Having problems with your 1991 Plymouth Acclaim ?

I have no signals and when brakes lights are on, lose brake light to either side turn signal is set on

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

\015\012If you activate the turn signal switch and you step on the brake pedal, the turn switch (on the steering column) deactivates the brake light to make the signal light more visible. The bulb for the stop and turn lights is the same.
\015\012Turn hazard lights ON. If they don't blink, replace turn/hazard flasher, If one or more lights don't come on, replace bulb.
\015\012Check fuse and circuit wiring for broken or loose connections. If all looks fine, check following:
\015\012If front turn lights work fine, check brake/turn bulbs.
\015\012If turn lights come on but don't blink, replace turn signal/hazard flasher.
\015\012If front and back turn lights don't come on, replace switch on column.
\015\012Let me know how it worked out, Good Luck
Repair Help & Product Troubleshooting for 1991 Plymouth Acclaim

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have no signals and when brakes lights are on, lose brake light to either side turn signal is set on

Hi!!\015\012\015\012If you activate the turn signal switch and you step on the brake pedal, the turn switch (on the steering column) deactivates the brake light to make the signal light more visible. The bulb for the stop and turn lights ... 1991 Plymouth Acclaim

2000 Ford Expedition-Left turn signal and brake light in rear does not work, and left front flasher works but flashes quickly. The front and rear right side of turn signal and brake works perfectly. I changed bulb for left rear and on left top of vehicle for brake bulb, but still does not work. Also, my wipers do not stop on their own (as if off by one on each speed setting, because each speed works but not the "off" setting-it just stays on "1st speed setting) & I have to take fuse out of box f

You may have some wiring 'grounding' problems in the areas of concern. Remove each connection, and clean any rust. Place a light film of grease and a fresh star washer next to ground point, then the wire connector and other washers. Tighten firmly. C ... 2000 Ford Expedition

I have a 2001 Chevrolet Malibu & was side swiped a few months ago. After this accident my turn signals sometimes work & sometimes they don't. We have checked the fuses and the light bulbs & all this is fine. Brake lights & hazard lights have never quit working. I went to O'Reilley's & they told me that I have to replace the top half of the steering wheel column which is $99 with a lifetime warranty. This is what controls the turn signals, windshield wipers & brights on either side of the steerin

Failure of the Multifunction Switch (Turn Signal Switch) is relatively common and will cause the lighting problems you are describing. This failure probably has absolutely nothing to do with the vehicle being side-swiped.\015\012\015\012 ... Chevrolet Malibu

Ford f600 1987 --stop lights not working , switch on pedal is good -no 12 volt on either side of fuse , need a wiring diagram , truch has mini master cyl and a booster motor which runs when pedal is pushed when engine is not running. Where does power come from for stop lights? Turn signals work ok, no volt from brake circuit going to turn signal switch.. A wiring diagram please. tk has hyd brakes.

I have the electrical diagram and need to scan it first ( haynes manual), it's very late night here and I'll send it to you tomorrow morning. ... Ford F 450 Super Duty

When I press brake pedal only one side has brake light. When I turn on headlights both back running lights come on, but when I press brake pedal only one side lights up. Turn signal only works on one side, the same side as the brake light that works. I have replaced fuses, blinker fuse, and light bulbs and can't get turn signals to both work and brake lights to both work.

Do you have a towbar fitted?? if so, check wiring installation. If not you may have a bad earth connection on that light cluster ... GMC Vandura

Right side brake light doesnt work,also turn signal.Right side back up not working either,changed bulb and still not working.Tail lights work.When turn left turn signal on it does makr right side flicker on opposite

... 1996 GMC Sierra

I have a 2007 Shelby GT500, when I use the turn signals only 2 bulbs blink on each side, the 2 outer most. The inner lights seem to only work as running lights, they do not light as brake lights either. Is this correct? I want to add sequential turn signals and cannot figure out how they'd work since the inner most lights are not blinking.

... 2007 Ford Shelby GT 500 Convertible New Cars

Try to hook tail,brake,turn lights up on flat bed truck but brake and turn will not work right both blink when turn signal is turn on. Can they be hooked up to a tail,signal,bake light set? if so how and whats my problem if hook turn to light by themself with brake and tail lights hooked to different light set works fine would like to just use one light set if can if not then guess will have to use two wire color green red dots green yellow stripe red dots green white stripe red dots other wire

... Toyota Pickup

The left turn arrow on the driver's side does not work nor do the front and rear left turn lights. The left turn signal flashes rapidly on the dashboard. The left brake light does not work either. The right side operates properly.

If the light flashes rapidly one of your bulbs is out. Turn on the flasher and see which one does not blink and replace the bulb. If only your left brake light doesnt work chances are its the bulb. Anytime something like this does not work check t ... 1997 Ford Expedition

I have a 1995 Nissan Altima GXE that has an issue with the back lights. Only 2 of the bulbs on the left side work, none on the right. The 2 on the left go on when I turn on the running lights. Nothing happens when I hit the brake pedal. Turn signals do not work either when using them normally, but they do turn on with the hazard lights. I have replaced all bulbs and double checked the connections. I checked all fuses as well. Wiggling the wires at various points does nothing. The

There's also a unit called the electronic flash unit / module that controls your signal lights and it can affect your brake lights... this unit is not tied into your hazards so one will work without the other.. unfortunately, I don not know where thi ... 1995 Nissan Altima

My turn right turn signal stays solid till i pull the turn signal forward towards me and hold it thats the only way it will flash and my brakelight wont work on the right side either tried changing the brake light bulb and it still wont work

May be the contacts in the switch, the brake lights and turn signals use the same circut on many vehicles ... 1989 Chevrolet Corsica

My 88 jag xj6 has a tail light problem. the turn signals work. the brake lights work. the tail lights work. but if you have the turn signals on and hit the brakes,there are no lights on that side in the rear. the blinkers still work in the front. the opposite side shows brake lights. i'm confused as to what would cause this. any advise?>

Hi, you have a bad earth connection either where it connects to the light unit or to the body, suggest you clean and refit at these points. ... 1988 Jaguar XJ6

Wiring problem for 2005 Pathfinder trailer hitch harness. Brake lights work on left side, no running light or turn signal. Right side turn signal and brake lights work. Replaced harness, but result is the same. Tested trailer wiring with another vehicle, all systems fuction. Should I by-pass the harness and wire tow vehicle side thru taillights.

Sounds like the converter is bad. Go to http://www.etrailer.com/faq-wiring.aspx and check the testing section. Hope this helps. ... 2005 Nissan Pathfinder

1998 cavaleir 1998 cav has no brake lights & no turn signal lights emergency flashers work as well as tail lights I haven't found any blown fuses either new bulbs on both sides of tail lights too

I have a 92' Chevy Cavalier and am having the same exact problem i've checked all the fuses and relays everything there is fine where do i need to look next someone please help..... ... 1998 Chevrolet Cavalier

Have a 89 dodge raider;;have no turn//4-way flashers or brake lights;;all fuses good;have power to brake light switch and leaves switch when apply brakes;;found round flasher[4 way flasher]know this because have power to it on one side and when pull 4-way fuse loose power;;square flasher beside it;has power to it;loose power when i pull turn fuse[also when i remove turn fuse i loose warning lights on dash and hear relay on middle or pass side kick out]i got another turn signal switch[columum swi

Hey HotrodHarley, \015\012 I would pull out your hazzard switch and clean it real well. the signal, brake lights are connected to the hazzard switch and if it doesn't fully disengage you wont get the brake lights or the flashers to come on. ... 1987 Dodge Raider

1984 chevy 1500 driver side brake and signal light not working. Parking light works but is too bright. volt metre shows a ticking the same readings as the passenger side until a bulb is inserted then shows nothing. recently problem got worse. signal light indicator on dash for right hand signal stays on when lights are turned on and brake lights and signals don't work at all. was going back to normal after a drive down the road but now stays like that. -Other things that might be help

Sounds like a short, no way of knowing fwhare for sure till You run a tester the lenght of the wire. ... Chevrolet 1500

Passenger side taillight turn signal upper brake light not working, both back up lights not working either...not a fuse

... 1999 GMC Yukon

2002 Jeep Grand Cherokee - Brake lights not working properly. With lights off Driver side no brake light when brake is engaged. With lights on and all rear lights on, engage brake - no driver brake light and passenger side lights go out completely. Top brake light works great and all turn signal lights work. Is it a ground short when brake is engaged?

The problem is that the tail lights, light bulbs get too hot and melt the plastic where the bulb socket goes into the lens assembly. On the lens assembly you will see one to three metal tabs where the socket fits into. Lift up the tab a little bit wi ... Jeep Grand Cherokee

Rear lights the flashers work great but the brake lights seem to be dim and when you turn on the tail lights they seem to be bright and the turn signalls flash fast and only one bulb on each side lights up for the brake and turn signal.

Youhave a bad ground problem. remove thr lenses, and chech the wiring behind. if it checks good, then check the wiring behind the rear panel ... 2000 Chevrolet Express Cargo

I have a 1991 Volvo 240s recently I had to replace the circuit board on the left side taillight assembly because the connecting parts for the turn signal were worn out. Upon doing so the turn signal and one of the brake lights worked however the rest of the lights in the assembly stopped. I replaced the fuse and checked all the bulbs so I am really at loss for what to do because the lights on the other side and the headlights do work. What is wrong with the lights on the left side, and how can I

This is most likely caused by a poor ground.\012If you have a multimeter, measure resistance between each socket shell to a clean ground elsewhere; you might have the best luck on hardware inside the trunk on an older car.\012\012If you don't h ... 1991 Volvo 240

When I turn on lights of 91 Camry, tail lights & backup lights are not lit. Rear side marker lights & license plate lights are lit. When I step on the brake, all the rear, stop, backup, plate and side marker lights are lit. So I changed all the bulbs (4 sets). Again, the usual rear lights not lit. When I step on the brake, only one bulb in each set is lit. Please help ASAP.

I have a 98 Camry and was having problems with tail lights and fuses. I kept blowing a fuse which was making my tail lights not work. I tried paying very close attention to when they would be working and all the sudden not be working. I know it so ... Toyota Camry

I have a 2000 Ford Escort. My left turn signal inside is blinking real fast. Outside it isn't working. Also, the brake light and Haz.Flasher isn't working on the outside either on the left side. Running lights are fine. Pulled both bulbs and they look good. Also looked at all the Fuses inside the car and none are burned out. Not sure what the common problem could be.

Try with a new bulb and check for a good ground at the bulbs sochet ... Ford Escort

1997 Ford Light Duty F-250 Problem: Passenger rear brake light / signal light Brake light is intermittent. Signal works most of the time. Emer. flasher is intermittent. Center & left side work fine. I changed the lamp, checked and cleaned the socket. It works for a while then no brake light but turn signal works. While working on it over several days everything would work then no brake Maybe no flasher. Someone told me last month it was out but when I checked everything seemed fine??

It appears that you may have an intermittent earth connection between the globe sockets and the vehicle body.\015\012First, check how well the metal base of the globe fits into the socket. If it is a bit loose remove the globe, squeeze th ... Ford F-250

I have an 1988 Volvo 240 DL, when my head lights are off the drivers side brake light works and the passenger side tail light acts as a brake light. When my head lights are on, the drivers side brake light works but not the passenger. Tail lights and turn signals are fine, bulbs are fine and wiring. I took it to a shop and they didn't know what the problem was. Any tips?

... 1988 Volvo 240

I have a 91 F-150 XLT Lariat.. Brake Lights and both signals work fine with the lights off, but when the lights are on the Left signal and brake light does not work...(tail light DOES work though..only the brake light and turn signal on the left side doesn't) I have no idea what the problem is. Wires and plugs are fine, but it does work with the head/park lights are off. Thanks for the help!!

... 1991 Ford F150
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.4193 seconds