Having problems with your 1992 Honda Accord ?

How to replace key ignition switch on a honda accord 1992 lx

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1992 Honda Accord

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My 1997 Honda Accord (2.2L. automatic transmission) ignition is wired into the door window operating switch. so, to start, I must press that switch while turning the key in the ignition. How do I bypass or disconnect that procedure and start the car directly from ignition to starter? the problem is intermittent. I have replaced the negtative battery cable and ensure that the grounds are tight and clean.

Youll need a wiring diagram form chiltons online or another repair manual It may be testy for an amatuer cause modern wiring is so complicated You may just want to consult a specialist in the field ... 1997 Honda Accord

I own a 1997 Honda Accord V6 and it just wont start. I turn the key in the ignition and it turns but just won't crank. I was told that the speed sensor was the problem by the diagnostic scan that was ran on my car. I was also told that it might be my ignition switch going bad and I heard it was a recall on that part. Also the day that it stopped starting the car was in park and it was on and it kept cutting back like it wanted to shut off. I replaced the Ignition control module and still had no

Check main relay for cracks ... Honda Accord

The wrong key is stuck in my ignition of a 1994 honda accord ex;how do I remove it and replace it with a new ignition switch?

... 1994 Honda Accord

How to replace key ignition switch on a honda accord 1992 lx

Http://techauto.awardspace.com/ignitionswitch.html ... 1992 Honda Accord

My honda 96 accord steering wheel will not unlock. Do I need to replace the ignition key lock?

... 1996 Honda Accord

I have a 91 honda accord and something may be wrong with the ignition switch. When I put the key in the key won't move either way like the switch is jammed

Have you tried another key?You may have to change your ignition lock.....or switch.The electrical switch is bolted to the back of the ignition lock.You will have to remove the electrical switch part to check which one have fai ... 1991 Honda Accord

Honda accord 2001 standard four door lx model Issue number one turn signal and four way flashers do not work when pressed in fuses and relay are fine no problems. Issue number two when the four way switch is pressed in , when the key is removed the engine is still running . Issue number three no key in ignition and the four way switch is pressed in u can operate the power windows

The power windows\015\012 are connected to the driver door multiplex control uni ... Honda Accord

Changed the ignition switch and key for 1998 Honda accord do I need to program it

... 1998 Honda Accord


Yes you can replace the switch yourself, it would help to have a manual though. I have heard of this issue, but first verify that no crank signal is reaching the starter motor solenoid using a 12 volt test light while someone holds the key in the cra ... 1992 Honda Accord

Lost my key to 1991 honda accord. Need to replace entire ignition key system since it was after market. Any ideas how to get old one out without a key?

Well yeah,,, basically it still has the same function,, ignition, start, and power,, all u have to do is just connect the correct wires in their proper place ,, any technician should be able to trace and do this for you,, but it will work,, just buy ... 1991 Honda Accord

Key wont turn on 2004 Alero. If key is inserted and door is opened the alert bell sounds off indicating keys have been left in ignition,but that is all that is functioning. Have tried 2 different keys and ignition will not turn. Need i replace the entire ignition switch or is there a way to determine which part of the switch to replace?

Ignition lock cylinders are pretty notorious for this. You may get the thing to turn by wiggling the key up and down while turning at the same time. I have also had luck in tapping on the cylinder with a screwdriver handle while turning the key. T ... 2004 Oldsmobile Alero

Battery light was flashing Turned key and radio came on. Turned radio off. Attempted to jump start 1990 Honda Accord with no success. Took battery, got it checked and replaced it. Installed battery put key in ignition and nothing, just silence. Not even a click. [email protected]

Check the altenator ... 1990 Honda Accord

Recently bought 97 honda accord. my brake lights and horn did not work,replaced fuse--brake light and horn works but now i cant get key out of ignition unless i remove fuse. is this dew to a key interlock system problem or shift lever adjustment?

... 1997 Honda Accord

I have a 95 Honda civic and I was driving on the freeway went to get off and right when I was down shifting it wouldn't move out of neutral even though the stick was in the second gear position. So I pulled over turned the car off and when I turned it back on as soon as I let go of the key it would stall. So I had it towed home, I replaced the ignition switch, distributor cap, spark plugs, fuel filter, I checked all the fuses in the car and under the hood and I replaced the main relay, now the b

To clarify something you said, the accessories should go off when the key switch is in the start position. Are you getting power to the coil and the computer when the key switch is on and in start ? ... Cars & Trucks

93 honda accord wagon. Replaced ignition coil main relay distributor and vehical has no spark. Checked voltage to ignition coil and both wires show 12v with vehicle is switched on vehicle still has no spark from coil. What have i not checked.

The coil itself can be bad. is the check engine light on? ... Cars & Trucks

I have a 1991 Honda Accord sedan. The ignition switch sometimes sticks in the ''start'' position when I start the car and doesn't automatically spring back to just the ''on'' position. Unless I specifically look for this condition, the starter motor keeps on turning while I drive. Its like it ''catches'' on something inside the switch. What should I replace?

You have to replace your ignition switch. This is not easily done, your best bet is to take it to a locksmith and have him do it for you. If you try to do it yourself you will never get it out of there. ... 1991 Honda Accord

Key is stuck in broken ignition of 1994 Honda accord EX .How do i remove broken ignition and replace a new one .Thanks

REMOVAL & INSTALLATION \015\0121994-95 Accord \015\012NOTE: Do not attempt to remove the ignition switch assembly if you do not have replacement bolts available. These special bolts have break-away heads which shear off when tight ... 1994 Honda Accord

Truck will not crank over while turning key switch. If you cross over the starter solenoid it will start right up. According to a manual that I have, it says the problem could be the ignition switch. I replaced it and it still doesnt crank over. I checked the volt rating through the small wire that connects to solenoid and it reads 4 volts. Also tried to start the truck in neutral and that didnt work, What could be the problem

It is likely the fuseable link on the starter is broken or a wire is loose on th starter \015\012it is a ford so check the selinoid ... 1999 Lincoln Navigator

99 honda odyssey Dealer replaced the ignition switch in the steering column. After they did this, the SRS light has come on in the dash. Also, now, when the vehicle is placed in to park and the keys taken out, the parking light stays illuminated in the dash and the front and rear lights come on. Only way to get them off is to remove the negative battery cable. The dealer says that the problems I am now having are not the result of them replacing or messing with the steering column.

That's bull....it is because they did the work on your vehicle. If they do not fix the problem they created, a simple comment to the effect that they will be talking to your attorney will change their attitude.\015\012\015\012What was the ... Honda Odyssey

The ignition lock cylinder, in my 1993 Honda Accord Wagon, has malfunctioned. I can only get the car turned on and off with great difficulty, and the key cannot be removed from the lockset. The electrical portion of the ignition switch works fine, it is the mechanical lock portion that has malfunctioned.

... 1993 Honda Accord

I have a 1990 honda civic with a 4spd manual transmission and it will not start with the key but u can kick start and will run find, i had the starter tested and it was good, then i replaced the ignition switch and it still will not start by d switch

You stated you can kick start it? DO you mean pop the clutch while moving and start the car? If you do then I don't think its your starter or igniton. It your clutch depressed sensor (just like a neutral safety switch on an automatic) it keeps the ... 1990 Honda Civic

98 honda accord ex v6. key switch went out. replace whole colum. now the car want start. changed both end pieces on the end of switch still want start.

Does the engine crank over but no start? Is there an alarm system? Where was this column purchased from and is it the exact replacement? Thanks. ... Honda Accord

How do I replace the ignition switch on a 1999 chevrolet suburban? After the key is placed in the ignition switch, the key becomes very hard to turn and activiate the starter. I ''jiggle'' the key, turn the steering wheel, place my foot on the brakes...no help. Ignition is probably worn out and needs to be replaced. How do I do it, please. Also, how do I identify the low pressure nozzle for the air conditioner? The two outlets are virtually identical and there is no indication on either nozzle/h

For the a/c, if caps are still on valves, blue side is low and red is high. Also, looking at the the valves one is slightly smaller. The smaller one is the low side.\015\012\015\012As far as the key cylinder, you must remove steering wheel, lock pl ... 1999 Chevrolet K1500

How do I replace the ignition switch on a 1999 chevrolet suburban? After the key is placed in the ignition switch, the key becomes very hard to turn and activiate the starter. I ''jiggle'' the key, turn the steering wheel, place my foot on the brakes...no help. Ignition is probably worn out and needs to be replaced. How do I do it, please. Also, how do I identify the low pressure nozzle for the air conditioner? The two outlets are virtually identical and there is no indication on either nozzle/h

You have to take the steering column cover off and then find the little hole near the ignition tumblers. you put the key in and turn it forward one or two clicks, find a small screw driver and push the little pin in the hole. that is what holds the ... Chevrolet 1500

1999 honda accord ex v6 won' t start sometimes replaced ignition switch 3 time inless than 2 months

... 1999 Honda Accord
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4515 seconds