Having problems with your 1991 Oldsmobile Cutlass Ciera ?

How do i install new power steering pump in my 91' olds ciera cutlas

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1991 Oldsmobile Cutlass Ciera

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do i install new power steering pump in my 91' olds ciera cutlas


... 1991 Oldsmobile Cutlass Ciera

I need to replace the o-ring that prevents power steering fluid from escaping from the power steering pressure hose of a 2003 ford windstar. When you change the power steering pump, as you take the hose out from the old pump a new o-ring must be installed because the old one will not be useful again. I'm trying to buy the o-ring but i no one knows where or how to get it. This o-ring goes into the power steering pressure hose, which goes into the power steering pump.


... Cars & Trucks

My daughter's 1999 Dodge Neon has a problem with the steering (they all do, eventually). I have replaced the steering rack and pinion as well as the pump (the old rack was very notchy). Currently, the power steering is very week at parking lot speeds but acceptable when on the road. I had the steering rack and assy. replaced and it worked very nicely for a week or two. Subsequently, I noticed a noisy bearing on the power steering pump, so I purchased a new (rebuilt) unit and installed it - tryin


Check the pressure releif valve if your Neon has A/C. this will make a difference to the powers steering ... 1999 Dodge Neon

I drive a 93 oldsmobile cutlass ciera s 3.3L and I am having very difficult time removing the fan because the power steering pump and reservoir is in the way. How do I remove the power steering pump and reservoir so I can remove the heater core fan and install a new one?


GM Celebrity/Century/Ciera/6000 1982-1996 Repair \015\012Guide\015\012Power Steering Pump -REMOVAL & INSTALLATIONGasoline \015\012Engines(see Figures 1, 2, 3, 4 and 5)\015\012\015\012 ... Oldsmobile Cutlass Ciera

My IH 1256 tractor lost power steering and new pump did not work. The 3 pt went out also. Put a new p steering pump and can't prime, but 3 pt started to work again. Will change spring & filter next. Old oil very dirty with sludge, bought used recently. Old & new power steering pump both pump if stick in bucket of hydraulic oil and spin gear by hand. Understand there is a check valve that might have sprung open while pulling land leveler. Not sure where it is located. Any help appreciate


... Cars & Trucks

Need to know how to install a power steering pump on a 1996 s420. I need to take the old one off and install the new one. How many bolts hold the pump to the engine. Is there only two hoses to disconnect.


Hello,good day,you have a 119 engine v-8,yes 2 hose tobe remove and 2 bolt holding the pump,try to memorize or draw the rotation of your fan before remove,you can do it,it"s upper part of your engine,ty ... 1994 Mercedes-Benz S-Class

So I have a 1995 Olds Cutlass Ciera that leaks power steering Fluid. It winds even when topped off but will work smoothly for a little while and than will be tough. The pump is new and I am wondering what is leaking, I heard abotu problems with a Power Steering Cooling Line but I have not been able to find said part for sale in stores or online so I do wonder if it exists. If anyone can help, thank you


Usually there aren't P/S fluid coolers on small pass. cars like this. Your rack & pinion could be leaking, or one of the lines. There is a great deal of pressure involved, up to 1600PSI. Pressure wash your engine, rack and pinion and lines. Fil ... 1995 Oldsmobile Cutlass Ciera

Can't get the old power steering pump off to install the new one


First of all why are you doing it? I am having an issue with my 02 Tahoe, 5.3, 4wd, that mainly when turning left, at any speed, usually when not on the gas, it is hard to turn. Feather the gas, and all is fine. Does occur to the right sometimes, but ... 2002 Chevrolet Tahoe

(1)I am replacing a 1995 Jeep Grand Cherokee Laredo(not Limited)Power steering pump (AC - 6 cycl.). I wnet to the junk yard and got one off a '93 I believe. I got the old one off and ready to install


Check with the junkyard where you got the pump...you may need to change the pump bracket with the pump, or use a different pump. You don't have a separate tensioner the pump is on a slide mount and is the tensioner (why the parts guy is a parts ... 1995 Jeep Grand Cherokee

I purchased a new power steering pump and installed it but the pulley on the pump appears to be one pulley width out of line with the tensioner and other pulleys even though i mounted it in the same way i dismantled it i removed it again to check it against the old one and determined they are indeed the same what have i done wrong


Make sure that went you press on the pulley to the pump, that the pulley is flush with the end of the shaft. ... 1988 Plymouth Grand Voyager

How can you flush the steering gear box after removing old power steering pump 98chevy C1500 silverado? I dont want any old fluid to get in the new power steering pump.


Leave the return line disconnected from the pump and run into a bucket. fill new pump and start engine have some one keep adding fluid until clean fluid is going into bucket. Caution make sure to secure hose to bucket or you will make a mess. Also ... 1998 Chevrolet K1500

My 2000 chevy impala, 3.4, is having power steering issues. The entire system has been changed. New gear box (reman OE), new lines, new PS pump w/reservoir (reman OE thru Auto Zone), pulley was transferred and a new serpentine belt. After installation steering was still very tight after warming up. So, I again replaced the gear box and pump. System was flushed then bled thoroughly. There are no leaks. The problem is when the engine is cold the steering is a one-finger turn with ease. Unf


No there is no high pressure switch/sensor.as you have traced and replace all the possible possibilities which can create this fault still check out \015\012Make sure the power steering belt is tight, sounds like it's slipping then even ... Chevrolet Impala

Need to take off old and install a new power steering pump in my 98 durango 5.9l 4x4 and have never done it before. wondering how.


Once you release the belt tension and remove the serpintine belt it's a pretty straight foward job but you will need a puller and a pulley press for the pump pulley.\015\012good luck chris ... 1998 Dodge Durango

Rack and pinion? have play in wheel no sign of leaks new power steering pump installed


Hi Gunny, If your vehicle is fitted with rack and pinion steering also check the rack ends for play. The rack ends are the rods which the tie rod ends screw onto. The other end fits onto the rack of the rack and pinion. To work on those you will need ... 1990 Dodge Dakota

2000 dodge stratus, thump noise increase/decreas while driving,new tires 4,new cv axles,new brakes,new power steering pump installed, but thump sound is still there ?


... 2001 Dodge Stratus

My 89 eagle has a v6 i have installed 4 used fuel pumps and when i getthe car going it runs fine till i get 20 miles down the road then it losses power till i drop it a few gears bring the rpm up high then it starts to gain till i slow it down im an old school mech i believe im going to need a brand new pump as the used ones arent any better than the one that failed. i think when the used pump gets hot it starts to restrict fuel i think a new pump will fix everthing i hope


Well always use a new fuel pump,then get a tune up,cap&rotor,wires,plugs,electric coil ... Eagle Premier

Purchased a 97 Jeep Grand Cherokee with an empty and leaking power steering pump. I replaced the pressure and return hoses and filled it but it makes a chirping noise when the engine runs cold. The pulley also has a slight wobble. I would like to replace the pulley and pump. Is te pump sold with the pulley already assembled or will I need a tool to install a new pulley on a new pump?


When you but a aftermarket power steering pump the only thing you get is the pump so make sure you take off & keep your pulley & reservoir BUT you can buy the pump with the reservoir but you still need your pulley & dip stick... ... Jeep Grand Cherokee

2000 kia sportage, hard steering like manual steering. New power steering pump & gearbox installed. New intermediate shaft & u-joint (connects between column & gearbox). Any ideas????????


... Cars & Trucks

Had a new power steering pump installed about 6


Hose or connection most likely has broken, have you lost fluid aswell? take it back to the garage who did it they might sort it out for free as long as it's not a burst hose ... 2003 BMW 325

Remove/replace power steering pump on a 2002 Olds alero. Works perfect-except whining noise-after I emptied/refilled the sump with new prestone power steering fliud!


Make sure that u get all the air out by turning the steering wheel from left to right.. And most important make sure the power steering fluid is for GM product.\015\012Hope this helps.. ... 2002 Oldsmobile Alero

1998 gmc sierra half ton 4wheel drive changed out motor now power steering doesn't work even installed new pump still have no power steering


I am assuming you are using the same belt configuration as before. Is it possible the pulley for the pump is turning in the opposite direction? ... Cars & Trucks

My timing belt is ever so slightly off on the a/c pulley since the shop recently installed a new power steering pump. Now at 2000 RPM, my truck whines like no other. Also, the power steering comes in and out, usually out when the rpms are sub 1000. Is there a home remedy to get that belt back in line? And why is my PS still messed?


It is an easy fix with the correct tools and elbow grease. First I would recommend taking it back to the shop that did not correctly place the belt in the first place and explaining the problem. To do it yourself, under the hood should be a diagram o ... 1997 Chevrolet K1500

Need to install a new power steering pump on my 1992 lumina


Are you wanting to know how to do it? If so your best bet would to purchase a Haynes manual for your car from advance auto or autozone, pep boys sells them as well. It will take you thru a step by step process. ... 1992 Chevrolet Lumina

Power steering acts funny. when i put my foot on the brake and try to turn its really hard, like i have no power steering, but if i let off the brake i can feel the power steering kicking back on more and more as i depress the brake, but sometimes when i dont hold the brake it does it, always when i am stopped it happens both ways, when i have my plow on and not holding brake its tuff, i have replaced power steering gear box, put a new remanufactured pump on and a new belt, if the new pump tests


These are two different systems and they do not interact to the point that you are describing. The problem was addressed as normal and it is the result of inadequate flow at the speeds that you are driving. It is a designed feature and there is nothi ... 2003 Ford F250 Super Duty Crew Cab

2008 Impala. Replaced Power Steering Pump. New pump is noisier than old pump. Looking for proper bleeding procedure to remove air from system. Thanks Harold


... 2008 Chevrolet Impala
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.7625 seconds