Having problems with your 1983 Subaru Gl Wagon ?

Wont shift clutch goes all the way to the floor

\015 Wont shift clutch goes all the way to the floor it pops out of gear when you start it and dies when you slow down\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

8degrees before tdc
Repair Help & Product Troubleshooting for 1983 Subaru Gl Wagon

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Wont shift clutch goes all the way to the floor


8degrees before tdc ... 1983 Subaru Gl Wagon

Brake pedal goes all the way to the floor, will slow the car a little, but wont fully brake. master cylinder is fine, calipers and pads are new, brake lines look okay, it's holding brake fluid fine, lines have been bled multiple times, and we can't find a leak anywhere. Any ideas why my brakes still wont work? I'm pulling my hair out trying to figure this out! Thanks!


Must be something you have overlooked. clamp off the front brake hoses and rear hose. if you dont have the propper clamps use g clamps or locking pliars. try the pedal then. if it still goes to the floor its either air in the lines or the master cyli ... Lexus SC 400

I have a 1996 honda civic clutch goes all the way to the floor and wont shift when running only when it is off. got ran off he road the other day went up a pretty high curb and thats when i niticed the clutch pedal was feeling realy funny now it wont go in gear


Your master and slave cylinder can cause this, try replacing the kit for them and if that does not work then u might need to bu a new clutch. ... 1996 Honda Civic

My 1997 s10 wont shift into park, the button wouldnt push in on my floor shifter, i took apart and found that a white piece fell off that clamps onto this thing that pulls out a white knob allowing the button to go in and shift. however the piece that goes from the shifter to what engaged the white piece to move isnt there. the button goes in half way but doesnt make contact to pull the white knob out. am i missing a piece? also i can shift by pulling white knob out with a finger but now i cant


... 1997 Chevrolet S-10 Pickup

Breaks went out 2006 grand caravan. first lost power brakes and pedal was hard to push then went to the floor now goes all the way down and wont build pressure. checked all lines its full of fluid with no leaks all calipers seem ok


IT sounds like your brake mastercylinder has went out so what you need to do is get a new mastercylinder and replace that and bleed out the whole brake system after you put on the new mastercylinder. ... 2006 Dodge Caravan

My honda wont go into gear & the clutch goes all the way too the floor


Hi, I believe you have a clutch reservoir located under the hood, near the master brake cylinder, It's round with a removable cap. Check the level, it's probably low. ... 1991 Honda Accord

04 cav clutch pedal wont go down all the way at times when driving if u let up slightly then push back down it goes down farther if u keep doing this it will eventually get to the floor


You have a leaking hydraulic clutch release slave or master cylinder, have them inspected. ... Chevrolet Cavalier

I have replaced and bleed the front brake but the pedal still goes all of the way to the floor and the truck still wont stop. what could be the problem?


Did you just bleed the one brake or all of them. You need to bleed them all. Also, be careful with bleeder screws the are quite easy to break. Check the level of you brake fluid, if the reservoir is still full bleed all four brakes again. One at a ti ... 1991 Chevrolet C1500

98 wrangler - brake pedal goes all the way to the floor. The master cylinder and all brake lines are free of leaks. I'm not losing any brake fluid anywhere. I replaced the booster that is attached to the master cylinder and fire wall and still the brake pedal goes all the way to the floor. With the engine running I can push on the brakes really fast and I get a little resistance. Before I changed the booster I replaced the master cylinder thinking that was the problem. Can anyone help?


... 1998 Jeep Wrangler

Brakes had to change the left rear caliber. tried to bleed the brakes and lost all braking. Then I changed the master cylinder and got some braking back, but pedal goes all the way to the floor. Again tried to bleed and again lost all brakes. changed the master cylinder again (froze) and have brakes, but still the pedal goes all the way down to the floor. Any idea how to fix this?


The brakes just need to be bled properly which take 2 people or a bleeding pump,Please tell me how you are bleeding the brakes. ... 1998 Audi A4

I have a 1997 Range Rover and the brake pedal goes all the way to te floor.Before it went to the floor it wasb locking uph the brakes.Now it goes to the floor and has no brakes.Thanks


... 1997 Land Rover Range Rover

I have a 1998 jetta, when i push in the clutch the peddal goes half way then slams itself to the floor. i have to manually pull the clutch pedal back up and it does the same thing on the way up. it goes half way then slams itself to the upright position


It sound like the release fork/arm has bust , this is common on these and when halfway down, it slipps off, only way to fix is transmission out, and hope the housing is not damaged ... Volkswagen Jetta

Key doesnt turn! We have used two keys a key that wasnt for the car that worked and a the key that worked. We used the wrong key to start the car then parked and now when we went to start it using wrong and right key, the wrong key wont go all the way in and wont turn in the column and the right key goes all the way in but wont turn. We have moved the steering wheel shitloads and rocked the car back and forth but still nothing thanks guys


Sounds like the key cylinder is bad! the way u described the problem sound like an older car and the original key looks worn or is rounded at the edges ... 1992 Plymouth Voyager

My break pedal goes all the way to the floor....i have a 94 pontiac bonneville.....and i read a few things on you website.....i added break fluid but they still go all the way to the floor....do i have to bleed my breaks??


You either have air in the line or your vacuum booster needs replaced. Try to bleed them first. Then pull the vacuum line of the booster and see if it makes a change. Good luck. ... 1994 Pontiac Bonneville

83 Dodge Ram Van, Wont Start... Did Get It Started Once, But Had To Keep Gas Pushed To Floor To Keep It Running! When I Tried To Drive It Wont Go Over 2 MPH, With the Gas Pedal Pushed all the way to the floor! Was Fine 2 days ago when I parked it! what could be wrong? Thank you! It Also Has Recently Gotten Very Cold! I Have Anti Freeze In It and Always Check The Oil.. It Also Had a white gunk built up around the oil cap, but none on the dip stick? Thank you again!


If it's puffing black smoke out the tailpipe, it's probably the choke on the carburetor sticking closed and needs to be adjusted, or at very least freed up and lubricated.. Do you know what part I'm talking about? Do you need more guidance? ... 1994 Dodge Ram 2500

We are bleeding the brakes on my 2003 kia spectra. the right front and the left back are doing exactly what they should be doing- getting pressure then when releasing the bleed screw the peddle goes to the floor and brake fluid shoots out.. the left front and right back on the other hand do nothing but sputter and maybe drip a little brake fluid and the brake peddle goes all the way to the floor every pump. what is going on? ps: there is no leaking in or around the master cylinder


You should try presher bleeding them,,,its way easyer,,,keep the fluid toped up as well ... 2003 Kia Spectra

I have a Saturn SL 1998 Man.Trans. When the car is cold, I walk out to start it and the car cranks right up, I notice the temperature gauge goes straight to half way point and the coolant fan immediately comes on also. I drive the Saturn and as it warms up the temperature gauge goes all the way down to cold and at this point if I turn the car off, it will not crank unless I hold the gas pedal to the floor and just keep turning it over and over finally it will catch fire and start. If the car si


There is a sensor its the ects sensor. Its in between the EGR valve and the upper radiator hose on your car. I just changed mine two days ago. And it fixed my problem. My car was doing the same exact thing yours is. The temp. gauge in your car should ... 1998 Saturn SL

We replaced the front and rear brakes and now when I press on the brake peddle it goes all the way to the floor. I've pumped them and still goes to the floor. I checked the fluid and it is ok what else could it be?


Ok just pump the brake pedal until it get hard ... 1995 Oldsmobile Cutlass Supreme

Wont start I have a 2000 ford focus tht wont start. It has spark fuel pump is kicking over and have even pourd a lil into the throttle body to see if that was it and still nothing. i have banged on the starter motorand solinoid and still nothing. the battery is good even tried jumping it. it turns over bout 3/4ths the way most times and doesnt kick on. other times it kicks almost all the way over then goes back to the 3/4ths.....ANY IDEAS????


... 2000 Ford Focus

I am drying to diagnose brake problem with 1993 Pontiac Bonneville SE. The brake pedal goes all the way to the floor when pressed. The brakes grab at first, then the pedal slowly goes to floor and brake power decreases. I checked pads and that's OK. The reservoir fills beyond fill line when brakes applied. I suspect the master cylinder, is that correct?


Yes it sounds like the problem it could maybe be the brake booster if the brakes are better at a higher idle but there is a check valve on the brake booster that cost 2.00 too replace that runs off vacume i would replace first ... Pontiac Bonneville

Brake pedal is mushy all the way to the floor. Have already replaced front calipers, master cylinder, and bled all the brakes. Pedal still goes all the way to the floor when stopping the car.


If the car has drum brakes in the rear, Jack the rear up and have someone push the brake pedal hard and you try to turn the wheel. If you can turn it you need to adjust the rear shoes. They may be traveling out so far that the fluid level drops causi ... Honda Accord

Brake pedal goes to the floor. When engine is off the brake pump up. With engine on pedal goes almost all the way to the floor. 1989 chevy 1500 standard cab, 5.7 ci engine


You have a faulty master cylinder. ... 1989 Chevrolet C1500

I HAVE A 1999 F150 4X4 WITH 4 WHEEL DISC BRAKES WITH CRUISE. MY BRAKE PEDAL GOES ALL THE WAY TO THE FLOOR WITH VERY LITTLE EFFORT. THE BRAKES DO WORK, BUT DON'T ENGAGE UNTIL OVER HALF WAY DOWN. I JUST HAD TOTALLY NEW BRAKES ( CALIPERS - PADS - ROTORS) AND IT DID NOT MAKE ANY DIFFERENCE. I HAD BETTER BRAKING, BUT PEDAL STILL GOES DOWN. THE MECHANIC RAN OVER A GALLON OF BRAKE FLUID THROUGH, LOOKING FOR AIR OR LEAKS, BUT FOUND NOTHING. WHEN THE TRUCK IS TURNED OFF THE PEDAL IS SOLID FIRM AT THE


\015\012ya deffinately this is due to bad master cylinder.. Evantually there are two types of cylinder mainly depinding upon car model on1999. You have to choose your car type cylinder. because to cylinders are slightly differ from one another ... Ford F-150

I have a 2005 mustang with windows when windows are up and you open the door it goes down a little then you shut the door it goes up.Problem: some times it stops working and wont go up all the way or wont go down and catches the rim at the top


I had the same issue. In some cases the computer needs to be re-programmed. You can do this my disconnecting the negative lead on your battery and then reconnecting. This is similar to re-booting your home computer. In other cases its an indicati ... 2005 Ford Mustang

Jeep wont start, engine goes to turn over but wont go all the way


Ok...what you need to determine next is if the fuel pump is operating. Turn the key to the on position and have someone listen at the tank. If you can't hear it, it's not on. (that can be pump relay, pump or sometimes asd relay) to quick check relays ... 2001 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.9156 seconds