Having problems with your 1985 Chevrolet S-10 Blazer ?

1999 chevy 4wd the 4wd light has been on for a while, but i was driving down the road and the transfer case shifted into neutral and i lost all movement

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1985 Chevrolet S-10 Blazer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1999 chevy 4wd the 4wd light has been on for a while, but i was driving down the road and the transfer case shifted into neutral and i lost all movement


... 1985 Chevrolet S-10 Blazer

1999 NBS Z71, transfer case will not shift with push buttons, build code NP8, shifted to 4HI got a SERVICE 4WD light but went away and the truck completed the shift to 4HI. When I went to shift back to 2HI it would not shift, it would shift 4HI to Auto 4WD. Have changed the selector switch in the dash, repair shop told me the transfer case actuator motor was bad, I changed that- now the TC will not shift out of NEUTRAL. The TC feels fine when shifting with wrench- Question: how many positions


... 2005 Chevrolet Silverado

I have an 06 Jeep Liberty with the 3.7 V6 and 4sp auto trans. with the 4wd full time, 4wd part time, neutral, 4wd low transfer case. It has 115,000km. on it. My problem is when driving on the highway between 60 and 100 kmh it sounds like it is either missing or having trouble shifting. It hasn't triggered any trouble codes. It doesn't matter if the engine is warm or cold. If I accelerate hard, it doesn't do it, but if I accelerate slow it does it. If I drive at a steady pace like at 100kmh it do


Also something to check would be the fuel filter. I'm not sure if this vehicle has an external filter or just one in the tank. From a service standpoint, low fuel flow can cause what appears to be transmission shift issues with automatic transmission ... 2006 Jeep Liberty

The red neutral indicator light is on for my auto transfer case 4WD selection. I cannot select 'auto', or '2WD'. The yellow indicator light next to these selections just flashes, and goes back to the red neutral position. The truck runs down the road with no problems.


... Chevrolet Silverado 1500

2004 Chevrolet 2500 HD transmission issue, need Help!! Truck will drive fine then sometimes with out warning will shift its self to neutral. When it does this if you step on gas, the speedometer will show the truck is going like 75, and of course there is little or no movement. I have replaced the ignition switch, and cluster, but no help. Trying to decide if it is a shift sensor, or a bad transfer case, or maybe something else???


... Cars & Trucks

I have had my Transfer Case Encoder Motor in my 2005 1500 Z71 replaced 2 times inthe last month, the last one replaced was less than 5 days ago. The last 2 mornings when I have started the truck the 4wd Low indicator is lit. I put the truck in neutral and press the 2wd button it makes a loud clank and stays in 2wd. yesterday afternoon when leaving work I started it and it said it was in auto 4wd. The truck has less than 50K on it and never goes off road to be abused. is this a known issue? Are


I would say the transfer case is hanging up and destroying the motor., and no there are no recalls, maybe technical service letters but these are not recalls. ... 2005 Chevrolet Silverado 1500 2WD

How do you put a 2001 dodge durango in neutral to dolly tow it. I know to put the transfer case in neutral but can't seem to shift the transfer case into neutral, 4h and 4L and awd shift


If your going to put the front wheels on a dolly then it won't matter whether or not the front end is in neutral,if the rear is going to be lifted then it is a good idea to remove the drive shaft,this will keep the transmission from turning. ... 2001 Dodge Durango

The transfer gear case lever is jammed. It will not go into 2wd or 4wd. My Samurai is stuck in neutral. Shifting transmission into 1st, 2nd, 3rd, or 4th has no effect. Is there a way to unjam it or is something broken?


... 1986 Suzuki Samurai

I have a 2000 chevy silverado 2500. It has the 6.0.The truck has a manual shift transfer case instead of the push buttons. The 4wd used to work fine but now it doesn't. The transfer case goes into 4wd but the front axle isn't engaging. I already replaced the actuator twice actually because I thought I recieved a faulty one from the parts store. The 4wd light on gauge cluster stays on a lot but not the service 4wd. I need to know where it recieves voltage from. I need any help I can get please!!


Are you aware you have a 15amp 4wd fuse lower left side of dash for the power that goes into the front actuator switch\015\012\015\012The tranfer case switch and the actuator both have a commn ground at left front body mount.\015\0 ... 1999 Chevrolet Silverado 2500

95 suburban with 4l60e and manual transfer case. shifts rather high in 2wd but livable. when in 4wd high it shifts into 4th and torque converter goes into lock up mode. shifting to third gets it moving again but shifting to od immediately locks the converter again. does the transfer case gear selection interact with the computer control of the transmission or is there a wiring problem?


Sounds like a solenoid problem or trans module, ... 1995 Chevrolet K1500

1999 siverado 4wd problem..started having problems coming out of 4wd, pushed 2wd dash indicator said 2wd but not in any gear. put in park, got grinding gear sound shut off engine restarted 2wd active now. this happend 3 times over about a month. now it wont even go into 4wd I hear transfer case shift into 4wd low but not in 4wd high. boy why couldnt they leave the manual hubs and shift lever alone?? lock hubs before you need 4wd and just use shift lever in cab.hehe


Sounds like it might be an encoder moter, but the best thing you can do is take it to a good transmission shop so they can hook up their reader and find out for sure ... 1999 Chevrolet Silverado 1500

1996 chevy s10 blazer with electronic shift transfer case. How can I get the transfer case into neutral? So I can tow it behind an rv.


... Cars & Trucks

I have a 2000 Durango SLT 5.9 with a nv231 transfer case and a manual slider for the 4wd hi, Neutral, 2WD, and 4WD low selection. I cannot get the 4WD hi to engage even when stopped and in neutral. It makes a grinding sound when you try to push the slider forward. I can still get the truck into 4WD low and 2WD works fine. I can't understand how 4WD low works and 4WD hi doesn't. Is there something in the NV231 that syncronizes the front axle speed to engage it in 4WD hi. Thanks Dave


... 2000 Dodge Durango

I have a 1999 chevy suburban with the 5.7 1500 series the 4wd quit working but the lights on the push buttons are lite and cant hear the the transfer case shift could it be the transfer case shift moter that has gone bad?


1992 1500 blazer could the vacum on the map senser cause in not to engage. it does engage when vehicle has set and cooled down ... 1992 Chevrolet Suburban

I have a 2000 GMC sonoma 4x4. When I try to switch from 2wd to 4wd lo or hi it won't switch most of the time or if it does go into 4wd it doesn't want to switch back to 2wd. I have replaced the motor on the transfer case and the switches inside the truck and still have the same problem. Is there a way to convert it to a manual shift for the transfer case?


Im not sure if u can switch it to manual but behind the pass side kick panel is the 4x4 mod. the wires going to it are going to broke check all the wires repair them and your problem willl be fixed ... 2005 GMC Sierra

I have a 2006 silverado and I installed an engine and wiring harness out of a 2003 silverado, along with a new transmission and transfer case. The cruise control, and 4wd do not work now. The "service 4wd" light is displayed and I dont know what to check, It sounds like the transfer case if shifting when I push the button but the front actuator is not switching.


... 2003 Chevrolet Silverado 1500

Got a used 1993 wrangler 4.0 6 cylinder. Going through a complete fluid change and found the transfer case Empty. Brought up the fluid to proper level with synthetic ATF+4, and it shifts from 2WD to 4WD and back, but I cannot physically move shift lever into nuetral or 4 WD LOW. Could linkage be a problem area, or do I need to go into the transfer case further?


Only a suggestion. disconnect linkage and then try shifting transfer case through all positions. ... 1993 Jeep Wrangler

1998 toyota 4runner. the transfer case shifts into 4wd lo fine and gos into 4wd when button depressed.It shifts into 4wd hi but wont engage 4wd and indicator lite does not come on.


Sounds like the motor on your transffer case is either gone bad, or needs adjusted. ... 1998 Toyota 4Runner

Will not shift out of 4wd low to 2wd hi the truck is in nutral it trys to shift but will not shift unless i turn the truck off and turn the key on while the truck is still in nutral then it will shift into 2wd i have changed the PRNDL switch and the 4wd acuator on the transfer case and still no worky. can some one help or leed me in the right direction?


... 1999 Chevrolet Silverado 1500

Does anyone here understand how the 4x4 system works in these trucks? When you engage the tranfer case, what happens? After you are in 4WD and start to move the vehicle, what happens? It appears to me that there is a sensor in the transfer case that detects the position of the TC shift lever. When the lever is put in a 4WD drive position the 4WD indicator on the dash illuminates (whether the motor is running or not). Next, when the vehicle starts to move the RFWD switch illuminates and the front


The front wheel drive is activated by the electric switch on the dash when you push the button in there is a bladder that engages the front wheel locking device, if this bladder is blown or is dirty it will not ... Mazda B2600

My 98 s-10 wont shift from 2wd to 4wd i can hear it clicking but nothing the book suggest an adjustment on the transfer case where on the transfer case and how do i do it


... Chevrolet S 10

I have a 2003 chevy blazer LS, 2-door 4wd w/ vortec engine. The 4wd is activated by a 3-button switch on the dash (2wd-hi, 4wd-hi, 4wd-lo). The problem is I can't get it to go into 4wd-hi no matter what I do. When I shift into 2wd-hi or 4wd-lo the switches light up momentarily and I can hear a clicking sound from under the dash behind the glove box, and then the transfer case goes into these gears just fine. But when I punch the 4wd-hi button, nothing happens. No light, no clicking noise from un


Try putting in nuetral and then shift into high gear . if still does not work sounds like the 4x4 acctuator is bad ... 2000 Chevrolet Blazer

2000 chevy blazer reverse is out and transfer case makes noise when shifted into reverse.The 4wd dash switch doesn't come on and it is stuck in 4wd. It will shift into forward gears.


I'm Going to say the low/reverse 1 way roller clutch is broken,you are hearing the low/rev.planetary gear set spinning.it is at the very rear of the tranny,right where it bolts to the transfer case.It may have died of old age but the ones I've broken ... 2000 Chevrolet Blazer

My 1999 Tahoe (odo reading 137,400 miles) won't go into 4 wheel drive. A couple of days ago the "Check 4WD" light came on for a while and then went off. I planned, but haven't done so yet, to get all the fluid levels checked this weekend. But now I see the red "Neutral" light is lit and I can't engage 4 wheel drive. If there is a low fluid level sensor, can low transfer case or front diff lube cause this? Also, the problem may be a blown ATC fuse for the transfer case, but my owner's manual does


Hello,\015\012Your ATC fuse is located in the underhood fuse block you may have a second one in the left side of the dash panel.\015\012 I have had great results reseting the ATC module by disconnecting the battery or batterys if there is ... 1999 Chevrolet Tahoe

I've got a 97 Chevy k1500 with automatic trans and push bottom 4wd. transfer case will not engage into 4 high, all the lights flash. The truck will not shift into low range and 4wd does work in low but nothing happens when you try to shift into 4 high. no clanking, or anything. no blown fuses or unhooked wires. just all lights blinking.


It could be one of 3 things, it could be a vacuum leak or the vacuum actaulor could be bad they are usually under the battery tray if that don't do it check the vacuum line under the truck for oil in the line if there is it will be the vacuum switch ... 1996 Chevrolet K1500
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.4354 seconds