Having problems with your 1984 Honda Accord ?

Starting when i turn the key it makes a whinning sound but never starts already replace starter still does same thing

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Could damaged flywheel teeth where starter mesh. Turn the motor by hand a half turn and then try starter again. Does the vehicle start when you push or tow it?
Repair Help & Product Troubleshooting for 1984 Honda Accord

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Starting when i turn the key it makes a whinning sound but never starts already replace starter still does same thing


Could damaged flywheel teeth where starter mesh. Turn the motor by hand a half turn and then try starter again. Does the vehicle start when you push or tow it? ... 1984 Honda Accord

Car doesn't start. When you turn the ignition key,it just shows lights on dash but doesn't crank. I have had the problem here for 4days,but still getting same responses...dead battery,bad starter,etc. It isn't any of these. I have replaced ALL these things. I need someone who knows about cars,particularly electrical issues relating to starting one. I am not mechanically inclined,but do know what I have already fixed and replaced. The battery,starter,selanoid,and alternator are ALL fine! I can't


If you can turn things on that are normally turned off by the key, then you have a bad ignition switch. What year is the car so I can get a accurate diagram and rand r instructions. I also need the sub model of the Escort(i.e. LX, EX, etc.)? ... Ford Escort

I have a 96 cavalier.it wouldnt start by using the ignition key,so i shorted the solenoid and it started...got home and it still wouldnt start,so i did the same thing and it started,then all the warning lights came on,the daytime running lamp was flashing and the anti-theft indicater light was on...i shut it off and still wouldnt turn over so i replaced the starter solenoid but still wont turn over with the ignition switch....what could cause this?


It can be the ignition switch or the neutral safety switch. put the transmission in neutral to see if it will start, if it does then the neutral safety switch is bad. if not then check your ignition switch ... 1996 Chevrolet Cavalier

I have an 85 mercury cougar with a 302 v8. I cannot get the engine to start. I turn they key, and the starter works and it sounds like it will start, but it never does. It acts as though the coil wire has been removed from the coil and distributor cap. I have drained my battery in attempts to start it after replacing several parts. After replacing these parts, I tested it and discovered i am STILL not getting any spark from my spark plugs. i replaced the coil, I replaced the ignition box, I repl


Did you try resetting inertia switch in trunk behind panel at drivers side rear fender? What about module on side of distributor. (it's about 3"-4" long & 1-1/2 wide) attached to side of distributor? ... 1985 Mercury Cougar

I have a 98 Z24 I have replaced the altenator, starter, and the thing still will not turn over just the sound of a relay clicking turn key asnd nothing at all happens. Turned the key on for 20 sec and no theft light goes off undid the bat. also and still nothing can jump it by the starter and well start does anyone know what this could possibly be?


If the starter has the solenoid attached to it then you may have received a bad rebuilt starter, it happens a lot these days. If the starter solenoid is separate from the starter it will need to be replaced. ... 1998 Chevrolet Cavalier

I have a 2006 chevy cobalt ss and the several times over the past 3 years I go out to start my car and it will not crank. Pop started it and took it to shop and they found the fuse under hood to starter blown....replaced and was fine for months and same thing happened again. last time the fuse blew ,when I had started the car, the starter was stuck and was still cranking after car was already started. What could be causing this?


Sounds like your starter solenoid is sticking or the ignition switch to keep the starter engaged rotating the engine. First change out your starter solenoid should solve the problem also the starter may be pulling to many amps and blowing the fuse si ... 2007 Chevrolet Cobalt Coupe

When I turn my key to start 1999 Durango 5.9 there is no spark I have to sometimes turn key on and off for up to an hour then all of a sudden the fuel gauge will go up then it will start , I took it to Pep Boys they said it was the starter they replaced worked good like always once it starts then it kept doing same problem also took to Dodge dealership hooked up to computer to see what us wrong, they said NOTHING but still doing the SAME thing ,, please help me WHAT is wrong


When the ignition key is turned to the on or run position, What lights and accessories come on? Does anything get power from the switch when you turn it on, whether it starts or not?\015\012How many miles are on this vehicle? ... 1999 Dodge Durango

1998 jaguar xj8. the car will not start. the dash lights up and all i hear is a click when i turn the key. i thought it was the starter, and i replaced the starter. it still won't start. does anybody have any idea what kind of thing would stop the starter from turning over?


Is the battery fully charged ? ... 1998 Jaguar XJ8L

Problem with not being able to starting S40 Volvo yr 2000 i had 2 starters replace, battery good, alternater replace, key change, relay switch replaced can any one help me i already spend a fortune and 3 mechanics can't find the problem even the volvo dealer can't find the problem it is now occuring every 2 weeks i never now if the car will start or not please help thank you


Possible a earth strap corroided inside the casing, requires wiring diagram and checking all power and earth points and resistance through the wires to make sure that they are ok these cars suffe with the loom across the front of the subframe corroid ... 2001 Volvo S40

I have a 1994 Nissan Sentra, It stalled on the highway, and would not start back up. First thing I did was put some gas in the tank because you never know. Next thing I did was to spray ether in the intake, and it started and ran until the ether burned off. So I replaced the fuel pump, fuel filter, and fuel pump relay, I can hear the fuel pump turn on when I turn the key, but it still will not start. I have checked the fuel lines for breaks and did not find any. Even though I think it is a fuel


You'll need to check your fuel pressure regulator,it will be on the fuel rack on top of the motor, just follow the fuel lines on top of the intake, it will be a round silver cylinder on top of the motor, just follow the silver fuel lines, just an adi ... 1994 Nissan Sentra 4-Door

1999 Ford Taurus SW SE DOHC- my car will not start. The engine tries to turn over but it will not catch. Last week we were able to get it to turn over by spraying starter fluid into the manifold, but once the car warmed up it would die. Now it will not start at all. We replaced the fuel filter and it is still the same thing. I can hear my fuel pump priming when I turn the key (I believe). Any ideas? could it still be my fuel pump? We also checked the fuel pump regulator and had no fuel comi


If the car started with starting fluid and you are sure you hear the fuel pump priming the system it may be an obstruction in the line after the pump and before the injectors there is a fuel filter usually located on the fuel fill side by the gas tan ... 1999 Ford Taurus

92 F900 dump truck. Ignition switch sticking. REplaced switch and lub key. Turning key to start does not engage starter, but gages, etc are on. Replaced coil connecting to starter. Still nothing. Jumping coil connectors starts truck but will not remain running, and it sounds like the starter does not disengage/stop. Any ideas? Is it possible that when key and switch malfunctioned it burned out something? Someone mentioned starter has internal fuse, but if jumping terminals starts it would that b


... 1992 Ford F350

If the temp gets below 20 degrees f first thing in the morning after setting overnight all lights and dash lights come on but when I turn the key I get nothing at all just a click. If I continue to turn the key off and on numerous times it will eventually start. Its never the same amount of key turns and the battery light on the dash stays dimly lit sometimes it goes out sometimes it dosent. Any idea what the problem might be already replaced the battery. General Motors you would think if they d


Sounds like your starter solenoid is wearing out. Inside the solenoid, there's a copper disk that comes in contact with two copper posts when the solenoid activates, completing the starting circuit. When the posts arc out, or the disk arcs out enou ... Chevrolet TrailBlazer

I have a 1989 Jeep Grandwagoneer that won't start. I've had it running since I bought it about 6 months ago, never had a problem with it starting other than when the alternator went bad. Replaced it and ran fine. Was driving it yesterday and it overheated on me, stopped and shut it off to let it cool down and when I went to start it there was nothing. It still has power, lights, radio, etc come on, but when I turn the key there is nothing, not even a click from the starter.


... 1989 Jeep Grand Wagoneer

1996 Subaru legacy with 5 starters replaced since June 2011. Still not starting normally. Will generally work for 2 weeks post replacement and then nothing when the key is in the start position. Starters check out ok on the bench. Normally after 2-3 weeks we can start it after tapping the starter lightly with a half inch socket extension bar. Sometimes it is a 2 person job with one person having the key in the start position while the other one taps. Now with our latest starter we are have


I really think you have some other problem going on that you think is the starter. Maybe a starter relay. Does it just not start when it is warm and after it sits it starts? Does you remote starter switch bypass the key switch and go straight to the ... Cars & Trucks

I have a 2000 Mitsubishi eclipse gt that the starter quit working. We could here a click when turning the key to start. So im thinking the solenoid was engaging. But the starter was bad. I replaced the starter and it cranked and started right away. 3 weeks later the same thing happened. Thought it might just be bad luck and got a bad starter. Replaced it again and the same thing it cranked and started right away. Took the starter back to get it checked, it checked out and turned over like it sho


... 2000 Mitsubishi Eclipse

Car runs, but stalls. All power indicators on. Car rests, then starts. Runs for short distance, then stalls again. Tests indicate no power to starter from ingnition leads when keying to start. Already replaced starter solenoid relay, fuel pump relay, auto shut-down relay and bypassed starter motor. Applied power directly to starter and it cranks. Now, turning key does nothing. This vehicle has key decoder module. Do I need to replace this module????


Check for proper current from alternator more than13.5 volts that should do it if not check active codes if its not stolen ... 2003 Chrysler Town & Country

I have a 2004 Pontiac Grand Prix GT that doesn't want to crank at times. Used to be first thing in the morning. You turn the key and it will try to start but dies. When you try it again and push the gas it would start. Now, it does it a lot, not just first crank. I have had it checked out and the alternator and starter are fine. I was told it could be the crank sensor, had that replaced. Still the same problem. Now I'm being told it could be the temperature sensor. I'm not sure what to do. Any i


... Cars & Trucks

Want start when i trun the key the car want do anything sometime when i keep trun the key it will cut on or sometimes it wouldnt i replaces the ignition it had three starters an it still doing the same thing


You have a short somewhere between the battery and the starter. Follow yer battery terminals and look for damaged loom. Or an unsecrure ground...If you are turning the key and its not even clicking this is your problem... hHave a friend slam your car ... 2000 Pontiac Grand Am GT

My 2002 jeep wrangler x with the 4 litter in it will not start. I turn the key and nothing happens. I have replaced the starter and the electronic ignition switch and I still have not had any luck with getting the jeep to crank. It wont turn over at all. I have check for corrosion on the battery and I have check all the receptacles under the hood for corrosion. every thing is good to go in that department do you have any suggestions on what to do? The only way I can get it to start is to shor


Have you checked the neutral safety switch and the starter relay in the power distribution center? ... 2000 Jeep Wrangler

My 1997 Chrysler LHS on some days the gauges work when you turn on the key switch to start car and some days they don't work.The car starts and drives ok. The gauges that don't work are the temp,fuel,tach,and the speedometer.I already replaced the ignition switch. Still doing the same thing.


Check fuse relay box on firewall could have a short or lose wire. ... 1997 Chrysler LHS

MY 89 ACURA WON'T START AFTER I DIDCONECTED THE BATTERY TO CHANGE THE HEAD LIGHT EVERY THING WORKS LIKE THE DASH BUT EVERY TIME I TURN THE KEY THIER IS NOTHING HAPPENING AND THE RADIO GOES OUT WHEN I TURN THE KEY. I HAD IT SERVICED JUST A MONTH BEFORE AFTER CHANGING OUT THE ALTINATOR AND THE STARTER SAME ISSUSE. THE SHOP SAID IT WAS MY FULE PUMP FUSE, SO I REPLACED IT STILL NOTHING


... 1989 Acura Legend

Parked 91 trooper went to start week later starter clicking, replace starter still same problem replaced battery same thing. replace starter relay fuse dose same thing hear clicking on starter,losen starter to see if starter is in bind and cleaned battery cables. stater clicking and has had it tested no problem with starter.


You could try spining the engine with a 1/2 inch breaker bar and the socket for the crank bolt and see if the engine turns. If engine turns u cud check your ground wire and hot wire going to the starter. ... 1991 Isuzu Trooper

1992 Jeep wrangler, 4.0L HO, manual transmission, replaced Key cylinder, starter switch(on steering column), starter relay, starter soleniod, rebuilt starter, and still have same problem of periodically when the key is turned to the start position the starter does not engage. The battery is new and very good. When I jump the starter soleniod and turn the key to the ON position, transmission in neutral, it starts very well and runs fine.


You have an ignition voltage problem or ignition box failure. ... 1992 Jeep Wrangler

2000 jeep cherokee wont start. i turn the key to crank, but all i get is one click and then nothing. i thought it was the starter so i had that replaced and i had the same results. thought it was a battery problem so i jumped it with my wifes car and it still did the same thing.


If the starter seems good and the battery all that is important is to check if there is power to the starter when the solenoid clicks. you need to check this before anything can be confirmed.\012Check the leads, the ground of the e ... 2000 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.0391 seconds