Having problems with your 1991 Mitsubishi Mirage ?

How ecu reset on a 91 mirage the check engine light on the dash will not turn off

\015 Blog discinnect the air filter because it was not working\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1991 Mitsubishi Mirage

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How ecu reset on a 91 mirage the check engine light on the dash will not turn off

... 1991 Mitsubishi Mirage

How can I change the dash light on a jeep cheroke 2003. The check engine light must have burned out after it took me 6-months to get it fixed. They reset the check engine light that the computer said should have been on, but no light when you turn the key.

... 2003 Jeep Grand Cherokee

Check engine light was on. OBD II scan said both pre-Cat 02 sensors running lean. Also shows P0000 code which is a undefined code. S dash light comes every few days then transmission will stay stuck in 4th gear until car is turned off and on. Removed and replaced both o2 pre cat sensors and reset. The air filter is clean. Now the check engine light is back on. Have not done new scan.

The pre cat sensors running lean does not mean they need to be replaced. They are are detecting a symptom. You need to know why.\015\012\015\012If you are using a basic scantool (code only) you need to look up the P0000 code.\015\0 ... 1999 Cadillac Catera


The computer does not know what gear it is in. You need to replace the transmission position switch 8-96017-511-0 ... Isuzu Rodeo

I have 2003 baja with check engine light ON. I check the code P0030. I did replace catalytic converter and both sensors with new one. After replacing both sensors I did reset code with code sensor. but still CHECK ENGINE LIGHT turned OFF until car running. When I turn the car off and little later starat the engine CHECK ENGINE LIGHT comes back. Is this normal or it takes some time to reset light?

... 2003 Subaru Outback

I have a 1996 dodge caravan 3.0 with about 220,000miles it ran perfect on wed and ran like **** the next day.its spitting and sputtering and if you really get on it the acts like it wants to die knocking and sputtering,the check engine lite came on and then the light started flashing.i thought the computer needed reset so i undid the battery for a little while hooked it back up and had no dash light radio turn signals nothing except an abs light and air bag light.so i shut it off and turned the

Sounds like you have a bad bcm as far as the lights ! The running rough and the cel flashing indicates a misfire condition ! Check your plug wires and see if a critter hasnt chewed a wire ! ... 1996 Dodge Caravan

Before check engine light was always on. But the car ran fine. Recently the check engine light would only flash occasionally. Now my car turns over but engine doesn't fire. The check engine light doesn't come on when I turn the key on but all other dash lights are on. Could my car not starting have something to do with check engine light?

There are plenty reasons for the check engine to come, from fuel system malfunction to timing belt sensor, you need to get the car somehow to a garage and perform a diagnostics test, that will tell you what is wrong. ... 1997 Chrysler Concorde

Detroit motor 60 series , FreightLiner problems with ECU 128 code on dash display... I can drive it fine but check engine light., engine protect light comes on still.. And turns truck off... I've changed the oil temp sensor, water temp sensor, and the water level sensor.. And still no solution.. Help please!!!!

... Cars & Trucks

I have dodge grand caravan 1998. two issues: left turn signal works when it feels like it, so it doesnt work, starts working againg, stops working. second is dashboard meters used to stop working for a split second and would reset while driving( this happened like once a month) yesterday they just shut down completely while driving and check engine light came on. This morning I started the car dash meters seem to be working again, but check engine is still on. What should I do? Is there some sen

More then likely this is all caused by a cool named car part called the clockspring. It is located in the steering column. The good news though, call a Dodge dealer, I believe this is an item/repair covered under recall/warrenty! ... 1998 Dodge Grand Caravan

Detroit motor 60 series , FreightLiner problems with ECU 128 code on dash display... I can drive it fine but check engine light., engine protect light comes on still.. And turns truck off... I've changed the oil temp sensor, water temp sensor, and the water level sensor.. And still no solution.. Help please!!!!

... Cars & Trucks

Detroit motor 60 series , FreightLiner problems with ECU 128 code on dash display... I can drive it fine but check engine light., engine protect light comes on still.. And turns truck off... I've changed the oil temp sensor, water temp sensor, and the water level sensor.. And still no solution.. Help please!!!!

... Cars & Trucks

I have a 1996 Saab 900 when I start the car and turn on the head lights the dash lights will turn on and then go out. Along with the dash lights, the radio lights and the lights along the shifter (PRND123) will also go out. The CID display lights and the warning lights (SRS, Check Engine and the hazard light [!] ) will stay on but my Speed, Tach, Engine Temp. and Fuel are all out. If I switch from my headlights to parking lights, or turn the lights off and then back on they will flicker and m

I would go around the block connectors with a wire brush but make sure you disconnect the battery ... Saab 900

I have a 2003 dodge ram 1500 . I gave someone a jump the other day (improperly). It worked for the rest of that day. The next day nothing worked at all. the keyless entry, the interior lights, the engine wouldnt turn. I checked the green light on the battery and it was good. I even took the positive end off of the battery for a min. to reset it. but still nothing. The only thing is the security red light blinks on the dash and it makes a soft frog sound

You tripped the factory ignition security system . you may have a reset button near the fusepanel ... 2004 Dodge Ram 1500

I had to replace my turn signal socket and now my check engine light is on along with the traction light. These lights did not come on until the turn signal socket went out. I went to autozone and they tested my car for any engine problems and he said that they were no problems showing up. How can I reset the check engine light? Or is it possible that I just need to change the fuses?

You will need an obd2 scanner to reset the light. It also checks all codes but is needed to reset the light as well. Fuses wouldn't set this off. There has been known problems with the traction control system which could set the light off. ... 1998 Oldsmobile Intrigue

Check engine light on, Brake and ABS lights illuminate, speedometer fails and odometer goes to dashes. The problem is intermittent but happening daily, turning the car off and then back on seems to reset the issue until it happens again...how do I differentiate between speed sensor problem or ABS module problem?

To make sure, you would have to have the vehicle scanned with Volvos' Vida scanner. However, the most common problem is usually the control unit. ... 1999 Volvo C70

1999 volvo v70 awd xc. Trouble code p1618. Symptoms are it wont start. LImp mode? Seems that after testing and resetting codes, we turn the key, it starts as normal for about 3 seconds, then dies. Trying to start it again results in no real "ignition" allowed. Seems computer is telling fuel pump to stop or some relay. Tested and bypassed relay. same same. Pump operating normally. Only other issue is the up-arrow light is flashing on the dash sometimes (and check engine). The flashing arrow light

I got the same car as urs. its seems to me that its the classic problems that you have. To slove them. Dont go to a dealer, coz they ll rip u off. Now, check on DIY guide for uninstalling ABS moudle. Go to ebay, find urself a ABS Moudle rebuild. 60-8 ... 1999 Volvo V70

I have an 04 grand am with the 3400 v6 i have all my dash lights,accesories, headlights everything except when i turn the key it will not turn over, no noise, no starter, nothing, i have checked the fuses and batt voltage (12.39v) sometimes i have a security light sometimes not, if i leave the key in the run position most of my dash lights go out except the service engine light oil light and battery light, i assume that is because the engine is not running

To beat security problems that turn off the starter, check out this link. http://vatspasslockpasskeysecurityhelp.yolasite.com/ ... 2004 Pontiac Grand Am

I have a 2007 dodge magnum sxt 3.5lt v6...recently the etc light came on and also the check engine light. the light was flashing when it came on while driving, when you turn the vehicle off then turn the key to the on position all the dash lights come on like normal and then shut off one by one, like normal....but the etc light and the check engine light stay on until you start the car....i have not had it scanned yet so i don't know what the codes are, i plan on having it scanned today....just

... 2005 Dodge Magnum

I have a 1996 Cadillac deville my Digital dash board went out last week the only thing that you can see is the check engine light and yesterday I drove it to church it ran just fine and when it came time to leave it wouldn't start the lights on the dash where still off and the check engine light will still come one but its wont turn on but I can hear a clicking sound coming from the the engine please help thank you!!!

... Cars & Trucks

Check engine light but the code reader doesn't see any codes. Resetting the ecu - vehicle will run for hours without light coming back on. When vehicle sits for about an hour or so. check light stays on after engine is started. Smog station says ecu failing to complete initiallization. All Test parameters on smog tests excellent Fails intialization thus failing. Replace ecu and reflash. Retighten ground connection. This has been ongoing problem since 2005 spent 1000.00 to get passed in 2008. pro

Hi,This is a Known Problem on this Model and a Technical Bulletin is already issued for the same.Details :-This article supersedes TSB 04-3-1 to update service part information and applications.ISSUE: ... 2002 Ford Escape

04 altima dash lights just went out.Checked the fuses but not all because the direction chart does not say which one ? when i turn the head lights on the dash lights turn off.......head lights off the dash lights come back on,don't know the exact fuse to check. Also when i turn on my a/c on and moving it's fine but when i come to a stop/ idle, the engine start screeching

... 2004 Nissan Altima

I have a 1998 Jeep Grand Cherokee Limited 5.2 v8. Engine was lugging check engine light came on as engine quit. Pulled over turned off the key and it restarted and ran fine. Went to Auto ZOne they said speed sensor fault of speed greater than 15 mph and trans speed less than 60 rpm. Car ran fine for two days but resetting check engine light by disconnecting battery is no help as check engine light comes back on as soon as speed comes up to 15-20mph. Today it would not shift out of first but tur

Hello there, One of the problems Jeeps do have is Transmissions. It is very typical of the sensors and solonoid packs to go bad, Also Jeeps as well have well know problems with the computer causing transmission issues as well.\015\012\015 ... 1998 Jeep Grand Cherokee

The check engine light went on - my mechanic replaced the sensor and it was fine - the next morning I started the car and turned on the defrosters and the check engine light went on again. My mechanic reset it and it went off this morning I turned on the dome light and the light went on again HELP

The technician is going to have to use the scanner to read the code. There is obviously an issue with a sensor or its circuit. ... 2005 Ford Escape

My daughters 2002 Tahoe has no brake lights. Bulbs are good checked the fuse under the hood=good, also checked the fuse under the back seat labeled brake, it was good also. Now the ABS light and hand brake dash warning lights are on. My guess is pulling the fuse under the back seat tripped a code for the warning dash lights. So how do I reset the dash warning lights? By the way, still no brake lights...turn, direction, and running lights are good. Also the brake light over the back window

To clear the code disconnect the battery, you could have a bad brake lite swich, its under the dash by the brake pedal ... Chevrolet Tahoe

I hace a kia rio 2001 i thought my check engine light bulb was burn but i found that is good,when i turn the keys to the ON position the check engine light does not come up at all i thougt the ECU was bad so i replaced it and it is doing the same no power to thge coils and stil my check engine light does not come at all.Thanks.

Your post is 6 months old .if you bought the car used it was probley disconected to hide the check engine light being on . heres the simpelest thing to do for free .go to an advaced auto or auto zone etc etc 1 of those stores that checks your codes f ... 2001 Kia Rio
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.5006 seconds