Having problems with your 1983 Nissan 280ZX ?

Where is the thermo time switch located

\015 A small unit on the top of the intake manifold is leaking some fuel\012I don' know what it is called\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Fuel pressure regulator maybe ?
Repair Help & Product Troubleshooting for 1983 Nissan 280ZX

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where is the thermo time switch located on a 93


First of all, I own the same vehicle. 93 camry xle v6. I have rebuilt the engine, etc. Open the hood. Looking at the engine, it's on the right side under the air intake tube from the air cleaner box, on the top of the intake manifold. There are two s ... 1993 Toyota Camry V6

Where is the thermo time switch located on a 92 landcruiser?


... 1990 Toyota Land Cruiser

Thermo Time Switch, 75-83 280Z-280ZX Non Turbo whats it's location


... Cars & Trucks

1998 chevy S 10 won't start in cold weather. starts just fine when around 25 degrees or so. looking into cold start valve and thermo time switch, but don't know location of either, or how to check.


A coolant temp sensor will cause this problem if it is reading warmer than it is outside this will give lean condition .the sensor is located by the t-stat follow upper radiator hose down to housing.the sensor has two wires. thanks for your quest ... 1998 Chevrolet S-10 Pickup

Where is the thermo time switch located


Fuel pressure regulator maybe ? ... 1983 Nissan 280ZX

My cooling fan runs all the time when the key is on until I unplug the switch located in the back of the AC compressor. Read somewhere that this is supposed to keep the fan running while the AC is on. AC works fine, and is fully charged, but off or on the engine cooling fan runs. Suspect switch is bad, but having a hard time locating a replacement.


Check your releyss \015\012go to the salvage yard and buy a couple for 2 bucks each or a pocket full for free ... 1984 Chevrolet Corvette

I have a 1998 Ford Escort ZX2 4cyl. I am having a problem with my car starting. Sometimes it will crank over OK, but other times I will just hear a click, as if it is not getting good contact. I have replaced the starter and I have checked the battery and terminals. I recently purchased a starter relay switch but I am having trouble finding the location of the starter relay switch to replace it. Could you give me any help finding the location of this switch or any other help solving this problem


Hi.my paretner had the same problem with her car.\015\012We sorted the solution by disconecting the terminals on the battery.\015\012on the negative terminal there should be two thick leads of which both go to the negative side of the bat ... 1998 Ford Escort

Wont start i have a 96 ford explorer v6 engine. It wont start in various locations after running fine to the location. I have replaced the fuel filter, fuel pump, fuel pump relay, coil pack, control module, ignition switch, and crank position sensor. I have run out of parts to replace. It seems like every time i fill up the gas tank it gives me trouble. If it sits for a long time it seems to help. Sometimes it dosent matter how long it sits. I tested the spark plugs and it dosent seem to spark w


I would check the cam position sensor ( at the right rear of the engine) and the plug connector at the PCM. I believe when you say "control module" you mean the PCM because these engines did not use a separate ignition module in '96- it is all done b ... 1996 Ford Explorer

This vehicle is a 2002 nissan sunny singapore model. The air conditioner system is fine, the air blower(fan) located in side the vehicle is continuously blowing air regardless of the blower switch position. The only time it stops blowing air is when the ignition switch is off. the air conditioner control circuit is fine. I tried tracing the wires from the blower which goes to some power unit, but this I cannot locate. Those wires are blue and are of a thick gage. I have deduced so far that the p


... Cars & Trucks

2000 Civic with a B16A. Where is the thermo switch located. Fan will not come on. Checked the fan it's fine. Next to test is the Thermo Switch. Also what temp should it close at? Thank you, Mike


... Honda Civic

Signals work some of the time most times not . i changed the switch but same problem now io want to change the flasher but cant seem too locate it on the car please help thank you.


Hello, having same problem with my car hope this article helps there was a recall here's the information...\015\012\015\012\015\012\015\012\015\012\015\012Recall Reason\015\012EXTERIOR LIGHTING:HAZARD FLASHING WARNING LIGHTS:SWITCH\015\01 ... 2000 Oldsmobile Alero

I have a 1992 chevrolet c1500 4x4 5.7 litre -when you first start it up,with ac on,ac compressor clutch will engage,disengage 3 times then will not engage,if i run 12 volts to the clutch pressure switch green wire located on the accumulator,the clutch engages ,i am assuming this pressure switch is bad.Do i have to recharge the system if i unscrew this pressure switch and screw in a new one or is there a schrader type valve in there ?


The pressure switch will open when freon pressure is too low, the compressor clutch is controlled by the computer or module.\015\012The switch isn't necessarily bad, you can check it with a multimeter. The fitting it is threaded onto should hav ... 1992 Chevrolet C1500

Where is the oil pressure switch located on a 96 nissan 200sx se-r, sr20de motor 2.0? my powersteering liquid gets low from time to time, i know its a leak. do i have to change the who powersteering pump? can i install high performance cam gears for example (JWT, BRIAN CROWER) with a stock modifications on the motor? or does the motor have to be tuned? and can the high performance cam gears be installed with a regular timing? chain? i have after market speedometer cluster and the lights went co


... 1996 Nissan 200SX

1990 pathfinder has alarm system with a impact shut off switch . Where is this switch located and how do you reset it. Thanks for your time


... 1990 Nissan Pathfinder

Headlights will not come on. day time running lights will not work either. i can pull the headlight switch forward and hold it and the headlights work, but as soon as i let go they go back off. I was thinking that it may be a headlamp relay or headlight dimmer switch was the cause of the problem. but i dont know where the relay is located.


... 2003 Chevrolet Tracker

1996 landrover dicovery , breaklights staying on all the time. Removed trailer wireing and checked break pedel switch , which is working fine. Heard that there is a second switch on the transmition somewhere, could this be the problem? if so, where would this be located?


I have the same problem. Up until now that I have time to correct the problem the right way I have had a spring attached to the brake pedal that keeps it from pushing the brake llight switch on. Makes the brakes hard to push but keeps the lights of ... 1996 Land Rover Discovery

Electrical problem I gave someone a jump several months ago. Since I did that everytime I exit my vehicle my running lighjts and dash lights turn on and drains by battery. So every time I park my car at night I have to take out a fuse so the lights won't come on. Also, when I do reinsert the fuse in my vehicle my rear lights and running lights stay on. Is tlhere a problem with my electrical relay switch, and if so where is the relay switch located'


Check your alternator. I had the same thing happen when I gave someone a jump. For some reason they go out after you jump someone. I would have the alternator checked and go from there. ... 1990 Oldsmobile Cutlass Calais

1994 Buick LaSabre, great car, except for headlight/parking light issue. Went to party got out of car and heard bing, bing, turned it off, dash lights went out, I didn't think another thing as someone was speaking to me. Headlights stayed on! Dead battery. Now sometimes, If I do in correct order, turn off car, turn off lights and then open door lights go out. Some times NOT, some times lights do, but parking lights don't. We did already replace switch for light that is located on drivers door


It sounds like you have a bad light sensor for the auto lighting feature. When you are ready to exit the vehicle, first turn the lights off and then turn the car off and that should provide you with a quick fix. ... 1993 Buick LeSabre

1998 exporer Limited Edition Day time running lights don't work. I am trying to locate the DTRL Module on the vehicle. I will start by replaceing that first.Also have problem with my high beam indicator lamp in the dash not coming on. I checked the bulb,It;s good, I checked for power at all the pins to the dash or gauge cluster with head lamps on and high beam on. As I located power wire I switched to low beams to see if any of the power wires would stop illuminating my test lamp. Non Did. I am


There is a fuse that controls; headlamps, DRL module & instrument cluster. It is the fuse box inside the vehicle mounted on the side of the dash on the drivers side and you can see the panel if you open the door. the fuse that I am talking about is i ... 1998 Ford Explorer

Where is the power window relay located on the '03 Buick Century? And could this be the problem for all windows to stop working at the same time EXCEPT the driver's window? Or possibly the lock switch not letting the others to work, but they won't work from the driver's master switch either.


The lock switch is designed to keep the passenger buttons from being used. It should not stop the master switch from operating the windows - or at least, that's what the 2003 Buick Century Owner's Manual says.\012\012After studying the s ... Buick Century

Location fan relay switch and thermo switch - 1991 Honda Accord


Open the hood of the car and you should see a black box with alot of fuses ... 1991 Honda Accord

We have a 1997 chevy blazer that once it sets for a while will not start unless you poor gas down the throttle body. Then it runs fine until next time. Does it have a fuel regulator and where is it located? Does it have a fuel relay and where is it located? You can hear the fuel pump come on when you turn on the switch. Any advice will be appricated. The car belongs to my soon and he is out of work.


Sounds like your looseing fuel pressure or electric choke is sticking open ... Chevrolet Blazer

I started having trouble with the heater on my 2005 Highlander, one time the heater comes on & the next time it does not.Is their a control switch that would cause this problem ? if so where is it located ?


... 2005 Toyota Highlander

2002 Chev Venture: The electric door locks, and the emergency chimes stopped working, and at the same time , when i turn off the ignition and open the drivers door, the radio continues to play.I thought that perhaps the drivers door jamb could be stuck, but I can't locate it?? Has any one had the same problem? and can any one tell me where the switch is located? Thanks


... 2002 Chevrolet Venture Passanger

Over heating I need to replace my clutch fan relay switch & I cannot locate it in my car. My fan works fine if I bypass it and every thing else is good, its just the relay, the car over heated 2 times only nothing bad came of it. I refuse to have a dealer fix it,bad enough the relay is $35.00 & no dealer is going to charge me hundreds of dollars to fix what I can do my self. Can eny one help me? Wheres the electric clutch fan relay located for my 86 chrysler lebaron?


Looking for the electric fan thermostat/switch on a 93 lebaron myself.. ... 1986 Chrysler LeBaron
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.9832 seconds