Having problems with your 1991 GMC K1500 ?

Where is the proper location for the checkballs i a 700r4 transmission

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

You need a diagram 4 those, go to Chilton DYI .comOnly $20.00 and everything is printable. and you get everything on your car. 700 R4 tranys are good ones,Good luck
Repair Help & Product Troubleshooting for 1991 GMC K1500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where is the proper location for the checkballs i a 700r4 transmission


You need a diagram 4 those, go to Chilton DYI .comOnly $20.00 and everything is printable. and you get everything on your car. 700 R4 tranys are good ones,Good luck ... 1991 GMC K1500

I need to know the location of the Transmission dipstick on a 2006 malibu maxx LTZ 3.5 lite, as the car is not shifting properly shifting,it runs as its stuck in 2nd gear and yet its an automatic transmission,so I'am thinking the fluid must be low? but cannot locate the dipstick for the transmission. PLEASE HELP Me!


If you can't find the stick, likely you have one of GM's "better ideas"...See if there is a fill cap on top of the trans, If it's there, there is a plug on the right side of the transmission. Remove the plug and on flat ground, fill 'till fluid comes ... 2006 Chevrolet Malibu Maxx

1986 corvette 700R4 transmission will not down shift from overdrive to third during hard acceleration. Transmission recently rebuilt new throttle valve, TV cable working and adjusted properly. Help?


Are you sure the TV ( trans shift cable at the throttle valve) cable is correctly adjusted?? Without line pressure readings, I can only guess that the D3/Part throttle check ball is missing, if it is a trans problemIf the TV is correct, I am as ... Chevrolet Corvette

Where is the transmission silenoid located in a 1996 Oldsmobile Shilhouette 3.4 6 cylinder the transmission is not shifting properly


... 1996 Oldsmobile Silhouette

Fellow Mechanic's ...TH-700R4 Four speed automatic transmission. I havewhat I believe to be a 1988 700R4. For the life of me, I cant seem todecipher GM's screwy method of identifying this hunk o'lead. The 8character designation located on the passenger side rear ''lip'' justabove the pan is: 8MZMO12H.....I think the eight designates 1988, the Hmight be reference to the 350 C.I. smallblock...the rest, I havnt thefoggiest idea. This thing also has the MD8 stamp on the passenger side,just behind th


The shap and the number of pan bolts usually tell you what you have for a trany.Your local auto parts store should have a chart with all the various pan and bolt patterns to help identify your transmition. ... 1998 Honda Accord

Fellow Mechanic's ...TH-700R4 Four speed automatic transmission. I havewhat I believe to be a 1988 700R4. For the life of me, I cant seem todecipher GM's screwy method of identifying this hunk o'lead. The 8character designation located on the passenger side rear ''lip'' justabove the pan is: 8MZMO12H.....I think the eight designates 1988, the Hmight be reference to the 350 C.I. smallblock...the rest, I havnt thefoggiest idea. This thing also has the MD8 stamp on the passenger side,just behind th


Okay... you section at a time... LOL 700R4 Trannies have Overdrive... To better figure out your tranny, Look at the SHAPE of the pan not the part number! ... 1986 Chevrolet Suburban

Diagram of a 1991 Chevy 700R4 Transmission check ball locations


... 1991 Chevrolet Caprice

I need to adjust the Throttle Valve cable so that my transmission will shift properly. I can't locate the TV cable linkage to adjust it.


... 1989 Ford Thunderbird

What is the proper location of the oil drain plug for a 98 Isuzu Trooper? There are two plugs one for the transmission and one for the oil. I don't want to drain the wrong one.


I guess if you have to ask this question, you really shouldnt be going anywhere near your vehicle armed with a spanner! ... 1999 Isuzu Trooper

Can i see a diagram for checkball locations 1984 700r4 valvebody


Need to buy a manual from ATSG .Com for a 700R4 unless you can find something on the internetWe are at home & like you, & just use the site asyou do,have no data base ... Cars & Trucks

(1993 Buick Centry 6 cyl automatic) I have been told there is an electronic module in or on the transmission, If bad will cause it to slip periodically as the car is doing-is this an easy fix that i can do myself, If so may i please have a diagram or picture to see the location of the part and the proper name so i can get one? Thank you,Jerry Davis


I would recommend replacing the Vacuum modulator first. It will look like this and is mounted on the side of the trans.\015\012\015\012\015\012I'm a ... Buick Century

Diagram on where checkballs are located on ford e4OD transmission


... Ford E-350

Where is transmission fluid temperature sensor on a accent 2002 located? when the fluid is cold the transmision is not working properly. as soon as the fluid hets hot it's okey , the tranny shifts to all gear. pulse generator has been replaced, except for the temperature sensor.


Those are the 3 most ridiculouis answers imaginable- completely wrong subject and worse answer. think twice about who you listan too. ... 2002 Hyundai Accent

Where is the automatic transmission fluid temperature sensor on a 2002 Mitzibishi Montero Sport located? The transmision is not working properly. The tranny is stuck in 3rd gear.


Its in the transmission pan area part of the valve body,this sensor just does one thing report the temperature of the transmission,If you are stuck in 3rd gear this sensor has nothing to do with gear change, it is not responsible for shifting. If you ... Mitsubishi Montero Sport

I had driven for at least seven hours and started hearing a rattling noise by the left side of the engine around the Timing area. It was a dangerous location to be stranded so I kept going and couple of hours later the transmission stopped shifting properly. Then shortly after, the speedometer failed though I managed to get home. The Car still starts but the speedometer wont raise and the shifting problem is still there. The Car has been in the garage for about two years and embarked on this jou


If you mean right side, as you sit in the vehicle, this could be a CV joint that went bad and caused a problem in the Transmission or Differential or a motor mount. (The timing belt is on this side but would not cause the shifting problem) If you a ... 1998 Plymouth Voyager

Hello, I have a 1992 Camaro RS 25th Anniversary ed. 3.1 V6. 118k miles. 700r4 Transmission. & My problem is.. I ran it low on gas, put gas in it.. ran like ****.. missing.. sputtering.. low power.. backfiring.. Then I couldn't get it to start at all.. so I replaced Rodor button, Distributer cap, plugs, wires, spaced the plugs properly, checked firing order.. replaced fuel filter.. I can get it to start after 40 minutes of cranking.. lol and when it does start.. it runs horrible.. missing.. sputt


CHECK FUEL pressure and take a fuel sample see if has water in it. since started problem rt after getting gas sounds lik you got some bad fuel ... 1992 Chevrolet Camaro

Where the ecu located on 90 maxima? I had transmission rebuilt now it won't shift ino third gear and cooling / condensor fans are not working properly


... 1990 Nissan Maxima

My 1996 toyota tercel with automatic transmission does not shift gears unless at high r.p.m's I can'y get proper adjustment on kickdown cable. I found that the kickdown cable is let go from the transmission ( housing only) can I just force the housing back down over the fitting in the transmission to get proper adjustment or do I have to replace it.? and can I replace it without having to remove transmission? also do you think this is my problem ?The fluid level is fine


... Cars & Trucks

Transmission My 2000 Ranger 4X4 (85000 easy miles) has developed a clanging sound when slowing down to stop. It doesn't happen all the time. I'm guessing it's coming from the transmission (automatic) as it down shifts. I have checked the transmission fluid which was at it's proper level. The fluid dosen't smell burnt and looks ok. From stop to 50mph the transmission shifts properly and seems normal. Its only when slowing to a stop. Any ideas? Thank you


... 2000 Ford Ranger SuperCab

Fill plug location on 2006 freestyle transmission


... 2006 Ford Freestyle

Purchased an Olds Intrigue that has three out of four power windows not working. They all have power, the but don't move up an down. Cables do not seem to be in proper location however when the up and down switch is pushed up or down, the cable draws in opposite directions. window is on the track properly. Need diagram of proper location of parts to evaluate problem.


Hi. Power windows might be problem in proper railings. This could be a power problem or the motor itself. I provided you a link how power windows works. This will gives you better idea on how to troubleshoot the issue. please ... Oldsmobile Intrigue

Where are oil and transmission dipsticks located what color are they and where is transmission fill on 2003 4 door chevy cavalier? where is oil filter located? do you have diagram of engin transmission and drive shaft?


Oil is yellow and the tranny is red and the trany dipstick is the fill. Filter is on the passanger side below the exhaust. ... 2003 Chevrolet Cavalier

Transmission Dipstick I need to know where my fill/check transmission dipstick is located at. I have a 05 Nissan Altima 2.5S 5 Spd Manual. The owners guide only shows the dipstick for an automatic vehicle. Where is the transmission dipstick located?


You have no dipstick in the manual trans. it's non-maintenance kinda system and its sealed. \015\012unless it's leaking you don't need service. ... 2005 Nissan Altima

OK i have seen my question asked several different times on here, and have seen several different answers, from a simple electrical problem to a complete transmission rebuild. 1997 Chevrolet S-10 Blazer 4 Wheel Drive Some days the transmission shifts trough the gears properly in the automatic mode, some it does not. Here are my symptoms, my transmission does not shift through the gears properly, all the time. On Days that it does not, I can place it in first gear manually, shift to s


If you have a modulator valve on your tranny it may be bad,the vacum could be restricted on it,the mod. valve controls shifts smoothly.lucas trans. additive helps with stuck valves in trannys, ... 1997 Chevrolet Blazer

I have an AXODe from a 2000 Windstar. My car is a 1998 Taurus. The only difference is the Windstar transmission has a VSS and the Taurus has an OSS. My question is, can I change the connector to the VSS and will it work properly for the PCM of do I have to put the OSS on the transmission for it to work correctly. If I have to put the OSS in, does the Windstar transmission still have the plastic gear on the shaft for it to work properly?


... 2001 Ford Windstar
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.0749 seconds