Having problems with your 1987 Honda Accord ?

Timing belt just changed the timing belt and pulleys in my 87 honda accord exi automactic fuel injected know when it starts the engine shakes bad any ideal why.

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Timing may be off , NOT SET RIGHT. here is a diagram good luck and contact if you need more help.http://www.2carpros.com/car_repair_information/tec_info/1987/honda/accord/1987_honda_accord_timing_belt_diagram_marks.htm
Repair Help & Product Troubleshooting for 1987 Honda Accord

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Timing belt just changed the timing belt and pulleys in my 87 honda accord exi automactic fuel injected know when it starts the engine shakes bad any ideal why.


Timing may be off , NOT SET RIGHT. here is a diagram good luck and contact if you need more help. ... 1987 Honda Accord

I have a 1995 Ford ranger and I have a bad water leak but don't know where its coming from. It leaks from the bottom pully but at the same time when I have the truck running it spits water from the left side and right side from the belt running. That is from looking at the engine on top. Ive been told it could be the water pump, the timing belt could be offset,or a leak in one of the hoses. I just want a little more advice before I start taking my truck apart n having to buy all kinds of parts t


... Cars & Trucks

2002 volkswagen jetta-engine warning light that looks like a little camera is on and car idles very rough and sometimes cuts off when I come to a complete stop and engine shakes very bad until I speed up. The timing belt broke and was just replaced but not by the dealer so maybe the timing isnt set right I dont know but it wasnt doing this before it was fixed.


... 2002 Volkswagen Passat

Change heads an timing belt know when i starte my truck it vabrets really bad what can be the porblem its got a 2.3 engine


... 2002 Ford Ranger Regular Cab

I have 1999 Toyota Camry CE 4 Cylinder, my water pump went bad, but the timing belt was okay. I replaced the water pump and timing belt. I had problem with applying tension. I am not really sure how number one idler pulley and tension spring work to apply tension on the belt. After I finished the car started okay but every time when I start the engine there is a loud thumping sound. When the engine runs the sound disappears so sound is only when the engine starts. The sound is coming from the ti


The belt is either too tightly fixed or a bit loose.See to that but it does not affect the running of the car in anyway.Cheers. ... 1999 Toyota Camry

How to I know what is squealing in the engine of a 1995 Honda Passport it has new belts and squeals a lot when you first start the engine then still does it once in while when its ran for a while. I sprayed belt dressing and it goes away for only a short time. Its (really) loud when you first start the engine


You need to check belt tensioner.If belt tensioner is bad you need to replace it as soon as possible,because of possibility of part can and will seize up. ... 1995 Honda Passport

2003 Dodge Ram 1500 4.7L shakes badly from the engine, which causes a very bad shake through the truck only when accelerating. The check engine light is on. Anyone know what could be causing this? It starts to do the shaking at about 20-45mph.


Check the engine and transmission supports on truck.Possible broken support and you might look at the driveshaft for a damaged u-joint or missing balanceing weight on driveshaft. Any one of those things will cause a vibration. If all checks out look ... 2004 Dodge Ram 1500

Timing belt was very loose so i changed the timing belt tensioner pulley.I tried to make sure and not move the timing belts position on the cam and crank but now im not sure if it may have moved.I located the crank tdc mark but i don't know if the cam tdc mark faces up or down.And once i get these marks lined up how do i get the belt back on without moving the gears. The engine is shutting down almost immediately after start so I want to make sure timings not the problem.


Sorry for the severe delay. I am personally going back to answer your unanswered question. I do not know if you still need the answer, but I am going to answer it in case you still do.\015\012 \015\012Click ... 2001 Volkswagen Jetta TDI

I have a '84 toyota tercel 3AC engine. I have correctly installed the timing belt and am presently having problem starting car. I am trying to static time the engine so that I may use my dynamic timing light to set the correct timing. I know my car has to be running to do the latter. I have primed the carb and it will run until the fuel is consumed by the engine. I have had it running for more than 20 minutes I am just unable to leave the gas pedal to put my timing light in place. Any idea


... 1984 Toyota Tercel

Stalls when hot,turn but won't start until it's cold. it started that the engine would miss once in a while around 50mph. then it would not start at some occasion would shake the wires and it would start soemetimes. Timing belt,plugs.wiring ,all ignition components(cap.dist even the stutor)change. last thing i tried was to unplug the o2 censor no different when it got hot engine died,black smoke in the back and smells gas (too rich) no check engine light on,


Change air temp switch. ... 1990 Dodge Shadow

Need to time the engine ..trying to put new timing belt on it accidentally moved the top sprocket a bit and lost original timing not starting now...worked perfect before need to know how to put it


You will need to pull the distributor cap off and pull the #1 plug out and timing covers need to come off leave the harmonic balance on or take it off an put it on temporally so you can line up timing marks. with the #1 cylinder at top dead center an ... 1996 Ford Ranger SuperCab

My ford ka started slowing down on the park way i had to pull onto the verge and it started smoking badly we later realised there was no water or oil in the car now having replaced the water and oil the engine is shaking like mad its cuts out unless foot hard on the accelerator and its smoking. i dont know what it is been told could be the rings or headgascet or the engine has blown just dont know and its a p reg so dunno if its worth fixing but its my first car and im fond of it any solutions p


Fried piston rings, probably need to hone the bore too as there will be melted piston ring frid to them, plus head gasket and no doubt it has warped the head badly so will need to be skimmed, its going to be pricey! ... 2004 Kia Spectra

My 2002 saturn l300 turns but wont always start you usually have to try it about 10 times before it starts. I just had a new computer put in and timing belt, accessory belt, crank shaft sensor replaced and spark plugs replaced. I dont know what else to do. There are no engine lights coming on.


It is possible the fuel pump is going out.you need to check the fuel pump pressure when this happens.Now it is possible,the fuel pump relay could be the problem,but start by checking the fuel pressure when the problem is occuring,sometimes the check ... 2002 Saturn L-Series

P0300 random misfire code My gilfriend have a 2004 saturn ion 2 door with 2.2 ecotech motor and she have a part time problem,sometime dont know why the car is getting off,try to start back the engine but it runs pretty bad,the engine light goes on with a p0300 code wich is a random misfire and at each time the problem goes off just like it goes on and we dont know why.I look at the coil on plug (seems ok) change the spark plugs,do the same thing yesturday,and the weather is always different so i


... 2004 Saturn ION

I have a 95 Bonneville 3800. First start of the day under acceleration the engine misses out and shutters very bad, there is a loss of power but when the rpms are up or you drive it a half a mile or so the shake stops and it runs fine. I also have had a couple of instances where the vehicle would not start after I had drove it. It would crank over but not start, I let it set for a little while a cycled the key a few times and then it will start.(the times this happened I had 3/4 to a full tank


Clean your MAF & TPS sensors with the battery disconnected ... 1995 Pontiac Bonneville

A couple of weeks ago I hit a pot hole that was covered in water and couldn't tell it was there until to late and my Lincoln Navigator 98' started shaking badly right after I hit the pot hole. Now every time I start the suv it shakes a lot. And when I press the gas to go it shakes even worse. And now the Engine light came on and keeps blinking. I was told it may just need a tune up. But it shakes way to much, and I no nothing about cars, what can be the problem? Please help!


It is most likely a coil electrical connection,or a coil that is shorted out,but you will have to have some one check the vehicle to see if that is the problem,from what you have said,this is the best solution . ... 1998 Lincoln Navigator

I just bought a 2001 saturn l200 and we knew it had engine problems and didnt start but we dont know if we need a new engine or a new timing chain. Iv read many reviews complaining about the timing chain. Should i change the timing belt? My car wont even turn over.


These cars are equipped with an anti theft that will disable the motor. Just a thought. http://vatspasslockpasskeysecurityhelp.yolasite.com/ ... 2001 Saturn L-Series

Hi. thank you for help. I have a VW Jetta 6 cylinders 2.8L displacement. after start, the car is shaking badly. I took her to two repair shops, one said the one combustion has air leaking, the other said engine is fine, only the clutch is bad. Please back me up, I really don't know what to do. The car is shaking, my heart is shaking. My email address is [email protected]


Hi well this will depend on if you are driving it or not, if you are driving it, it could be the clutch, but if it is not moving and just idling then i would say it may be air leaking into the system...so i can not give you a 100% conclusion, as ever ... 2004 Volkswagen Jetta

Smoke problem started to give smoke, when I drive fast no smoke power is ok, no loosing oil, no loosing water BUT when stop and leave the engine running, after 15 minuts the grey smoke starts to build up very badly, Now after two months I was driving down, first time she started to loose the power then the engine cut off, then I called AA , he checked the wire plug feeding to fule pump, he found no power going to fule pump. Can any body let me know that what this problem could be and the best so


Heythere are couple of smoke type.blue smoke is oil, black smoke is fuel, and white smoke is \015\012water, if it clears after starting and running a few minutes it's probably your \015\012valve guide seals leaking oil down on top of your pisto ... Peugeot Liberte

My 1991 Camaro stalled on me I was driving and the car started shaking and it didn't want to drive any more the engine was shaking really bad and it turned off on me. I started the car again and it continued to shake but this time i wouldn't move at all I put it on drive and pressed the gas and nothing i put it on reverse i pressed the gas and it still wouldn't move all. I would turn it on and it would automatically turn off i checked the spark plugs and they are fine I also checked the Fuel


... 1991 Chevrolet Camaro

97 dodge neon timing belt broke while going down the road need to know how to get car back in time bought a new timing belt new tensioner and still cannont get car to start junk yard says my car does not have an interferance engine what am i doing wrong and what tooth should the cam be on?


I do not have good news for you.\015\012According to the Gates Timing Belt guide 2002 Edition, both engines offered in the Dodge Neon are interference engines.\015\012This means that your engine has likely sustained sgnificant valv ... 1997 Dodge Neon

Fiat Multipla Hi, i have a ticking noise coming from the car when engine is tickin over and a grating noise when i'm starting the engine the car has done 76,000 miles, i thought maybe the timing belt needed done but the belt felt fine, any ideas. I've not got a clue. ps i can see the gear linkage in the engine through a square that someone said had been cut out dont know if i'm meant to see it. Cheers


Going by the same sort of problem try turning your air conitioning off to see if it gets rid of the problem. As this is what caused mine to knock ... Fiat 124

I have a 2002 Hyundai Sonata 4CL (interference engine) that broke down recently (no longer starting) and upon inspection, found out that the timing belt needed replaced. After taking the timing belt off, we found not only a lot missing teeth on the belt in general, but there is a large section that the teeth are all missing, which leads us to believe something may have jammed. Also, knowing that all of this happened while the car was in motion, the big concern is that the pistons may have been d


I think you are going to find that your valves are bent and you will have no compression. removing the head and getting a complete valve job is most likely in your future. in a fight between the top of the piston and the bottom of the valve the pisto ... Hyundai Sonata

My 2000 caravan was running fine, then one day my nephew drove it and it just shut down 2 miles from the house. Now when you try to start it all it does is ''click'' just one time. You can see the belt try to turn but it just jerks. The ASR starts clicking and doesn't stop until it is unpluged. After switching out the relays they all do the same thing. When we try to manually turn the engine it won't turn. Will the ASR if bad cause the engine to not turn over?


I would remove and check the starter. If the drive came out and stayed out it will lock the engine and give you the click. The ASR will click as well because it is trying to engage anyway. ... 2000 Dodge Grand Caravan

I just changed a Timing Belt on my 95 Eagle Talon Esi 2.0 DOHC Non-Turbo, I know the timing is correct, as I started the engine before i put everything else back together. Since I got everything put back together when I start the car in idle there's a very loud vibrating noise coming from the front passenger side. What do I need to check and fix?


Sounds like your Hydraulic Timing Belt Tensioner, or could be the Idle Pullys. There's a kit available that includes all needed parts for around $150.00 depending on your location. ... Eagle Talon
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.5455 seconds