Having problems with your 1990 Nissan Maxima ?

Remove turn signal dimmer switch 1990 nissan pickup

\015 When sprayed with electronic cleaner the lights work but when the cleaner drys most of the lights will not burn\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1990 Nissan Maxima

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Remove turn signal dimmer switch 1990 nissan pickup


... 1990 Nissan Maxima

I have a 97 nissan pickup and the head lights will not turn on, an the tail lights will not shut off. had to take fuse out to turn off tail lights. turn signal switch??


Yes it sounds like the switch is stuck in the park position.You could pull the harness plug for the switch and check the circuits with a meter, or replace the switch. ... 1997 Nissan Pickup

How do I remove the turn signal switch on a 1966 chevy pickup? I have the steering wheel off and the screws out of the switch, but it doesn't budge.


... Cars & Trucks

The starter on my pickup keeps running even after the ignition key is turned off and removed. I suspect the ignition switch is faulty. I know it is on the steering column bolted to the lock cylinder, but I need to know any tricks to removing it and I need to know which wire sends the signal to the starter so i can test it. I assume the signal wire to the starter should have no power when the key is not in the 'cranking' position?


... Nissan Pickup

I have a 1995 nissan pickup , both turn signals quit working at the same time , i replaced the flasher module that didnt work , i replaced the turn signal switch ,that didnt work and the fuse is good as well as the fuseable links by the battery are good , please help thank you


Are you sure you replaced the signal flasher and not the hazard flasher as they look the same and many people change the wrong one. ... 1995 Nissan Pickup

I need help on how to remove the turn signal switch on a 1965 or 66 Ford pickup (F100)


... Ford F-100

Need to remove the steering wheel so i can replace the turn signal/ dimmer switch. How do you remove the air bag so you can remove the steering wheel?


Disconnect the battery negative/earth/.Wait for at list 10 minutes to deactivate SRS airbags.Then remove the drivers airbag useing 5 mm allan key behing the steering wheel.There is two holes.Disconnect carefully the airbag.24mm socket to unscrew the ... 2002 Volkswagen Jetta TDI

When i step on the brakes or use the left turn signal, all the running lights come on. I replaced the turn signal switch and removed the trailer wiring hookup. I unplugged the brake switch and it still does it when you use the left turn signal. The right turn signal works fine. Do I have to stop making left turns?


Yes, you do unless you fix that botched wiring job. The left turn wire must be connected to the running lights wire in the back. Actually it could just be the wrong bulb or a socket that is shorted across the terminals. Try taking the left rear bu ... 1992 Jeep Wrangler

I have a 2000 Nissan frontier SE. when i apply the brakes, both my turn signals faintly light up. when i turn on left or right signals they appear to work fine, sometimes the blink faster as if i had a bulb out....but when i go to hit the brakes while my signals are on they stop blinking and both signals light up as well as reverse lights. bulbs are all fine. Not sure if i have a wire grounding out or if its a problem with the brake switch/ turn signal switch or what?? Any suggestions.


... Cars & Trucks

How to remove turn signal switch 96 chey s10 pickup


... 1996 Chevrolet S-10 Pickup

How to remove and replace the turn signal switch in a 1982 chevy silverado1/2 ton pickup? Could you please include a diagram?


... Chevrolet Silverado 2500

How to remove ignition switch, 1998 Nissan Pathfinder for repair. Cannot turn key from the 1 position to 0 (Lock)


... 1998 Nissan Pathfinder

Need instructions on how to remove on 1998 c230 mercedes benz turn signal switch and tools required to remove turn signal switch?


... Mercedes-Benz C230

I need to change the turn signal switch box in a 1998 Monte Carlo. How do I go about removing the turn signal and switch box. This vehicle has cruise control on the turn signal lever


Disconnet the battery\015\012remove the air bag\015\012remove the the steering wheel center nut\015\012pull wheel off with a wheel puller\015\012remover the retainer off the steering wheel's lock plate with a compression lock ... Chevrolet Monte Carlo

It is a 2003 mercury sable. My turn signals don't work at all and I had the bulbs checked and changed and that didn't work. I also had a mechanic to remove the panels under the steering wheel to try and replace the turn signal switch but it couldn't be located. I just need to know where the turn signal switch is located on my 2003 mercury sable so that I can replace it.


The handle that you grab to turn on the signal is part of the switch. It all has to be replaced. It's right under the steering column cover. There are three or four screws on the bottom of the cover, there are usually two screws that hold the switch ... 2003 Mercury Sable

97 Passat Ignition Switch Removal Replacing ignition switch on 97 Passat. I've removed the steering wheel, turn signal lever, wiper lever....... Everything to expose the switch. All wiring connectors have been removed as well as the cable to the automatic trans shift selector, and the socket head capscrew that clamps the switch to the steering tube has been removed. The switch will slide up over the tube, but probably less than 1mm, then is stops dead. I have not removed the steel bridge o


1 did you drill the hole as directed on the autozone site. If so then you flip the drill bit over and push in the hole to release the spring. It is step 10. I hope you read the directions on autozone. ... Volkswagen Passat

My 95 cavalier keeps blowing the turn signal/ back up lamp fuse. i removed the turn signal switch, removed all bulbs and bulb connecters that could be removed, and made sure they werent over greased and the fuse still blows. please help.


... 1995 Chevrolet Cavalier

2000 Jetta 2.0 gasoline engine. Multiple electrical problems. headlights will not turn on, only hi beam and only while holding lever up. A/C blower motor, wipers, and turn signals shut off as soon as headligh swich is turned on. These will not work again until ignition switch is turned off and back on several times, and only if headlight switch is off. A/C blower motor and wipers will continue to run even after ignition switch is turned off and key removed. A/C blower motor and wipers if left on


Most likely you have a very bad ignition switch, the only other pathway for switched acc. to operate when key is off is if someone has had the wires feeding the fuse box crossed. so unless you had recent wiring done by an amature, you need and igniti ... 2000 Volkswagen Jetta TDI

Turn signal mounted headlight dimmer switch will not stay on high


This switch is not mounted around the column it is mounted on the side. Remove the clamshell around the column and you you can see the switch is mounted with 2 or3 screws. The harness goes down through the column. These are pretty simple to change. N ... 2001 Buick Century

I have a 1999 Nissan Quest, I've been having problems with my turn signals. It started out with the flasher buzzing but the turn indicator would work. Then they quit, I put a new flasher and turn signal switch on it and it worked for a short time then wouldn't work at all. I did some new ground connections and it seemed to work but then again they would stop working. This last time I noticed that the warning flasher wasn't working but the turn signals were, now they aren't working again. Any sug


Go here and read files\015\012\015\012http://groups.yahoo.com/group/villagerquest/\015\012\015\012we will help you with our team. free ... 1999 Nissan Quest

Have a 89 dodge raider;;have no turn//4-way flashers or brake lights;;all fuses good;have power to brake light switch and leaves switch when apply brakes;;found round flasher[4 way flasher]know this because have power to it on one side and when pull 4-way fuse loose power;;square flasher beside it;has power to it;loose power when i pull turn fuse[also when i remove turn fuse i loose warning lights on dash and hear relay on middle or pass side kick out]i got another turn signal switch[columum swi


Hey HotrodHarley, \015\012 I would pull out your hazzard switch and clean it real well. the signal, brake lights are connected to the hazzard switch and if it doesn't fully disengage you wont get the brake lights or the flashers to come on. ... 1987 Dodge Raider

I have a very clean 89 Crown Victoria from Florida! An old lady owned it bought brand new! I resently replaced all external lights now when I turn on my lights all my front turn signal lights my dash lights & taillights go out until Ive to smack the dash just below the dimmer switch & the come on! Do I need to replace the dimmer switch? Please help! Ive got alot of money invested! I love this car!!


The dimmer switch for the headlights only affect the headlights. The dimmer control for the dash lights only affect the dash lights.So if the parking lights are going off too, I would say its the headlight switch. Thats about the only thing th ... Cars & Trucks

My 1957 Chevy 3200 pickup has NO wiring for brake lights and turn signals, and I'm not quite sure how to get started to install. I did find a switch with two male posts (one a little larger than the other) with an arm that is contacted by the brake pedal. Using sand paper, I cleaned up these contacts and put an ohm-meter to confirm the switch is working. Also, I have a wiring ribbon cable coming out of the sterring column (presumably for the turn signals and horn) but nothing to connect to. Now,


If you go to faxonautoliterature.com you can get a copy of the original GM wiring manual for $8. This should be able to give you the help that you will need to get your wiring on track. Hope this helps. ... Chevrolet Chevy

The blinkers quit working but have flashers working replaced turn signal switch and flasher. The dimmer switch is on the the turn signal not the floor. This is a 2000 peterbilt 379 ex hd


... Dodge Pickup

00 Jetta 2.0 Car has daytime running lights but when switch is turned to on position car has no low or high beams. I can pull the turn signal lever and high beams come on but go off when released. I checked the voltage going to the headlight switch and it has power and the test light lights up with the switch is flipped. I was wondering if it is possibly a bad switch, dimmer switch, or relay


Check the headlight relay. ... 2000 Volkswagen Jetta TDI
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4989 seconds