount, still noisy and has already broken. Have had trouble getting the correct transmission mount. (2 differnt ones). The mounts replaced appeared to be in good shape. Any suggestions?


Is there a rubber bushing between the trans and mount. make sure this is secured properly. ... 2003 Dodge Neon

I'm trying to remove my oil pan on a 2000 Silverado 1500 with a 4.3L V6. I've removed all of the bolts, the starter, the transmission cooling lines, the oil level sensor bracket, the front wire bracket, the transmission-to-oil pan bolts, the starter bracket bolts (located on the top, passenger-side of the oil pan), etc. I cant seem to either break the gasket seal or perhaps there are other bolts. Please help


I am not sure, But there could be six more bolts to remove. They will be on the side of the pan, about half way up. three on each side. Sorry for guessing, I work on to many makes and models. Also the gaskets do hold the pan on tight sometimes. If th ... 2000 Chevrolet Silverado 1500

Need repair diagram of 2004 pontiac grand am wiper motor/ transmission & wiper arm connections. How to remove push-pin retainers without damage ,remove cowl air inlet cover , repair or reattach arm on driver-side wiper (that has loosened & fallen away from motor),


... 2004 Pontiac Grand Am

1991 corolla; cooling system losing water, but no visible evidence of leakage under car. When I turn the motor on and top off the radiator, the water gurgles and gets hot fast. must always top off radiator before driving, temperature gauge indicates motor is running hot


Head gasket failure & or warped head \015\012Get it fixed asasp!!! ... 1991 Toyota Corolla

I have to change the alternator on my 2005 Murcery Mariner, which is burried pretty deep at the back of the 6 cylinder engine. I am use to working on older cars where the alternators were typically located at the top front of the engines and were easy to get to. How do I go about removing this one? Do I need to go in from the underside or from the top? Do I need to remove motor mounts?


You need to go from the bottom and through the tire hard job recommend having a shop do it ... 2005 Mercury Mariner
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.6344 seconds