Having problems with your 1988 Porsche 944 ?

How to change the driveshaft in 1988 porsche 944

\015 Changing universal joint in driveline\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1988 Porsche 944

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I HAVE A P0300 OBD CODE I DID A COMPRESSION TEST TO ENGINE AND IT PASS THE TEST,I DID CHECK EGR VALVE,CHANGE SPARK PLUGS,IGNITION WIRES, CAP AND ROTOR, I DID CHECK TPS SENSOR MAF SENSOR,FUEL PRESSURE,AND OXIGEN SENSORSI I FOUND THAT ON BANK 1 BOTH SENSORS (UP STREAM & DOWN STREAM )WORKS NORMALY BUT ON BANK 2 THE SENSOR 1 CHANGE FROM 0 TO 600 MILIVOLTS BUT NO CHANGES FROM RICH TO LEAN &SENSOR 2 HAS 0 MILIVOLTS & NO CHANGES FROM RICH TO LEAN SO I SWICHT SENSOR TO TEST THEM FROM BANK 2 TO BANK 1 AN


... 1997 Nissan Pathfinder

98 buick lesabre oil pressure dropped to 0 and engine died. added 1 quart oil, waited 30 minutes, started and drove 5 miles then oil pressure dropped to 0 and engine died. does this sound like a bad oil pump? where is the oil pump and is it hard to change for a "handy" person? thank you.


My sister had the same problem. There are 2 sensors that can cause this when they go bad. One is the oil pressure switch, which is located near the oil filter. When the PCM reads this switch, and gets a low reading, it will automatically kill the eng ... 1998 Buick LeSabre

Using my OBD II on 2000 honda prelude trouble codes PO401 & (PO401 pd) all reads MIL on, monitors, 1 INC, EVAP, 7 ready, MISFIRE, FUEL, COMP, CATLYST, 02 sensor, 02 HTR, EGR. Will be cleaning out EGR, BUT do I need to replace my Solenoid? My prelude stalls and ideals out of first gear. (Autotranny). Is this stall caused by these trouble codes? Also with 1 pending code, what do you recomend? I ran car and used OBD II a 2nd time and only change was (0 inc) and 8 (ready).


... Cars & Trucks

Hi my neam is araz iam from iraq i have a hyundai tucson model 2010 like a shape of model 2009 i geted with 0 kilometer now i drived a bout 7000 kilometer i changed engen oil with oil 20W50 , during one month a go at the morning when i tern on my engen , engen make a litel vibration for 1 minits for this problum i changed fiule filter and plage and clened the fitpump but the problum still remain , pleese kindly help me to solve this problum, and is it oil 20W50 is a coreect or 5W30 is a corre


... 2009 Hyundai Tucson

It violently shakes when parked or when stopped with brake applied, doesn't shake when moving though, rpms is like 500rpm constant so between 0 and 1 on the gauge. it also notice at night my lights stay dim till the car warms up and than they are bright, the car also runs sluggish till the car warms up, the belt squeals till warmed up also, i start running mid grade it helped a little with the sluggishness, has a new air filter, new oil change, new tranny oil change, new brakes, new brake fluid


If it shakes, it is normally either a bad motor mount (if the car runs fine) or your car is "missing" on one or more cylinders (misfire). The belt will squeal because they stretch with use. That can be solved by replacing the belt or tightening the b ... 2003 Kia Spectra

How to change the driveshaft in 1988 porsche 944


... 1988 Porsche 944

This morning when I turned on my Durango, the radio volume would not increase when the volume knob is turned manually or with the steering wheel controls. The radio is on, I can change stations and to the CD player, but the volume dos not work. IT goes from 1 to 0 and back and that's it. I've tried turning the truck off, thinking the computer might need to reset and starting it back up, but nothing seems to work. What could it be?


Try disconnecting the vehicles battery for about 5 minutes. ... 2004 Dodge Durango

We own a 1996 Dodge Stratus and the check engine light is coming on. After changing all the spark plugs the light went out. The next day the light comes back on. While driving on the freeway the speedometer went down to 0 and when I gave the gas peddle gas the engine ribbed up while it was slowing down. (as if it was in neutral). Pulled over turned engine off. Waited about 1 hr turned the ignition key and it started up and the light was back on again. When in idle it shakes and there is t


The only way to tell why the check engine light is on is to have the engine codes read with a scanner. This will pinpoint exact problem location. It will also have to be shut off and reset with this scanner. Many part stores will do it for free. ... Dodge Stratus

I have a 2005 Kia Spectra 5, 5 speed manual transmisson. Recently the steering is hard a low speed like slowing and turning and eases up a higher rates of speed. What's up with this? I bought the car new and have kept the oil changed, had 1 tune up and 4 sets of tires. There's 140,000 miles on the car and I have had 0 problems with it.


... Cars & Trucks

I have a 1998 Ford WIndstar. It died on us the other day. we put a refurbished alternator in it, changed the clamps that attach to the top of the battery, when the battery is in OUR van and is charged, it will hold the charge running for 1-2 minutes, then the radio goes off, the RPM goes to 0 and then it dings a couple times, then it dies. However, when the battery was in my friends truck it ran it just fine. so its not the battery. we are pretty much stumped. anyone have any ideas? I would grea


I suspect you hav a defective alternator. Remans are famous for this. Take it back where youbought it and have them put it on their testor to make sure it works.\012\012A battery should read about 12 1/2 volts when charged, engine off. ... 1998 Ford Windstar

Before i started the tune up on a kia sedona 3.5l v6 engine i noticed the one of the hole of the intake had some metal type debree. i just changed the spark plugs and put everything back together. started the engine right away something sounded bad like sme thing in side is hitting metal. i checked the compresion on 6 valves 1 doesent have compresion 0 the rest 125 150 compresion.


... 2003 Kia Sedona

Gearbox fluid change, location of fill/drain plug on a Lupo -99 1,0 gasoline-engine.


Bougth a manual from the web ... Volkswagen Fox

My Suzuki Alto (year 2000, 1,0 ) does not run well. I get brownish/black exhausts and the engine runs uneavenly. When i do not use the gaspedal the engine makes short speed-up and down, speed-up and down all the time. When in gear and medium speed it does not run eavenly. A test has shown exhaust-recirculation fault and I have tried changing the EGR valve. No result. Same problem


... 2000 Suzuki Swift

2001 Dodge Intrepid SE, great condition, new water pump, timing chain, transmission lines, cam sensors, thermostat, head gaskets, raditor, 0 miles on oil change, Eagle R tires, DOESN'T RUN - NEEDS TIMING CHAIN and BATTERY whould i bye it for 1,400


After the repairs needed and the associated cost you will be above value for the vehicle, if you havent heard it run and know it needs a timing chain you run the risk of buying a car with twisted valves. resulting in the need of an engine ... Dodge Intrepid

I just changed the head gaskets in my 93 probe gt. After putting everything back togeather it wouldn't fire. After playing with the dist it fired for about 5 sec. then it almost seemed like it ran out of gas, Fuel cut off light was on, no noise from fuel pump, after rewiring cut off (by passing) fuel pump will turn on at ignition. Car still will turn over but won't start. After doing a compression test [email protected] 150 [email protected] 125 [email protected] 150 and 1 3 and 5 were at 0 is this just a timing prob. does this sound li


LOOK LIKE LOW COMPRESSION IN OTHER CYLINDERS.HEAD GASKET LEAKING. ... 1993 Ford Probe

Was drving my 2000 dodge caravan and the car stopped working while on the expressway. The RPM went from 2 to 1 and then finally 0 and the car wouldnt accelerate. The check engine light came on but changed the oil not to long ago; less than a month. When I tried to star the car everything works electronically and have a full tank of gas. The engine doesnt start.


Did you find that your engine overheated? What was the approximate ambient temperature? Has this occurred before? Periodically? These are just some of the questions I would need answered to better assess the cause of your problem. Nonetheless, what ... 2000 Dodge Caravan

Replacing an outer cv joint on a 1994 Nissan Micra 1,0. Is there a quick way to knock it off, or do I need to take out the driveshaft?


... 1994 Nissan Sentra 4-Door

Oil leak? My 1996 Volvo 960 takes 7 qts. of oil up on a oil change. after 1,000 miles, the dipstick shows no oil. Add 1 qt. it is full again. Another 1,200 miles, same outcome. I changed the 3 seals in the oil filter housing, changed the coolant hoses that connect to the housing, also the gasket on the oil pan drain plug. All of these places I believed were the main leak, but I was wrong. Still leaks. Please help me troubleshoot this problem.


Whoa whoa ... You've said that the car takes 7 quarts of oil. That's 14 pints. Depending on which engine variant is fitted, engine oil capacity is either:\015\012\015\012 5.75 litres + 0.4 litre ... 1996 Volvo 960

Check gages light turns on and doesn't go off. Already had the oil changed, the oil pressure needle keeps marking 0. It had the same problem once but I changed the oil and kept working fine; then about 2 months after that oil change the oil pressure needle started to drop again, so I changed the oil once again, kept working ok, and since that oil change it only has been less than a month, and the oil pressure needle dropped to 0, and the check gages light is on


At this point I would strongly suggest that you have your mechanic hook a mechanical oil pressure guage to the engine and make absolutlely sure that the pressure is up to manufacturers standards. It may simply be a failing oil pressure sending unit, ... 2001 Jeep Grand Cherokee

P0058 check engine come up, went to parts store to scan, showing bank 1 sensor 1, changed bank 1 sensor 1 after check engine come up with a code P0058, at a parts store they told me to changed bank 2 sensor 2 that what I did but check engine light still on


... Cars & Trucks

Hyundai sonata 2000 gls. v6. HAs no EGR. Emission test, first try, HC(0) CO (0) nox 1033 mechanic said my engine seems hot (there was also heat out of vents blowing out. I cleaned my maf sensor and put on high octane gas and fuel cleaner drove for a week and retested. ssecond try HC(0) CO (0) nox 1250. failed agian. I changed my mass airflow from anotehr car and change my 3 front spark plugs myself not the three at back. Car seemed to be running better and engine definitely cooler no mor


... 2000 Hyundai Sonata

I am loosing about 1 gal of water per 200 miles without stop leak. With stop leak it goes to about 1 qt. I have had the head gaskets changed. the water pump changed. Somebody told me is was the heater core so I disconnected it for a week with no change. I appears I am getting back pressure through the radiator overflow tank which may pushing the water out when I am driving. There is never any water (except for the A/C drain. All hoses have been changed. Note I also put a new radiator reservoir


Have you replaced the radiator cap? If so, you have a bad gasket, either an intake or head gasket that under HOT pressure, is causing coolant to leak in to the combustion chamber while driving. ... 2005 Chevrolet Avalanche

Change oil soon light comes on. oil was changed april 8th last month. have used only 1 tank of gas since oil change. have had the car 1 year and never had this happen.. I change oil every 3000 miles. What do you think?


This is just a mileage counter. There is no problem. 1. turn the key on 2. press the accelerator pedal down 3 times and on the 4th hold it to the floor and wait for for the display to reset. They probably did that for you each time they changed the o ... 2000 Buick LeSabre

Im not getting a spark in my cylinder 1 on my nissan 300zx and now im getting a mis fire and its also idleing in the middle of 1 and 0 what could it be please help


... 1993 Nissan 300ZX

Hi,I have a 1997 mazda mpv 4x4 ,the engine do like a misfire ,every time ,the engine ligth is on ,the scanner sed somthing diferent : O2,MAF flow sensor,catalitic converter,after change ,the problem still there,also I change the wires,rotor ,all distribuitor,put inyector cleaner,spark plugs(twice),the misfire still there,can? be 1 inyector ,when I change the spark plugs ,I see 5 are coffe/milk color and 1 is '' WITHE ''. The compresion is 170/160 in all cylinders. tank you ,George.


Swap the PCM, and see what comes out. These guys have two computers at least. One controls the 4X4, the other controls the engine. The PCM is under the foot carpet of passenger side. ... 1997 Mazda MPV
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.1167 seconds