Having problems with your 1992 Chevrolet C1500 ?

No rev. hard and high rpm shifting in fwd.

\015 No warning signs leading up 2 the loss of rev. drove it home with fwd. gears shifting at high rpms and hard.\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Check the fluid
Repair Help & Product Troubleshooting for 1992 Chevrolet C1500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No rev. hard and high rpm shifting in fwd.


Check the fluid ... 1992 Chevrolet C1500

My 2000 gmc sierra z-71 has started idleling at about 1300 rpm after driving for a while. when i turn it off and restarted it would idle fine for a while then start idleing high again. it is getting to where sometimes now it will idle high as soon as i start it. when it is idleing high the trans. does not shift when it normally does it shifts at a lot higher rpm than normal and shifts hard like it has a shift kit in it. any suggestions


... 2000 GMC Sierra

My 1997 5.7L 2wd will not shift properly, it will rev way too high before even shifting into 2nd or 3rd I half to get off the gas at a high rpm for it to shift, alot of noise from engine/fan when i hit tha gas not alot of movement, reverse works good, cannot shift with the tree 1-3, dosent seem like it would take it to 5th or 6th on the highway, has a loud squeal that comes off something in the engine bay when mashing gas and high rpm?? trans and truck has 190k miles havent serviced the trans s


If it 4l60e it shift on it on the computer control it to shift the trans is bad slipping or not shifting ... 1997 Chevrolet C1500

I have a 96 chevy cavalier 2.2l 5spd manual transmission...new clutch 3 months ago...fluid level is full...shifts with no grinding...but when u release the clutch... It takes a minute for it to start pulling... It started whining ...this happens in all gears and rpm ranges...if u rev it high it will engage tranny hard...like it's automatic with a 4000+ stall converter... Any advice would be appreicated


Sounds a lot like the throwout bearing is binding on the input shaft and not releasing the pressure plate. In any case, it needs to come apart to look before anything else gets damaged.. ... Chevrolet Cavalier

Hard shifting My 91 supra shifts hard and at high rpm the first two times it shifts when the car is driven for the first time each day or if it has sat for a few hours but after the first two shifts it does fine. Does any one know what is going on?


Does this trans have a throttle valve cable?, if so it may need to be re-adjusted, it controls when the trans shifts based on the throttle position, if it doesn't have this type of hydraulic control you may have an issue with one of the ... 1991 Toyota Supra

Ihave a 1998 nissan maxima it idles fine in park and when i shift into gear it idles up. When it shifts it slams hard and it takes awhile to shift when it does high rpm's


... 1998 Nissan Maxima

I have a 1993 Nissan Altima and the RPM is Running High at 2000 RPM and 3000RPM. I had a problem with my car only running a few miles and it shutting off, and when it cooled down it would start back up. It was a distributor problem.. I had gotten that fixed. It was running great until the RPM started going high.. The car aslo has hard shifting in reverse and going into 1st gear. I'm trying to figure out what the problem is. If you could help with Ideas that would be very much appreciated.. Thank


Sound like a vaccum problem check all hoses to verify they are in good condition ... 1993 Nissan Altima

Transmission is not shifting properly on my 2000 nissan frontier 2wd pick up, auto It revs at 3-4000 rpm instead of a nice consitent 2000rpm, revs real high and doesnt change gears intill 20 mph, it doesnt skip gears at all, but it just doesnt shift at the right time. also doesnt really go over 50 mph unless I want the rpms to rev at 4000- 5000 or more


You could have a bad valvebody in your transmission or a bad pump in your transmission or your clutches are bad. In any case you have a bad transmission. Please rate my answer. ... 2000 Nissan Frontier

High rev when car is first started, until it warms up, it has a high idle. But when shifting gears it has a high rev, about 2000- 3000 rpm.


Sounds like the throttle plate needs cleaning. ... 1998 Honda Civic

My 2001 Elantra is not shifting right. Sometimes it work just fine. Other times it wants to shift hard from 2nd to 3rd. After that it remains in 3rd till I turn off engine. Even when I slow down or stop it stays in 3rd or Drive. At 55 mph it revs at 3000 rpm, should be 2000 rpm. My alternator is also squealing when I start up the car. Do you think the alternator is not providing enough power to let transmission shift correctly or do you think this is a speed sensor issue. Again sometimes car


Start with the simple things and check the fuse and Wire\015\012 leads at the ECM's Transmission \015\012Control Module and the Transmission it self. Look for any damages to the\015\012 wire harness and leads. Try disc ... 2001 Hyundai Elantra

Trans shifting hard my trucks transmission shifts real hard when im in higher gears like 3rd and 4th and my rpm's go real high then when it shifts it jerks the whole truck. someone i need help????


I had a similar problem with my 1997 F250 only with 1st & 2nd gear. At the same time the ABS light was on and the speedometer was acting eratic. In my case it was a bad speed sensor on the rear differential. About $30.00 and took me less than ... 1998 Ford F150 Regular Cab

My 95 Jeep Grand Cherokee will shift but not until it is in high RPM's range 2500-4000 but it does not shift hard


... 1995 Jeep Grand Cherokee

My 1991 240sx is at my local mechanics shop. He is getting abnormal transmission pressure readings and has not been able to diagnose the problem or has not tried hard enough. The care does not shift into second until it reaches almost 5000 rpms and the shift is hard. It also revs high when it first starts.


The 240sx auto transmission will not shift from 1st to 2nd until going about 25 mph with gentle throttle (35mph with full throttle). I do not recall what engine RPM this corresponds to, but i know it always seemed high. \015\012\015\012As ... 1991 Nissan 240SX

My 2001 Manual mustang revs high whenever taken out of gear. When shifting, the RPM's increase and stay high even in neutral. When in neutral the only two ways to get the rpm's down is to completely stop (which after a complete stop still takes a moment to lessen) or to put the car in gear. Please help, i heard main cause is most likely a vacuum leak, but i dont know how to identify which hoses to investigate. Please help!


... 2001 Ford Mustang

Wont rev over 3500 rpm and under hard accel. wont shift wont rev over 3500 rpm


You should go buy a Haynes or Chilton manual to figure this out. Costs about $15. There could possibly more than one reason for this happening. Anything posted in response could only be speculation. ... 1993 Nissan Maxima

2000 Saturn SL2 engine will not go below 1700 rpm when in gear and driven up to 30 mph. At 30 mph, shifting into neutral, engine will stay at 1700 rpm. Will come down at stops and if I rev it up. Accelerates fine, shifts a little hard when slowing down to stop


... 2000 Saturn SL

Will not rev above 4000 rpm. Shifts hard


Possibility of fuel line filter being full of gunk, replace with new one? ... 2000 Saturn L-Series

I have a 2006 fwd Honda Pilot lx with a hard shifting transmission and the D flashing on the dash each time it occurs . Once the D starts flashing the check engine light comes and the D will continue to flash and will only stop when the ignation is turned off. At times the rpm goes beyound 5 before a shift is archived. Computer diagnosis revealed Error code P0752 -shift Soleniod stuck on A. I have not been able to find a technician who knows what to do and will appreciate any advice to help reso


Replace your 3rd ... 2004 Honda Accord

2002 Saturn l200, seems to rev a little high and doesn't shift up as soon as you'd like -- also shifting a little hard. I've been led to suspect the shift solenoid might be the issue. How would I know, and how much much labor goes into replacing these?


... Cars & Trucks

WHEN DRIVING AND THE TRANS NEEDS TO SHIFT ON MY 2005 VW JETTA 2.5-5 NEW STYLE THE RPM'S REV UP BRIEFLY THEN THE TRANS WILL SHIFT THE SHIFTING IS SMOOTH BUT THE HIGH RPMS WORRY ME.


When vw started to use the computer controlled gearbox system a criticism was the shift was very harsh,to counter this they made it rev slightly before changing.so that you know the system, try this out....without touching the gas.....put it in d and ... 2005 Volkswagen Jetta

2001 GRAND am GT LOW ON POWER AND WON'T SHIFT UNTIL IT IS HIGH RPM THEN SHIFTS HARD AND DOES IT AGAIN TO NEXT GEAR. iF i LET OFF IT WILL SHIFT BUT VERY DOGGY. cHANGED PLUGS & FUEL FILTER BUT DIDN'T HELP. cOULD IT BE A WEAK FUEL PUMP?


Check the transmission fluid the car needs to be running and in park to do so, if it is low that could be your problem if not look at the fluid it should be red, if it's brownish and it has a burnt smell to it you may need transmission work ... Pontiac Grand Am

Car not shiftting right. The check engine light came on and we pulled a code of P0507 ''Idle Control System RPM high''. The throttle body was cleaned out with throttle cleaner and the light stayed off for a week and has now come back on. The smae code was pulled and I was told it was the valve, so I have order the part and will replace it. But now when the car hits 30mph it should shift, but it revs and does not want to go. If i slam on the gas it will finally shift and go normally. My question


THE IDLE SPEED SENSOR SOUNDS LIKE IT IS FAILING. THE IDLE SPEED SOLENOID CAN PREVENT THE TRANS FROM SHIFTING AT DESIGNATED RPM'S. THE THROTTLE POSITION SENSOR WORKS IN CONJUCTION WITH THE IDLE SPEED SENSOR TO TELL THE COMPUTER THE DEMAND FOR FUEL AND ... 1999 Buick LeSabre

My 1994 F350 yesterday started to acted up, the overdrive off light keeps flashing, and the RPM gauge stop working, I can race the engine up by pushing the gas peddle and the RPM gauge starts to work and the overdrive light goes off, if I drive the truck and get up to high speeds the RPM gauge and lights goes off then also. the tuck does seem to shift hard, the guy I got the truck from said it was because he had the transmission rebuilt 5 years ago and had a heavy duty kit put in it. The truck r


You may want to check the cpu and see if he upgraded it when he did the trans,bully dog makes a tuneable one thats really good. ... 1994 Ford F350 Crew Cab

What would cause trans to shift hard and rev up high before shifting


Check for a vacuum leak. If the vacuum lines are old, dry cracked, or brittle, replace them. Also check the condition of the fluid, if its anything other than a red color, consider having the transmission serviced. Replacing the filter and fresh flui ... 1994 Dodge Spirit

Will not run smooth has a hard time finding the correct rpm range because of high idle speed the tansmission hits hard when down shifting and coming to a stop I'm thinking that a sensor of some type is out


That Sounds Like It Could Be The TPS Sensor Bad (Throttle Position Sensor) On The Trottle Body ... 1996 Ford Windstar
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.6611 seconds