Having problems with your 1989 Honda Civic ?


Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Your cable connects to the transmission...really shouldn't need a new cable unless the tranny end is messed up...good luck
Repair Help & Product Troubleshooting for 1989 Honda Civic

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :


Your cable connects to the transmission...really shouldn't need a new cable unless the tranny end is messed up...good luck ... 1989 Honda Civic

Hi guys I drive an opel astra 160ie 1996 model I lost my car key it is a transponder key is the another way like buying a new loom and get a computer bo,key and connect the cabled in my car

... Opel Astra

I have a 2002 mecury sable that has problems. For a couple of days in the last week or 2, I was able to start my car and drive to work or home. But, after I cut it off it would not restart. It took about 5 hrs. of sitting before I was able to start it up again for a one way trip. today it would not start or even turn over. I have replaced the battery and had no results. A friend of mine told me it may be the fuseable link. So I'm trying to move to the next step, buying a new cable with a fus

... 2002 Mercury Sable

I have a 1985 Cheverolet pick-up. I have a cluster of under dash guages that I installed about ten years ago. Last week I replaced them with new ones. After doing so, My rea tail lights will not cut off. They burn all the time even when the head lights are off. The only way I can get them to turn off is to disconnect the Battery +hot cable. Now, when I installed the guages the voltmeter is wired black to a ground and red wire to the fuse box at the radio fuse. The oil pressure and water

Sir,\015\012\015\012It's probably the brake lights that are staying on, check again, if the brake lights are staying on the brake light switch needs to be replaced. The reason I believe it's the brake lights is that they will turn on even with ... Chevrolet S 10

I went to gas up my 2002 Honda Civic. I pressed the lever inside the cab to release the gas hatch and the hatch would not open. I tried and tried again. A couple of "new" friends at the gas station tried to get it open but to no avail. I think the release cable must be disconnected or broken. How do I check this out or replace it? Thanks for listening David Lamont, AB.


I have a 1999 Ford Ranger, I lost my alarm, is there any way to disconnect the factory alarm to turn the truck on? Or do I have to go to the dealership and buy a new alarm? Thank you.

You will have to get another security module. these can't be bypassed ... Ford Ranger

Put in new battery first cable i hooked up the headlights come on and car won't start, Only way to turn off lights is to disconnect batry

... 2002 Dodge Stratus

I got a 97 vw jetta 2.0 mk3 transmission how do it get it to adjust wit self adjusting cable it seems like it isnt adjusting properly but it brand new cable when I get it to where it needs to b I can shift it into gear but when I try to move it it slips but it shouldnt cause of new clutch n when I got it adjusted another way it does let me shift into get gear while car is running and doesnt take up last 1/2 inch of slack on arm or cable can anyone tell me wat the problem is trans clutch n cable

... Cars & Trucks

Hi, I have a 1999 Camry LE 4-cylinder automatic. The car is not shifting into gear. I popped the hood up and noticed that the transmission control cable (shifter cable) connection to the neutral saftey switch bracket is broken. It's a piece of plastic that broke but the cable still moves back and forth just fine. It looks like it broke at the boot. Do I need to get a new cable or is it just a matter of buying a new part? Thanks,

I think the cable is molded into the little plastic piece. see if you can see the end of the cable. see if it looks like it broke, or was cut. if not, the molding came undone, and the cable pulled from the anchor in the plastic thing. ... 1999 Toyota Camry

Clutch cable I have a new clutch cable. What is the best way to remopve and install the new cable.

On the transmission, where the cable adjusts, loosen the adjuster enough to have enough slack in the cable to remove the hardware holding the cable on the release lever. Then from under the dash, unhook the cable from the clutch pedal. Lift the cabl ... 1985 Volkswagen Golf

My 2003 Buick Rendevous. Automatic. The Shifter Cable came loose. I can manually put the cable on the post and then shift. However it keeps popping off. Can this be rigged, without buying a whole new shifter cable? How hard is it to install a new one?

Buy a haynes manual.it will show and tell you how to replace shifter cable. ... 2003 Buick Rendezvous

Im going to buy a '77 chevy silverado. i dnt no much bout cars let alone one older than me. i no it has a 350 edelbrock engine n carb. n a new auto-trans. less than 500 miles on each. well the guy said it needed a new trans cable sum kinda detent cable or something i guess. well i started it yesterday n started rite up but when i shift it to drive it cuts off. could it b this cable the guy was talking about? i realize it could b a number of things but would that make sense

The cable he is talking about is a Throttle Valve or Kick down cable. What it does is it increases pressure to the clutches on hard acceleration and tells the trans when to downshift.It could be that your idle is set too low, try giving ... Chevrolet Silverado

2002 chevy silverado driver window cable keeps rusting and braking how do i fix it so it wont happen again and do i have to buy a whole new window regulator or can i just buy the cable?

... 2002 Chevrolet Silverado 1500

1998 ford escort 2zx. ssometimes the car woulld not start but if i fiddled with the key then it would finally start. Then it did that for quite a while. then new symptoms. if it would sit overnight etc get in acted like a dead battery it would start with a jump. anyway put a new battery in and changed the heads out on the cable but did not replace the whole cable. ran ol for awhile. then back to acting like the battery was dead but it would start with a jump. then one night on my way home it die

The valve you are talking about is the fuel pressure regulator. replace it, it is bad. Let me know . we can go from there .\012Randy ... 1998 Ford Escort

I have a 1992 geo tracker and I just changed the clutch cable with no problems.Today I went and backed out of my driveway and when I put it in first I heard a big thump and the tracker would not move.I can get the shift knob into every gear but when I depress the clutch,Half way I hear nothing but all the way in I hear grinding.The tracker starts eveytime but it just wont move.Is the clutch gone or could I have did something wrong when putting the new clutch cable in.Please be a cheap answer not

You didnt snap in the top end of cable into fork , above pedal.the cable is a cheap china knock off and is useless ( common)you did set the free play to 1/2 like it says in the book.need help post backor ask on my leave ... 1992 Geo Tracker

I have a new alternator and a new battery and the truck ran good for 1 week. went to start it and it was dead, but nothing was left on. what could it be? I can jump start it and it will run, but when we disconnect the jumper cables and the batter cables, it should run by the alternator, but dies instantly

It could have a bad fuse. It is also possible you bought a bad altenator have seen that many times. If you have a voltmeter check the output voltage at altenator ... Ford F-150

Locked motor Is there a way to unlock a motor without having to buy a new one? The motor on my 1991 ford explorer locked down after the muffler system got clogged up. I don't have alot of money to buy a new engine or car so if anyone knows how to unlock the motor that would be great.

You need to check to make sure there is enough oil in it and then you take a socket with a large breaker bar disconnect the negative side of the battery and take the socket and breaker bar and put it on the crank and rock it back and forth to see if ... 1991 Ford Explorer

Fuel Injectors. I have a 1998 Avenger 2.5L I'm sure I have bad injectors. My check Engine light stays on, and the problem was already diagnosed. Im just wondering, must I buy injectors that cost way op in the hundreds? or is there a way that I can buy some that are about 40 each for 6 of them? any help would be great. I'm not wanting to spend a whole heck of a lot. But im just wondering. Thanks for any help, Matt

Well I Ran injector cleaner through it already. I just put it in once,\015\012you think I should do it again? and the fuel pressure is good too. When\015\012im at a dead stop, the car shakes a little bit with low rpms... but im\015\012just not too su ... 1998 Dodge Avenger

Just a THANK YOU and GOD BLESS YOU to macvernal for his very recent advice on my 2003 Ford Escape cruise control problem. I took off the "hood" over the front of the engine today and....LO and BEHOLD.....the cable disconnected from the "nipple"as I will call it. Also, there was NO flat spot on the control arm, but the 1 1/2" or so plastic part at the end of the cable is worn, causing it disconnect. And this supposedly was a NEW part installed last September!!!!! I doubt it very much. Feel l

That is what dealers do\015\012\015\012They will not diagnose any drivability problem\015\012or check light issue,until the after you pay them on \015\012three different visits for other services\015\012\015\012Eve ... Ford Escape

I have a 1995 Chevy CK1500. The truck would not start the other day and I found that the trans shift cable was broken. I purchased and installed a new cable but now it will not shift(engine not running) from 1st to park. It does shift from park to first(cable is being pulled from the column) With the cable disconnected-I have checked the tranny linkage -it moves easy, the column shifter moves easy, and the cable moves freely. when I connect the cable to the tranny link and the column it will not

... 1995 Chevrolet C1500

Rear window wont go up and just falls down unless held up. can hear the motor workn n when i try 2 "roll" window up a cable comes out a plastic tube. the working motor on the other side a cable moves in and out of a plastic tube as well but the cable never comes all the way out of this tube. i can feed cable back in by "rolling" window down but when i roll window up all that happens is the cable comes out. what do i need 2 do 2 fix this or part i need 2 buy? any help will be greatly appreciated

You will need to replace the window regulator, thats the part with all the cables coming out of it. The door panel will need to come off in order to replace. ... 2002 Jeep Liberty

I have a 2004 GMC Envoy the shifter cable came off and I had to put it in park myself. I noticed at the end of the shifter cable that the round plastic washer at the end of the cable broke. How can I find that plastic part. I dont want to buy a whole new shifter cable just for that one part

Check out this site for the part to fix the transmission end of the cable. Go to the rear end of the transmission on the driver' side (under the car/truck). Make sure to push the transmisssion lever toward the front of the car/truck (park position) ... 2004 GMC Envoy

I have a 2003 GMC Envoy the shifter cable came off and I had to put it in park myself. I noticed at the end of the shifter cable that the round plastic washer at the end of the cable broke. How can I find that plastic part. I dont want to buy a whole new shifter cable just for that one part

... 2004 GMC Envoy

I'm trying to replace a clutch cable in a '90 subbie legacy. The manual says nothing about removing the cable from the metal bracket that holds it inside the drivers compartment well.. it only says to remove cotter pin ad ther e is NO cotter pin, only a metal bracket the cable goes through and is held by. I cant see any way to remove it nor to install the new cable once the old is removed

... 1990 Subaru Legacy

The drivers side interior door panel for my 2002 s-10 chevy pickup V6 4.3 truck is broken and is getting pulled off of my door. the mounts have broken and i need a new one. where do i get a new door panel besides the dealer? also, is there a way to fix the door panel without buying a new one? im looking for the cheapest solution without using superglue. haha thanks!

... 2001 Chevrolet S-10
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.4561 seconds