Having problems with your 1965 Ford Mustang ?

'65 Mustang Hazard Lights

\015 The battery on our car is dead. When the charger was connected, the hazard lights in front and the back taillights began blinking. They blink intermittently and only stop blinking when the charger was removed and the hood was closed. We have searched the original handbook and looked at/tried all of the switches on the dashboard, but nothing seems to stop the blinking. Any suggestions?\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Bad ground in rear taillight area
Repair Help & Product Troubleshooting for 1965 Ford Mustang

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Interior lights Hello, I have a 2002 ford mustang and the interior lights, signal light, back up light, and hazard lights are all not working... I spoke with someone and they said it was the box on side of the steering wheel needs to be replaced... do you know the name of the box so that i can get a price on it???


What they are speaking of is the GEM module however this will not correct the concerns you have.\015\012The GEM controls the following functions:\015\012\015\012warning chimes and warning lamps \015\012 ... 2002 Ford Mustang

Sequential signal lights on 2006 Mustang, one light is not working. We changed the bulb, still not working. All three lights run properly when the brake is applied and the hazard lights activated . The problem is when the turn signal is on only 2 of the three lights work. How can we troubleshoot/fix this?


A power inverter mounted in the trunk will have to be replaced to rectify this problem ... Ford Mustang

95 mustange gt brake light dont work check #9 fuses change all bulbs replaced switch on brake pedal hazards lights works ,parking or running lights works,turning signal lights works,what other places i should check is there a relay on there plz help me


I assume the fuse has power if the hazards work.The third brake light skips the turn signal switch, the regular brake light circuit goes thru the turn signal switch.Do you have power going into the turn signal switch on the red lite green wir ... 1995 Ford Mustang

2006 Mustang left turn signal acts like hazard lights.


A short in the tilt steering coulem typical...ford and gm problem ... 1992 Ford Thunderbird

Hazard lights on 2007 ford mustang not working but all other signal lights work. What's the problem


... Cars & Trucks

1992 4cyl mustang starter went out so i replaced it and when i went to start it the under hood cylenoid also went bad so i replaced it now the car has no power at all to the fuse box? if i tern the key nothing happens at all? no hazard lights no head lights nothing? but if i jump the cylenoid the dash and car then gets power turns over but wont start and the ignition swich is showing power all the way through? any one had this happen or know what it could be?


It can be a fow thing mybe you hock the wire up wrong ! or it could be the cylenoid is bad ! an it could be the safty switch that is in the front set floor on the pasinger side up under the panel by your feet it will be a red button . look over the p ... 1992 Ford Mustang

1989 Ford Mustang 5.0 / hazard lights & left and right turn signals do not work. checked fuses & light bulbs, all A'OK. please help.


Have you replaced the flasher? what do u mean by "amp" ... Ford Mustang

'65 Mustang Hazard Lights


Bad ground in rear taillight area ... 1965 Ford Mustang

How do I fix 1993 mustang blinkers. The hazard lights work, but not the turn signals


... Cars & Trucks

I need to know where the flasher is for the turn signals on a 1989 Ford Mustang 5.0. I found the one for the hazard lights.


HAZARD The Flasher is located:\015\012\011\011\011\011\011\011\011\011\011\011\011 \015\012\011\011\011\011\011\011\011\011\011\011Front seating area, driver side, under dash, driver side of steering column, mounted in rear of fuse block. ... Ford Mustang

1988 mustang gt no turn signals ,hazards ,wipers,parking lights all work...checked relays,fuses,fusible links and grounds.....help!


How about the flasher itself? Mounted on fuse block. or under dash ... 1988 Ford Mustang

I have a 1998 ford mustang 3.8L. The hazard light start flashing when I turn the car off. Could you please tell me why? Thank You Angela


... 1998 Ford Mustang

My brake lights dont work and my hazard lights in back.. brake light in window works.. hazard lights in front work blinking fast. when put turn signal on go back to normal blink. turn signals work and running lights work in back.. replaced brake switch twice and all bulbs are good... only brake lights and hazard lights in back out


... 1996 Mercury Grand Marquis

I have a 99 Suburban. About a week ago, the two main brake lights and the all hazard lights stopped working. The upper center brake light still works. If the hazard light button is in the on position, the turn signals do not work so there is no blinker activity. When the hazard light button is in the off position, all blinkers work. I have removed the trailer light harness T and replaced the bulbs, and fuses just in case. I started looking for bad/broken wires but haven't found anything.


Hi! Please do check the turn signal/hazard relay. They may be corroded or may need replacement. Hope this helps and thank you for using FixYa! ... Chevrolet Suburban 1500

I have a Nissan Murano 04 and I am facing the following trouble. There are two modes of operation for lock and unlock through the remote. One is the hazard light and horn mode and the other is just the hazard light mode. My car seems to have gone in the hazard light only mode and I cant seem to get in the mode where both the hazard light flashes and the horn chirps once. Also the panic button switch fails to produce any sound. I checked to see the horn while the vehice is stationary and t


First of all, the car did not come with remote start. That was not available on this model. Since it has remote start, it was installed by a previous owner, or by the dealer as an aftermarket add on. Apparently, whom ever installed it, programed i ... 2005 Nissan Murano

The hazard lights and turn signals stopped working on my 2000 Jeep Grand Cherokee this morning. the lights all come on with my headlights or parking lights, but when I turn my blinkers or hazard lights on, they don't do anything. No noise or anything. But before they went out, Ii remember hearing a faint clicking sound under the dash that would constantly click to the same beat as the blinkers and/or hazards when I turned them on. I was also getting a slow drain on my battery. Not sure what the


You have problem with the FLASHER; the flasher is located in the \015\012Junction Block (under the dash, left of steering wheel. See diagram on this page). Check the following repair tip:Look at the end of the flasher \015\012re ... 2000 Jeep Grand Cherokee

Break lights do not work. all my other lights work and hazards work. replaced the break switch under the break pedal and no joy. all my fuses look good and I have not idea where I should look next. Just verified again, running lights, hazards, lic plate light, head lights, turn sigs all working fine just no break lights. should I have power over my break switch? I checked for power over all the terminals on the harness and get nothing. I tried to inject 12v into the harness and the break light d


Yes, you should have power at the brake switch. If the fuse is OK. you have a bad connection or broken wire ... 1987 Dodge D150

I have a 1974 ford f100. when i turn on my right blinker, my left front and rear side marker lights as well as both license plate lights blink, all the right lights blink as well. when i turn on my left blinker only my dash, front and rear lights blink (not the sidemarker lights). then when i turn on my hazards all the lights blink like they should, until i step on the brake. then they stop blinking. it seems as if the right blinker is somehow tied into the hazard lights, but i cannot find where


I just want to sugest checking your ignition switch to see if it is sticking to far in the on postion and not bouncing back like it should when you start it. I have had the problem on several ford pickups i have owned. In all the cases it messed the ... Ford F-100

With the lights on, the tail lights and dash lights went out. The fuse was bad and was replaced. As soon as the lights were turned on the fuse blew again. Tried another time, same problem. Braeak lights and turn signals and hazards worked. Had to drive 15 miles to destination and used hazards and turn signal. 4 miles from destination the break and turn signal lights went out. Upon reaching the destination the fuses for breaks and turn signals was changed and blew out as soon as the break


Yes it could be a short at a light socket.Also a plug in the rear under the bed that splits the sides may somehow have rubbed through and when brake lights are applied has a ground short.I hope this link will send you to the wiring diagram.The di ... 1991 Ford F150

I was hooking up a trailer to my 2001 rav4 and the brake lights don't work. the blinkers and the hazard lights work fine. I can't get the running lights either. I found a blown fuse on the hazard lights and replaced it. the blinkers and the brake lights work on the same bulb. Is there a relay that works the break lights. This is a factory installed trailer kit but I never used it before.


... Toyota RAV4

Hi Pugwash, Seems you have been down the road I am now travelling before re the one downside of Alfa ownership. I have recently purchased an Alfa 156 2.0 JTS (2005) Sportwagon - Petrol Here's the newest mechanical issue: I had the hazard lights on while waiting outside a friends place, then when he arrived I indicated Right to pull out onto the road but forgot to turn off the hazard lights. So, I hit the hazard lights switch to turn them off & I then re-indicated to pull out to the r


With the lights on but no flasing the first place to start looking would be the flasher unit. It may be mere coincidence that the problem started with the sequence of events as described. The same flasher relay is used for both the hazard and indicat ... Alfa Romeo 156

I have noticed the following electrical problems with a 2002 Chevrolet Malibu. The hazard lights do not work unless the hazard light button on the dash is pushed down and held continuously. When the turns signals are activated they work sometimes, but may also not function unless the hazard light button on the dash is pushed and held on continuously. The right tuen signal, when it works, begins to flash rapidly when the brake pedal is depressed. When the brake pedal is released, the right t


Change flasher relay in fuse box ... 2002 Chevrolet Malibu

95 gmc jimmie, 4x4, everytime i use my brake pedal, a fuse blows, i have no brake lights, hazard or signal lights. how do i fix it my mom broke off the hazard button in the steerin column so i used a stick to stop the hazard lights from blinkin all the time, it worked for a while, now the fuse keeps blowin


Consider properly repairing the hazard light switch via junkyard parts for a cheap price. You invariably have a short that overloads the fuse when you activate the brake lights via pressing on the brakes. \015\012\015\012good luck ... 1995 GMC Jimmy

The hazard lights button was pushed all the way into the dash. Now the hazards lights are on all the time. I took out the hazard light fuse to save the battery.


If the button was pushed so far in it wont reset replace it. \015\012Remove the dash panel carefully, unplug the hazard warning switch from the loom, or cut and isolate the wires as near to the swich as possible, to prevent the lights activacti ... 2004 Saturn VUE

While driving my hazard lights keep going off at will what should i do ? The central locking unit is in situ but the there is no actual alarm and although you press the key and the indicator lights flash the doors dont actually open and i have to use the key to unlock the door. However I was told to unplug the unit and it should stop the problem. I did this and now my windows dont work and the hazard lights continue to flash at will. Please could you tell me where the fuse its for hazards and is


A hazard fuse is big and round mainly silver in color usually under the steering wheel or in the glove-box or on the side of the dash when you open the door ... 2007 Audi A3
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.7566 seconds