Having problems with your 1985 Jeep Cherokee ?

I have a 1985 Jeep Wagoneer LTD(2.8 V6 Engine).

\015 I have a 1985 Jeep Wagoneer LTD(2.8 V6 Engine). My a/c is blowing hot and when I checked the low side pressure while trying to add r134a it was off the gague(very high) and it would not take any r134. The compressor is running continuously(it doe not cycle on/off). Can you tell me what the problem might be?\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Your compressor could not be pumping freon through the system, have your compressor tested.
Repair Help & Product Troubleshooting for 1985 Jeep Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My 2006 jeep wrangler was making a noise like a belt squeeling drove about 5 miles noise stopped engine light appeared and oil pressure went to 0 (Jeep only has 38,000 miles)I imediatly turned engine off i checked oil was perfect checked water level perfect no oil under jeep really confused any suggestions


Have truck scanned for code can be anything oil pump timing chain etc also check warranty before doing any work most drive trains 5yrs- 100,000 miles ... 2006 Jeep Wrangler

Overhaul of the top in of 2003 jeep 4.7. It had jumped time, broke a valve spring and bent a valve. After the overhaul oil pressure at idle drops to 0 after the engine warms up. No engine noise what so ever. pressure jumps up while driving, but at idle drops back to 0. Afraid to drive, what should I do?


First thing you need to do is put a mechanical gauge in place of oil sender and read actual oil pressure. If mechanical gauge shows same condition, take a look at the connecting rod bearing serving the cylinder where the valve bent. If the piston hit ... 2003 Jeep Grand Cherokee

My jeep will grind and grind will will not start. It use to after a few tries and now it will not. I have replaced the battery and now I am not sure. Some say starter some say flywheel. I have a 1990 jeep with a 1987 jeep wagoneer engine. Some say trannie about to go out as well. Do not know where to start on a budget. Any suggestions.


... 1990 Jeep Wrangler

I have a 2000 jeep grand cherokee 4.7 liter 4x4. the problem i am having is that when i turn the jeep on and it is idling the oil pressure is at about 40 lbs. however as soon as i touch the accelerator the pressure will drop to 0 until i let off the accelerator and then it will return to normal. it only does this after the engine gets cold or the first start of the day. the outside temperature seems to affect this some what because i used to be able to let the jeep warm up for 10-15 minutes when


... 2000 Jeep Grand Cherokee

I have a 1985 Jeep Wagoneer LTD(2.8 V6 Engine).


Your compressor could not be pumping freon through the system, have your compressor tested. ... 1985 Jeep Cherokee

I have a electrical problem on a 1985 jeep grand wagoneer 360 engine. after shipping to alaska the radio stopped working theirs only static the engine dies unexpectedley the clock luminates ownley when the head lights turned on. I have replaced the ignition swich, the brain box on fender well checked radio connections new starter & starter silinode removed the fues block connector under hood an reconnected hoping for connection problem removed instrament panel checked for loose wires missing con


You need to get your hands on an electrical schematic for that vehicle everything you need to see will be there sounds like it might be a fuseable link i think there is 2 coming off the solenoid its also possible its the ignition switch ( electrical ... 1985 Jeep Grand Wagoneer

Have 1995 jeep cherokee v6 4,0 my jeep run sluggish loss of power cant get over 65 mph service engine light on took it to auto parts to get code read low fuel intake somebody told me also to start it 3 times then read the flashing light where can i get a list of information on the code names. what should i check for the low fuel intake? the fuel filter maybe the pressure tested please help


This sounds like you may have a problem with your oxygen(O2) sensors or a clogged component in your exhaust system. if you have a catalytic converter in your exhaust system, the filter element inside could break up and clog the exhaust pipe. you shou ... 1995 Jeep Cherokee

What is causing my 1986 jeep grand wagoneer engine to stall while driving? I cannot restart it but there is power. It will turn over but not start and there is gas in it. The jeep just went "poof" and died while driving.


Ok, its and old jeep, cranks but will not start.\012\012carb fueled right? crank it wide open throttle to clean the flood\012and block open the choke, if CARB has auto choke, if manual choke make sure its open. (push in knob... called c ... 1985 Jeep Grand Wagoneer

My 2003 jeep liberty will stall then shut off the engine and the RPM's jumped from 0-7 after the engine shuts off. The battery light comes on and off so does the oil light I changed the oil because it was two quarts low. It ran good after I changed it until the next day. I assume that a sencer went out any ideas.


... Cars & Trucks

2000 jeep wrangler 2.5 engine, when I came to idle the check dash gauges came on , I lost pressure on the oil gauge it went to 0. the gas gauge went to empty when I reved the engine everything went back to normal


I\015\012have found a fix that will be easy and cheap if you have soldering\015\012skills and a soldering iron. this will also fix your gauges from not\015\012responding or not working.Remove your instrument cluster and\015\012check the s ... Jeep Wrangler

WILL A 1990 JEEP CHEROKEE ENGINE WIRING HARNESS FIT A 1988 JEEP WAGONEER


... Jeep Cars & Trucks

Can i fit a wrx engine into a 2,0 ltr wagon


Well, it's possible, but it would take a LOT of work. You would also have to replace the wiring harness, multiple sensors, and the ECU for a start... ... 1996 Subaru Impreza

I have a 2000 jeep grand cherooke 4.7 l engine the check gage ligth came on then the oil pessure drop from 50 to 0 and then back to 50 or 40 while drving,truck runs good doesnt show anyroblems then while i drive it the oil gages keeps droping and pulling up to 50 it goes crazy i just dd the oil change on it i put a 10-30 castrol oil, im worried of what coul it be the truck runs good and seems to be ok..


Change the oil pressure sender -- most likely defective ... 2000 Jeep Cherokee

Hi there I have a 2000 mitsubishi cedia wagon with the 4g93 1.8ltr GDI engine. A few weeks ago I was having trouble with the vehicle idling and surging very violently when applying immediate gas so I had it checked out and apparently the mechanic diagnose the fault as having high carbon build up in the intake and cylinders aswel as a faulty fuel pump. So its been a couple weeks now with the repairs applyed and the vehicle runs ok but still surges when giving it immediate gas in the low range 0-


There are a few in tank cleaners out there the best is probably a cleaner called seafome, you can get it at NAPA or NAPA.com it will not work over night it might take a few tanks of fuel with the tr ... Mitsubishi Lancer

I have a 1996 Jeep Grand Cherokee Laredo 4.0L. About a couple of months ago, my dad did a tune-up on it: changed the spark plugs, the O2 sensors, and the fuel filter. However, recently my car has started to stall. For example, I was driving, and was about to turn onto another street. In the middle of the intersection, my car "shut off". The engine died because the gages all went down to 0, the power steering went out and the brakes were hard to push, but all the electricity was on like the radio


Is there a check engine light on when truck is running ? Does it stall when you hit bumps, only when you turn, stop ? ( my concern is the sometimes dont start.) for a minute or next day or what. Take it to a garage and have them do a fuel pressure te ... Jeep Grand Cherokee

Fuel leaking Hi, I drive a 1989 jeep wagoneer limited and it recently began to leak fuel from the steel tubing and what looks like a filter located on top of the engine just back from the main fan belt. It looks like fuel is seeping, fast from the seam of the steel tubing and the filter thing or whatever it is, any ideas on a quick fix so I can get to a garage tomorrow without blowing up. Thanks in adavance, Rob


If it's a 4.0 engine, the filter thing is the fuel pressure regulator (does it have a vacuum hose going to a fitting on the intake manifold?) Depending upon how much material (clean tubing) you have to work with the temporary"fix" is just about the ... 1990 Jeep Wagoneer Limited

I have a 1993 Jeep Grand Wagoneer with the 5.2 V8. It turns over no problem but wont fire up. I used to be able to hold the key in the run position for a couple mins then hear the relays clicking then the engine light would come on and i could start it. Now nothing...anyone know?


SOUNDS LIKE A FUEL PUMP RELAY CONSULT YOUR OWNERS MANUAL FOR LOCATION ... 1995 Jeep Grand Cherokee

Loud noise! 0 Jeep Grand Cherokee after about 5 min starts a very loud high pitch whinning.It used to eventually go away but now it is always whinning and even louder!Seems like it's coming from drivers side engine compartment near the intake manifold. I thought it was a belt because when you step on the gas the rpms go up and the noise quits until you slow down or come to a stop then it starts again!! Is it a vacuum leak? A bearing seizing somewhere? Belt tensioner?


I would say a bad pulley also. Try to open the hood at idle and see if you can hear where it's coming from. Possibly a bad idle pulley or even the fan belf if yours is a mechanical fan. ... 2000 Jeep Grand Cherokee

I have a 2000 Jeep Grand Cherokee and the oil gauge is going from 0-50 psi. There is oil in the engine. Should I be looking at the gauge or the pump for the problem.


The 1st thing to do is hook up a mechanical test gage and see what the pressure really is, the one used in the truck is electronic and u could have a sending unit problem, if the mechanical test gage show the same readings u will need a new oil pump, ... 2000 Jeep Grand Cherokee

I have 2000 jeep wrangler with a 2.5 engine and 5 speed. sometimes when i am driving down the road my instruments will all drop to 0. Tach, speed, everything. Any ideas?


Here's a really high tech test...Slap the top of the dash with your hand when dash goes out...if everything comes back on, remove the dash gauge panel and clean the contacts in both plugs. sometimes slightly bending them will help make better contact ... 2000 Jeep Wrangler

No power i have an 89 jeep grand wagoneer and it has a full 13 volts at the battyer but when i put the key in and try to start it. it is acting like it has a dead battery. none of the accesories work and there is no power going back into the hood. i have changed and added extra body,chasis, and engine grounds. and this did not fix my problem. any idea on where to start looking. any help will do thank you very much


At this point, I'd start tracing power from the battery (where you know it is) till you find a point where it stops. You either have a deteiorated terminal connection somewhere (under power distribution box?) or a burned fusable link.Most likely you ... 1989 Jeep Grand Wagoneer

Hi there,my 2000 jeep cherokee 4.0l temp gauge keeps going up and down,goes up to normal when the car is at idle in drive and then will start to idle rough then miss and then want to stall,and then when i drive the temp gauge goes down to 0 and seems to run rich and get run-on in the revs can you please help me??????and there is no engine check light coming on, thank you


It sounds like a fualty sensor like camshaft sensor or bad 02 but the check engine light should be on if the problem is sensor or electrical related. I would change temp sensor and thermostat. Sounds more like faulty temp sensor if the car is running ... 2000 Jeep Grand Cherokee

Hello and all the best in 2009, I drive a 1989 jeep wagoneer limited and it recently began to leak fuel from the steel tubing and what looks like a filter located on top of the engine just back from the main fan belt. It looks like fuel is seeping, fast from the seam of the steel tubing and the filter thing or whatever it is, any ideas on a quick fix so I can get to a garage tomorrow without blowing up. Thanks in adavance, Powderhound in Whistler


Put several wraps of black plastic tape around the leak than put a couple small hose clamps over the tape ... 1990 Jeep Wagoneer Limited

I have a 1990 Jeep Grand Wagoneer and just recently when you shut the key off every thing still has power, the windows,headlights stay on cigaret lighter still has power. These are things that are not supposed to be when you turn the key off. The engine does shut off. Do you have any Ideas? Thank you Tim Thomasson


Hi and welcome to FixYa, Based on your description, a possibility is that the ignition switch is faulty and the ACC position is left ON even with the key disengaged. Try spraying the inside of the ignition switch through the key h ... Jeep eer

1999 jeep automatic, 4.0 liter engine front end vibrates violently at 50 mph but not at 0 to 49 mph. is it power control module?


Could be unbalanced tires or bad balljoints or other suspension component, or both. You need to check this or have a shop check it out...It won't go away by itself and the shaking can damage other front end parts. ... 1999 Jeep Wrangler
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.1554 seconds