Having problems with your 1991 Chevrolet S-10 Blazer ?

Smoke From Left Rear Wheel

\015 Whenever I drive 3 miles or more and then park, Smoke (I believe it's grey) pours out from the left rear wheel. It looks like it's coming from the brake drum. The wheel spins, drives and brakes normally.\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Could be oil leaking onto the brake pads or shoes.
Repair Help & Product Troubleshooting for 1991 Chevrolet S-10 Blazer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Left rear wheel smoking bad


Why would you be using it like that? ... 1995 Chevrolet Blazer

Smoke From Left Rear Wheel


Could be oil leaking onto the brake pads or shoes. ... 1991 Chevrolet S-10 Blazer

Left rear wheel smoking bad


... 1995 Chevrolet Blazer

Rear left brake was smoking so i replaced wheel cylinder and shoes and its still smoking i dont know what it can be


... 2000 Dodge Stratus

The rear suspension is down on my 1999 Ford Expedition - Eddie Bauer. The cause: while out in the woods I came across a small dip (front right) which caused the back left wheel to lift off the ground. sequence of actions: While the back left wheel was off the ground, the suspension system caused the rear to pump up to the max height. I placed a small rock (4" tall) under the left rear wheeland and the Expedition backed out easily. The rear was still at max height. Upon getting


You have a seal that has not seated correctly or been damaged on one of the Shocks or an air line that has been pinched when the rear end lowered. To isolate which side is bad remove the air supply from each side in on the rear end and test them one ... 1999 Ford Expedition

GOT O2 XTEERA 2 WHEEL DRIVE HAVE CODES C1106 REAR LEFT SENSOR 2, C1102 REAR LEFT SENSOR 1, @C1111 PUMP MOTOR. THERE'S NO WIRE'S GOING 2 LEFT OR RIGHT REAR WHEELS 4 SENSORS 1 GOING INTO REAR HOUSING I C.ANY HELP OUT THERE ON HOW 2 FIX? THANKS.


Welcome to FIxYa.com\015\012\015\012Before i go on i need a few things to gather the correct info: I need engine size and how many miles on vehicle \015\012\015\012 \015\012\015\012Regards, Lee Davidian\01 ... 2002 Nissan Xterra

I have problem with the Mitsubishi montero rear wheel drive light left one it disappeared of the dash board while i was entering to my drive way the active skid control light began to flashes along with the rear wheel drive light then the light of the left one rear wheel drive it disappearded please help me on how to fix this problem thank you


... Mitsubishi Montero Sport

The rear suspension is down on my 1999 Ford Expedition - Eddie Bauer. The cause: while out in the woods I came across a small dip which cause my back left wheel to lift off the ground. The suspension system caused the rear to pump up to the max. I placed a small rock (4'' tall) under the left rear wheel and the Expedition backed out easily. The rear was still at max height. I then heard air exhausting from the front then the rear suspension sat down. I shut the down the engine then restarted. Th


I had a 1999 Expedition. When you put the 4x4 on it raises the vehicle an extra inch or 2.\015\012It may help to turn the 4x4 off. Two wheel drive is a lower air setting.\015\012Your original pump may still be good. The problem can be ... 1999 Ford Expedition

I have a 94 cavalier rs and i put a rear wheel cylinder in it and i started to bleed the brakes and i bled the right rear and it bled fine then i went to the side where i put the wheel cylinder in and it bled not much fluid at all so i went to the right front and it didnt push out much fluid at all either so i went to the driver side front and it bled real good like the right rear but make brake pedal still goes to the floor and i cant get the left rear and the front left to bleed really much of


Well sounds like its still full of air youll have to gravity bleed it. if you can leave your car on a steep hill overnight with the rear end up then bleed it the do the same make your front end sit high up overnight then bleed it. air bubbles always ... 1994 Chevrolet Cavalier

I HAVE A 2001 FORD WINDSTAR , wHEN BRAKING i GET A LOUND NOISE FROM THE LEFT REAR WHEEL, THE BRAKE SHOES HAVE BEEN REPLACED, NEW REAR DRUMS, THIS ONLY HAPPENS WHEN APPLING THE BRAKES. iN ADDITION to the SOUND, WHEN THE CAR IS ON STANDS, THE RIGHT REAR WHELL SPINS FREELY, THE lEFT WHEEL STARTS BUT BINDS A LITTLE.


I hav e a 2001 Windstar And I thought my problem was in the rear also but the sound was echoing from the front. It so happened that the Front caliper bracket was loose. ... 2001 Ford Windstar

No brake pedal on 1997 acheiva. changed abs master cylinder, left rear bleeder and left wheel brake cylindar, still no pedal. brakes stop 3 out of 4 wheels but not left rear. but pedal continues to go to floor.


Could be a stuck solenoid in the EBCM. ... 1997 Oldsmobile Achieva

My 2004 Yukon left rear wheel has a clicking noise coming from it sometimes, usually when at freeway speeds, but comes and goes. It is becoming louder and more frequently. Now the service tire monitor message comes on and stays on. I took it to les schwaab and had it inspected and test drove but they found nothing wrong except the left front tire monitor battery low. What could be the noise from left rear wheel?


... GMC Yukon

When out of 4 wheel drive the left and right rear end makes a shattering sound. while the verhicle is not running i can rotate the wheels left and right on the rear i don't feel any resistance or hear any noises. do you think it could be the transfer case. while on drive the jeep wont go forward it just makes a zinging noise. once on 2 wheel drive it will then go forward.


Its possible that the problem could be in the transfeer case. you didnt state which 4x4 unit is in the jeep.... there were 3 types, one was all wheel drive full time with a low gear selector, the 2nd was a part time 4x4 manual shift with a low range ... 1997 Jeep Grand Cherokee

What is the complete torque specification/procedure for the 2002 Elantra GT rear wheel bearing nut? My left rear seems to be good for no more than 50,000 miles or so. The dealer has changed the left rear twice before the warranty ran out and I'm on the second left rear replacement out of warranty. The right rear has lasted 150,000 miles so far! Oh, and third set of parking cables! I wonder if there is a specification for end play that the dealer and I am unaware of and not observing? BTW, if


... 2004 Hyundai Elantra

Rear scraping sound, Also when placed on lift and in gear (all wheel drive) the rear left wheel does not spin


Take it in for proper diagnosis - that's not supposed to happen in an 'ALL WHEEL DRIVE' - all WHEELS ARE SUPPOSED TO TURN. ... 2004 Hyundai Santa Fe

Left rear wheel is inset but the right rear wheel sticks out the side


Have your U-bolts that hold the rear axle checked to see if they have worked themselves loose or stretched. ... 1990 Jeep Cherokee Limited

HAve a roaring comig for rear end. Appears to from left axle. When Place on jack stands and stop roght rear wheel from turning and left wheel rolloing, get a loud noise from that side. Was told it was the pinon & spider gears. Sounds more like the bearing to me. Are rhw axle's "floating" axles or are they foxed with a keeper ring or device? Wayne


PINION BEARING ALSO CHECK FOR CHIPS IN THE PINION GEAR IF LET GO IT WILL TEAR UP THE REAR END IN WHAT EVER VEHICLE YOUR DRIVING ... 2001 Suzuki Grand Vitara

Left rear spring came off bottom perch. rusted. left rear tire jammed into wheel well. jacked it up but wheel will not come down. could the track bar be bent? what else could be wrong? is this fixable? the other side was welded 4 years ago. also the spring is still attached to the top. the car's engine is running good. it has 130,000 miles on it. need suggestions.


... 1994 Plymouth Sundance

The passenger side rear wheel on my daughters '04 Focus has developed a whir. A sharp turn to the left unloads the right wheel and the whirring stops. Rotated the tires to eliminate a wheel and/or tire issue. A manual rotation of the wheel feels like an incremental stutter, which is different from the drivers side. I am assuming a wheel bearing. I can turn a wrench and have tools. My question is, does the replacement of the rear wheel bearing require special tools? Any assistance is greatly ap


No just set good sockets and grease and a jack ... 2004 Ford Focus

Very little (almost nonexistent) rear brakes. Cannot stop rear wheels even with wheels off the ground. Replaced MC, wheel cyl.,Rubber hose, booster, proportioning valve, bypassed rear ABS, shoes, drums, hardware. What's left????? I burn through front brakes in 2000 miles and have replaced A-frame busings annually.


What happens when you try to bleed the rear brakes? If nothing comes out, trace each line back toward the proportioning valve--something would be blocking flow of fluid. Disconnect each line at the forward end and see if fluid comes out of the valve ... 1997 Dodge Dakota

My ML270 has a problem with front wheel camber. The left front has -55' and the right has -14'. Beaurepairs who did the checks tells me there is no adjustment for camber on the front wheels and the car pulls to the left. Beaurepairs tried to correct the pulling to the left by changing the toe in on the rear wheels which has improved it but obviously the tyres are scuffing. Can this situation be corrected, is there any camber adjustment? Regards Ron Mitchell


Yes, there are no adjustments possible on the front wheel angles except for the toe. Such big difference can only be caused by deformed parts. Since i assume that they would have noticed a bent front subframe then the only thing left are the suspensi ... 2003 Mercedes-Benz M-Class

Help please, I need to remove the inner wheel on the rear of my toyota dyna tipper truck...sounds easy, but the outer wheel nuts only hol;d the outside wheel, its pasenger side so the nuts are left hand thread..no problem there, but the inner wheel is held in by the stud itself, not the wheel nuts, the end is a square about half inch, ans an ordinary socket does not go on, its square like a square nut, I can not tell if its left hand thread or not, i can get an adjustable spanner on just about,


... Cars & Trucks

I had a rusted brake line to the left rear wheel and i replaced the section of line and bled the rear brakes. petal goes to the floor. front brakes lock up and rears are inop. found rear wheel cylinders leaking so i replaced them. no change. replaced master cylinder. no change. what the hell do i do next?????


First do you have ABS next did you bench bleed the new master cylinder if not you can;t bleed the rest of the system You have to keep in mind that you have opened the entire system up and there is going to be a lot of air traped in it Getting back to ... 1995 Chevrolet Lumina

2007 mazda 3 hatchback, 53000 miles. when hit bumps, patched potholes,even the dots that divide lanes, with right rear wheel ONLY. the rear end will jump out to the right, tires will actually slide momentarily. If pavement is wet I can get a small drift going if Im on a left turn when my right tires hit the bumps. when wheel is hopping really bad due to high speed or bigger bumps, rattle or clank is heard from right rear. right rear passes the "bounce" test but my first impression is st


... 2007 Mazda Speed 3 Hatchback

I have a1994 lesabre and have an issue with the drivers side rear brake drum, it will not brake after i have bled the brakes. It would stop the tire after I bled, but then when I started the car, it wouldn't. I bled the master cyl. an all the other wheels in order, rr,lf,lr, rf. All the other brakes work. I do not see any fluid coming from the wheel cyl., There is a steel tube in line just before the left rear wheel, could that the have an obstruction. Could my wheel cyl be taking in air. Not


Hi There,\012 can I just run this idea past you,,I had a similar problem on a brit car, put the car on axle stands, remove wheels and drums and un-adjusment the parking brake cable, start from scatch on the drum adjustment making su ... 1993 Buick LeSabre
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.3672 seconds