Having problems with your 1985 Chevrolet Impala ?

How do i get to my tail lights to change them in a 1985 impala

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Inside the trunk,pull the grey carpet material away from the rear,there will be four or five plastic wing nuts you unscrew and the light assembly will pull off
Repair Help & Product Troubleshooting for 1985 Chevrolet Impala

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do i get to my tail lights to change them in a 1985 impala


Inside the trunk,pull the grey carpet material away from the rear,there will be four or five plastic wing nuts you unscrew and the light assembly will pull off ... 1985 Chevrolet Impala

Hello, i am trying to change the tail light bulb in my 2007 Mariner and i can not get the tail light assemble to fully come out. i have take the two small phillip head screws out and try to pull it out but it seems to be attached from the other side of the tail light. is there something else i need to do to get it out? thanks


Yes it will be a little tough usually there ar retainers that the light sit in on the quarter panels be patient try tapping firmly on the outside of the light at qtr ... 2006 Mercury Mariner

How do I change the tail light to my 2005 Ford Taurus. Someone backed into me and it broke. I bought the tail light online and can't afford to get it put on. How can I change it?


From inside the trunk. Open trunk and you'll find large black plastic wing nuts on the inner trunk wall opposite of your tail lights. Simply unscrew them and the tail light bulbs will come out of the lenses from the inside area of the trunk. ... 2005 Ford Taurus

96 chevy cheynne 5.7 vortechas about 40to50 pounds oil pressure when first sart in morning and when it gets to temp. it drops to 20to25pnds and at a stop it goes to 0 and gauge light comes on until i give it a little gas then it comes up a bit and light goes out. lately it has gotten worse and i finely put a manual oil gauge on it . it shows around 30pds cold and goes to 0 warmed up. and it takes a lot of rpm's to get it back up to maybe 5-10pds. i even changed oil to straight 40wt. didn'


Well it could be the sending unit for the gauge.But odds are the oil pump or engine bearings are worn out.As the engine warms up, the metal spaces expand and the oil gets thinner. The oil pressure drops some under normal conditions, but not ... 1996 Chevrolet C1500

I have a 2005 chevrolet aveo and the left tail light has gone out. i have the replacement bulb but cannot get the light cover off to change it. please help. i certainly don't need to get stopped for having a light out.


Arhhhh! I have a BRAND NEW Aveo (20 days old) and during my first vacuuming of the trunk, found 4" of water around the spare tire. All the carpeting in the back is dry, so I dried it all up - and 12 hours later I had another inch (it was raining all ... 2005 Chevrolet Aveo

I can't get the tail light lense off the van to change the tail lights


... 2008 Dodge Sprinter

Tail lights i have a 2000 ford focus wagon and cant get at the tail lights to change the bulb


Behind paneling in trunk or whole tail light assembly come off. There is no seperate lens. ... 2000 Ford Focus

2005 Chrysler town and country van has lose power. When driving it goes from 0-70 in about 15 seconds, it appears not to have much power when trying to get up to speed. If you press down on gas to try to get up to 40mph very quick, the RPM go up, but you must let off the gas for it to change gears. However, it eventually does change gears. The check engine light is on and the code reads p0404 and p0420. I replaced the EGR valve, still same problem. I disconnected the catalytic converter an


Change plugs, wires, and fuel filter. Get a cold air intake or at least a k&n air filter.\015\012Clean the throttle positions sensor. Check for any vacuum leaks. After every sensor that you replace you have to reset the computer or the code wil ... 2005 Chrysler Town & Country

Turn signal out, no flashers and no brake light except third light on tail gate of a 92 ford taurus sw. changed fuses and bulbs but did not change flashers or relays signal started acting up, getting loud, slowing down and going off and on then it went out and so did brake and flashers.


Its likely the turn signal switch (multi function switch) if the hi-mount still works, ... 1992 Ford Taurus

Tried changing headlight bulb. I could not get the spring loose to get old bulb out. Now the dash lights and running tail lights do not work. I checked all fuses and they are ok. I don't know where to look for the problem. Also Is there a diagram that shows how to remove the whole headlight assembly? Thank you for any help you can give me


Assembly removal is easy. In fact, because of the problem you encountered--getting that stupid retention spring off, I recommend removal of the entire housing. The two 10mm bolts on top of the headlight housing are the most obvious, but not so is t ... 2004 Suzuki Forenza

Changed my bed to a utility bed, added back up and tail lights and i cant get the running tail lights to work. also the turn signals click fast like one is burned out but isnt. at this point i cant drive at night.


You may have led lights which could cause this to happen ... 2000 Ford F350 Super Duty Super Cab

Impala 2001 Sorry I meant while driving my car on the freeway I felt it pull twice it felt like my car lost some kind of a connection.It scared me!!! but we changed the spark plugs etc..tune up and my check engine light comes on then the next day it came off...I'm gonna get a full diagnostic..Oh also my friend said it could be my oxygen sensor...Im just scared b/c of my check engine light is on :-( and I have to press the gas to get it to start...


You just answered you own question, get it diagnosed. ... 2001 Chevrolet Impala

Change tail light bulb out on 2007 chevey impala


... Chevrolet Impala

I need to know how to get the tail light lens cover off to change signal bulb


Open hatch and on inside of body where the lens is are two horizontal screws going into the lens, remove them and pull the lens towards the back of the vehicle carefully. Good luck ... 2006 Dodge Caravan

Dash lights Report abuse My dash lights will not come on even though when i turn on my lights it does not work and yes my tail lights work,ive changed my fuses also .Even the little AC lights wont come on and wen i drive at night i have to shine my phone over the shift stick or whatever its called to put it in drive then when i do get on the road i have to also shine my phone over the dash to see how fast im going........ Can you please help me!!!!


This might sound like a dumb question, but I've done this myself: Is it possible that the dimmer switch is turned down? If not, check the fuse for the insturment/gauges, if that is ok then you can check to see if the ground wire came off under the da ... 1998 Nissan Altima

Cannot get the tail light lense off to change ram 2500


Drop tailgate and look for screws holding light assembly. If all screws are removed you may have sealant holding the assembly. Gently pry it out of is seat. Behind the assembly are the sockets that require a 1/4 turn to remove. Then change bulbs as r ... Dodge Ram Pickup 2500

How to get the tail lights changed?


I just made the change on a 2005 ZX-5. Removing the screw on side and the big plastic "wing nut" on the inside was all that was necessary to remove the taillight assembly. I had to jiggle it a lot because one other clip had to be pulled out. It was o ... 2005 Ford Focus

Recently our brake lights have stopped working all together. We have changed out all the fuses checked the Bulbs and even replaced the break switch all yielding no results. All the other lights such as turn signals, head lamps indoor, and tail lights still work. The only thing not working is the break light, it will not get brighter when we break. Does anyone have any ideas on why this is happening?


Bad brake light switch. It's just above your brake pedal under dash. Small plastic switch w/a couple of wires. Easy fix. ... 1995 Nissan Quest

My running lights and tail lights aren't working on my 1990 F350. I've changed out the fuses and do not see any wires disconnected. Problem use to happen when I pluged a horse trailer in but now I can't seem to get my lights to work at all. It has also affected my dash lights. Everything worked for about 2 years with no problems now I need a diagram or some insight for the wiring on my truck. Dad, brother, brother-in-law, husband don't have a clue. Any advice would be helpful. Thanks


CHECK THE HEADLIGHT SWITCH ,THE RUNNING LIGHTS CIRCUIT TERMINAL GETS TOO HOT AND MELTS THE WIRING CONNECTOR CAUSING THIS AND OTHER PROBLEMS . REMOVE THE SWITCH AND INSPECT THE CONNECTOR AND TERMINALS . IF ANY PROBLEMS ARE FOUND REPLACE THE SWITCH AN ... Ford F-350

My headlights on my 2004 chevy impala do not work. I have changed all four bulbs, the light switch, checked all fuses and still nothing. My parking lights work as well as my tail lights and running lights. I put a tester in headlight wiring and its constantly hot and i have no ground. What should i do?


I had the same exact problem as you. For some reason the high beam / low beam switch gets stuck in no-mans land. Turn it on and off a couple times and this should help. ... 2004 Chevrolet Impala

I have a 94 chevy truck and the rear tail light don't work. Running light and turn signal work. Changed out the switch on the brake pedal and the muti function wire on the column. Still no lights what else do i need to do to get them to work without having to take it to a shop.


Did you check the switch on back of brake pedal if not try replaceing brake light switch hope this helps ... 1999 Chevrolet Silverado 1500

Need to change brake light on a renault megane not the side brake lights but the tail light one, how do i get to it?


Hi \015\012I presume you have a megane 2, this is the procedure.\015\012How to remove the 3rd brake light.\015\012\015\0121. Unclip the tailgate upper trim \015\0122. Unclip the light by pressing on the lugs with a flat- ... 2004 Renault 181

I cant get the tail light out to change the bulb


No tools needed.Beetles: Round plug inside trunk pops out.Beetle Convts: Grille-looking rectangular panel pops out.Reach in and you'll feel a large finger-grip able nut, back it off (DON'T DROP IT) and place it som ... 2003 Volkswagen Beetle TDI

2001 3400 impala: no crank at any time. have tried to install jbs universal learning bypass module, no success. maybe installed wrong since there is no remote start? if I jump the starter vehicle will run for appros 2 sec before it quits, I assume that is all the fuel supplied before security cutout. display rotates thru- security,battery,service,change oil, etc... these lights contiuously cycle and do not change in at least a one hour time frame. any ideas on how to get this thing to run? do


... Chevrolet Impala

I need to change the tail light on the driver's side of my Jeep Liberty. I got the screws out but cannot get the cover off. What do I do?I tried to pry it off, pull it off, and move it around to get it off, but cannot.


If you can get to the back side via an access panel for jack or something, you can get to the back bulb sockets. But I do believe there are metal clips that help hold the light assembly in the body as well as the screws. ... 2005 Jeep Liberty
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.3398 seconds