Having problems with your 1990 Chevrolet Lumina ?

My flashers stopped working, both bulbs are intact. Autozone gave me an electronic flasher but I don't know where it goes. What do I do?

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

The flasher he gave you should be a round thing that looks like a giant thimble,with two flat wire connectors,
find your fuse box from your owners Manuel, the flasher for the turn signals is in there,the four way flasher is under the dash on the drivers side.
Repair Help & Product Troubleshooting for 1990 Chevrolet Lumina

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My flashers stopped working, both bulbs are intact. Autozone gave me an electronic flasher but I don't know where it goes. What do I do?


The flasher he gave you should be a round thing that looks like a giant thimble,with two flat wire connectors,find your fuse box from your owners Manuel, the flasher for the turn signals is in there,the four way flasher is under the dash on the ... 1990 Chevrolet Lumina

My gas gauge works (not incredibly accurate, but works). When i stop for more than a few seconds the gauge goes to empty. when i start moving it goes back to full and slowly comes down to where the gas level actually is. also, if i use the wipers when im stopped, sometimes they dont shut off. i have to start driving to get them to work properly again. i dont know if they are related. seems like too much of a coincidence to have 2 problems that only appear when the truck isnt moving, and then go


As far as the gas gauge level goes, it sounds to me like it could be the float ball system that is inside of the gas tank, which is connected to the fuel pump.I dont think your guage in the dash is broke, but i could be wrong. Sounds like something i ... 1998 Dodge Ram 1500 4WD

Flasher my blinkers dont work at all...and i just wanna know how to replace the flasher... i believe it goes where the emergency flasher is located but im not exactly sure how to change it help please!


The relay is inside the hazard switch. I'm not sure where it is in your car, so one of the VW guys will hopefully chime in on this one. If it's like my Audi A4, the button is rectangular and above the stereo. I have to slide the stereo head unit o ... 1999 Volkswagen Beetle

My turn flasher stopped working afta having my 96 accord just over 9 years, I've bought a new one , but doesn't fit....I don't know what I have to get for it to fit properly!!! =c plz help! I'm a female and not totally dumb with cars, esp my own, but dis has almost driven me insane, cuz I dont' know what else to do!!


What exactly did you buy a new one of...the light bulb? The light bulb is presumably the first thing to check when the flasher stops working. So drive yourself to a Hinda service place, take the flasher light bulb out, walk into the parts dept with ... 1996 Honda Accord

I drive a 2000 mitsu. mirage. my turn signals just stopped working. i checked the bulbs the fuses they're good. the emergency flashers work im wondering if maybe its the turning module but i dont know much about cars so what else could it possibly be


The emergency flasher switch is also the turn signal flasher It pops out of the dash and can be replaced easy. do chaeck the fuses before going to this much troble. check all the fuses as some work backup circuits that you wouldn;t think would be i ... Mitsubishi Mirage

So i got a 1994 chevy pickup z71 short bed single cab with the v8 motor and the issue im having with it is the 4x4 i dont know y it goes in but the light does come on and as soon as i get to where im going up hills it goes out or stops working im not sure wat the cause is but i would like answers please


... 1994 Chevrolet K1500

My car is skipping basically. It also does this weird thing to where my blinkers wont work and when that happens it bogs down and wont switch gears and barely goes when you put it in 1st. We changes the flasher out and it ran great i turned the car off and it started skipping and all again.. I dont know what is going on with it but its a piece of ****.


I had a similar problem with a '95 Rodeo. The transmission shifted gears based on electrical power sent to it. The voltage regulator in my alternator went defective and was outputting 16 volts. The higher voltage was fooling the transmission into thi ... 1994 Isuzu Trooper

Help dear sir i have daewoo cielo year 1996 and im facing problem with it and i would like to solve this problem if that is possible because we dont know weather the problem is electric or in the fuel system i will explain the problem to you the problem is that the car engine does not work perfectlly when i accerate the engine stops when the car goes the engine start cutting


I have a problem very similar same car only a year younger.\015\012But, it's not a spark problem (been checked), it's not the spark leads (been replaced), it's not the coil (been replaced), it's also not the distributor cap either (been replace ... 1999 Daewoo Lanos

Sometimes 1 of my directionals stops working, I bought a EP27 flasher, but don't know where it goes, as I have no manual. 2005 Ford Ranger


Find the fuse box usually under the dash you will see a round fuse bigger than most that will match the one you bought pull it out and replace with new one :) GL ... Cars & Trucks

I have a 1995 camaro i bought as a project car it originally had a v-6 but when i bought it the motor and transmission were pulled also the wiring harness is cut just outside of the "underhood fuse box" i would like to install a 383 stroker moter but really dont know where to start as far as wiring goes. In the end i also want all the cars factory electronics like radio and windows to work to. what do i do and what are my best options as far as re-wiring?


This site might be able to help u. http://www.ls1tech.com/forums/ ... 1995 Chevrolet Camaro

My turn signal is not working nor my harard lights i brought an new four way flasher but dont know where it goes


What type of vehicle, quite often it is controlled by the hazard switch and don't have flashers anymore. ... Chrysler 300M

1984 ford F350 diesel...Turn signals stopped working...don't know which fuse...but replaced them all and new flasher. Brake lights work and flasher works...but no turn...replaced brake light switch earlier and then turn signals stopped working...


... 1984 Ford F 350

Jimmy gmc 1997 stop lights are not working, but turn signals are working, stop light fuse is ok, hazard and turn signals flasher working good. I would like to know why stop lights are not working.


Is the third/hi mount brakelight working? Try wiggling the turnsignal switch while applying the brakes and have someone check to see if the brakelights come on. If so The turnsignal/multifunction switch is bad. ... 1997 GMC Jimmy

Hello i have a 1995 suburban and my stop light dont work. taillights license light backup light turn signals work. I bought a stop light switch dont know how to replace it any idea


Hi!!\012\012Look on the upper part of the brake pedal, it is the only device with an electrical connector, mark position or take a picture with you cell camera, disconnect connector and remove switch unscrewing it from pedal bracket. Replaceme ... 1993 GMC Suburban

Horn porsche boxter 2002 not working,, i hear the knock when i press , , and when alarm goes the horn is working,, i dont know if alarm have own horn or same one for both.. even i dont know witch fuse for the horn to check,,,, if someone can hlp me plz


... Porsche Boxster

I own a 2000 pontiac firebird. Just today, the turn signals stopped working. they dont flash in the dash panel and they dont flash on the car however, my hazard lights work perfectly. The fuses are good too. i dont know what it could be. i already replaced the bulbs but that didnt work. any help would be greatly appreciated.


... 2000 Pontiac Firebird

1997 FORD Aerostar Van, turn signals and flashers are not working. Even with the flasher "not working" I am not getting the turn signal light light to come on and hold. Figured out that the flasher buss setup in the 1997 was changed from what they show in the owners manual. I had a Ford flasher connected to the fuse box with a special bracket. I also saw another part connected separately, but I don't know what it is for. I have finally replaced the Flasher Buss with FL 34 from AutoZone. It


You need to check fuses for parking lights, brake lights, and the other fuse could have been an add on for sound system or a towing package for alternative lights for a trailer or camper. you should have 2 flashers one is for 4 way emegency flashers ... 1997 Ford Aerostar Extended

Light bulbs work right front and rear blinkers dont work but stay on (they do not blink) left front and rear blinkers work all 4 blinkers work when hazard light is on. I was told its not the flasher box if the left blinkers work we dont know whats going on our jeep is a 93 laredo Grand Cheerokee


You may want to replacer your flasher relay anyway, it sounds like it is bad and they are not that expensive. ... Jeep Grand Cherokee

Gages stop working, gas, speedometer, heat, and service engine light comes on. Each time I get gas, takes like 3 days and service engine light comes on , then i take off gas cap and put on and then goes off. The gages will stop working when car is started , then might pop on 10 minutes when driving, and then work and then dont work.


... 1999 Pontiac Grand Am GT

1996 Olds Cutlass Supreme Sedan: Left and right brake lights are intermittent. Both of the turn signals and emergency flashers work. Sometimes, both brake lights work until I use turn signal. Then opposite brake light goes off. The high stop light always works okay. I've tried to fix using the emergency flashers on and off several times, as suggested by another web-help Q&A. --**** H.


... 1986 Oldsmobile Cutlass Supreme

My top break light works all the time....but the other break lights dont come on unless i use my turn signal.....also my running light do work properly.....why would just the brake lights not work when the other one mounted to the rear glass does? i have replaced the bulbs, checked all fuses, and replace flashers....i dont know what else it could be....please help!!!!


The brake light switch is located in top part of the brake pedal and it controls all brake ligts the top and bottom lights use diferent power line, both come from brake light switch. ... 1997 Oldsmobile Cutlass Supreme

I have a 95 honda accord and the turn signals do not work you dont even hear the clicking noise when you turn them on ive changed the electronic turn signal flasher and they still dont work but the hazzard lights work.


... 1995 Honda Accord

Electrical fault i have water leaked into the passenger footwell. since then the alarm system stopped working, and the power windows have stopped working as well. also the interior lights will come on while driving getting brighter and dimmer. have stopped the water but dont know where to look for the electrical fault... can anyone help??


Under the carpet of the footwell is an ECU (electronic control unit). Its a convenience control unit and it manages all the electrical things you described, and more. The water has obviously caused a fault with the unit. You will probably need a new ... 2004 Audi A4

I keep going through thermostats. No one seems to know the reasoning when I ask them. It will work flawless for about 2 weeks then It will spring and the engine will again overheat and the heater stops working. I dont see any leaks and I don't smell it either. The truck is using a 16 psi cap could this be thew problem? I just don't know what could make a thermostat not break instantly it alwasy works for about 2 weeks.


After 35+ years in the auto business as a tech this is a challenge to me. Don't believe the cap is the prob. Not knowing the year, make , model this would be just a guess for you to check, if you already haven't done so. Do a reverse flush on the ... Ford Ranger

I have all four - front and back blinkers working - but when I turn on the turn signals to go either right or left they just glow - no blinking. I just bought a flasher but don't know where to install it. Question: could it just be the flasher is burned out or something else. where do I install it? I also got a dashlight dimmer switch which I installed. It has a dimmer wheel on it and it worked great. Now it has stopped working. I have checked all of the fuses and they are good. Qu


Most cars do have a separate fuse for the dashlights (usually the only 5 amp fuse in the box) A bad flasher could do that, it is usually located in or near the fusebox. Another thing that could cause these problems is a bad dash or body ground. Th ... Nissan Sentra
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.7618 seconds