Having problems with your 1991 Ford Aerostar Extended ?

Wont start i checked the fuel switch ,battery,starter,altonator,cables spark plugs on my 91 ford arostar and it wont crank over please help

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

You need to check starter relay, starter, and ignition switch
Did you check the fuel valve on enine to see if gas is getting to injecters? One thing I saw a man do was he took a rubber hammer and laid down under the truck and pounded on the bottom of the gas tank. What this did was to free up the **** on the filter on the fuel pump located in the gas tank. I have done this to other rigs and it actually works. Don't use a regular hammer but use a rubber mallet.
Repair Help & Product Troubleshooting for 1991 Ford Aerostar Extended

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Wont start i checked the fuel switch ,battery,starter,altonator,cables spark plugs on my 91 ford arostar and it wont crank over please help

You need to check starter relay, starter, and ignition switch ... 1991 Ford Aerostar Extended

Wont start my 1992 dodge Dakota died on me the other dayand wont start. It cranks but doesn't start. No spark or no spark to coil. I have checked the wiring harness under fuse box and replaced crankshaft sensor,distributor,coil cap and rotor. Help please, don't know how to check computer.

All fuel injection systems are looking for three things at start up 1: water temperature 2: oil pressure 3: throttle position vs crank input. You can buy an obd II reader at orielies/kragen for 80-150 dollars you do need it. there are 2 of each sen ... Cars & Trucks

My 2000 ford crown vic wont start it cranks fine but wont start.....i started it and the check engin light was on so i took my code reader and erased the code and now it wont start i need help fast please help

... 2000 Ford Crown Victoria

Vehicle cranks but does not start have replaced crank sensors have replaced cam sensor and PCM only two of my coils fire u can use one of the working coils to check for spark at other coils plugs and there is none...wen starting the vehicle it sounds like its out of time sometimes and others it spens over fine....i am getting fuel to cylinder jus not spark to all cylinders.....at times vehicle will start and run fine for about 1 minute then die after that it wont restart.....can u please help me

Sounds like u need two coils ... 1995 Nissan Maxima

I have a 1996 dodge neon the car starts for about 20 mins then i go to take off it shuts down on me.try to go back to start it wont start for about 2 hours.,replaced spark plug,spark plug wires,fuel pump, crank sensor,knock sensor, cam sensor,catalitic converter,check all the fuses,coil pack,head gaskets what the heck is it please help???

Check power distribution center.if ok you have a faulty ignition component. ... 1996 Dodge Neon

Ford Focus 1.8 tdci 52 plate, broken cambelt, replaced valves and belt etc. Cranked over once now wont start at all- no pulse to injectors. fault code p1608 pump injector control unit signal faulty- checked crankshaft & camshaft poistion sensors, checked wiring and rechecked the timing- NO reason why it should start. PLEASE HELP !!!!!!!!!!!!!!!!

Hi, may i ask hows your battery doing? is it strong enough? ... Ford Focus

I have a 1999 ford escort 2.0 DOHC and it will crank but wont start...it had a new fuel pump put in it and ive put a cam position sensor on it and a battery..its gettin fire and its blue spark but still no start..checked compression and all cylinders read 80 to 90 psi..idk what the compression is supposed to be but it seemed low... If anyone knows somthing that i dont please let me know..email me at [email protected]

... Cars & Trucks

93 jeep cherokee cranks wont start. No spark new distributer, distributer cap, rotor, coil, wires, plugs, cleaned battery terminals checked connections ruled out fuel problem proper pressure from pump to fuel rail goin to injecters changed fuel filter for good measure. Just put in new computer... Still nothing no spark. Please help.

Maybe cranksensor ... Cars & Trucks

I have a Toyota camry 2000 L.E it cranks but wont start i replace the Spark plugs and wires fuel pump fuel filter the Starter works i check for sparks the fuel line is good timing belt is good what can it be please help.

Is the engine check light ondo you have enough pressure at the fuel rail is the pump running when u swing the engine is the MAP sensor and crank angle sensor faulty ... Cars & Trucks

My 1991 dodge dakota was running fine, then it just stalled and would crank but wouldnt start, no spark, so i checked the fusses by the relays, not the fuse box, the one under the hood . the auto shut down fuse was blown, i replaced it with another and it blew that one , now the truck wont even crank over , please help thx...dont know whats wrong , i have a manual but can find where the relay box is to trouble shoot it....

There is a conn. by the washer fluid bottle that corrodes apart, u will have to open up the harness to check that. It is a soldered joint. this is a very common problem so check it first. ... 1991 Dodge Dakota

Wont start i have a 2000 ford mustang v6 that sputters but wont catch. after various attempts it catches but once turned off it does the same thing again. i have replaced the ignition module, sparks plug wires, cap rotor, ignition coil, crank shift yet i still have the same problem. help me please!

Have you checked fuel pressure yet. This should have been the first thing done. ... 2000 Ford Mustang


Where did you check for spark? Unplug the coil wire from the distributer cap and check there by placing the end of the wire near something like a ground wire or head bolt while cranking the engine. Don't hold it in your hand. If you have spark com ... 1998 Chevrolet K1500

Truck will turn over but not start checked fuel pump it puts fuel out when engine is cranked its getting spark out of coil and even tried ether but wont even try to run please help

Ok if it wont start on starting fluid you either have no spark or you have internal problems like valve timming or low compression or you can check the distributor and make sure your rotorbutton is turning and not sripped hope this helps ... 2001 Chevrolet S-10

Wont start car cranked over about ten times with a no start stopped cranking and then tried again but would not crank over the second time dash is also showing a code but have not had the chance to check them, it crankes over fast when it does and i have load tested the battery and checked connections but uncertain as to what the problem could be please help

If you have not checked the alternator i would check that. but i also had the same problem but not as bad as it seems like you have but my problem was the water pump, so i would check that on your vehicle as well ... 2004 Oldsmobile Alero

I have a 89 f250 with a fuel enjected 460 it started one day then went out to start it the next an it wouldn. All it does is fire but wont start. Ive check everything I can think of. Its like its flooding its self. Ive checked the coil an distributer cap its getting alot of spark. So what could it be i need help please? Can anyone help me?

... 1989 Ford F 250

I try turning the car on but it wont start. I can hear the starter cranking so I know it can't be that. Checked battery and alternator and both were fine. Checked the spark plugs, they were ok but it wasn't getting any spark. So I thought it was the distributor, so I changed it out but it still won't start and there is still no spark. Can you help me....?

Pull out the coil wire from the distributor and see if it is sparking. If there is no spark, the coil is dead and it needs to be replaced. ... 1997 Honda CR-V

Ihave a 1996vw jetta it wont start,it cranks but wont start, i checked for gas and there is gas,i don't have spark coming out of the ignition coil,ibought a new ignition coil but it seems like it's not the coil because after installing the new coil it wouldn't start,timing belt is good i checked it,i think is some kind of sensor but i'm not sure,I do have a scanner but there is nothing on the computer memory,I would really appreciate any help thanks.

On the front of the engine at the crankshaft pulley is a sensor. Ck the sensor and connector. This sensor provides the timing pulse for the ignition system. make sure all is secured properly. Also listen for the fuel pump working. It's a low hum at ... 1996 Volkswagen Jetta

I have a 1998 ford explorer (sport) and it was running fine, but when i got in to go somewhere (work) my engine wouldn't start, and all it does is crank over! I checked every fuse and relay in the power box under the hood and the fuse panel on left side of dash! My owner's manual doesn't give me any info. on ( ENGINE WON'T START)! Can you please give me some idea as to what i must check to get the spark back? I already know it's not a fuel issue and i have no spark from testing one of the sp

Try a different key. It sounds like it has immobilised. ... Ford Explorer Sport

My 95 4 banger ford probe wont start in cranks but wont start, is there anything common with this cars that i should check first? besides the dist/spark plug check to make sure the motor is getting spark

Has the chip fallen out of the key?? ... 1996 Ford Probe

1990 nissan sentra wont start i replaced starter 1 year ago and has been running fine,now it wont start battery is fine lights everything works when i turn key the starter doesnt crank so i hit the starter with a hammer still nothing then i jumped the terminals on the voltage regulator got spark but not no cranking of starter please help i need this car to go to work

Good day Sir, try to check the spark plugs and the coil hope this will help you. ... 1990 Nissan Sentra

Wont start i have a 96 ford explorer v6 engine. It wont start in various locations after running fine to the location. I have replaced the fuel filter, fuel pump, fuel pump relay, coil pack, control module, ignition switch, and crank position sensor. I have run out of parts to replace. It seems like every time i fill up the gas tank it gives me trouble. If it sits for a long time it seems to help. Sometimes it dosent matter how long it sits. I tested the spark plugs and it dosent seem to spark w

I would check the cam position sensor ( at the right rear of the engine) and the plug connector at the PCM. I believe when you say "control module" you mean the PCM because these engines did not use a separate ignition module in '96- it is all done b ... 1996 Ford Explorer

My 91 integra LS just stumble and stalled out while driving. engine will crank, and it sounds like it wants to start, i think few times it almost started, but it didn't. removed valve cover to check timing, its good. loosened 17mm bolt on top of the fuel filter, with key on, gas squirt out with some force. also stick a screw driver in one of the spark plug wire boot, and put it near a bolt {gound} on the valve cover, there are sparks when cranking. i m lost. please help.

... 1991 Acura Integra Hatchback

I have a 95 Geo Metro 3cyl, It cranks fine but wont start, I checked the fuel, spark, compression, and air all look fine. I cheched the mechanical timing marks on the crank and cam gears and they look good. I loosened the distributor and rotated it back and fourth while my brother cranked the engine around and it almost starts but not quite, If I advance the dist or ****** it nothing but if I rock it back and fourth it tries to start. Whats up with that. Thanks for any help.

... 1995 Geo Metro

Everything seems to be working in my car. it just wont start. the serpetine belt came off while i was driving on the freeway and the car died immediately. a new belt was put on. after that the motor turns but the car wont start. i also changed spark plugs and wires. checked everything and and everything seems to be working but it just wont start. please help..

The crank sensor is located on crank pulley. When the belt came off it could have broke it or the wire. ... Ford Escort


... 1995 Chevrolet Lumina
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.6627 seconds