Having problems with your 1988 Chevrolet Celebrity ?

I have a 1988 Chevrolet Celebrity sedan and I need help replacing a bulb for the tail light located in my rear window (not the two turn signals). I already have a new bulb ready to go, however I cannot remove the cover to get to the old bulb.

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Try looking in the trunk seeing if it unscrews from inside the trunk
Repair Help & Product Troubleshooting for 1988 Chevrolet Celebrity

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 1988 Chevrolet Celebrity sedan and I need help replacing a bulb for the tail light located in my rear window (not the two turn signals). I already have a new bulb ready to go, however I cannot remove the cover to get to the old bulb.


Try looking in the trunk seeing if it unscrews from inside the trunk ... 1988 Chevrolet Celebrity

I have a 87 dodge ramcharger and the brake lights or turn signals dont not work. i have already done the basics. new bulbs fuses flashers. there is power to the fuses but the lamps do not light up. i also can get my emergency flashers to work. If I test one pole on the flasher it test hot and the other pole starts making the flasher click but no lights. Any ideas???


... 1987 Dodge Ramcharger

My parents are repairing a 2003 kia rio that had been slightly wrecked. He is having an issue with the turn signal switch. Here is the email they sent me. I sure hope you can help. ,........i cant get the turn signals to work on the car the hazard lights work but not turn signals with the handle i have checked bulbs and fuses we put a new turn signal and hazard flasher thing in it and it wasnt that with the cover off i can turn the signals on by hand if i hold it over but not by handle see if th


Since the lights themselves work there is not a power or fuse issue. Therefore it must be at the switch, which leaves either of three options:\015\012\015\012Least likely: Turnsignal stalk is not getting power, which comes ... 2003 Kia Rio

Turn signals stop working when head lights are turned on or with out head lights turned on when you apply the brakes. i have already replaced all tail light bulbs with new sylvania 3057 bulbs,i have tried a new brake light switch at brake pedal.


First remove all the signal bulbs both front and rear. Clean the sockets with electrical contact cleaner and replace the bulbs that you haven't changed yet. If still no solution replace the turn signal flasher. Lastly, if all else fails, check the wi ... 2000 Honda Accord

Im in the process of changing the high/low beam bulbs on my 07 GMC Sierra SLE(New Body Style) and have run into a bit of a problem...allready have changed the Drivers side but the passenger side i was able to squeeze in behind the air box and remove the old bulbs but when trying to re-install the new ones i cant get the highbeam bulb to turn and lock in. the replacements are obviously the right ones. it slides into the 3 slots but wont turn, lack of space probobly isnt helping but would it be po


It possibly would be easier to remove the airbox out the way if you remove the headlight it may possibly put it all out of allignment and then you would have to get it re aligned by the garage, so its proberbly better to remove the airbox, it normall ... 2007 GMC Sierra 1500

2003 Ford Ranger, XLT 6Cyl. Flashers, Running Lights, Reverse Light, Right and Middle Brake Light and Headlights are working. Front running/parking lights are not working. Signal Lights, Front and Rear are not working (replaced Bulbs already). Rear Left Brake Light not working (replaced bulb already). Fuses checked an all appear to be good. What do I do? State Inspection was due yesterday, getting all kinds of hand gestures and horn honking for slowing down to turn without signal lights.


Found very detailed assistance and instructions, FREE on the Ranger Station Forum. It is nice being able to go on-line and find lots of free information from fellow American Ford Ranger owners and not be asked for $$$.\015\012\015\012If ... 2003 Ford Ranger Regular Cab

My '89 S-10 pickup turn signal quit working on left side. Right side works. Bulbs look okay. Flasher makes the sound when I try the left side, but no lights. Instrument panel lights quit also, but don't know if this is related, or if it happened at the same time. I tried a new flasher, but when I put it in the fuse blew. I checked continuity on both old and new flasher; old one had current, new one wouldn't light my tester. Store said it is the right one. I reinstalled the original one because


Check your terminals at the fuse block sounds like someting shorted out maybe bad ground ... Chevrolet S 10

Once truck is started run for a short drive basicly not letting it get warmed up and shut off. then when i try to start it again it turns over fires up quickly as if to run but will not keep running acts as though there is no gas flow. then i turn key to the on position wait 15secs. then turn it over and it usually will start then. check engine is on and codes say a vacuum problem also i already put a new vacuum canster on it about a month ago. also has a new fuel pump which is about a year old,


I do know that gm had problems with the electric connectoin on those but ur problem is still in thepump try this when it does that turn key on for 3 seconds then off do this obout 4 to 5 times try to start if it does ur pump is bleeding system pessur ... Chevrolet Blazer

Left turn signal doesn't work and the old bulb looks good and the new one will not light. My headlamps are fine, my rear signals and brakes work...my only issue is the left turn signal.


Is this the left side front that is the only light that will not light? ... 2005 Saturn ION

I am replacing an A/C compressor on a 2003 Honda Pilot. How much oil do I add to the new compressor? The book says to replace what you drain out of the old one. However, the old one appears to be empty. The new compressor is a Valeo part number 10000664 and the oil required is PAG46. I tried rotating the old compressors shaft to try to get oil to drain but it will not turn.


The oil needs to be vaccumed out.. You can try a pump attaced to the valve and that should pull it out.. If not you will need a vacccume.. The type thy use to pull out transmission fluid works well.. Any mechanic should have one ... 2003 Honda Pilot

I have a fast blinking left turn signal. How do I fix it? I already changed out the bulb, cleaned the contacts, and checked the fuse. I couldn't, however, locate the turn signal relay to check


The bulb? did you check both left side or just one? ... 1996 Lexus ES 300

My left turn signal has sped up when i turn it on. even with a new bulb the light is dim but not out like the old one was and it is still blinking fast.the right signal blinks normal speed and the hazard blinks both at regular speed what is wrong?


Check the flasher for the turn signals ... 2000 Ford Escort

2001 jeep grand cherokee ltd just the drivers side rear turn signal not working checked bulb socket is new not getting power what color is just the turn signal wire and can is be run separate all the way back or is the solution easier


Unless the multifunction switch failed the only other link is you have a ground for the rear drivers side turn signal under the driver seat. Make sure it ok. ... Jeep Grand Cherokee

2003 passat 1.8t, GL My left brake light wasn't getting brighter when I braked for a while, replaced the bulb and no luck. I replaced the bulb housing and it still wasnt working properly until I took the old bulb out and tested it using a bulb from the right tail light. I had a lot of bulbs next to me and wasnt paying attention when I put a turn signal bulb in the brake light socket and it instantly cut off my right tail lights. Tried resetting them and tried switching the fuse. Any idea?


... 2003 Volkswagen Passat

RE: 1991 Plymouth Acclaim----------------------------------- the right turn signal goes on but does not "flash"on & off-both front & rear bulbs are 'lit'/do not have "burnt out" look to them-I DID change the (turn signal) fuse-should I change both front & back bulbs even though they aren't burnt out? Will changing the bulbs correct the "won't flash" problem? The left turn signal works just fine. Thank you for your help.(Need to get signal flashing again-so I don't get pulled over by the police a


... Plymouth Acclaim

I have a 2006 HHR and my rear drivers side directional bulb went out. I have a new bulb, and I can't get the old bulb out. The manual says to turn it counterclock wise and it is not moving. I feel like I am going to break it if I keep trying. Any help would be great :)


Give these websites a try www.alldatadiy.com and www.autozone.com if you have a Napa or Avdavce or Autozne o ... 2006 Chevrolet HHR

Turn signal I have turn signal problems on both sides. On the passenger side the bulb doesn't come on at all (new bulb), ever. On the driver's side the bulb (new) doesn't flash when the headlights are off. If the headlights are on, the bulb comes on, then flashes if I signal.


Go to your local NAPA auto parts store and get replacement tail lights circuit boards. This should solve the problem. I did for my daughters van. ... 2003 Pontiac Montana

2000 Buick Lesabre. I parked the car about 6 months ago because I bought a newer car. When I tried to start again the starter gets no power. There is an odd electrical problem because things like the vent fan, turn signals, head lights, tail lights all work fine, but other things like the electrical locks, electrical trunk release, electric windows, and electric locks do not work. I bought a new battery because the old one when checked would not take a charge, but the new battery still has the s


The immobilizer has come on you need to diss arm it or bypass it.This some times happens when the battery is left flat for long periods of time. ... 2000 Buick LeSabre

I have a Hyundai Santa Fe, 2002, 4 cylinders, 2.4 L, gasoline engine, automatic transmission front wheel drive. I recently changed the crankshaft angle sensor because it got damaged (the wires got out of place and were cut by the timing belt). It has now a new sensor. However, now only 2 cylinders work. The other two don't get the spark signal; the ignition coil #2 permanetly has 12 V, and it has already damaged this coil (I have removed theis coil). I do not want to put a new coil unti


You describe an issue which should be diagnosed by an authorized and certified Hyundai Technician. Here's what happens when a coil fails: Overload of the drivers in the in the PCM (Powertrain Control Module) as well as the IFS (Ignition Failure Sen ... 2002 Hyundai Santa Fe

Within the last week, my truck has stalled on me several times, but I was able to restart it immediately. However, just recently, it stopped accelerating and died out completely and I can't get it to turn back over. I'm already planning on buy a new altenator and battery to get it started again, but what would cause it to just stop accelerating like that?


The new alternator and battery is likely the solution to your problem.\015\012\015\012If the computer doesn't get enough voltage, it will shut down, and when you try to start it, it won't turn over. \015\012\015\012So, I'd say ... 2005 Dodge Ram 1500

Electrical my turn signals dont work at all. they dont even make the clicking sound . none of the bulbs even light up. iv checked both the relay and fuse and they are good.iv even put in a new switch and bulbs and still i get nothing.please help.


Please check the wiring of the car..try that after visual check under hood confirms no obvious failures like missing drive belt or disconnected electric wires... Good luck........ ... 1995 Nissan Quest

Turn Signals My right turn signal up front does not blink and my back turn signal blinks but very rapidly. I already tried switching the bulb and the bulb was good so is there another fuse from the turn signal? I mean is there one next to the lights that I have to change? or is a cable loose and making my lights blink faster?


Yea ok i looked it up i meant to replacethe thermal flasher. unless this is what you said you did already. it in the inside fuse box. here is a link to what it look like . thermal flasher.\015\012 ... 1993 Nissan Altima

2005 Scion XA rear passenger side turn signal bulb stopped working and indicator started blinking rapidly. I changed the bulb and still the same. Checked fuse and it's ok. Switched the working driver side turn signal bulb with housing to the non-working passenger side and it wouldn't work there. After putting new bulbs in both sides (since I bought a pair I figured "why not"), I disconnected the car battery to "reset" the power in the car, and when it turned back on it was still the same. What e


... Cars & Trucks

Turn signal problems, flasher works bulbs are new i just dont get anything when i switch to either side


Http://groups.yahoo.com/group/villagerquest/ ... 2000 Nissan Quest

2002 Chevy Cavalier - one turn signal blinks twice as fast as normal - have already put in a new bulb. What causes the fast blinking?


Turn on your 4 way flashers go in front and back of car see witch light is not flashing its blown must replace easy fix good luck CJ ... 2002 Chevrolet Cavalier Coupe
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.1306 seconds