Having problems with your 1989 Mitsubishi Mighty Max Macrocab ?

After overhit i can not start engine - 1989 Mitsubishi Mighty Max Macrocab

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Try to cool down the engine and fill the radiator with water
Repair Help & Product Troubleshooting for 1989 Mitsubishi Mighty Max Macrocab

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

After overhit i can not start engine - 1989 Mitsubishi Mighty Max Macrocab

Try to cool down the engine and fill the radiator with water ... 1989 Mitsubishi Mighty Max Macrocab

1992 Mitsubishi Mighty Max ran fine until two days ago. battery checks out and electricity is running. After starting engine, pitch starts higher than usual. After removing key on non-diesal engine, engine continues to run, until it burns out in a couple of minutes.

You need to adjust your timing ... Mitsubishi Mighty Max

I have a 1992 Mitsubishi Mighty Max v6 3.0. It runs rough at high speed (not necessarily rpm) and the check engine light was on earlier this week, but is now off. Does the computer retain check engine codes? If so, how can I retrieve them? Any ideas why the engine would run and accelerate fine through about 45 mph and then start to run rough above that, seemingly regardless of rpm?

Yes, the computer does retain fault codes. They can be retrived either with a scan tool or by using an analog volt meter. (Good luck finding one of those if you don't already own one.)\012Volt meter method:\012Find the diagnostic conne ... 1993 Mitsubishi Mighty Max

Hi, i have a 1990 mitsubishi pick up mighty max the probleme is some start fine then 5 minuts after turns off end wont start again and no spark at all some body tolds me that a distribuiter or engine cotrol module, some body can tell me whats the problem???

Ignition switch ... Isuzu Pickup

My 1988 Mitsubishi Mighty Max 2.0L, Auto, 183,500 miles. Just had the head gasket replaced in 2008 and rebuilt the carb in 2007. Now I notice in the mornings first start (cold engine) it runs real rough and hesitates for about 30 to 45 seconds then it seems to clear up and runs good. It only does this once in a while (not everyday). The last time I had it smogged in March 2010 it BARELY passed on all readings (HC, CO, NO). Wondering what this could be. Any ideas? Please help me....... I'

Pull off ur egr an clean it or use a small bit of plate and exhaust paste and blank it it ill do her no harm but at least itll show if the valve is faulty r not ... 1988 Mitsubishi Mighty Max

My 1990 mitsubishi mighty max being non operational for 5 yrs., i decided to use it. bought a new battery and tried to warm it up.it start but the engine won't fire up. I prime it with gas direct. it ran for a while. so i suspect the fuel pump is not wolrking. how will i check it or are there some more causes for the pump not work.

If it has been sitting for 5 years, your fuel pump is most likely toast. They tend to rust up without use. You may also want to look at the inside of the gas tank and make sure it is not too rusty. It may need to be replaced as well. ... Mitsubishi Mighty Max

1995 mitsubishi mighty max stalled and won't start 2.4 engine

... 1995 Mitsubishi Mighty Max

Engine wont start - 1986 Mitsubishi Mighty Max

... 1986 Mitsubishi Mighty Max

1991 mighty max starts but dies soon after - 1991 Mitsubishi Mighty Max

... 1991 Mitsubishi Mighty Max

1991 Mitsubishi Mighty Max 2D 4X4 V6 3.0L No Start.

You can get pressure specs from your local parts dept, and check injector signal with a noid light ... 1991 Mitsubishi Mighty Max

Took my 2009 #.0 Mazda BT 50 for a wash. Engine light now stays on and revs to max of 2200 rpm. Wash included engine wash, but the problem started day after wash. Don't know if it relates.

... Cars & Trucks

1991 Mitsubishi Pickup Engine turns over but will not start. New computor,fuel pump and fuel filter. New fuel pump relay and coil and distributor.Has fire at plugs and will start if I use starting f

... 1991 Mitsubishi Mighty Max

2.0 mitsubishi engine firing order - 1987 Mitsubishi Mighty Max

... 1987 Mitsubishi Mighty Max

I have a vacume line I dont know where it goes, its between the carb and the head, the vacume is at the botton of the carb at the base, the hose came off and it disaaapeared, i looked at the diagram under the hood, in my chilton book, all over the engine, and I just cant figure it out, its a 1987 mitsubishi mighty max, 2.0 engine.

... 1987 Mitsubishi Mighty Max

2007 mitsubishi turns over but won't start - Mighty Max Mitsubishi Cars & Trucks

... Mitsubishi Mighty Max


Try the oxygen sensor. the heated one, when the heater burns out it causes problems. Its the one with 3 wires usually in the rear ... 1991 Mitsubishi Mighty Max

1991 Mitsubishi Mighty Max starts hard when cold

... 1991 Mitsubishi Mighty Max

1988 Mitsubishi Mighty Max 2.0l auto 120,000mi will die and takes 30 - 60 mins to start?

You would need to figure out if you are dealing with a fuel problem or ignition problem to proceed.Checking the fuel pressure and for spark at the plugs when it will not start is a good place to begin.Could be a relay or a long list of other ... 1988 Mitsubishi Mighty Max

03 gmc envoy with 5.3 140000 miles. Oil pressure reading fluxuates between 0 and 40. When problem first started pressure read 80. When vehicle was new it stayed at midpoint (40) vehicle has plenty of oil. if you rev engine or increase rpms it goes to 0 and stayes there. let off and it jumps around like it did when started (0 to 40). No engine pecks while running. Display indicates low oil pressure and stop engine. orange light (check gages) comes on when at 0. any ideas. Service engine has not c

There may be a loose wire or the gauge or sending unit may be going bad. The first thing I would do is to hook up a temporary oil pressure gauge, not using the old one at all. With this watch gauge while driving and see what readings you get. If the ... 2003 GMC Envoy Xl

1990 Mitsubishi Mighty Max, 260k miles. Oil light illuminated on dash but plenty of oil in engine. What should I do?

Bad sensor needs to be replaced or oil pump is not producing enough pressure can be checked if u have tools or take it to a mechanic ... 1990 Mitsubishi Mighty Max

Starter won't turn over in a 92 Mitsubishi Mighty Max. Starter has been tested. I've replaced the battery , cable ends and ignition switch. And when trying to start , it is still just making a very quiet click at the solenoid. But I can jump the starter in the truck and it turns over fine.

Tested or not if u replace the starter solenoid the starter will work, trust me on this one please, have heard this same story over and over, the starter solenoid heavy electrical contacts that supply power to the motor of the starter ar ... 1992 Mitsubishi Mighty Max

How do I read the check engine codes on a 1993 mitsubishi mighty max?

At the ECU there is a connector that you use standard analog volt meter. In using the twio proper PIN connections the ECU will give yoy a type of Morse code to determine engine and sensor errors\012If you like I can email you these codes. ... 1993 Mitsubishi Mighty Max

Where is the Fuel pressure Regulater on a 1991 Mitsubishi Mighty Max 4X4 3.0L V6?....can i get a picture of the whole engine pointing it out if you can please.

I found this picture. At the front of the engine to the left of the round opening on the square intake. The glove is sitting on the fuel rail. At the front is the pressure regulator.\015\012 ... 1991 Mitsubishi Mighty Max

1992 mitsubishi mighty max wont start after being parked overnight.

... 1989 Mitsubishi Mighty Max

What diesel engine fits in a 1987 mitsubishi mighty max 4/4

I have one of these and I converted it to Diesel. I installed a Mitsubishi 4D56 2.5L Turbo inside the hood and runs much faster, more economic and more power than its old 2.0L Gasoline engine. ... 1991 Mitsubishi Mighty Max
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.6060 seconds